4Runner/GX470 :: 1990 - Loud Rubbing Noise In The Front Right Of Truck Intermittently?
Dec 29, 2009
Here' the low down. I have a 90 4runner v6 4wd. It is intermittently making a loud rubbing noise in the front right of the truck. It starts randomly and sometimes stops on its own or will start when I hit a bump,it will stop when shifted into 4wd, or when I brake or turn hard to the right. but happens only a portion of the time. took it to mech, he removed front drive shaft and said prob went away, it seemed the vacuum pump or the solenoid that activates shifting out of 4wd is defective. So he manually switched off the 4wd replaced the front shaft and all good! but on my way home the noise began again. super frustrated, 3rd mechanic in a week.
View 1 Replies
Advertisement
I have an 1990 Toyota 4Runner. V6 engine. Automatic. 4wd. Today it blew an upper radiator hose. A few seconds after the initial pop of the hose and the spew of fluids the vehicle died. I replaced the upper radiator hose and the lower hose- and refilled the antifreeze. There are no leaks as of right now.
The engine will not start. The belts spin whenever the key is turned on. But the engine will not crank. You can hear the starter trying to start it up. Jumping the vehicle was of no luck. Charging the battery was of no dice.
The vehicle makes a whirring noise (belts spinning) when key is turned, but the engine does not crank at all. The noise stops as soon as you shut the key off. The oil is clean and full still.
View 2 Replies
I have a 1990 Toyota 4-Runner, manual 5-speed transmission. About a week ago, while shifting gears, I heard a loud "popping" noise from the general vicinity of the clutch. I did not feel anything different in the clutch, it returned to the appropriate position and didn't feel any more or less "loose." However, after the "pop" it seemed difficult to get the vehicle into first gear and second gear, and I really had to "push" it to get it into gear, but it would not grind or anything else. Also, when shifting into reverse, it would grind loudly and be very difficult to get into reverse gear. If I turn the vehicle off, put it in reverse and then start the car, it works fine, though it seems like it "sticks" longer in reverse and takes a bit more muscle to get it out of reverse and into first again.
Additionally, when the shifter is in first gear, but the clutch is pressed, it seems as if the clutch is not disengaging entirely, because the car wants to move forward slightly when I take my foot off the brake, almost as if I'm letting my foot off the clutch a bit with it in gear. All of this has been happening pretty regularly, but the car has still been driving fine. However, today, the poor thing wouldn't start. This vehicle (like many manual transmissions) needs to have the clutch pedal pressed in order to start the vehicle. Even when I press the clutch all the way to the floor, the car won't start (and I know it is not a starter/battery issue). Given the other problems with the clutch and shifting gears, it almost feels as if the clutch was not getting disengaged all the way even when the pedal was pressed to the floor, and now that it won't start, I'm wondering what is going on. Does this model have a linkage adjuster that needs fixing? Is it something wrong with the clutch fluid? Or do I need a new clutch entirely?
View 6 Replies
I have a water leak in a 1990 4runner (3vze) at the back of the block i called the dealership and they said the headgasket had been done, i noticed this leak because the water is well orange rust colored to be exact my 4runner needs a new radiator but that's kind of self defeating until i fix the leak at the back of the engine, what it could be? or how to check if its the headgasket, the oil doesn't appear to have any water in it,i believe it's coming from above the head but there isn't much clearance between the injector plant and firewall.
View 13 Replies
My 1992 3.0L V6 is showing it's age. My 4Runner problem is getting worse by the day. It started the day after I bought it. My truck won't accelerate with the RPMs over 3k. My truck smells like fuel. The fuel filter is 3k miles new. I can't get it to start like it used to now. It will take me at least three cranks for it to turn over. The battery is new too... less than one year old.
