I drive a 2001 Hyundai Accent. About a month a go the CE light came on. at first, the car was driving fine so I thought nothing of it. Then I started noticing that the acceleration was sluggish and when it finally accelerated, it basically slingshot forward. What could be wrong. There's no smell, rattling or anything else. The only thing I noticed was the engine was a bit louder.
View 1 RepliesMy wife called to tell me that her Camry would barely pull away from a standstill this morning. Very sluggish until about 2500 rpm, at which point she said it took off normally. This accompanied by the Check Engine light, which just appeared this morning. I haven't been home yet to check fluid levels or take a test drive. Anything in particular I should be looking for?
View 6 RepliesI have a 2003 Cadillac Deville with about 120,000 miles on it. The SES light came on and I had some maintenance done at STS. The light came back on the night I picked it up. I took it back the next day, they said it was related to the transmission and they do not do transmission repairs. They cleared the light and said if it came back on they could flush the transmission and maybe that would take care of the problem or they suggested I should take it to a transmission repair shop. The error codes are p0741 & p1860. Once in a while at the beginning of a drive I experience a sluggish acceleration, it does not last long( a second or 2) and then runs fine for the remainder of the drive.
View 6 RepliesWas on my way to work when my coil plug light started to blink - acceleration was sluggish as hell so I tried restarting the car to see what would happen. After restart the coil plug still lit up followed by the check engine light. Was gonnna be late for work so I used my other car to get to work and got the car towed to the dealer to check it out. This is what they found...
Birds decided to make a nest in my nice and cozy warm engine compartment ...
I have a 2000 accent. Automatic tranny with 167000 miles. My current problem is the car is misfiring upon acceleration and engine revving. I have to accelerate very slowly to minimize this but i once the engine revs up enough I can give it more gas and it will rev normally with plenty of power. I have had to unplug the maf to keep it driveable. Ive never had a car stay running after disconnecting the maf so this is strange to me. My accent barely stays running with the maf connected. I just got the car from my dad and he had it fixed and it ran good for awhile with the maf connected so I don't think it is the maf. But the same problem came about and we had to disconnect the maf again. And he cant remember or is not sure what was exactly fixed on the car. I've read up about the purge control valve and havent had a chance to check it out but some of the symptoms fit.
View 21 Replies2002 accent 1.6 motor and 5 speed,when I take off the motor sputters for a moment then is fine and if I let it slow down in any gear and step down on it it will sputter again then is fine, so far I have changed the plugs and air filter cleaned the throttle body and MAP, the wires and timing belt were changed out not long ago, took it in and hooked the machine to it and it said misfire bank 1 oxygen sensor upstream so replaced it and still have the problem, the body has 200,000 on it and the motor 100,000.
View 8 RepliesMy problem is this: when I am driving and press the throttle hard from low rpm (anything under 2000-2500), the car will struggle to pick up rpm, and be incredibly sluggish to accelerate, until it reaches around 3500 rpm, at which points it returns to normal. Whilst it is struggling to accelerate, the exhaust sound is almost like a subaru, in that there is a series of small burp noises which stop once it returns to normal acceleration. It only whilst attempting to accelerate from low rpm that I have this problem, i.e. idle plus mod-high rpm is fine.
View 2 RepliesI have a 2005 Hyundai Accent with the 1.6L in-line 4 cylinder engine w/ 160K miles. Over the last few months, I have noticed that when I run the A/C, the car has been at idle for a while, like at a stop light or in park at idle, and I have been driving the car for awhile in the afternoon (summer here), the engine sputters and hesitates on acceleration. The engine makes a pinging, sounds as if it's misfiring and then bolts like lightening, especially when I turn the A/C off. The mpg has declined. I barely get 21 mpg. The car does not have an inline fuel filter, only the "sock" in the tank. I have changed the spark plugs, plugs wires and have run two cans of Sea Foam FI cleaner through the fuel system and the problem still persists.
I am clueless to what could be causing this other than my injectors are still dirty and need a heavy duty cleaning. Could it be an alternator problem because I have noticed the dash lights and headlights get brighter. Could the ignition coil be going out. The car idles fine and the problem disappears when I shut the A/C off and only seems to do this when the weather is hot!
