Suburban :: 97 - Motor Stop Rotating For A Split Second Then Start Cranking
Apr 5, 2014
97 Suburban 5.7. When starting, engine turns over normally, but every 2 seconds or so the motor will completely and suddenly stop rotating for a split second, then start cranking again. It is as if every few seconds there is a buildup of compression in a cylinder that won't allow it to turn over. It will eventually start and run normally, but i believe this has contributed to going through 3 starters within 20k miles. The starters are free (warranty) but getting tired of putting them in.
View 6 Replies
Advertisement
The night temperture was only about 37 degrees. But every morning my 2000 F-350 7.3 crew cab 188,000 on it would not start. The first try there would be a split second where the motor would fire, but that would be it. I had to plug the engine block heater into my generator for at least an hour before it would start. I don't see how all the glow plugs could be bad at once??
View 14 Replies
I have a 1990 suburban that has had a rebuilt x-mission about 50,000 miles ago. At this time when I drive there is a hesitation, split second, when running on flat road. It happens when going up a hill, too.My mechanic said change the: plug wires, then the plugs and rotor. No difference.
I think the thing is dropping out of OD for a split second and then going back in. If I drive in 3rd, I don't think it is happening. Isn't there a relay or solenoid that controls this function?
View 2 Replies
I own a 99 Suburban 1500 5.7. The front blower motor stopped working on all speeds so I replaced the resistor, it still did not work. I then replaced the speed selector switch and it started working fine. Three days later I smelled a slight electrical burning smell and the fan stopped working again. I plan on replacing the switch again to see if that is what went bad. Whats causing this to happen? Maybe the motor is going bad and causing the switch to short?
View 6 Replies
My 96 cherokee 4.o is having trouble. the motor is cranking but will not stay running unless i am pouring gas directly into the butterfly valve. it runs great while i am pouring gas into it, but it sputters out and dies once i stop. i checked to pressure in the fuel rail and gas will come out of the valve however the pressure gauge doesn't have any response. it feels like the fuel pump.
View 2 Replies
First bit of cold weather and I'm getting thirty seconds of loud clicking (or clacking) coming from the immediate vicinity of the blower motor on start up and shut down. Doesn't matter whether my climate control is on or off, it still makes the noise. I'm assuming it's stripped out teeth on one of the blend door actuator gears and I'll probably just end up replacing it. My problem: Where exactly is the offending actuator? I've removed the glove box and noted one located on the left side. I unplugged this but am still getting the ratcheting sound so it obviously isn't the culprit. I had this happen a few years back (same time of year) and out of ignorance and frustration solved it with a well aimed kick but the way it's acting this time I don't think I've got a big enough boot.
View 4 Replies
I have owned this 96 k1500 5.7L Vortex Suburban for 3 years.
Problem: Intermittent stalling upon coming to a stop. When it stalls and I try to restart the engine, the starter can barely spin the motor. The timing is thrown so far advanced that it will literally fire the engine backward and grind the starter gear on the flywheel. I have killed about six starters so far. I took it to the dealership and after two weeks they are clueless.
So far we have replaced: TPS, Ignition Module, Cam sensor, Crank sensor, ECM, and perhaps a few other things I don't recall at this time. If it would stall and simply restart, I could cope with it. The only way I have found to get it to start is when it stalls, pop hood, unplug the power source to the ignition coil, turn key and spin engine over for a few seconds, replug the power source to the ignition coil, and attempt a restart. Usually I don't have to do this more than once or twice.
View 1 Replies
I have a 2005 Suburban Z71 and when in 2wd it will run for several miles then just stop moving like it is in neutral. In auto 4wd it runs just fine. What could this problem be and will it be okay to drive in auto 4wd until I get it to the shop?
View 1 Replies
We have a 99 Suburban LT 5.7 V8 4x4 with 210K miles. My wife was driving the vehicle the other day and while at a stop light the oil pressure got very low approximately 20psi according to the gauge. I need to find the oil pressure sensor location to check the true pressure using a pressure gauge but I can't seem to find it. From what I've read it should be by the oil filter or by the distributor cap or on the underside of the engine. It's neither around the oil filter or the distributor (using a mirror looking everywhere) nor on the underside of the engine.
What I have found is two sensors. A sensor I believe by #1 and #3 spark plug (driver's side) screwed into the block and a sensor on the passenger side of the engine (screwed into the block) accessed from underneath the vehicle. The sensor on the driver's side of the vehicle appears to be the best candidate however neither of the sensors looks like the replacement part when I view the picture of the sensor online.
View 14 Replies
My 06 f350 power stroke has a viper 2way remote starter.
When I try to start it when the truck is cold it doesn't crank long enough for it to start the truck. It will try 3 times when I hit the start button and normally won't go. It almost starts most times but stops cranking right before it starts. This is driving me nuts.
I just tried 3 times to start the truck and it in ally went on the 8th time trying to crank.
View 12 Replies
I have a K2500 suburban that has a rather aggressive/violent "vertical" shake when braking above 30mph... I bought it about 6 months ago and was told it just had a full brake job all around(receipts provided). The shake has been off and on, mostly reserved to highway speeds, however recently it has been constant at any speed above 30mph... Thinking it may be the rotors. I pulled the wheels off and even though everything looked brand new (as described) I replaced the rotors and put on new pads... did not fix the shake... and I had the old rotors mic'd and they came back good as new with zero need to turn/resurface.
