My old car has this problem when it's on highway the steering wheel shakes quite a bit. Is it a wheel alignment problem or wheel balancing problem? Since I've just fixed the transmission I am driving this car more often(to save gas) and this problem is really annoying.
View 4 Repliesdrive an '05 sc430 and the steering wheel shakes at above 50mph when I lightly step on the brakes. I have recently had my brakes done and an alignment done as well as both rear shocks replaced.
View 14 RepliesMy accent just crossed 180K mark. From last year the steering wheel shakes quite a bit at highway speeds ,say 70MPH. It's especially bad when I accelerates . Took the car to a shop, they told me two things, the CV axle of passenger side needs replacement, and the wheel hub bearings are bad(both front wheels). They quoted me $200 for replacing the cv axle, and $400 for replacing both front wheel bearings. Since I don't even think the car worth $600 right now(given high mileage), I told them I'll just do the axle(I know how to do it myself but don't have the time, plus it won't be that much cheaper DIY anyway). They said fine, but if you don't replace the bearings you may have the wheel fly off one day and that's dangerous.
They replaced the axle, and the car drives a lot better now. There's still a little bit of shaking at high speed but 75% of that shake has gone away. My question is, does the worn out bearing causes car to tremble at high speed? I heard other people told me there should be a grinding or loud hawling sound if the bearings are bad, but I don't hear that. I searched the internet and some people say, to determine if the hub bearings are bad, just drive it for 10 minutes then feel the hub. If it's barely warm, the bearings are good. If it's warm to hot, then the bearings are bad. I felt it and it's warm, but not too hot to touch. I tried the rear wheels and those are barely warm indeed.
So from this method it seems the front wheel hub bearings are indeed bad. I wonder how long I can keep driving this without endanger myself. $400 is not cheap for this car and I don't have a machine to press in the bearings myself. I can disassemble the rotor and hub that's not a big deal, but I don't know how to get the old bearing out and the new bearing in. Is there a machine shop that just do the pressing? Or, is there any shop selling the hub assembly with bearing already in place? this way I just remove the old hub assembly and replace it with the new assembly, a lot easier. I searched the internet but can only find pre-assembled hub w/ bearing for the rear wheel of this car. I need the front ones.
I just bought this transmission from a reliable parts dealer. Should have about 50k miles on it. Looked really clean when I got it.
The guys who put in the tranny cracked a speed sensor, so I bought a new one and put that in. I dried off the sensors and screwed them into their spot on the tranny after removing the intake filter that was in the way.
Even with the new speed sensor the car is still doing the following:
1) Does not go into reverse until I've gone into drive for a couple seconds, pulling forward. Reverse does not work. However, when I unplug the speed sensor reverse works right away, but we still experience the following...
2) car goes from first to second gear to third gear smoothly, as it should. Seems really smooth like a car should shift! However... it won't go past 3rd gear and then it won't downshift! So, even after stopping and idling, I can't leave 3rd gear.
3) When I turn the car off, then turn it right back on, I can go through first, second, third gear again then... it stays in 3rd gear.
Another issue that has come to my attention since I got the car back, is the steering wheel shakes pretty hard while idling with no gas. While driving it seems smooth -- idling again it shakes heavily. what could they have damaged while putting in the tranny to cause this shaking?
So far as the funny tranny stuck in 3rd gear, it seems to me like it's a computer issue? But, what could be the cause? What tests can I do to determine the cause of this problem besides the ones I've run so far?
I have an 05 Camry LE & when ever I'm on the highway going around 50-80mph & need to break my steering wheel starts to shake until I either stop or put my foot back on the gas. Last year my power steering rack & one of my motor mounts got replaced, & for awhile it stopped & figured because that was going out that's what was causing it.
Well about a month later it started back up & still does it, I've taken it to the dealership & have told them & they test drove it, felt the same thing I felt but didn't find anything. Is there anything else that could be causing it ? Earlier last year my bearings were lose in the front, and I managed to get my brakes stuck & had that all fixed & since then that's when it started shaking . I took it back to that shop & mention every time I go in for oil changes at my dealership, is there something else I'm not aware about that I should ask them to look at ?
If I said that I can "feel the road" in my gas pedal and steering, what this means (like every bump etc...). If so where would I start to look to try to fix this issue or how to lessen the feel. Also is there anyway to make the steering wheel more stiff it shakes while hitting a considerable speed.
View 7 RepliesMy wife drives a 2010 Honda Civic LX sedan with about 18k miles. She mentioned that its steering wheel started shaking a couple of weeks ago when driving at about 60 miles/hour at the same streth of the road during her daily commute. She did experience the problem during rest of her drive at lower speed. I drive the car about once a week at lower than 45 miles/hour and had no problem. I have checked the tires and noticed nothing obvious.
View 1 RepliesI've been noticing my steering wheel shakes if i normally brake going on the highway at high speed. My friend said that it's probably your brakes and rotors. Get them replaced and resurface and that should fix the problem. Can i get some confirmation before i do this?
1. I just had my tires replace at 55k and bought this car new back in feb 09. it has 62k.
2. also i've been reading up on camries fail water pump. i'm thinking of doing this over the weekend or should i just wait until i notice some leaks?
