I have a '96 Dodge Stratus that keeps blowing fuse #20, which is for the fuel pump and the ignition. How to isolate the problem? This happens as soon as the key is turned on. The car has 140,000 miles and runs excellent otherwise.
View 3 RepliesMy 1996 Ford Ranger's Fuel Pump- Fuse keeps on blowing... (Fuel pump is new)... We need to find where the short is coming from!
View 2 RepliesIntermittent fuel pump problems in '96 Dodge ram resulted in new fuel pump 50,000 miles ago. Happened again 100 miles ago, so another new fuel pump. Now to start car must turn the ignition on several times before going to the start position. It appears the latest new pump may have defective one way check valve, so the pressure is depleting after turn off. Any favorite brand of fuel pump for the Dodge "pump in the gas tank" arrangement? Or solutions such as installing an external pump to do the work of pumping the fuel?
View 1 RepliesI've got the 2.4 L DHC 97 Stratus, 4 cylinder. I just finished a head gasket job and now I'm getting a crank, no start condition. I noticed I was getting no fuel pressure at the rail and when checking the 4 pin connector to the fuel pump in the trunk, I'm getting 0 volts when cranking. I ordered new fuel pump and ASD relays, though I did the tests in the Haynes manual and the ones I have seem good. All of this stuff was working before I took everything apart. I've checked around for obvious electrical connections or ground wires I missed hooking back up, but can't find anything. l am getting spark, so I think that means my crank and cam sensors are working. I'm stuck on this one.
View 9 RepliesI have a 1996 geo metro that I have been working on for the last couple days. The problem that I have been running into is the ignition fuse keeps blowing the instant that the key is turned.
This kills the power to the fuel pump as well as the power to the ECM. (killing all the idiot lights). The engine still cranks over and all the accessories still work.
I have tried disconnecting the fuel pump wires as well as the ECM and the ignition module to try and narrow down the problem but the fuse still blows about 2 seconds after I turn the key.
My R32's Fuel Pump Fuse keeps blowing. This started after driving my car in a bad rainstorm. I think water may have gotten in the door which could be causing the short, but I am not sure. This car has two fuel pumps as it's been modified. I know for a fact the main fuel pump works as it did prime after replacing the fuse (then letting the car sit over night then opening the door). Right after the fuel pump primed though, the fuse blew. I decided to replace the fuse and start the car. The car started and ran for maybe a second or two before the fuse blew. I took a look at this thread in regards to the fuel pump not working as I thought the fuel pump was dead till today. I was wondering what are the possible problems that could be causing the fuse to blow? Could it be the relay? Could it be the switch in the door shorting? Also, where would I find the relay? I know it's under the dash, but is it under the panel on the passenger side or driver side?
View 1 RepliesOk so I just bought this car, 1993 pontiac grand am se, from a neighbor. When I test drove it, the back seat was all unscrewed so I thought no biggie and it drove really nice for being a 1993. Ended up buying the car. I get the car home, husband puts seats back together and we go to leave for town and the fuel pump fuse blew. Put a new one in, go to start the car, fuse blows again! Tow the car home. Husband checks the wires to make sure there is no faulty wires. Has to reground the ground wire. Car then starts. Go to drive down my driveway and the dang fuse blew again! Mind you there is a new fuel pump in the car so we know this isn't what is wrong with it.
View 4 RepliesWhen I changed the alternator on my 2000 plymouth neon, I crossed the wires for the plug. Now the fuel pump fuse keeps blowing, when it turns over, which isn't often. I turn the key and nothing happens.
View 2 RepliesI have a 2000 F150 with @175K miles. Replaced the clutch about a year ago, replaced the front calipers a few weeks ago, due to the right front locking up on my way home from work. Since then, when I try to start, it blows the fuel pump fuse. (#10)...
