Volvo - 240 :: 1991 Station Wagon Will Reverse But Stalls In Drive / Neutral
Nov 3, 2013
This is a 1991 Volvo 240 Automatic Station Wagon. The Check Engine Light has been on for at least 6 months, the timing belt was replaced 3 months ago , the battery is a month old, the oil was just changed, gas tank just filled and the odometer stopped at 259,000 miles before I bought it so it has well over 300,000. Yesterday morning it took a minute to start, which happens on occasion, but backed out and drove about a mile and stalled at a stop light. It finally started, after 6 false starts, and I turned around to go back home. It then stalled again but reversed just fine, so I got it turned around and drove in reverse the rest of the way home. It drove fine after a few hours but did the same thing today.
View 13 Replies
Advertisement
I have a 1997 Volvo 960 station wagon. It has been sitting in the driveway for 5 months. I went to drive it and it wouldn't start. We jumped it and it ran but wouldn't hold a charge. The battery was about 7 years old so we went and bought a new battery. We took the old battery out and replaced it and now it does nothing. It won't start and there is no sign of power to the car at all.
View 5 Replies
Got a 90 740 GLE station wagon (missing its rear muffler at present) that turns over yet doesn't like to start up on the first or second try. It has also stalled out at stop signs, and once when driving. Had a tune up about 3 months ago, new plugs and plug wires, and some welding on the exhaust, but the muffler is still missing. Could the exhaust be causing this in any way? It always eventually starts. Could use a little more power, but, hey, it's a 22 year old car. I'd really like to get this solved, as my ex drives it with my kid. Could this be a fuel pump or fuel filter issue?
View 3 Replies
1991 740 Wagon 2.3 I4 with turbocharger and an intercooler.
My rear taillamp brake lights do not come on.
Of the 4 red lights on both taillamp cluster, only bottom two red lights stay on when I turn on the head lights. When I step on brake pedal with both headlights on or off, all 4 read lights do not come on.
I only get the middle small red light on. (which probably means the brake light switch on the pedal is fine.) I do have the lamp malfunction warning on when I turn on the headlamp or signal lights on.
I changed the lamp malfunction relay (big red cylinder) but things are the same. Found the bottom right red light had one of its filament broken so replaced the bulb but things are still the same.
View 3 Replies
my daughter has a 91 volvo 240 with a 4cyl and auto. roughly 100000 miles. it starts and runs fine but after driving it, if it is shut off for less than 30 min, then she tries to start it again, it stalls immediately. she can keep her foot on the gas slightly and drive it the distance of a parking lot, the car will run fine and not stall. i was curious if a tune up would fix this or if there is a smaller fix such as a sensor.
View 1 Replies
My 1993 Toyota Corolla station wagon is not starting. The starter tries but the car does not start. It was fine yesterday but just won't start today.
View 5 Replies
I have a 1989 Toyota Camry station wagon. I was driving it tonight on a slow neighborhood street and it just died. When I tried to start it back up, it won't start. I have power, all lights and things at full strength. When trying to start it it makes a high-pitched whirring screeching sound. I don't know where the starter is located, but the sound seems to be coming from around the spark plugs or behind/under them.
View 2 Replies
I have a 1997 Dodge Dakota V8 (automatic) with about 140k and live in Vermont. Recently, my truck will konk out while I am sitting at a red light. As I'm sitting there, the RPM's keep going down below 700, until finally stalling out completely. When I shift into Park/Neutral then turn ignition, it will start right back up again. To get around this, I have been shifting into Neutral while I wait at the light, then back into Drive when it turns green. I have recently installed a new battery and exhaust system. I am wondering if this is occurring because of worn plugs, a dirty air filter, cracked vacuum hose, or bad alternator?
View 2 Replies
"95, 2.3L, automatic. Stalls for a couple of seconds and nearly dies when shifting from drive to neutral or from drive to park. Doesn't do it when cold at high idle or when AC is on. It catches back up and idles fine but nearly dies when coming out of drive. Installed a new idle air control valve but no change.
View 1 Replies
Vehicle was repaired after front end collision and I get no codes found on scanner, had some bad connectors which I replaced and codes went away. I don't get ready light and the dash lights do not cycle off (ABS, SRS, Check engine, Etc. Etc.) The car will shift into neutral but not drive or reverse. Has new Aux battery and Hybrid battery is showing two bars. What to check ?
