Audi A4 :: 1997 Stalling - When Started Up And Left To Idle All Of A Sudden RPMs Drop
May 10, 2012
I have a 1997 Audi A4 that has been acting a little bit strange lately. When it is started up and left to idle all of a sudden the RPMs drop from around 600-800 to 100-200 sometimes rebounding back up and sometimes the car just dies. This also is happening while I am driving and stopped at a stop light for a short time. It will idle fine then suddenly drop RPMs and if I don't give it any gas then the car usually dies. I have just had some work done on it to try and fix this problem thinking it was the air flow sensor (or something like that) but apparently that is not the case.
View 2 Replies
Advertisement
I have a 2001 Mazda Tribute with 150,000 miles that is meticulously maintained. This past winter (as far as winter goes in San Diego) the engine would run rough and the rpm's would drop close to stalling when stopping at a light for the first 2 or 3 miles. After that the engine has warmed and there is no problem. Could this be the intake gaskets needing replacement. This only happens on a cool or damp, rainly morning.
View 6 Replies
Twice now this has happened to me and I'm concerned it will become worse if I don't fix it. Driving down the road my engine has disengaged. By this I mean the vehicle both times has been at 55 MPH, my foot on the throttle rpms riding around 1300 revolutions, and the engine disengages rpms drop below idle and my "wait to start" light comes on. This both times lasts approximately 2 seconds and throttle reengages while still traveling 55 MPH, "wait to start" light goes off and its like it never happened. What's going on with my truck? Ford diesel 97 250 7.3 ...
View 2 Replies
I have a very specific problem with my 2008 Chrysler Town and Country. It has happened 4 times in the past few months and the dealership is unable to replicate the problem, so they tell me there is no problem. When I am decelerating/coasting the traction control light on the dash will come on, the power steering will go out, the RPMs will drop to zero and the gas pedal is loose and has no effect, and then the power brakes will go out. All the electrical still works, I muscle over to the side of the road, turn it off, wait a few seconds, turn it back on, it starts up just fine and I drive off with no problem.
The first three times it happened I was on the same stretch of road (which I dubbed the Bermuda Triangle Road), I was going 25 mph, the road is fairly level, the pavement was dry and it was above freezing. The fourth time was on a different road, but still level, there was snow and it was below freezing but the road was clear, and I was going about 33 mph. Each time the car had been sitting in my garage for at least a couple of hours, and it happened only a few minutes after leaving the house.
View 4 Replies
We have a 1997 Saturn. For the past few months, whenever we're at a stoplight it suddenly fluctuates in RPMs, giving it a rough idle (going from 1000 down to 500 or so for a second or two, before coming back up to normal). It appears to be temperature sensitive (i.e. the longer the car runs or the hotter the outside temp, the more often this occurs). I sprayed the throttle body connection and vacuum connections to attempt to find a potential vacuum leak, with no effect. We've already had the transmission replaced, and haven't been having any other idle issues besides this. What else might be causing it.
View 4 Replies
While driving on the highway, I experienced sudden acceleration of the RPM's only on my 1997 PT Cruiser. What would cause this? I had to stop and shut the car off and it was okay when I restarted.
View 15 Replies
I just purchased a 2012 F250 XLT with the 6.2. It has 38,000 miles on it. Yesterday I noticed, when coming to a stop, the idle will sometimes drop below 500. The engine will stumble a little, then the RPM will jump up to 1,000. Twice it has stalled on me. When it stalls, the engine will restart just fine. No codes in the computer or warning lights on the dash.
I will be bringing it back to carmax, as it is under their 30 day warranty still. Hopefully they will be able to figure out something. I am thinking either the TB needs to be cleaned, or there is an issue with the canister purge valve. I saw the TSB for the CPV but it doesn't cover my truck.
View 6 Replies
I've made posts about a rough idle before now I noticed something new about it. I noticed when I approach a red light the vibrations don't start immediately. They start as soon as the RPMS would drop a little. They stay above 500 but it seems like it's below 750. As if the engine is slightly starved from power? Now i'm wondering if it could be related to another problem I have.