I was told it may be the ABS, So I pulled the fuse... and it didn't fix the issue also I have no light on the dash
I was told it may be a flat spot on the rear drums, so I replaced the rear drums and it didn't fix the problem... the shoes looked brand new and had just as much pad left as the set i was replacing them with, so I left them alone.
I had happened to have new tires put on it, and they advised my pitman arm and idler arm were shot and that they couldn't do an alignment, so I replaced the pitman and idler and brought it back to be aligned which they did... this did not resolve any issues...
I spoke with the previous owner and he said he had the same issues and couldnt figure it.. he said his mechanic replaced the wheel bearings, rotors, pads, calipers, brake lines, ball joints(all receipts provided, and all these parts look brand new)...
The shake is very aggressive it makes the dash jump up and down and vibrates the hood to the point where it looks like it will rattle off.. the pedal doesn't pulse and the steering wheel aside from vibrating up and down doesn't pull or shake one way or the other... truck doesn't pull when braking or during this shake... and the second you let off the brake the shaking stops... and only ever shakes when you hit the brakes...it rides as smooth as can be when not braking...
View 10 Replies
I have a 1997 suburban vortek 5.7 with 200k miles. Went on vacation for a week and when I got back it wouldn't start. Cranks strong, good spark at spark plug and coil wire. I can hear fuel pump humming when key is turned on. Fuel pump was replaced 2 years ago (4th time in 6 years) with GM OEM pump. New plug wires. Engine will almost start and then goes back to just spinning. I sprayed starter fluid (generously) in the air intake while cranking it and it didn't fire at all (despite good spark). I thought that would be a good test to see if it was getting fuel. Strong smell of raw gas after attempting to start it. I'm going to download trouble codes this weekend....
View 5 Replies
I have a 99 Suburban 5.7L that does not like to start when outside air temperature drops in the fall. This only effects initial morning start and once started it starts and runs fine all day! If i give it a very small shot of either in crankcase vent opening in intake bonnet it starts and runs fine after that! The pump cycles and seems to be fine! Once started all is fine untill the next morning after it sets 12 hours! Could it be the AIT switch?
View 9 Replies
I have an '05 Suburban with starting issues. When it's cold out (below 40 degrees) and you turn the key, all accessories come on but truck will not crank. It then seems like the power just cuts off.......dash lights go out but gauges are fixed in place and a couple of seconds later, I hear a strange buzzing noise from the dash area behind the radio and the gauges will then go to power off position. Then if I try to start it, there is nothing, no lights on dash, no starter engaging, no clicking of the relays, nothing. I tried, on a hunch to disconnect the ground lead from the battery. Had it off for 10 minutes or so, put the cable back on, tightened it down (wasn't loose to begin with) and it started right up first try in 20 degree weather. I had previously had the battery and alt checked and both were good.
View 3 Replies
Strange thing occured this morning. My 99 Suburban 1500 2wd 130,000 miles would not start. It would turn over but it sounded as though it was starved for fuel. It eventually started but then I noticed that the word "SECURITY" was lit constant on my dash and I read up on it in my manual. If it is faulting I would like to pull the fuse, but the manual says it shares a fuse with steering. My mechanic pulled out the steering sensor about a year ago because the steering wheel would turn sharply in a curve for no reason. Do you think the reason my truck would not start is because of Passlock? I have not done a fuel pressure test and the fuel filter was replaced almost 2 years ago.
View 3 Replies
Coming home from a 2500km round road trip and back. At the time I was about half way home during the 1300km day, the car is in D and has been all day and it has been about 500km since I last came to a complete stop. I stop at a red light on the highway in a small town on my way through, look at the tach and see the rpms, once its dropped down to first, dip down to about 300 or so, then quickly back up to 550/600 which is its normal idle, then all the sudden it stalls out completely killing the motor. Cycle the key and start it up right away and it drives as usual. his might be the 2nd time this has happened. R32's and DSG.
View 9 Replies
I have about 05 with 110000 miles on car and have started to notice that the motor sounds like it is revving up when I come to a complete stop or even hyper miling. I have plenty of juice in battery Not Green and Not Orange. While at a complete stop if I switch from Park/drive/Neutral some times it will then shut off.
View 6 Replies
My van ran fine, no problems until yesterday. I started it and it ran for a few minutes then I heard it bog down 2 times ran for a few more minutes fine then stalled. Now it turns over but will not start. I can hear fuel pump, I changed fuel filter.
View 14 Replies
I have a 94 Caprice L99 4.3L V-8 won't start . Car has been sitting about a year with a full tank of gas. I parked it because I was having hard start no start issues during rainy or really humid weather assumed it was the opti distributor . The car would start after prolonged cranking. Saved up for parts now I have no fuel pressures at the Schroeder valve I pulled the fuel filter it was clear no fuel there with the key on. I can feel the relay click and hear the fuel pump cycle but only after I ( bump the starter ) but no fuel pressure.
View 8 Replies
When I try to turn on the car it cranks and seems like it is about to start but just keeps cranking. I have put dry gas, shoot starter fluid up the air filter and tried jumping it. I have managed to get it started but dies a second later. Not sure what to do, someone told me that it might be the fuel filter.
View 2 Replies
99 1500 2wd 5.7 burb
Out of the blue I started old red up yesterday (after charging the dead battery) and got a huge cloud of white smoke. Smells of coolant so Im thinking oh great a head gasket. The thing is, I can see no trace of coolant in oil or vice versa. I started it up with radiator cap off, while cranking I got a little fluid spit out the neck but once it started it was not gushing or bubbling at all.
View 1 Replies