View 6 Replies
I am experiencing a slight vibration with in drive or reverse but not when it is in neutral. I change the spark plugs and checked the PCV. I have the latest model already and I replace the gasket in the PVC. There is no errors in VAGCOM.. What could be causing that? Mounts???
View 4 Replies
i have a 1994 nissan quest 3.0 v6 and when i put it in reverse or drive it will slip into neutral if i am stopped. Also the front motor mount needs to be replaced, which I will do soon. Are these problems related, if not how do i fix the shifter/linkage problem? When driving the vehicle upshifts and downshifts perfectly.
View 1 Replies
I have recently been having problems with my 2013 Prius v (lowercase v for the Prius v wagon). When I press power, all the dashboard lights turn on. And when I try to shift the car into reverse or drive the car stays on neutral. What is going on?
View 7 Replies
Have a 2003 Saturn Vue with a variable transmission (rebuilt). It will only go in reverse even when in drive, or natural.
View 5 Replies
The truck will go into reverse, but will not go into drive or any of the other gears. When shifted into one of those gears, it just idles as though in neutral. This started as I was driving down the highway at approximate 70mph. The speedometer jumped up then fell to zero as the car slowed to a stop. There was no noise except the sound of rapid fuel intake and then it went to idling. I have been told it may be a speed sensor, but I was wondering if there was anyway to confirm that before I have the truck towed down to a mechanic and find out its more than I want to pay to fix it.
View 1 Replies
I have my 1995 Volvo 940 Turbo that stalls in reverse and hesitates on take off. The following is a breakdown of what has been done so far:
1. Initial Issue from March to October is hard starts; it would take 15 minutes or more to start car; it would be longer sometimes in cold weather.
2. Car would have erratic idle after startup; car reaches operating temperature before movement; car would bog down in idle and die only in reverse; initial acceleration from takeoff is slow;
car runs fine once out of first gear from takeoff; car bogs down on braking with idle lowering; sometimes car stalls at braking; gas is sometimes tapped slightly to stop stalling.
3. Issue of hard start would be intermittent; it would be less prominent in hot weather and more prominent in cold weather.
4. Sometimes in rain or wet weather, car would stall and sometimes backfire; Distributor Cap is normally changed.
5. By October, a no-start condition occurs.
6. Car starts now, idle is not erratic; car would bog down in idle and die only in reverse; you barely tap gas to keep from dying in reverse; initial acceleration from takeoff is slow; car
putts a little; car runs fine once out of first gear from takeoff; exhaust flows strongly; takeoff slightly improves incrementally with continued operation; car bogs down on braking with idle
lowering; sometimes car stalls at braking; gas is sometimes tapped slightly to stop stalling.
7. During idle or operation, sometimes coolant will boil in reservoir; toggle fan brings temp down to normal in between fan cycles; toggle fan keeps coolant temp normal in really hot weather.
The following parts have been changed and are still prominently new:
-Ignition Coil
-Spark Plug Wires
-Spark Plugs
-Distributor Cap (Initially Sealed With Sealant, Condensation Issue When Raining Causes Stalling)
-Rotor Button
-Condensation Cap For Distributor Cap (No Need For Sealant Now)
-K&N Air Filter
-Turbo Intake Hose (Original Had Disentegration In Spots)
-Exhaust Manifold Gasket (With New Locking Nuts and Sealant On Manifold Side, Not Block Side)
-Power Stage (Ignition Module or Ignition Stage Amplifier)
-Engine Coolant Temperature Sensor
-Gauge Temperature Sensor
-Knock Sensor
-All Vacuum Hoses
-All Coolant Hoses (Including Oil Cooler Hoses)
-Fuel Pressure Regulator
-Oxygen Sensor
-Catalytic Converter (Honeycomb In Original Rattles, Discovered Gone When Removed)
-Exhaust Resonator/Central Muffler (Original Damaged By Honeycomb, Sounded Like Broken Glass, Baffles More Than Likely Clogged)
-Idle Air Control Valve
-Starter Solenoid (Starter Tested Good)
-Power Brake Booster (Original Replaced, Failed 2 Out Of Three Brake Pedal/Vacuum Tests)
-Battery
-Radio Suppression Relay
-Throttle Position Sensor
-Fuel Filter
-Timing Belt and Tensioner
-Crankshaft Position Sensor (Last In Chain, Resolved No-Start For Now)
The following are checkpoints, mods, and maintenance:
1. Modded Airbox for more airflow, no codes present from OBD before or after
2. Cleaned MAF Sensor with MAF Sensor Cleaner, no codes present from OBD before or after