View 6 Replies
I have a craigslist nightmare vehicle in the shop today, a 98' Toyota 4runner Limited V6. Runs and drives fine, but it's got a heck of a growl in the front end over 15mph. We removed the diff and found that when it was turned it had some vibration and a ton of noise. Disassembled it and found it to be full of metal flake, and it appears the spider gears are worn and causing a good lot of the noise. The bearings seem to be alright, but I'm planning to replace those anyway while we're inside, due to the amount of metal in the fluid.
My questions are:
1. Is this a common failure?
2. Where can I purchase spider gears? Most places don't seem to list them.
3. Is there a rebuild kit that includes bearings and spider gears so I can make one part order and run with it?
View 1 Replies
I have a 1991 toyota 4runner with 4wheel drive stick shift and it has been making a loud rrrrrrrrrrrr sound. It seemed like it was coming from the front right wheel or somewhere close to that area, so I checked the brake pads and rotor for rocks or any other object that might have gotten stuck. There was nothing stuck, however I did notice that the boots were ripped. So I changed both front axles and I also replaced the wheel bearing only from where the noise appears to be coming from. The noise is still there. It makes the noise sometimes, if i'm going slow or fast. Other than that, the car drives well.
View 2 Replies
Not so simple as an unbalanced tire. Left front wheel/tire starts shaking at about 35 mph, worsens with increase in speed up to 52 mph then quits shaking. Some residual (though minor) vibration after that. Had tire balanced already at a good shop so I don't think that's it.
Struts are due for replacement - could that be part of the problem? I've had the thing on a lift and don't see anything indicative of a ball joint or an a-frame bushing, BUT, is it possible/probable that my problem is one or more of the latter problems combined beyond the tire issue?
View 2 Replies
i proudly own a 1986 4runner and i loved it ever since i got it. but i noticed on the way to a buddies house, a really high pitched squeaking noise...almost like a mouse. I just set it aside and turned up the radio. well this morning it was really getting worse. it was more audible and I am sure others can hear it in the parking lot of my school.
Also, I have another problem (trying to kill two birds with one stone here) i went to start the truck the other morning and its getting really really cold, about freezing point and when i started it up, the engine was idling at about 500rpm and there was a really loud noise under the hood, it sounded exactly like a vacuum cleaner. I quickly turned it off, hoping the started didn't stick or something, but the engine stopped and the vacuum cleaner noise stayed for about 4 or 5 seconds. I waited a few minutes and tried again and started right up and idled correctly. got to school, turned it off and started it back up and started correctly. went out there in the afternoon and it did it very shortly and just idled right. it still does it just barely every morning I start it.
View 11 Replies
I brought my 4runner in to fix a rear axle seal and to see if they could isolate a clunking noise I've been having. They said the clunking was coming from the rear differential (I believe him as that's what I heard, while driving or even just putting it into gear). They have yet to call me back, but any guesses here as to whether it is a bearing (my guess, as it is most pronounced on a bumpy road) or a cracked gear or something else. I've been driving with a clunk for about a week, but have various clunk problems for the last 80k miles ....
View 14 Replies
I have a 2001 Toyota 4Runner SR5 with AT and V6 with 70k miles on it with pretty much everything loaded. The car has been trouble free since I got it 3 months ago. However,the past month, the engine has been making a high pitched "squeaking" noise whenever im at a constant speed. If I accelerate or brake, the noise goes away.
I also noticed today that it stays constant no matter what when I am in 4WD mode, but when I am in 2WD it behaviors like I describe earlier. I had the Toyota dealership do a complete lube service and they found two of the belts were "dry" and re-lubricated them however the problem persisted. The noise doesn't happen when im in idle or at a stop either. The noise seems to emanate from the right side of the engine.
Also, do 4Runners have a noisy brake cylinder system? Almost every time I brake I hear this slight "Pssssssssssssssssssss Tick!" sound from the engine. The car brakes just fine and the Toyota dealership found nothing out of the ordinary but i've never heard a car break that noisey before. This a 4Runner trait? What could be causing these two noises, especially the gawd awful squeaking noise from the engine. It never made that noise until just one day..
