Accent LC (2000-05) :: Car Doesn't Want To Go In Reverse And 5th Gear
Nov 14, 2016
Just bought a 01 Accent hatch the other day. It's a 5 speed 4cyl. First gear through 4th have no problems. If I try to shift into 5th gear or reverse, the car doesn't want to go into them. The dealer I got the car from said that the problem is with a pin or something. I have never bought a Hyundai before this, I've had old 70s american cars. I was thinking it could be a shifter linkage but I figured I would ask you knowledgeable people about it first before I go and break something trying to fix something simple (hopefully simple.
View 8 Replies
Advertisement
I have a 2001 Hyundai Accent GL the reverse gear went out but all the forward gears work. Ive been told that I need a new transmission. I found a great deal on a transmission from a 2007 Hyundai Accent. Will this transmission work in my car?
View 1 Replies
I've got a 2003 Accent and my automatic transmission went out, no reverse and the only forward gear is 1st. Was thinking of pulling it and swapping it for a used, but I have been reading on here the many, many automatic transmission problems of the accent and my next thought was to just rebuild it myself. But now I'm thinking more along the of a swap from auto to manual, as I don't want to have to rebuild a transmission that is only going to have to be rebuilt again anyway. As far as stuff like the clutch pedal, linkages, gear shifter, I can get those pretty easily. Does the Accent have a hydraulic clutch?
View 2 Replies
Reverse gear doesn't work on my 1999 F350, is the transmission need to be rebuilt? or it can be adjust thru the cable. the rest gears on transmission is Ok.
View 8 Replies
My daughter has a 03 Accent that within the past week will not start at certain times. Some times it will some times it wont. It always cranks but doesn't catch. If she tries to start the car and it cranks, but doesn't catch, if you wait 15 -20 minutes, or longer, it will turn over and run fine. We are thinking crank position sensor or possibly fuel pump...
View 4 Replies
About a month ago my 2002 accent started intermittently turning on. The car cranks nice and strong when it doesn't start-(until the battery loses too much power from repeated cranking). When it does start, it happens instantaneous, no issues no hard start.
I have talked to multiple people with varying amounts of automotive experience, who have given many things to try.
Things I've replaced or tested, hoping they were an issue:
-Starter and relay
-Fuel pump and filter, as well as relay for pump.
-Battery, post connectors and wires to starter
-Alternator and belt
-Multimeter tested fuel injectors and ran fuel system cleaner for last 3 fill ups
-Replaced spark plugs and wires
-Ran fuel line antifreeze every 2 tanks or so
Things I've been told might contribute to the intermittent starting, but haven't looked into
-Inconsistent fuel pressure
-water in the fuel tank
-Bad ignition switch
-MAF sensor
I live in area, currently in the icy grip of winter. I thought the cold would be a huge contributing factor, but alas, when the car has fired up the temperature has ranged from 1 to -32 degrees and has no issues starting in the deep cold.
View 9 Replies
So my 1.6 accent (140,000) decided to no longer start. Just keeps cranking but doesn't ignite. Plugged a scanner in and it's the crankshaft position sensor. How difficult is this to get to? From what I've ready its just held on one end by a 10mm bolt and the older end is just a connector, but it looks like it might be in a pain in the ass location. Does anything need to be taken off first to access? Should this take less than 30 min?
View 1 Replies
I bought the car maybe months ago and the gas gauge nor the thermostat worked. The fan kicks on just fine never seems like it's over heating and it doesn't lose water or anything like that. For some reason it's a pain in the booty hole to put in gas it stops every 45 cents. When I first got the car the dash lights didn't want to work but kicked in and now they work fine also the AC button doesn't light up or turn on and the dome light also doesn't work.
View 1 Replies
After every time I jack either the front of the car or the whole car up, the ride is really rough for a few days. The suspension doesn't seem to absorb the bumps, it feels like the body does and it makes for a really rough ride. What would cause this? I can tell you, one of my front struts is so stiff, you can barely compress it when pressing down on that side of the car. but after a few days of driving and taking the bumps, she evens out and rides normal.
View 4 Replies
I have had my manual 2014 four months now and still can't get used to the fact, that to engage reverse you have to move the stickshift FORWARD into the same spot as first gear. I have had a half dozen near wrecks because of this.
View 5 Replies
My 2001 Accent GS (1.6L DOHC) wouldn't restart after a short 2 mile trip to a local store. The engine cranks fine but doesn't fire.