3. Checked EGR Valve - Diaphram not broken, free movement, appears functioning
4. Had EGR Pipe Rewelded - Pipe broke from connection to throttle body, completely sealed and functional, Minimal Carbon Removed
5. No codes from EGR temp sensor before or after
6. Checked EGR Vacuum Controller through OBD - appears functional
7. Checked Fuel Pump - Repaired frayed hot wire, sealed, pump fully functioning
8. Checked Fuel Pump Relay - Functioning
9. Properly adjusted Idle Air Speed - Steady Between 700-800 RPM
10. Checked EGR Pipe to Exhaust Manifold - Minimal Carbon Removed
11. Cleaned Throttle Body with Throttle Body Cleaner - No Soot/Carbon exiting system
12. Created Toggle with Fuse in between connection, connected to slot in fuse box, cuts off with car, slight battery drain issue before and after installation
13. Checked oil in case - oil change still new, no milky appearance suggested head issues
14. Removed and cleaned breather box - no oil deposits clogging operation
15. Checked charcoal canister - stalling in reverse happens with and without it connected
16. Checked muffler during disassembly of exhaust system - no honeycomb/debris present during testing
17. Car is at Top Dead Center - Timing
18. Fuel Injectors tested fine with OBD and Pressure present at rail
The following parts have not been changed yet:
-Charcoal Box
-MAF Sensor (No Codes)
-EGR (No Codes)
-EGR Vac Controller (No Codes)
-Compressor (No A/C, issue with stalling is unrelated)
-Power Steering Pump (Slight squeaking on rotation, PB Blaster in bearing area confirms, issue with stalling unrelated)
Other Issues : Slight battery drain coming from somewhere in the car, have to remove negative from battery for now
View 3 Replies
When I started my car and put it in reverse, it didn't move. It felt like my front, right wheel was in a divet or was being blocked somehow (intuitively it seemed like if I accelerated enough, it would eventually move, but since there was nothing physically stopping it - that I could see - I didn't want to break something by doing that). I tried putting it in drive and neutral and the same issue was still there. I put the car up on a jack and checked one wheel at a time - I could move each wheel completely around in both directions.
I could move the steering wheel all the way to the right and to the left. I tried turning off the 4-wheel drive and that didn't do anything. At this point I'm concerned it could be the transmission or the drive shaft, but I'm not sure what to look for in order to know if I need to get it towed to a shop (hoping I can avoid this) or if there's a simple test I can do, or a way to "reset" something if it may be locked. I haven't had anything happen to the car that would have been of concern.
View 2 Replies
I am having difficulty with my Prius, (just started) that it won't shift out of neutral to drive or reverse. I have read several posts, one says replace the shifter knob, but I did read one i thought that said the 12v battery might be the problem with low voltage. The battery is 5 years old.
View 2 Replies
I have an '07 Prius Touring with about 95K miles that I have owned for about a month (after my previous '07 was totaled). My wife tried to drive it for the first time today, and the problem is that when my wife tries to start the engine, the dash lights come on and the color display comes on, but the car won't "shift" into Drive or Reverse (it will go into Neutral). A dash warning light also comes on that the owner's manual says means Take to the Toyota Dealer for Service. Then if she gets out of the car and then I get into the drivers seat, everything works fine.
View 16 Replies
2009 Touring Dead at 55000... All lights on dash light up and won't shift to reverse or drive only neutral. Towed to dealer and they said it threw several codes and are replacing the tranny.
View 18 Replies
it's a 2000 honda civic EX. I pulled into a parking spot and slowed down, then decided to speed back up and when I accelerated it was like the car was in neutral. No gear would drive. Turned off the engine and re started and it shifted and did fine then about a 1/4 mile down the road the same thing happened. It just switched into neutral. The transmission fluid is full and clean and the filter has been changed. There was no warning signs at all.
The only caveat I can think of is last week at 15 mph my front passenger wheel fell off after someone replaced a tire. I traveled less than 10 feet on the wheel. But didn't think the transmission would be low enough to hit the ground.
At first I thought transmission clutch but it would be doing it in one direction? Then I thought maybe a pump? Or could it be a sensor or the torque converter.
View 6 Replies