View 6 Replies
Today I was out getting lunch in my Ecoboost When it started making an extremely loud grinding noise from the front end of the truck. My first thought was I blew a turbo. After holding the break and building boost I discovered it was not the source of the noise. Also the truck runs perfect and there is no smoke. I then took it to my friends auto shop and pulled both front tires off to check and see if anything break related came loose. We found nothing. The noise only happens upon acceleration or cruising throttle, as soon as you let off the sound goes away. So after I found nothing I took it to ford and what would cause that, but they assured me that they would have my truck for a long time while they figure out the issue.
View 14 Replies
I have a 92 4runner with v6 5speed Manual tranny it has the A.D.D hubs ,when I put it in 4wd its not going into 4wd the 4wd indicator in dash is not coming on ,that could be a bad bulb cause it doesn't come on when you turn key on.The transfer case is working all right .Its something in the front end that's not engaging .I noticed on the front diff. there is some kind of solenoid there with vacuum hoses and a electrical connection .Does this have anything to do with it not locking into 4wd?
View 2 Replies
on a 93' 4 runner that will not engage 4 wheel drive. The 4 wheel manual shifter works fine, and the linkage underneath looks fine; however, the indicator does not light up - and it definately only has rear wheel drive.
View 5 Replies
I have a problem with my 4runner, it ran good when I drove it before I deployed, not I got back and it will not run, it starts for about 30 seconds then dies, sounds like something is killing the fuel, I took the cap off the tank to see if it was clogged, but thats not the problem, it just will not stay running for longer than 30 seconds. Also I realized that the alternator was very hot for the 5-7 times I started it and had it run for 30 seconds? Oh it's a V6 3.0L 5SPD manual 4X4 by the way.
View 3 Replies
we have just pulled out head resurfaced and put engine back together now it won't start tried the timing and checked for fuel but wont start the only way it starts now is with brake fluid in the intake but that only fires up and won't stay idle.
View 3 Replies
I've noticed that my brakes are very sensitive lately. I'm wondering if it has anything to do with the differential oil that got on the rear pads when the rear seals blew out about 3 months ago. The shop cleaned them off but they still looked oily to me. I'm also wondering if it is parking brake related as one or both of the bellcranks are frozen (there's no cable sag, but one of the stops has a gap and the parking brake doesn't work). Or is it brake fluid related. I am years past the point of needing to replace the brake fluid and bleeding out the old fluid.
View 5 Replies
The transmission went out on my toyota 4 runner ...
View 1 Replies
I have a 93 4Runner, and it won't start all it will do is turn over, But won't start, my dad has tried everything we could think of It has gas, an new battery and new battery cables...
What is the location of the MASS AIRFLOW SENSOR, AND THE MAIN COMPUTER...
View 2 Replies
The son inlaw just bought a 86 4runner. It's been beat pretty good but I know Toys are good for it. My question is, it rev's just fine in every gear but 5th. Going down a flat highway and in 5th it won't rev over 2500 no matter how much gas ya give it. It has a 22re and 31-9.50's under it. My daughter had a 86 p/u with a 22r (I believe) and 33-10.50's and it had no problem hitting 90. Is there a limiter on these things? Thought i'd ask before chasing vac lines.
View 2 Replies
I have a 91 4Runner SR5 V6 3.0L that has been a great truck (like all of them?) until just recently.
Symptoms are bogging at roughly 25 mph or 2500 rpm in second to third gear. It will also sometimes not take off from a stop at a slight incline. By hammering the throttle down and forcing a downshift, the truck will rev up and then accelerate, but then again sometimes bog down until the same "forced shift" is done.
This seems prevalent when the engine is hot, however, that may be coincidental with the high temps here in So Texas lately. The truck does seem to run fine for a while after starting it. Mechanic hasn't isolated anything.
View 7 Replies
