Accent LC (2000-05) :: Engine Would Turn Over But Wouldn't Start
Oct 16, 2016
o my wife was driving our 2005 Accent GLS with about 95k miles yesterday, and it had an issue that it's had three or four times before: the engine would turn over but wouldn't start while it was still warm. In the past when it happened, whoever was driving would wait a few minutes and try again. It always started on the third or fourth try after waiting five to twenty minutes.
Yesterday, however, she was frustrated and so called AAA to have them send a battery truck over and have them take a look at it. The truck came relatively quickly, and they started their diagnostic procedures. The battery was fine (knew that), and he tried all the standard things like cleaning the terminals/harnesses and whacking the starter with a hammer. My wife said that as she and the tech tried to start the car, the turn-over seemed to get shorter and shorter- so when she first tried it would turn for a few seconds, and after a dozen or so attempts it was only turning for a second or less.
Finally, the tech (who apparently seemed to be frustrated at this point) got behind the wheel while my wife was looking under the opened hood and turned the ignition on and held it. The positive battery terminal apparently started smoking and my wife had to yell at him to get him to stop.
After this point, the engine no longer turned over at all. He tried a few more things like cleaning the cables, but no change. He finally said that he would call for a tow truck, and we ended up getting it towed back to our house.
The problem is unchanged since yesterday: there is full power when in ACC mode, but when you turn the ignition all the way to the on position there is nothing but a single loud "click" and a high-pitched whining noise.
I left my ODB bluetooth interface at my office, so I haven't been able to see if there are any codes.
View 6 Replies
Advertisement
Our 2005 Hyundai Accent GLS refused to start yesterday. It seemed like the engine was struggling to turn over. It took about 10 minutes and then the engine FINALLY started. CEL came on. We drove about 1 mile and back, and the engine seemed fine. We even turned the car off, and turned it back on with no issues.
We took it into the shop but it's been about a day and they can't replicate the issue.
FYI, the CEL code is "P2096" (Post Catalytic Fuel Trim Bank 1 System Too Lean). This has prompted the garage to look at the fuel pressure system.
Historical Issues:
1. Last year, we found out that the car had minor issues trying to start up. Specifically, it takes an extra second or two for the fuel to be injected into the engine upon start-up.
We would mitigate this by: sticking the key in > turning the key halfway > wait about 2 seconds > then turn the key all the way.
I wonder if this starter ignition or fuel injector is wearing out.
2. About 2 months ago, the car started to struggle when it came to changing gears -- especially on the highway when trying to reach the 4th gear. The car would also randomly jerk regardless if we were decelerating, accelerating or maintaining speed.
Around that same time, the car struggled to go uphill (especially on a very steep highway hill that's near our house). The CEL would flash and we were constantly nervous that the car would simply die and roll backwards.
It seemed like a transmission issue but the garage we took it to replaced the coils, wires, plugs, and vacuumed out excess carbon dioxide buildup. Since doing so, the car was running perfectly.
View 4 Replies
Last week I started having problems with my 05 Accent, hatchback, 1.6L engine, automatic transmission. Filled the tank up with gas and the car stalled pulling out of the station and wouldn't start unless I pumped the gas while cranking the engine. Ran and started fine after that and I thought it may have just been an air bubble in the fuel line, since there wasn't a check engine light or any other symptoms after that. Fast forward to this morning and the check engine light comes on during my commute and when I checked it, it gave an EVAP code (P0441). I also stopped to refill the gas and it stalled again as I was leaving the station. Also after I measured the gas mileage I found that I'd lost around 7 mpg (from around 30 to around 23).
I've never heard of EVAP problems causing stalling and loss of gas mileage but I'm not all that familiar with these systems so I don't really know. I'm going to test if it's the gas cap going bad since on the list of things that could cause a P0441 that seems to be the easiest place to start, but other than that where to start looking?
