We have a 2006 Civic and there appears to be a coolant leak coming from the engine block above the started motor, so it is hard to see clearly. The kids are about to leave for Atlanta (from Iowa) and I am concerned that this could be a crack in the block based on some on-line discussion. Is it risky to send the kids on a 1000 mile trip without fixing?
View 6 RepliesI have an 04 ford explorer, with severe coolant leakage. I am far from an expert but it seems like it's coming from the center engine block, but I can't get much access in to tell. What's going on?
View 2 RepliesI replaced my Radiator, Upper and Lower Hoses, Thermostat and the thermostat gasket yesterday. I am leaking coolant from the thermostat though, It's coming from the seal between the housing and the block. The gasket was brand new and seemed to fit fine. I don't see any damage around where the seal is made..
Going to run and get a new gasket when the store opens.
My 2009 Vue developed a coolant leak into the oil at 130k km. I had to have replaced. GM has a technical note about this exact problem with the recommended fix: Engine Replacement. The coolant was leaking into the oil at the water pump.
The Statement from the dealership states that there was a crack in the block near the water pump. The dealership was good but a block should not break like this. Is this a design defect with the block, and if so is their a class action already started?
My 2001 Civic sedan coolant reservoir was full after a long drive - with coolant blown out from the top. I am trying to isolate the problem.
1) I Did not notice if temperature gauge rose above the mid-point on the gauge.
2) I Discovered issue after 120+ drive on a hot day (90 degrees plus).
3) The car has almost 230,000 miles.
4) About 1,500 miles prior to this incident I removed my drive belt and replaced it with the shorter drive belt to circumvent the A/C compressor as it or the compressor clutch crapped out on me.
5) The morning after this occurred the coolant reservoir was still ful.
6) I removed the radiator cap and ran the engine for about 15-20 minutes. During this time I noticed the coolant in the radiator begin to rise into the fill neck area of the radiator - no bubbles or movement other than up into the neck area. The top hose was warm and then got hot but it seemed the bottom hose remained cold. I then throttled the gas briefly and nothing happened to include the radiator remaining off. The temperature gauge read just below the mi-point. I then throttled up to about 3,000 RPMs and coolant blew out of the radiator – about 1/2 to 1 liter of coolant came out. At that point, I shut everything down, installed the radiator cap, and cleaned up the coolant. I noticed the bottom hose appeared to now be much warmer than before the coolant blew out. The next morning the coolant reservoir was empty.
7) Today, about one week later, I applied power at both fans and both worked. I checked the relays and both registered no continuity across terminals 1 and 2 - as they should. I checked the radiator fan switch for continuity when cold and there was NO continuity across the contacts - as it should. I ran the engine for about 20 minutes with the radiator cap installed. The temperature reading rose to just below midpoint (normal) and stayed there. Radiator fan had not come on yet. I throttled up and nothing. Idled for several minutes and the temperature gauge rose to about ¾ of the way to “H.” I throttled the engine to look for smoke from the tailpipe – there was none (there is no history of any kind of smoke coming from the exhaust of my civic). I throttled up again, the temperature gauge dropped quickly below the mid-point, and the radiator fan came on for the first time. After the fan kicked off the temperature gauge again rose to ¾. I hit the gas, the temperature gauge dropped quickly to below mid-point, and then the fan came on again.
I was thinking this could be a blown head gasket but now I am questioning my initial thoughts. As of right now there is no coolant in the reservoir. One would think if the head gasket was blown that I would continue to get fluid in the reservoir even with the lost ~1 liter from my earlier test. I checked my engine oil dipstick and it looks clean - just oil. Nothing unusual visible when oil fill cap removed. Wy my coolant reservoir would have filled, blown over, not empty when cooled, only to empty out by the next morning after blowing 1/2 to 1 liter. This has been a loyal car (other than the recent loss of A/C) and I would like to see if I can get 250,000+ miles out of her with no serious maintenance.
I've been working with my son to get a 92 Honda civic LX running. When finished, it was running fine except for the temp gauge always showing Hot. My son replace the Thermo sensor for the gauge but over tightened an snapped it off. I had to drill out the remaining piece and clean the threads to install another sensor. When we started the car, white smoke was pouring out of the exhaust and when rev'd, coolant came out. I think I may have drilled in too far and created a leak. How can I repair this?
View 3 RepliesI have a '98 Honda Civic with 230K miles on it. Last month, I suddenly saw few drops of coolant on my garage floor. I opened the hood and saw coolant splashed over the engine. I opened the coolant reservoir and it was empty. Surprisingly, the car never overheated and neither did the temp needle go up. I took the car to the mechanic (Honda shop) and they said that the radiator is leaking. I replaced the radiator and after driving for couple of weeks, the same issue re-occurred.