It has had a CEL issue for awhile and after it wouldn't start I checked the codes and got:
303
335
722
I replaced the Crank Position Sensor and Fuel Filter but it still just turns over.
I hear the fuel pump run when I turn the key on and I broke the fuel line and it is Pressurized, so I doubt it is a fuel issue.
The 722 code indicates the output speed sensor has an issue. Need to know definitively if that sensor is completely shot could this prevent the ECU from firing the engine?
I have had this car since it was brand new and I'd like to keep it going a little longer.
View 5 Replies
Ok, so I got my car at 60k miles, and the clutch went out almost instantly so I had the entire clutch replaced, and it was working just fine until now. It has been 25k miles since I did the full clutch replacement so it shouldn't be messing up again already. It is not going in to reverse at all, it goes in to 1st gear, but only after a lot of coaxing and grinding, and the clutch feels strange. The clutch is too soft (too easy to push down), but after a while it seems to get better.
2007 Hyundai Accent GS
Manual, hatchback
85k miles
View 8 Replies
I have a 2000 Accent with about 150,000 miles on it. Recently I have noticed that when my car is sitting in an intersection, the car appears to idle roughly. I would't exactly say that the car is idling rough, cause it stays at a consistent RPM while in drive or park, but the engine gets louder and the steering wheel starts to vibrating. When I slightly step on the gas, the vibration goes away. Also, when I put my car in park or neutral, the car quiets down and the vibrating stops.
I was wondering if it could be the throttle position sensor, or maybe a broken motor mount, but I haven't had a chance to look into it it. I did replace the purge control valve last week, which slightly improved the vibrations.
View 14 Replies
What this sound is? I thought it was the brake pads so I tried to change them and broke the bolt on the caliper (both sides). Long story short, the car now has new pads, rotors AND calipers. But i hear this scraping sound. Follow the link to a youtube video. It speeds and slows with the car and doesn't change when i apply the brakes but seems to quiet down when I'm in reverse. Wheel bearings seem unlikely since the sound doesn't change when I turn the wheel to either side.
Video: [URL] ....
View 4 Replies
I have a 2003 Accent with 30,000 miles on it... It is making a variety of noises right now but the latest and loudest is that when I am backing out of parking spot or something like that it makes an awful squealing noise... What that might be?
View 2 Replies
I have a 2001 accent 1.6 5 speed manual. When I put it into reverse it dont fully engage until I give it some gas and then it slams into reverse with a bang. I am not really sure but I think it only does this with the car is cold I may be wrong though it started this a few weeks ago.
View 3 Replies
I have the opportunity of getting i believe a 2004 accent gt for next to nothing. It recently lost reverse and all gears aside from first. The codes it is triggering are p0734 p0732 and p0733. Prior to throwing the codes it moved back but wouldn't budge forward. With codes no reverse or any gear higher than first. Car has 160k miles I am pretty mechanical. Should I run from this "cheap" "gas saver" or pick it up? With all 3 codes could it be just that sensor?
View 6 Replies
I have an 02 accent with 1.6 that has no reverse and throws P0732 and P0734. How to repair?
View 5 Replies
2004 accent had a drink spill on lower console, and think this is why it quit shifting? Disassembled, cleaned switches, unhooked battery, and car still has no reverse, shifts HARD into drive, will not move further.
View 5 Replies
I'm not very mechanical when it comes to cars. I have never had any clutch issue with my car. I arrived to work yesterday fine. When I started to leave it was incredibly hard to get into reverse and I had to force shifting after I left and the clutch had also lost all resistance and I could easily push it all the way to the ground. What could be a cause of the clutch always working perfect including the last time you drove it, and then 8 hours later you start up and it has done a 180. The fluid level is fine. I would presume if my clutch had went I have have slowly noticed it going.
View 1 Replies
I have a 2003 Accent and it has been over heating constantly for about 5 months. After it started, we replaced the main radiator hose, thermostat, radiator cap AND a head and head gasket. It worked for about 2 weeks and then over heated again. It seems like there is too much pressure somewhere because the lid for my reservoir shoots off and all the coolant comes out. I'm just not sure where to look for a clog since it is coming out of the reservoir. It also recently started having transmission problems(?) or that is what I think it is... It won't go in reverse and has a hard time shifting sometimes. I'm not sure if it could be related or if it is the tranny also.
View 4 Replies
