Steering :: 2003 Silverado Hard To Turn To Left At Low Speed
Sep 16, 2015
I have a 2003 Silverado 1500 4wd at low ( 5 mph ) speeds it turns to the left like I have manual steering. To the right it turns fine. As soon as I get the speed up to 6 or 7 mph turns fine. At a stop you can't hardly turn left but again turning right if fine. I can put in neutral and rev the engine up and it makes no difference. I googled the problem and I don't seem to be the only one with the problem and no one seems to have an answer. I have tried a lot of "fixes" like check the air in the tires and replace the steering fluid etc but nothing has worked yet.
View 3 Replies
Advertisement
I just replaced the power steering box on my 1979 dodge B200. now when I start it it turns hard to the right and I can't turn it to the left.
View 6 Replies
The problem makes the car unsafe to drive. The quickest way to describe it is a hard pull to the left after a very linear steering feel. My perception is almost as something is holding on and then just fails and lets go and the car quite abruptly shoots left in a very unsafe manner. Here are the things I have done to remedy the situation, I replaced the struts with factory replacements 15,000 miles ago. At the same time i replaced the left and right axles, drove the car with the problem then last weekend, I replaced the upper tie rod arms, and lower tie rod ends, the sway bar bushings, and the control arms on both sides. I literally feel as though it is a darn near new front end.
Just yesterday I had 4 new Goodyear eagle tires and an alignment done and the problem became more pronounced and worst. I really like this car and want it to be a joy to drive as I know from others these little hatchbacks are a real joy on winding mountain roads.
View 10 Replies
I've got a nasty groan and vibration on the steering wheel coming from my Steering Pump when I turn hard right or left. There seems like a little bit of oil around the pump and some traces of shiny metal (tiny sparkles) near the spline so I'm pretty sure the pump and pulley needs replacing.
View 1 Replies
In tight corners exits off the freeway, usually speed limit is around 20 - 25, my steering wheel is to hard to turn just like there is NO power steering at all. Feeling the same when turning around my neighborhood. Mine is C4 just bought it last Sunday June 3rd: is it defective?
View 9 Replies
Last night at 2am and it was about 10 degrees out (I say the temp because it might matter?) I started my car, let it warm up to normal running standard and backed up. My car moved backwards but the wheel would not turn at all. I pull forward into my parking spot and noticed that the wheel is extremely hard to turn left or right... almost impossible.
I check under the hood and noticed that my car was leaking something onto the group but it was dark and I couldn't quite see what it was.
Checked this morning and I found that my power steering fluid was completely empty. I had a half bottle in my trunk and put it in my car, then turned my car on. All of a sudden I noticed that the fluid is leaking onto the ground. Not really leak, more like a slow/medium pour and the wheel still wouldn't not move.
View 8 Replies
My steering got real "heavy" almost as if I had no power steering so I replaced the power steering pump. The steering got a little easier but is still very stiff. It's extremely hard to turn at low speed just off idle...I have to rev the engine a bit to get it to turn.This is on my 1999 7.3 f350...I've ran 33" and 35" tires on it it's whole life and this is the first PS pump I've replaced since 1999...never replaced the steering box.
View 9 Replies
I have an 03 F350 4x4 dually. Was pulling hard left at low speed when braking (front). Replaced pads, calipers, rotors, hoses and tires. Still the same problem. You can feel the abs activate right before it almost locks up the left front brake (basically will pull the steering wheel out of my hand). BTW the abs light does not come on.
View 2 Replies
I have a vibration when i take a right corner above 35 mph. Its coming from the front left wheel area. The brakes and rotors look fine. The ABS light cuts on and off sometimes also.
View 3 Replies
I have a 2003 Volkswagen Passat, and I'm having some trouble with it. When I turn the steering wheel, there is a groaning sound both to the left and right. the other problem is when I'm accelerating slowly up an incline and turning the steering wheel, there a type of clicking sound I hear and feel on my accelerator. By the way, it's a V6 engine, Front wheel drive.
View 2 Replies
2.4l std. The steering started getting hard to turn intermittently. I pushed the fluid and took out the reservoir and cleaned the screen. It was pretty dirty and smelled kind of bad. The belt looks ok and there are not strange noises or leaks. I figure it's the pump but I read a lot of posts where the pump was changed and problems persist. Also, I've never had a bad power steering pump so I don't know the symptoms. Is this simply a bad pump?
View 4 Replies
Having trouble turning my wheel both ways on my trail blazer. Just replaced wheel bearings on truck not sure what would causing this. Also tries are wearing down..
View 6 Replies
I have a 2003 Toyota Camry. About 10 months ago, when I get a transmission fluid change, the mechanic told me that my power steering fluid is dirty. A few month later, in the cold winter month, my steering wheel make loud screeching noise when the engine is cold only. The mechanic told me that I have a small power steering leak. But since I don't see the power steering fluid level goes down and the mechanic say I don't have to fix it now, I didn't do anything about it.
