Accent LC (2000-05) :: Taking 5 Turns To Start - Engine Noise And Car Revving Itself
May 13, 2011
I have a 2000 model accent manual trans its just recently clocked 200 000 km I know the car has had problems but they are getting worse. Occasionally I have Problems starting the car in the past but it usually takes no more than 5 turns to get started but this is getting worse the other day it took about 5 min maybe more to get the car started I am guessing my starter motor probably Needs to be changed.
Next problem yesterday after I put a full tank of Premium 98 in the car its starts to rev itself changing the sound and note of the motor running constantly it has done this in the past but not so severely and It only seem to do so after putting petrol Especially when I put fuel From a servo I don't usually go to the car would have stalled more than once but didn't only because I tried to keep the revs up when it sounded like it was gunna die also I am pretty sure my fan was making some weird noises but the car has had no engine Light show and no Overheating.
View 1 Replies
Advertisement
I have a 2000 accent. Automatic tranny with 167000 miles. My current problem is the car is misfiring upon acceleration and engine revving. I have to accelerate very slowly to minimize this but i once the engine revs up enough I can give it more gas and it will rev normally with plenty of power. I have had to unplug the maf to keep it driveable. Ive never had a car stay running after disconnecting the maf so this is strange to me. My accent barely stays running with the maf connected. I just got the car from my dad and he had it fixed and it ran good for awhile with the maf connected so I don't think it is the maf. But the same problem came about and we had to disconnect the maf again. And he cant remember or is not sure what was exactly fixed on the car. I've read up about the purge control valve and havent had a chance to check it out but some of the symptoms fit.
View 21 Replies
2003 accent. I had an intermittent starting issue, nothing serious. Then one day dead in the water. Had it in my garage so i changed all belts, Crank position sensor, starter and solenoid. It seemed to start different, a little longer than usual to start, but started. Drove it for about a week and dead again. Dont know if it was chance or not but as weather got colder, seemed to take a little longer to start. Cranks but does not fire. I can hear fuel pump priming. I took the spark plug wire and held it next to frame and did not see a spark. To double check i tried ether and still would not turn over. Assuming fuel is not an issue at this point. How ever i did get an evap code p0441 but it went away. I am stumped at this point. I am not very good at electrical on vehicles. I want to check coils, and work my way back but not sure if I am doing it correctly. Most vehicle videos don't have the same parts.
View 13 Replies
I got a 2002 accent 1.3 si, engine warning light comes on but doesn't seem to affect cars running, no misfires, no stalling, still good acceleration and mpg, occasional engine revving on its own, changed tps sensor and engine revving on its own was worse. Was told by hyundai mechanic to disconnect battery for 30 seconds and if light went out it was either faulty tps sensor or an intermittent non constant fault reading, light did go out for some time but is now back on.
View 1 Replies
So yesterday during a work lunch my CEL light came on. my car only has 20,700 miles on it. and I bought it brand new. So obviously I was very nervous. I took the car straight to the dealership and dropped it off, seeing as I was only 3 blocks away from the dealership.
They ran the diagnostic and it said there was issue with a cylinder misfire. And after some more tests it led them to replace the engine coil. They drove it 5 miles and believed it corrected the issue. That evening after work when the shuttle came to pick me up, I drove the car home and no issues what so ever. Car actually seemed to be getting up to speed better than before. (car is automatic).
The issue, this morning when starting the car and getting ready for work, I hear a weird noise when starting the car, revving the engine, and getting up to speed. It is not a ticking noise, I would describe it more as a rattle but that doesn't even describe it real well.
They also did an oil change. I bought the car brand new, and have never had any issues and religiously get oil changed by dealership every 3 months.
View 5 Replies
When you start the engine on my 04 hyundai accent something under the hood is making a ticking sound. Seems if you run the engine awhile the ticking decreases. What this is?
View 5 Replies
So my wife drove her car all day yesterday, everything fine. This morning went to start and it wouldn't. It turns over fine just not firing.
Now during the summer I had replace the fuel pump/filter before discovering that was not the issue.
I know you are already thinking CPS!.. I replaced that over the summer.
I have not checked the spark yet, kinda hard to do that one by yourself.
Beyond spark I am not sure what else could be wrong, especially because it was running fine last night. Is it common for accents to have issues in 20 degree weather?
View 3 Replies
I'm having a problem with my mom's 2005 Accent. It starts up just fine when cold, and will run for 15-20 minutes just fine, sometimes longer. Then, usually as you're slowing down, the engine just turns off. No bogging, no sputter, just turns off as if someone turned the key. Sometimes it will start back right back up, more often, it will need to sit for 30 seconds to a minute, and then it will fire back up. After that, all bets are off. Sometimes it will run again for 10-15 minutes, sometimes it will idle rough and die. I'm leaning towards a coil pack, but I'm sick of throwing parts at this. The last time I got it to idle roughly, it threw a random misfire, and cylinder 1, 2, and 4 misfire codes. I've changed out (in rough order) MAP sensor, the fuel pump (no fuel filter in this model), TPS (threw code for this), spark plugs, and most recently the Crankshaft Position Sensor. I'm not sure how to test the coil packs.
View 5 Replies
Might be a long shot here, but I JUST had this noise/rattle pop up in my '12 GTI 6MT w/ 13k miles.
Turns out I found someone who posted a video with basically the same noise:
Another one:
I hear the same noise while stopped and revving the engine as well as when driving if I let off the throttle and let the RPM's sweep down past the same rev range (1,800-2,000). Sounds like it's coming from the passenger side area.
I'm under warranty so I'm going to take it to the dealership...but I know how they can be with rattles.