View 8 Replies
I have just recently acquired an 01 Accent with the 1.6L and have had a few problems with it. It has about 112,000 miles on it and at about 109,000 it had the following services performed by the previous owner (reputable shop did the work)
-New battery
-New timing belt kit
-New water pump
-New valve cover gasket
-New plugs
-New belts
-New front pads
-New front rotors
-New rear wheel cylinders
-New front CV axles
-New tires all around
-Alignment
Now since I got it with about 111,000 miles on it, it ran and drove great until I had to put a new alternator on it as well as having to take the center console and automatic shift lever out to repair the wires for the O/D button. Car wouldn't shift into high gear. The problem I am having now is the car will crank but it will not start. Not even a sputter. I drove the car to and from work the day previous and then went out and started it to go to work in the morning and it started fine and ran fine for a minute or two then it just died like I turned the key off. No spitting or sputtering like it was running out of gas just died completely. Checked a few fuses and such and really not sure where to go from here because I don't have a code reader and don't wanna just throw parts at it, I would rather troubleshoot the problem.
View 1 Replies
I have about 26,000 Miles on it, this afternoon I tried to start it. The starter engaged and turned over and over and over, but the engine wouldn't start. Then I took the key out, waited 5 seconds, and tried again, it started. It was about 60 degrees out, so it wasn't cold. Half a tank of gas.
This may seem a little petty, but its a 2012 with only 26,000 Miles on it.
View 1 Replies
My 2k Passat has 130k on it. I have done regular oil changes and had the timing belt done 6 months ago. It is in Las vegas right now, as it wouldnt start, and I was informed that it needs a new engine. It ended up starting when the guys at the shop squirted tranny fluid down a plug hole...but has been smoking. I was told this means I have a blown head and the engine would have to be torn apart to check out the bottom half.
I am almost inclined to continue paying to store the car until I pay off the 5k that I still owe on it, just to turn around and junk it...but I feel like maybe that would be rash.
View 15 Replies
That said my wife bought a 2001 Accent 1.6L Auto while I was overseas and it's been a great car, about 8 days ago it just crapped out. The reverse went out on her so we took it to get the codes read and on the way it went in limp mode, started hard shifting between gears and wouldn't go over 45 she says. Took it in to the stealership today and they said that the trans is shot as well as showing codes for P1527, P0732, and P0734. I know what the two slippage codes are and I can prolly just replace the speed sensors and that will be fixed but I'm not sure about the reverse and P1527.
View 4 Replies
I go out to start the car, it cranks and cranks and cranks. I stop turning the key. I then try again and it hesitates to starts. I give it a little gas and it starts. When it does this, the car begins running very rough and idling rough. When I give it a little gas while it's parked, the check engine light begins flashing at me.
I turned the car off and came back to it the next morning (maybe 10 hours apart). It started right up no problem, no CEL either.
Plugs/Wires were done a few months back.
View 1 Replies
I just bought a 2004 hyundai accent 1.6L standard transmission on the 13th of June, ran great drove it everyday, was driving fine when I came home monday night, went to drive it yesterday and get nothing, turn the key no click, no crank, the radio turns off as it always did when you try to start, I checked the fuses, and the battery shows twelve volts on the meter, what could cause this to abruptly happen?
View 3 Replies
2003 Hyundai accent GL 5spd has new rings/bearings/lifters and all gaskets (when i got the vehicle it over heated to the point it shut off ) figured it was just a head gasket so replaced it found out rings were shot.. so that's the jist of it. okay so she's timed right spot on but when I go crank up the car it cranks over fast and i have to feather the throttle to get it to startup the IAC makes a weird buzzing sound and wouldn't idle right so i unplugged it and it'll idle fine. When it would finally crank up and idle she drives really well put about 20 miles on her so far just the starting issue pissing me off. I'll post a vid of it trying to start for better description...
View 1 Replies
When the car is running, the noise is not there OR it is drowned out by the engine, but when you turn the key and run on battery, you hear a buzzing and it sounds like it is coming from the engine, it stays until you turn the engine on or turn the key back off.