3. lastly, any major thing i need to be aware of. i've done the normal engine oil and filter change, cabin and engine air filter change, that's about it. i hope these camries are bullet proof like the old school (92-95).
My GX470 steering wheel shakes/vibrates when I hit speeds over 50mph. What is causing it?
View 12 RepliesHow the easiest and safely dismantle my steering wheels...
View 1 RepliesGirlfriend went to start her car on a nice cold day, and said it wouldn't turn over. so after taking her to work, i tried to see what the issue was . . . and the key wont move. the steering wheel is loose, i used the transmission override to move the stick back and forth a few times. still no go.
Did the hammer tap on the key, and used electronics cleaner on the switch in case something was stuck.
Oddity was, the door ajar chimes come on without the key inserted. So am I chasing electrical gremlins or what? the car is a base model without keyless entry.
I had new tyres put on my 2002 Accent 1.5 CDX a few weeks ago, they are 175/70 R 13 and i have Genuine Hyundai Alloy wheels. Over the past few days, Ive noticed a bad wobble that i can feel through the steering wheel, but seems to come from the rear of the car, although it could come from the front, as the car seems to wander around on the road, but going along at 50 mph and taking my hand off the wheel for a second or two it doesn't pull either way, you can just see the steering wheel visible moving from left to right and back again!!!!!
I changed the back wheels to the front and vice versa, and the problem went away, for 24 hours and came back again!!!! This wobble is getting worse, I've had the wheels balanced, rims seem ok, suspension checked, etc and all fine. The only thing I am not sure about is worn track rod ends, and I am not sure what to look for this wobble is at its worse between 30 and 55 mph, but it can be felt on any road (from starting off) and at any speed.
I have a Hyundai Accent 2001 and today while driving the battery light and brake light both went on and the steering wheel became "stiff" - hard to turn - although driving in a straight line seemed to be as usual.
I would just take it to the garage, but although it still starts as usual, it seems hard and probably a bad idea to drive it there in its current condition.
when Im going down a hill or when I hit a certain speed my steering wheel shakes and I don't mean a small shake I mean my arms are grabbing the steering wheel to keep control and they are violently shaking with the wheel. Now in the begining I heard that if alot of snow got packed into your tires the wheels would shake but theres no snow I check everyday before I leave and if there is I get it out. So then I think maybe it could be my tires aren't balance right but no less then 2 and 1/2 months I got new snow tires put on in a shop so they SHOULD'VE balanced them right? so that can't be the problem so then I thought alingnment! but the thing with that is if I let go of the wheel when I'm going under 50-60 miles an hour and it stays pretty damn straight then it can't be that either..
View 14 RepliesI have 2009 Honda Accord with approximately 66,000 miles (I drive 70 miles r/t to work every day). I had service done on my car the other day to get the front brake rotors replaced and four new tires. Upon receiving my car and driving to Boston the car began to shake at highway speeds (50+). I took it back to the mechanic and they re-balanced the tires. I drove to work the next day and the car still shakes (albeit now at 60+). Today the mechanic rotated the tires in case there was a bent rim in the front causing this. However, on my drive today the car still shakes (though it's not as violent or noticeable as the trip to Boston).
View 10 RepliesMy steering wheel vibrates when I stop or when i turn on the AC...
View 8 RepliesMy 2010 Tiguan R-Line only experiences vibration in the steering wheel noticeably at 70mph plus. The tyres were brand new when i collected the car in July this year and the alloys have been balanced since having the existing alloy weights replaced with new ones in August. What the problem could be and how best to resolve this nagging issue.
View 6 Replies1981 Corvette rebuilt/restored. 35+ mph. steering wheel shakes/vibrates. Higher speed, depress clutch, smooth ride. Taken to mechanic recently, test driven to acknowledge, lift done twice, no clue.
View 5 RepliesWhen i put on the brakes the steering wheel shakes and pulsates. Iam getting mixed info. One person I know said it is the brakes (front), another person said i need the alignment checked. yet another said Rotors, and still another said back brakes.... When i touch the brakes the whole van pulsates and the steering wheel shakes.
View 3 Replies'02 SE!!! It came with issues needing to be fixed and I'm more than happy to do it... but 2 current issues: Front brakes and O2 sensor/check engine...
BRAKES: When slowing down from highway speed, the front end shakes and the steering wheel moves. I'm guessing bad rotors, as I've had the issue before and that was it. I want to do the pads and rotors and call it a day...
But I don't want to buy crap and I know that's mainly what I tend to find at the drop of a hat, so I have to order something anyway.
O2 SENSOR/CHECK ENGINE: The code which is coming up is "P0420" and when I researched that, it came up as being either the O2 sensors or the cat. I'd like to know which O2 sensor is the UPSTREAM, which is the DOWNSTREAM, and if there's a way to test the sensors on the car currently to find out if they are in fact bad.
I've also heard a bit more exhaust noise than I'd like to hear out of the car (like a leak), but it isn't howling yet. Is there a chance that a leak in the flexpipe/downpipe/etc could lead to throwing this code?
1,200 miles on my gx 460. dealer states, he has balanced all tires, and checked for radial run, at 60-65 miles, my steering wheel shakes.
View 14 Replies