I have just changed my clutch and machined my flywheel on my 1.5ltr 16v dohc 2000 lc accent. I used all the correct trans fluid and refilled and bled the clutch fluid. It takes of from lights like a new car but if you put your foot down around 40kph it revs out a bit and does so through all gears untill you reach a bit of speed. What is going on?
View 11 RepliesI have a 2005 Accent with just over 35,000 miles on. Last night (in extreme cold here in Chicago), the car started running loud. Loud on start, idle, and acceleration - normal when maintaining speed, even at highway speed.
Since the loud sound first started, I have driven about 100 miles (had to for work, no choice). The sound is pretty much the same - definitely in the front end, and the best way I can describe it is a much louder version of the normal sounds you would hear - idle sound but louder, acceleration sound but louder, etc.
No warning lights have come on, car hasn't shown any signs of overheating on the gauges, etc. I had a somewhat similar issue with an old '99 Saturn SL2 w/ 115,000 miles - but in that instance the flex pipe had corroded and completely separated from the rest of the exhaust system.
I have a 2002 accent 1.6.(272,000 miles) It has been having this issue for awhile now. It is very slow to accelerate, seems like it is losing power. Also if I press the gas pedal hard it does not want to shift correctly unless i back off the gas pedal some and then it will shift fine. I have had the transmission checked and it has no issues (transmission has be replaced with only about 80,000 miles on it). Also if i try to run the AC it really looses power. It currently does not have any diag codes when I have it scanned. So far I have replaced spark plugs, ignition coil, fuel filter, and a diode that I was getting a code for. I am just curious if there is something that could be causing the issue that will not report a code.
View 5 RepliesI have a 2002 Hyundai Accent with a 1.5L SOHC and manual transmission, with 207,000 trouble-free miles on it.
I have recently noticed a hesitation under acceleration. It happens most frequently under hard acceleration under lower RPM, if I'm close to lugging the engine. The engine "hiccups," almost like it is missing a cylinder. It will hiccup 2-3 times until engine RPM's increase, then smooths out.
What the cause may be? Last changes: Plugs at 175K; Plug wires @ 160K, Fuel filter @ 100K, Timing belts at 60K, 120K, 182k. K&N air filter cleaned at 50K intervals, last time @ 200K.
My '03 gives a rattle sound under load/acceleration conditions. This does not happen during the warm up period, so it appears that the engine runs lean under acceleration. There is no check engine light on for this. Approx 172k KM, (100k miles). The noise appears worse when it is hot/humid outside. I have run a can of Seafoam through it (half in the crankcase, half in the fuel line), and that doesn't seem to have worked. Therefore, I don't think that it is the injectors. Possibly fuel filter (still original)? Any easy way to test?
View 8 RepliesI have a 2004 Hyundai Accent 1.6 DOHC 5-speed Manual Transmission ... so here is my problem;
Regardless of whether I am going from a complete stop or if I am simply changing gears the acceleration is practically non-existent, sometimes taking up to 3 minutes to accelerate just 5 mph. While I am driving at a consistent speed of 65 mph, the RPMs will randomly jump from 3000 to 4000 or 5000 with no apparent cause.
I have been told everything from putting air in the tires to replacing the clutch. I do not have the time nor the money to try every option of fixing this issue. I need to attempt to narrow this down to as few probable causes as possible.
I'm an Accent 2000 gs owner and since a few days i had this problem. It has a bad idle and looks like it will stall... need to give some gas to stay alive.
Bad acceleration too, it misses some gas. (puffing, rumbling, shaking a bit). After accel, it's ok until the next red light.
Now I can't even drive cause it's worse. (too difficult to accelerate). Is it a sensor?
Well, I just went to grab some lunch and on the way home I got on it a bit. I was met with sluggish acceleration and a flashing CEL. Before I could even turn the car off, the CEL went away. I was about 200 yards from my house so I coasted home. What could the issue be?
