Ford :: Repetitive Whirring Noise From Right Back - Wheel Bearing?
Sep 19, 2013
2006 Ford Focus with an ongoing wheel bearing issue. Earlier this year I heard a repetitive whirring noise from the back right, figured it was a bearing, brought the car in for repair. The shop confirmed and replaced the bearing.
3 months later, I heard the same noise. I brought the car to a different shop (I had moved since) and they confirmed that it was the same wheel bearing that had just been replaced. They said it may have been faulty. They attempted to repair it, but the noise persisted. They actually ended up putting the new bearing on the driver's side rear and swapping out the old bearing that was on the driver's side with old one on the passenger's, which is the only way they could get the noise to stop entirely. (This confused me)
Fast forward two months and the noise is back on the same side - passenger's rear. The shop is telling me that it is unrelated since the new bearing was technically put on the other side, however, I am thinking that the same thing keeps happening whenever any bearing is put in the same spot (passenger rear). My question is as follows - what could be happening in the passenger rear that would cause bearings to continually fail?
View 1 Replies
Advertisement
Have a whirring/wheel bearing metallic rubbing noise at 70-80 mph, 6th gear (manual transmission). It's hard to pinpoint the location but it's from the engine area! I heard about water pump failures but thought I'd hear that all the time not just at speed... MKVI GTI ...
View 15 Replies
Ok, so my 2007 F150 Lariat super crew cab has been at the dealership for a week now with them claiming that a part is on back order. How hard is it for them to get in a right front axle?? Granted, it was in there for other stuff too (which they can not give me a straight answer on if they fixed or not cause they are claiming the technician hasn't done the write up on it yet). My main concern is that they are screwing me around or that something happened to my truck. I am planning on stopping by there on Wed. morning after I get out of work.
Are these trucks known for bad front axles or was there some kind of a big recall on them?
Other things it went in for was the radio having the CD's cycle through when you first start up the truck, but does not happen like that all the time. Black plastic driver side front door hinge is cracked exposing the metal reinforcing part. Whirring/bearing type noise when you first start up the truck when it is cold and sits overnight (which they claim they can't hear yet waited to bring the truck inside and check it out at 3PM when they had the truck overnight from the night before when I dropped it off.) and the front driveshaft not fully disengaging when the truck is in 2wd. Almost seems like the vacuum locking hubs are still engaged.
View 8 Replies
The whirring noise from the back of the car, like a servo motor maybe. Often happens several times after parking and shutting down engine.
View 7 Replies
My fiance drives a 2006 Escapse XLT v6 AWD. It's really a great car.
She noticed an issue when she filled the fuel tank the last time. It took about 8 miles of driving for the gauge to read full after being filled from empty. She also told me there was a "whirring" noise when shutting off the car and turning it back on. I checked it out and found the fuel gauge is making a noise. Whenever you shut it off or turn it on and the needle moves there is a distinct whirring noise that sounds like dirty plastic gears meshing, which is what I'm assuming is the issue.
I've done a search and came up with 0 results. Can the cluster be disassembled and possibly just clean the gears?
View 5 Replies
So on my girlfriends 2000 echo I get the classic bad wheel bearing noise/vibration on the front left (driver side) wheel. Worsens under load (right turn) and goes away when unloaded (left turn). I've replaced left side bearing, CV axle, brake rotors/pads and the noise still persists. My next thought is maybe the ball joint but humming/vibration tells me something out of rotational balance. Bearing in the transmission? I don't know. I'm stuck.
View 5 Replies
So my ranger was having a textbook wheel-bearing noise at around 50mph....when I turned to the right the noise went away implicating a passenger side wheel bearing.
So I replaced both of the hub bearings on the pass side and noticed that the front axle shaft u-joint right behind the spindle was really bad and was going to change it but couldn't get the spindle off so I said screw it.
Took it for a drive and the noise is still there. Could a worn u-joint possible replicate a wheel bearing noise? I am used to them making a clicking/popping noise while turning when they're bad, but not a whirring sound.
1993 ranger 4x4 manual locking hubs.
View 4 Replies
Not my video, but I have the same exact sound coming from my passenger side wheel on my 03 V10 4X4, 130K. Passenger side only, no noise from the other side.
YouTube .....
Before I spring for the Timkin, does this sound like a bad bearing? No play in the wheel, but it's a clicking sound.
View 7 Replies
I have a 03 explorer with approx 160k, I am experiencing a thumping noise while driving. It gets worse on right turns and gets better on left turns. initially i thought LF wheel bearing so i ordered a hub assy and replaced LF. noise is still there. I guess, thumping noise caused by wheel bearings, i know its usually a grinding kind of whirring noise.
The noise doesn't seem to change with accel/decel so I don't think it is driveline related (diff, drive shaft etc.) should i bite the bullet and replace the rf as well??? I should also mention that there is also a shake in the steering wheel that seems to coincide with the thumping (i.e., my hand shakes along with the thumping, and the shake gets worse when the noise does)...
View 8 Replies
Wheel bearing go out? My left front just starting making noise and when turned by hand you can hear the bearings are shot. Called around this morning and with my luck its on back order and the entire hub has to be replaced since the bearing is built into the hub.
Anyways, I was wondering replacing this unit themselves and how long it took to complete? I was going to let Ford do the work but I figured I have never done a job like this and wanted to give it a try and looking at some Youtube videos on older vehicles it did not look that difficult.
If I find that its not difficult I will tackle the other side as well since I figure it is probably not long before that side is gone also and I would not want that to fail while I am out towing somewhere.