View 3 Replies
I have a problem with a Torrent. Still have my old GP with over 400K on it. Anyway, son's Torrent wouldn't turn over so he got a new battery and it still won't turn over. I'm getting 12v to the starter but nothing when he tries to start. Have taken starter off to have it looked at tomorrow. In the meantime, anything else it could be? He just spent a small fortune having head gaskets replaced.
View 14 Replies
I have a 2003 Santa Fe with AWD, automatic, and 3.5L engine. Saturday I went to get in and key wouldn't turn. Tried to mess with shifter and steering wheel but no go, Wife got it to turn after I went to work. Won't start. Waited for a new ignition lock cylinder then replaced today. Still won't start. There is no chip in the key as far as I know and the kill switch thing is still plugged in. Jumping does nothing. Doesn't even try to start or do anything when I turn the key all the way. What am I missing here?
View 5 Replies
My car wouldn't turn start today at school The ignition would "click" continuously but the car wouldn't turn over. Battery is fully charger and didn't start with a jump either. Alternator issue??
Anyways, me and a buddy tried to push start it in 2nd gear a couple times with no luck... is this even possible with our cars?
View 9 Replies
Timing belt broke, replaced belt and head camshaft position sensor. After engine is ran awhile 5-10 miles it will not start until it cools down for at least 45 minutes. Even with jumper cables attached.
View 2 Replies
My hyundai accent 2004 is not starting after the cluch plate and disc were replaced. what could be responsible?
View 1 Replies
I bought a used 2008 Toyota Camry per-certified from a local Toyota dealer about 2 years ago. About a year and a half ago I got in the car to go to work one morning and it would not start. You turn the key and all the lights come on but nothing else happened. Took the battery to Auto Zone and they said the battery was OK so I had it towed to the dealership. Dealer called when he got it and said it cranked right up for them and it has not been an issue since.
Two days ago I get in the car to leave work and the same thing happens. You might hear the starter click when you turn the key but nothing else happened. The car was getting power from the battery but that was about it. I tried to jump the car off but still the same thing. I had the car towed to a local Goodyear shop and after looking at it the said it was a problem with the alternator, that needed to be replaced, which also killed a cell in the battery that needed to be replaced also. They said since they are replacing the alternator they might as well replace the belt also.
View 14 Replies
When you start the engine on my 04 hyundai accent something under the hood is making a ticking sound. Seems if you run the engine awhile the ticking decreases. What this is?
View 5 Replies
I have an accent 2003 1.6 dohc crank but not start !!! Who do not fire and no gas ... and the check engine light is off when I turn the key on... (I test the check engine light and it is not burn).
I change the engine control relay and this is not work... I have all the wiring diagram and I check wire by wire and I don't find anything...
View 2 Replies
I have a 2000 model accent manual trans its just recently clocked 200 000 km I know the car has had problems but they are getting worse. Occasionally I have Problems starting the car in the past but it usually takes no more than 5 turns to get started but this is getting worse the other day it took about 5 min maybe more to get the car started I am guessing my starter motor probably Needs to be changed.
Next problem yesterday after I put a full tank of Premium 98 in the car its starts to rev itself changing the sound and note of the motor running constantly it has done this in the past but not so severely and It only seem to do so after putting petrol Especially when I put fuel From a servo I don't usually go to the car would have stalled more than once but didn't only because I tried to keep the revs up when it sounded like it was gunna die also I am pretty sure my fan was making some weird noises but the car has had no engine Light show and no Overheating.
View 1 Replies
My 01 accent's engine makes a clattering sound(sounds a little bit like a diesel engine) when it's first started in the morning. After warming up (in about 20 seconds or so) the sound disappears. My oil level is normal(last oil change about 4k miles ago with full synthetic oil. I normally change oil at 5k intervals with full synthetic), timing belt changed about 1 year(20k miles) ago. Should I be worried?
View 4 Replies