The coolant ran low in the reservoir and there was coolant splash over the engine. I took the car back to the shop and they said that the hose was not properly installed. They fixed it and said there is no sign of leak. I have been driving for a week now and check the coolant routinely. I have noticed that the coolant level has again dropped significantly. But, after the last fix, I do not see any visible sign of leak. There is no evidence of coolant anywhere under the hood. I am not sure if there is something else going on now. Is there something else I should check?
Every time we have the oil changed on our car, the car smells like cigarettes. Today I noticed smoke coming from the hood when I parked it. My husband says that it is caused by oil dripping on the engine block, that this happens to all Honda Accords, and that it is safe. Is it safe? Smoke coming from the hood seems scary. Engine oil is highly flammable, no?
View 12 RepliesI drive a 2001 Honda Civic EX and have over 248,000 miles. Almost at a quarter million! Recently, the engine has been overheating. The coolant has been leaking and the coolant reservoir would becomes full. I've checked out the fan and the fan relay and both seem to be fine. The temperature seems to increase (to redline) during traffic jams and any times of idling. When I blast on the air conditioning, the temperature seems to decrease, but would later increase when the car idles. The temperature also decreases to normal when I sustain my speeds over ~60mph. Also, the temperature will fluctuate from cold to hot to cold. What does this all mean?
View 4 RepliesSo broke down today and have no tools, in a city I don't live in. Huge coolant leak behind the block on the passenger side. Luckily we broke down right at a mechanics shop. They need to take off the manifold to get to the rusted out metal piping in back.
I am new to the V10. Looking for information on what could be leaking back there? I know I could do this myself but I need to know what parts I might be dealing with first. And its tight quarters back there.
Seen a coolant leak near the back of the block? I did an oil change and noticed coolant on the bell housing.
View 7 RepliesIs this common? No coolant in the oil-YET........
Any way to fix it without pulling the cover?
I have a 2001 Honda Civic with 145000 miles. My mechanic recently completed a coolant flush on my vehicle and when I went to pick it up said that the radiator sealant was affected by the flush so I should bring the car back in a week to have them check it. On my way home the engine was steaming and continued to that week. When I brought the car back they said it looks like it's sealant again but I may need to buy a new radiator soon. The engine still occasionally has steam coming off of it and another mechanic says I need a new radiator ASAP. I don't know much about cars (obviously) so I am wondering if this is a normal occurrence? Is this something I should pay for if the mechanic damaged the sealant when they completed the flush?
View 12 RepliesWe have a 2002 Honda Civic EX. Recently we have heard this rattling coming from the engine. It is the same rattling no matter what speed we are at or gear we are in. When we turn the air conditioning ON the rattling stops. What do you suppose the issue is?
View 5 RepliesI have a 2003 Honda Civic coupe (EX) that makes a loud squeal. It starts when I just get going in the car, maybe two or three minutes into the drive. The squeal seems to come from the engine, and lasts for 15 to 30 seconds, before abruptly stopping. I seem to think its a belt, but not sure why its doing it or how to stop it.
View 5 RepliesThe coolant is leaking from the gasket that is on the front of the engine. My repair guy suggested that I also do the timing belt at the same time. Do I have any other options? The Honda has 217,000 miles on it.
View 5 RepliesI have a 02 Honda accord which is leaking oil from behind the engine. Where could it be coming from?
View 2 RepliesI've got a 1997 Dogde Ram 1500 Pickup. It's got a major coolant leak that seems to be coming right from the middle of the front of the engine. I can't see where it's coming from. I changed the thermostat and the water pump, but it seems to be even behind that. There is a rubber hose that comes off the water pump and disappears between the two banks. I can only see a tiny end of it, where it goes. It looks like getting to that would involve taking off the whole intake manifold. If that's the case, I might as well total the truck. I dunno...
View 12 RepliesWhere is the coolant drain plug on the engine block? Have the haynes book and still can't figure it out.
View 3 RepliesRecently replaced the head and gasket on 2010 accent blue. Torqued to factory specs. There is an oil leak between the head and block in the front driver side. Can i tighten that bolt? Is there a break in period, do i need to re-torque or buy another gasket and head bolts?
View 7 RepliesI have a 1992 Civic sedan with a lot of coolant in the muffler. Let me put it this way: we messed up the head and coolant leaked into the exhaust pipe. Anymore detail than that and it's a long story. We have a new head now, but there's a lot of coolant in the muffler. My dad tried taking it off and tipping it on one end, but the fluid is stuck and only dribbles out when we slosh it around. How can we get this fluid out without damage to the muffler?
View 12 Replies