View 8 Replies
I have a 2003 Sport Trac 4wd with 299,000 miles. There is what sounds like wheel bearing noise (grinding) that was noticed after returning from a trip where I flat towed it behind my rv. I did not notice the noise the last time I drove it - before towing it about 450 miles. I have towed this vehicle for many years and miles this way - transmission and transfer case in neutral with key in on position to unlock steering. I stated this part about the towing because the noise may have gone unnoticed for many miles. About 20,000 miles ago, I changed front wheel bearings, brake calipers, upper and lower ball joints, shocks and outer tie rod ends. Also rear brake pads.
I put the vehicle on jack stands and in drive mode couldn't hear anything in either 2wd or 4wd. I held one wheel at a time so the other side would spin. After checking for wobbling wheel bearings, I took off the wheels and did a push / pull on everything - all seems good. I changed driver's side wheel bearing anyway because I thought it to be a little rough. I removed the front drive shaft and took it out on the road. Noise was still there. This makes me think front differential but before entering unknown territory (for me) is there something else I can do to narrow down the problem? At this point, I'm not even convinced it is from the front end - maybe the sound is radiating through the truck.
View 3 Replies
I'm working on a 02 explorer. The front end is howling so I replaced the left side and no change. The howl goes away when braking. Is it the right side then or something else? I replaced both front brakes pads so it's not that.
View 2 Replies
I have an 01 Ranger 4x4 that recently started to make a loud speed dependent noise from the drivers side front wheel, a quick jab to the right on the steering wheel and it stops, straiten out and it comes back...since I know my shocks are worn and have some cupping on the front tires my first thought was tire noise so I moved the back tire which is evenly worn to the front and no change, next I removed the tire and checked everything visually.
All seems ok, the brake does not seem to be dragging and there is no evidence of a cv problem, everything seems tight, so I'm guessing the problem is a bad wheel bearing? If I grab the tire at 12 and 6 there seems to be excessive movement from top to bottom, there should be none right? If memory serves any movement is indicative of bad wheel bearings? I guess I'm looking for some vindication before getting a new hub?
View 14 Replies
I have a 94 Explorer. I recently swapped over from auto to manual hubs. I followed a detailed write-up that I found online. During the process I repacked my outer wheel bearings. Ever since then I hear a grinding noise coming from the front wheels. Sounds like the bearings aren't seated properly. The guide that I followed instructed to torque the spindle nut that sits next the the outer wheel bearing really tight in order to seat the bearing, then loosen it back up and hand tighten it. But when I loosened the spindle nut the wheel bearing would pop back out. What is the best way to get a wheel bearing to stay seated properly?
View 2 Replies
I owned a 99 f250 a little while ago. Just bought a 2006 crewcab F150 xlt about 2 months ago, and for the past month there has been this unusual grinding or whirring like noise coming from the front passenger side wheel.
I took it to the mechanic and he found a bad wheel bearing on drivers side and replaced it but that wasn't the issue. He could hear the noise but wasn't able to figure out what the actual issue was.
The noise only happens when my foot is on the throttle. (not when coasting) and i also just discovered that it doesn't make any noise at all when put in 4x4.
View 4 Replies
I have this repetitive rubbing sound coming from the driver's side front wheel. It increases as I go faster and slower as the car goes slower. When I apply the brakes the sound disappears. It usually isn't audible when first driving but will show up after a few minutes. If I'm turning slightly to the left it will go away, or if I make a right turn I will occasionally get a rattling noise that's distinctly different.
I had this looked at a while ago, before the rattling noise appeared, and they determined it was a motor mount and replaced that. The noise did not go away.
I've taken a look at it and do not see anything obvious. Brake pads are still good, rotor is smooth and not visibly warped (though it has more rust on it than I'd like). I tried moving the tire to see if the bearings were shot but didn't have any luck (I'm not ruling it out yet).
View 5 Replies
Have a rear wheel bearing making some noise. A friend told me that it is always the outer bearing that goes first . Can you replace the bearing without replacing the race?
View 14 Replies
My girlfriend and I just bought a 2011 a few weeks ago. We test drove it a couple times ourselves, and had our mechanic take a look at it and drive it also. Everything looked and sounded good. Not sure how much it matters, but it's a Certified Used as well.
A couple days ago, returning from a 45-minute drive which included some short stretches of gravel road, I noticed an oscillating sound. It's definitely not a noise that was there when we bought the car. Unfortunately, my cell is apparently bad at capturing audio, so hopefully my description will be enough.
The noise is very faint, almost inaudible, at low speeds. Between 30 and 35 mph it gets much louder, peaking at about 33. There's some vibration through the accelerator pedal also. Above 35, it fades pretty quickly and I can't really hear it at 50. The sound itself is 3 beats on, 1 beat off, about every second. There's a slight difference in pitch between each beat.
If that isn't enough to go on, let me know and I'll give the recording another shot and upload it if the noise is audible.
View 6 Replies
2002 F250 4 wheel drive manual hubs, 7.3....
My first thought was to have the tires rebalanced and rotated to see if it is tire noise? I am hearing damage on top of the noise from the 7.3, hard to be sure!
View 11 Replies
So after doing wheel bearings in the car. both front and back. I'm still getting the "wheel-bearing hum" sound if you will. Don't know how this can be possible with all brand new wheel bearings and hub in the front passenger side. other hubs were fine. I do need tires which will be ordered soon/ alignment im sure.
View 5 Replies
I took my car in for what to me sounded like a wheel bearing noise. Dealer thinks the culprit is brakes need to be replaced. In addition to needing brakes I was told i need a throttle body service (service agent says it's needed every 15k for carbon buildup) and also a fuel tank vent filter ("needed every 2 yrs") are these legit repairs I should perform or is this a dealer shake down?
View 15 Replies