About a month ago, there is a squeaking noise come from my steering wheel every time I drive very slowly out of (or into) my driveway and turning the wheel. Now I heard the noise when I drive slowly (10 mph) and turning the wheel too. So what is the problem that cause the noise when I turn the wheel at slow speed? I only drive about 5k miles a year. Is it safe if I just continue to ignore the problem?
Also, the color of my current power steering fluid is amber, but a little dark. Which power steering fluid should I buy?
View 6 Replies
I have an 01 2500hd crew cab which has turn signals that flash at hyper speed. the only bulb that wont work is the passenger side outer turn signal. i believe its a 194 bulb. it has no power to it. i changed the short harness and socket and still no power. the turn signal switch has been changed recently for another issue and this didn't correct the turn signal issue. is this a known common issue or do i need to pull apart my wiring harness and start chasing wires? turn signals work but blink extremely fast and it is a little annoying.
View 2 Replies
My power steering is only working when i turn it to the left. When I turn it to the right i have to get a 1/4 of a turn in until the power steering takes over. So i get under my truck to discover what seems to be a piece of my tranny missing. How screwed am I ???
View 11 Replies
I have a 2003 Silverado 1500 with 198,000 miles. I was on the PA turnpike a few days ago and notice that when I take my hand off the wheel, the truck pulls to the left. I have to hold the steering wheel center to keep it straight. When I let go, it makes a slight turn to the left.
I did notice that I had a bad ball joint on the passenger side. So I replaced the upper control arm with a new ball joint included and did the lower ball joint on the passenger side since I already had everything apart. I just got my truck aligned this morning and still am having the same pulling issue. The dealership couldn't figure it out either. Here are the specs from the alignment printout:
Front Left Camber:
Before: -0.7; Actual: 0.0
Front Left Toe:
Before: 0.13; Actual: 0.01
Front Right Camber:
Before: 0.7; Actual: 0.0
Front Right Toe:
Before: 0.02; Actual: 0.00
I do rotate the tires every 5,000 miles and are all wearing evenly.
View 9 Replies
I have a 01 Chrysler Sebring 4D Sedan. I have been working on cars many years, never done tie rods. This my first attempt, I messed something up I believe. I replaced both inner tie rods and outer ends. I followed what I thought was correct procedure., counted turns on ends coming off. Installed new ones the same amount of turns. Before I did this the steering was fine. Now when I turn sharp to the right or left, like turning in to a driveway, I get an awful binding grinding noise, and I can feel it shimmy in the wheel. It will even stop the car going hard right. I can see evidence of rubbing on the CV boot closest to the wheel on the pass side. I assume I messed up somewhere with setting the steering when I installed the Tie rod ends to the wheel hubs.
View 19 Replies
The other day as I was leaving my neighborhood, I had to turn the wheel all the way to left to circle out of my culdesac. I heard a brief clank and a yellow light on the dash indicator came on for a split second and went away before I could see which light it was.
I remember when I first bought the Phaeton I read throug the manuals and read something like: do not turn hard left for an extended period of time. I always thought that was odd and wondered why. I also wondered if that clank and brief yellow light was because I was doing this hard left. What's special about left vs right?
View 2 Replies
I bought a 2007 GS350 April of this year and I love the car. Been wanting one since it came out and I was fortunate to find one with only 52k miles. When I purchased the car, it had 20" TSW wheels. Onto my problem, it just started a few days ago, at crawling speed, my steering wheel pulsates to the left. The faster I go, the less it will pulsate but it will pull to the left. The wheels aren't bent, tires are almost brand new, no bubbles nor knots. The balance on the wheels aren't off. I read somewhere the wheel bearing could cause the steering wheel to pulsate but I don't hear the hum nor grinding noise associated with bad wheel bearing.
View 5 Replies
My friend with an 07 with about 109k miles on it now has started getting a "groaning" noise whenever the wheel is cut hard to the right or left, either sitting still or rolling. A local repair shop (not the dealer) checked it out and said there was some "stuff that needed to be lubricated". Not trusting this opinion he went to a Toyota dealer where he was getting new brake pads installed on all 4 corners (no Lexus dealer in the city where he lives), they diagnosed the car as needing 4 new struts and a new balljoint.
If in fact he does need the struts and balljoint, I am thinking chances are there will be a bunch more suspension stuff that should really be done at the same time when everything is apart anyway - perhaps bushings, endlinks, etc?
Is he better off sticking with the OEM strut replacements or should he go aftermarket? He's not looking to slam the car or anything, and is more of a ride comfort guy than handling enthusiast.
View 1 Replies
When I turn hard right & left, near the left wheel well there's a little metallic clicking sound. Either way I still don't what it is. Upon inspection when I removed the wheel the I noticed that the red portion with the large arrow is able to move clockwise and counter clockwise. Just curious as to whether or not this should be capable of happening.
Wheel baring, control arm and bushings have been mentioned from Le Shwab's workers... I dunno though I need Vortex's opinion
When collar 3 is turned all the way down it can't rotate, but I'm almost positive that collar 2 and 3 are suppose to remain in contact with one another to prevent movement of collar 1. Just making sure that my theories are correct.
View 9 Replies