View 8 Replies
I have a 2001 Accent GL DOHC 1.5L (which I believe is the same as your LC model).
One night it started running poorly - missing, bad acceleration - like it was only running on 3 out of 4 cylinders. It was missing whilst idling and would backfire and struggle to accelerate. I took it to a mechanic and they said I needed a new coil pack. So I bought a coil pack from a 2nd hand wreckers that looked pretty good, the car idled better but accelerated worse, like it was only running on 2 cylinders .
So I swapped it back to the old coil pack - and now it wont even start. The engine turns over once then clicks loudly a few times - I think the clicking is from the distributor.
View 3 Replies
Just installed a Phatbox in my customer's Touareg. With engine running, there is a hum which turns into a whine with engine revving up. VW Service does not have a fix from factory yet. I suspect it needs a filter (capacitor) to suppress RF coming from the ignition system.
View 6 Replies
I recently replaced my driver side axle due to the inner CV joint boot being ripped. Its a 2001 Jetta VR6 with 173,000 miles on it and I have been driving it with a ripped boot for about a year and finally decided to replace the whole axle last night. I replaced it with an aftermarket axle (was on a budget) and the job was fairly easy. Since I did it late at night I was too tired to take it for a test drive so I waited until today. When I was driving it all was well until I took a right turn and I could hear a very distinct clicking sound coming from the driver side wheel well, it is constant throughout the turn.
The noise is only present when taking turns above 20mph and it sometimes even occurs when driving in a straight line. Take note that I have not had an alignment done yet since I had replaced the axle. The car is lowered about 2 inches on Raceland coil-overs that are pretty old and I think they are shot. But like I said the car has NEVER made this sound until I just recently replaced the axle. I am at a loss of what it could be and I am trying to sell the car currently so I would like to get this problem sorted out as soon as possible!
View 12 Replies
I have just changed my clutch and machined my flywheel on my 1.5ltr 16v dohc 2000 lc accent. I used all the correct trans fluid and refilled and bled the clutch fluid. It takes of from lights like a new car but if you put your foot down around 40kph it revs out a bit and does so through all gears untill you reach a bit of speed. What is going on?
View 11 Replies
I recently changed my Hyundai Accent 2004 rings and top cylinder. a day after I left the mechanic garage, the car started bringing out white smokes particularly when I rev.
View 2 Replies
I have replaced the MAF sensor, TPS sensor, and fuel filter. Like the title says...if I rev the engine ...as soon as I let off the accelerator the engine stumbles and almost dies...then settles back down. I initially pulled codes PO121 so I replaced the TPS. PO103 so I replaced the MAF sensor. PO112..did not address directly as I assumed the MAF was causing. PO1123...again I hoped the parts I replaced would solve the problem. Initially the engine would just drop out while driving just for an instant and then be fine...also I had the 4 codes mentioned above. The only code that has returned is the PO121. I just got done replacing the fuel filter and things seem to be worse.
View 1 Replies
Just the other day I was driving my car till I've noticed the gears started slipping. At first it was having some issues shifting through the gears (automatic transmission btw). As soon as I got off the highway, I parked in a parking lot just to check underneath the hood. Everything looked fine, went to pull out of the parking lot, no reverse. The gears started to slip up really bad. I noticed that the RPM's kept on reving up and wouldn't go any faster than 20mph. I went to an advance auto parts to get automatic transmission fluid. Still having the same issue and no reverse either. I had to park the car at a location to get it towed back to my house. Some people are saying my transmission is bad, some say it could be a real simple fix. Where to start diagnosing this issue. The car was driving normally until last Monday. My question is where should I start to check and what can I do to see if the transmission is completely shot??
View 33 Replies
Just noticed today, while taking slight right turns 20-40MPH, I get a really loud and angry chirping sounds? Its only right turns...It sounds like a forest of angry crickets.
View 4 Replies
I have a 2001 Accent GL 1.6L Automatic.
Yesterday it started acting up on the freeway. I was driving about 50 during traffic hour when it started revving. I got off the freeway and moved to 35mph on surface streets, the revving continued at lower speeds but much worse (4-5k rpms going 10-15mpg). Doesn't seem to do it in idle or park. If i shut the car off it'll drive fine for a while then start acting up but when I was driving, after awhile, it did return to normal.
What could cause the problem? TPS? Transmission? Sensor of some sort?
View 5 Replies
On my 09 accent, it's been cranking slow/taking longer to start. Occasionally it won't even have the guts to spin the starter (clicking solenoid noise).
I checked the battery (<1 year old), and it has a resting voltage of 16.2 (?!) When running, it jumps to 17.4. Is this a bad alternator?
View 48 Replies
Today I started my car (in the garage so it wasn't too cold) and everything was fine. The car warmed up in a couple minutes and I was off.
As i was driving, I noticed that my shifting was horrible. It felt like i was burning the clutch and not releasing the clutch smoothly in general.
I then noticed that when i pressed in the clutch ready to take the next gear, the engine would raise the rpm's about 500-1000 revs before coming down.
I started to wait till the revs came down to shift and that seems to work.
Why would the engine be revving itself higher the second after i push the clutch in. My dealer can't take me until Wednesday so I don't know what to do.
View 46 Replies
After changing the timing belt and water pump I want to change the coolant. Stupid to have no temp gauge so I got a scan tool connected. Been idling 20 minutes and it hasn't gone above 189 degrees. Assume it has a 195 degree thermostat. I put fresh water in the radiator but still don't see it mixing with coolant in the block as if the thermostat has opened.
View 6 Replies