2008 Passat 2.0T Tippy with APR stage 2.
My 2011 stick shift no air Accent has a hesitation or stumble on light acceleration that comes and goes. It may not occur for weeks then re-occurs. It is hard to reproduce intentionally. It never occurs in cruise. The CEL is not on. Most often occurs at 1400 to 1500 rpm with slight acceleration or a slight increase in load as coming to a slight hill. I tried injector cleaner a few times and changed air filter. It seemed more reloaded to induction airflow so I changed the MAP sensor. I understand the 2011 Accent does not have a MAF sensor. It is still occurring. It is fine in steady cruise as well as in hard acceleration. I am wondering if it is a TPS sensor problem. It has 60,000 miles and otherwise runs fine.
View 4 RepliesI recently took my truck to the mechanic for a bad transmission leak, they told me they had to replace the Oil Cooler Lines (upper and lower) and that they did a transmission service (flushed out the transmission), the leak is fixed, but as soon as I started driving, I noticed that the acceleration is very sluggish from a full stop, I can floor the pedal and there is no difference, once I get going it seems fine (though a bit high on RPM's but not much). I also noticed some of that liquid sealant residue droplets on my windshield, similar to the type of sealant an AC place did for me to seal an AC leak, not sure if that has anything to do with this.
View 8 RepliesI picked up my first GTI about 3 months ago, a 2011 Autobahn with about 35,000 miles. I love the way it drives. I had been admiring them from a distance, and was finally able to pick one up. Unfortunately, I've run into a few issues. I'm pretty much a rookie when it comes to the inner workings of cars, but I'm eager to get into it more. My issue is below:
Over the last few weeks, the car has been consistently a little sluggish, and the acceleration has seemed a bit jumpy. I've only used premium gas, and I've been looking for simple things that might be the issue. I live in Houston, and I was wondering if maybe the extreme heat and humidity might be the reason behind the sluggish performance.
Yesterday, I decided I would clean the air intake filter. It has a K&N intake from the previous owner. After cleaning the filter and replacing it, the car wouldn't start. I may have put too much oil on the filter or the humidity may have just caused it to take longer to dry than the instructions on the cleaning kit recommend.
I called my bro-in-law who is the go-to car guy in our family. He recommended that I try starting the engine without the air filter and pull out the MAF sensor and check it out. When I took off the filter, the car started fine. I replaced the filter, then also pulled the MAF sensor to see if it needed to be cleaned. I found that the bottom of the MAF sensor was bent and slightly dented. I could also see a place where the sensor had scratched the bottom of the pipe.
This morning, the car is running a little smoother (better than before, but not as quick as I remember), but the check engine light has come one. Could the performance issues be due to the damage to the MAF sensor? With the check engine light, is that something that is automatically triggered by removing the MAF sensor? Or is there some other issue.
I have a 96 aurora that has been giving me alot of problems. It started with the car being real hard to start and very sluggish upon acceleration. I had an engine code of 0300 (multiple cylinder misfire) I had a full tune up as well as an intake manifold gasket done. This seemed to fix the problem for a short time. The problem then started again. this time i was told that it was a fuel pump so i went ahead and changed that as well. Again this fixed the problems for a short time. Now i am having the same problem again. I now have 2 engine codes 0300 as well as 0151(bank 1 sensor 2 o2 sensor) This started after it rained and i notice the problem always seems to be a little worse when its wet out. Also the car is really only hard to start when it has sat for awhile. m If i drive it and come back 5 minutes later it will start right up though it still idels really rough and has no acceleration. Can the o2 sensor be causing the misfires and if so will that make it hard to start. Also if i changed the fuel pressure regulator about a year ago.
View 2 RepliesLately I have found that when I am trying to go up an incline on my road, that my car has trouble accelerating. Almost as if the engine is being choked off like it is about to stall or is out of gas. I have to press the accelerator almost to the floor to get up the incline. The suddenly it will lurch and accelerate rapidly as if I have put the car in Power Mode.
I should also add that this only happens when the engine is cold. I didn't have this problem last year at all. I usually wait a couple of minutes after the engine starts before I try to drive, but that doesn't seem to work.