All my lights on the driver side don't work, replaced brake light and then nothing. Would it be a fuse? if so which one or wiring and how would I go about finding the fault.
View 1 RepliesI have a 2000 Hyundai accent and the exterior door handle on the driver side does not work. It will open from the inside...I already have the door panel off but not sure how to fix the rest.
View 4 RepliesI have a 2003 Accent and I'm having a problem with the brake lights not working. The tail lamps work when the night lights are turned on so it's not a bulb issue. The brake lights keep blowing the fuse. Brake lights will only work with a fresh, new fuse but only works for about a trip, give or take and then its blown.
View 1 RepliesThe rear driver side running lights don't work, brakes blinker and reverse lights work fine, I tried the panel from the pass side on the right side and the same thing happened everything else but running lights. Where do I start ?
View 2 RepliesI have a 2000 Sierra and my driver's side brake light won't work but the light bulb is not bad. The Passenger side light, however works. What should I check on the truck to solve this problem. Would it be between where the bulb snaps in and where the plug for the lights plug into the truck under the bed or should I check something else?
View 5 Replies There is no solenoid on the drivers door just an energising switch so a remote system, without modifications, will not open the drivers door.
To get it to work you would need to source & fit a solenoid into the drivers door, wire it, then wire in the remote locking box for the remote function - complicated for the average person and expensive otherwise.
My driver side brake light is not working. I noticed it yesterday after changing my front brake pads. The bulb won't light up. I changed the bulb and didn't fix it. I checked fuses and all were good. The running light and turn signal both work on the tail light and the passenger tail light is fine and everything works on it. A couple hours after I noticed the driver side tail brake light wasn't working the hatch brake light went out. Not sure if it was just bad timing for the bulb to go out or not. I think I may just need to get a new wire harness for it. Not sure.
View 1 Replies2002 accent with the driver window stuck down. I have the door panel off and when i look up I see the pulley with the cable balled up and two cable ends hooked to nothing.
View 3 Replies2003 Hyundai Accent 4 door. Well its been raining here in Portland Oregon non stop and this morning I went to get in my car and smelled a mildew odor so I took out the drivers floor mat and the carpet was soak. Then I laid back the carpet and that grey spongy covering thats under the pedals was soaked to the bone like a sponge.
I did a test with a water by putting the hose on top of the roof of the accent and turning it on full bore and nothing leaked in the car. I sat in their for a good 5 minutes with the hose blaring down the windshield and door sides. I even took a jack and lifted the car up too see if there was any cracks or a rusty hole underneath but nothing. So Im completely stumped on this I do have A/C and the drain hose is clear since I have been using my defrosters and the A/C pump kicks on.
The other day I replace the front brake pads and rotors on my daughter's '03 Accent. On the test drive I noticed a scraping noise coming from the driver's side. Got it home and didn't see anything obvious, but for fun I removed the pads and swapped the shims around. It was better, and afterwards I put the new brakes through a few heat cycles. The scraping noise became less noticeable so I figured she should just drive it for a few days. Well today I'm informed that the noise is "really bad".
View 1 RepliesHaving problem with the front electric window sliding out of it's track? My friend's 2001 Accent has been doing this with the driver's window when going up. It gets between about 1/4 to 1/3 closed and suddenly the glass jumps slightly left out of the track on the right-hand side of the door frame.
The drivers door is on the right, it's the tallest part of the door frame it's jumping out from. If the glass is pushed right by hand it pops back into the track and the window can be closed normally.
I've had the door card off and can't see anything broken with the window regulator. With the window down it's possible to rock the glass left and right so something is obviously loose or not holding as it should be, but I can't find any loose or broken clips where the glass is attached to the white plastic thing which holds it onto the central regulator rail, it all looks intact.
I was expecting to find something broken or slack which could be causing this but I really can't.
Noise sounds like its coming from driver's side. It's not terrible until you hit 30-40km/h, after that its quite loud. No whistling sounds, which i was told to listen for if it were a wheel bearing (although I ma not convinced is the only sound a warn bearing makes).
The sound sometimes goes away when I am on a bend turning left (taking the weight off the drivers side wheel).
Just bought a 2005 accent yesterday. I new the bulb was gone, when I lifted the bottom noticed that the battery is so close to the lights I can't get my hand down there. Do I need to remove my battery to replace this bulb? Also what is the model # of the bulb?
View 2 RepliesI just purchased a 2000 Hyundai Accent. I was told it has a bad wheel bearing on the front driver's side. I am assuming that would be the clicking sound that associates with speed. I was told the cv joints or axles were replaced but have a leak. I couldn't see a filler hole or one to check from. I also don't see fluid under the car from parked. Also, there is a humming which sounds like knobby mud tires. The humming disappears during hard right turns.
View 6 RepliesAt times, not often but on my 04, when I turn headlights on, the drivers side front window will go down, and when I work the switch to make it go up, the passenger side front window will go down.
I don't have a wiring diagram for the car, so tracing the circuits would be next to impossible.
Further reading suggests it could be the fuse blown causing this code, this code was coming up among others with the old lambda, so at least it cleared some codes.
Where is the fuse located for the O2 sensor? Will try that. How much more fuel will it be using also? Used half a tank doing approx 110 miles surely that's not right?
I have a 2005 accent that keeps blowing the ecu 1 fuse. It is also showing a code for "system voltage low", and the battery is wet around both posts. I read somewhere else that the alternator could be surging and blowing this fuse. Had both alternator and battery checked at autozone, battery is said to be on the way out and alternator shows its fine. Battery does not show any problems, start car just fine.
View 7 RepliesI got Corolla 2012. Dome light fuse 10 amp is blowing off as soon as you put it in. Light bulbs checked seems it is not a problem. Maybe relay?
View 11 RepliesI just bought this one and it came with no owners manual so I can't figure out how to open the box.
View 3 RepliesI have a strange problem. My driver side low beam dont work and my right side high beam dont work. Try different relay (switching), check fuse, bulb etc. Also in my dashboard the right green arrow for the flasher always still on(solid).
If I activate (with the control arm) the right turn flasher the flasher light blink in the dash board and my outside flasher bulb flash but my left high beam also blinking in the same time!
My driver side horn is not working but the passenger side is. Before I bring it to the dealer, is there a fuse for the horn?
View 4 Replies