View 2 RepliesI have a 1994 Ford Ranger king cab 4x4 with a three inch lift kit on it . My problem is the fuse is blowing that goes to the fuel pump . It started out blowing the fuse now and then when it was raining . Well I thought it mite be the fuel pump going bad but after I put the new pump in the truck it lasted about a week and started blowing fuses again . I put another fuse in and it go a few days and blow it . Last week on a 100 mile tripe I got almost there and it burned a fuse on the highway . I tried to put another fuse in and it would blow it as soon as I tried to start the truck . Burned five fuses right then . So I had it towed to mothers house and put another fuse in and it cranked up . I looked at the wiring that was not wrapped in that plastic cover stuff and have not found anything yet ...
View 14 RepliesI have a 2006 Dodge Stratus and recently lost my transponder key for my ignition. I do have a spare key cut but it doesn't have a chip in it, I can only use it to unlock the doors and open the trunk.
What I want to know... is there:
➣ A way to disable/bypass the theft prevention system so I can use the non-chipped key in my ignition?
➣ a way I can modify my key to trick the theft prevention system into thinking it is a real key?
The fuel pump fuse keeps blowing intermittently. I would assume it's a wire grounding out somewhere but I can't seem to find one yet. I do have a faulty purge solenoid on the canister but I don't think that would cause this. The reset switch doesn't seem to be tripped either.
View 3 RepliesI have a 1999 Dodge Stratus in which I am having fuel injector issues with. A few weeks ago I replaced the #4 fuel injector with a new one and now the #4 fuel injector has failed again. What can cause this to happen?
View 8 Replies1999 Dodge stratus fuel gauge works form Half to Full. Fuel pump replaced and mechanic thinks the BCM is bad. Need to figuring out the issue. Fuel gauge was checked and it gives the correct voltage.
View 3 RepliesMy 96 Metro for some reason is popping the 15 amp ignition fuse randomly. First time it happened I disconnected the alternator and replaced the fuse and it got me home. Pulled the alternator and had it tested and it tested fine. Put it back in and everything worked for about a month. It popped the fuse again while driving down the road. I disconnected the alternator again but this time the fuse still blew. I disconnected the coil replaced the fuse turned on the key and the fuse did not pop. I reconnected everything and it worked fine. Hasn't repeated itself in a week. I think there is a short somewhere. Just can't find it.
View 1 RepliesI have had this car for sum yrs never had any problem a couple months back while driving it would just shut off. Well come to find out my ign fuse would be blowing. I would replace it and it would start up and run just fine. Since then my daughter owns the car and it happened again and she replaced the fuse and it started up fine but while out of town it just shut off and now even if you replace the fuse it just blows. Just as you turn the key, it blows. So i did sum research and replaced the ignition switch. Tryed to start it and it still blows so im at my wits end. If I knew what every component that fuse ran , i could figure it out by process of elimination. I have the Chilton book but i still can't seem to find what all components that one ign fuse runs. It is a 94 grand am 3.1 v6....
View 7 RepliesI know the not going into park and key wont come out are related but not sure what to do about it.96 Dodge Ram V-10 I was told about 120000 miles I haven't looked .....
View 7 Repliesok, i just became the proud owner of a 71 dodge dart.. fuel pump was not working, and am converting to an electric (airtex e8016s) and am told i need a relay. airtex doesn't seem to have one, is there another i can use? fairly new at this sort of thing, but have fixed a 72 honda motorbike, so not afraid of engines or whatnot.
View 19 RepliesI have a 2004 Hyundai Sante Fe 2.4L that keeps blowing the ECU fuse under the hood when the ignition is turned on. We have replace the fuel pump and the inertia switch. I have tested the relay, ignition failure sensor, both coils and O2 sensor wiring.
View 10 RepliesLooking for a wiring diagram for a 96 model with 3.4 engine? The horn fuse keeps blowing and I don't know what else is on that circuit to check. The horn works when the fuse is replaced but the fuse blows at some time afterwards.
View 5 Repliesmy wifes explorer is getting no fuel. (there is a valve I depressed similaR to a tire valve, I pressed it once some fuel dribbled out, and thats it, turned the key several times and not a drop off fuel. I went as far as checking the fuse, the fuse is not blown. what are my next steps of trouble shooting.
View 8 Replies