Whenever I start the car, the battery light flickers until the car is started all the way. This is on a 2007 Camry 4 cylinder. So far everything iv'e done is: New NGK Spark Plugs, NEW OEM mounts (all 4) Seafoamed the engine, Seafoamed the throttle body, cleaned the MAF sensor, New air filter, and cleaned the air filter box, replaced the PCV Vlave, new belt, new alternator (duralast), and a new battery (from autozone).
View 2 Replies
1997 Subaru SVX (Alcyone) LSi, 3.3L H6 engine.
My SVX was driven from Denver to Las Vegas, NV and it developed an odd habit where the RPMs would start to oscillate while on cruise control. I had to disengage the cruise control to get the oscillations to stop. Three days later I was driving the SVX to work and the RPMs started oscillating at idle and the car started running rough and it died.
These things have all been replaced with OEM grade parts: Spark plugs, electric fuel pump & strainer & fuel filter, Mass Air Flow sensor, new air filter and fuses.
The car starts up fine but after a few seconds the RPMs begin to oscillate. Then the car tries to recover, the idle becomes rough, and the the RPMs drop very low and the engine shuts off.
View 2 Replies
As listed above I own a 98 Volkswagen Passat. It seems to run just fine for the most part, but if I push on the gas and let off I notice a slight sputter. The RPM's will drop to about 800RPM up to 1000RPM and back down again and it will eventually stabilize and idle fine. My only guess that I have so far that I read on a post somewhere is that the EGR Valve tends to get gunked up and stick. I will try to clean that off.
View 12 Replies
I have a 1997 Saturn SL1 with 100k. Every so often the RPMs will drop by 500-1000 or so for a second and then come back up to normal. This happens both when stopped at a light and while accelerating, and doesn't seem to happen predictably. I've already changed the filters and cleaned out the IAC, without any success. I've sprayed the obvious connection points in hopes of locating a potential vacuum leak, also without any luck. Other ways to locate a potential vacuum leak that wouldn't be overly time-intensive?
View 7 Replies
Two weeks ago Sun, truck ran fine, however Mon morning all hell broke loose. Truck was running very sluggish and stalling while coming to a stop. My first thought was tune up. I replaced the plugs and wires. During this I found that i could not get a socket around the ever loved driver side rear plug so i was only able to replace 7 plugs however in that process i managed to break the metal coolant tube that runs to the heater core.
Aday later replaced the entire intake manifold,egr valve, egr tube, IAC valve, both coil packs, fuel filter, tranny fluid and filter. During the removal of the intake i looked at the rear spark plug and found that a screw had been wedged into the hole breaking the plug and got it changed now it is all back together and the truck runs amazing however did not solve the low rpms during stopping. ive replace the above and checked fuel pressure which is good.
I have a TPS sensor just haven't installed it yet not sure if it is related to the issue. Tranny guy says it may be a bad solenoid or TC however last night I reset the PCM and drove it it ran flawless. this morning the problem returned which leads me to believe its not the tranny. ok one last kicker that 6 experts have failed to answer when i manually put the truck into 2nd gear the engine dies! no studder no fighting just quits.
Truck is a 98 F150 4.6 V8 186,000 miles i have yet to
1) change TPS.
2) clean throttle body.
3) clean MAF sensor. n
Not sure if any of this has an effect on the issue. There is only a EGR insufficient Air flow code..
View 14 Replies
I have done everything I can think of to this car. New; plugs, wires, distributor, battery, fuel pump, fuel filter, relay, and electrical lines to fuel pump. The timing belt is fine. The car has a rough idle and when I am stopped the RPM's drop below normal. Now it won't start. What can I try now?
View 1 Replies
Cold start. engine starts but wont idle, just dies. rpms drop. Restart same. Must neutral drop to get going keep rpms up until engines shifts then things are fine until next cold start. Cleaned throttle, changed air filter, dry gas, injector cleaner, no warning signal, scans clean. 180k miles.
View 6 Replies
So I know there has been lots of posts on surging issues and how to troubleshoot. My truck is a 97 f150 4x4 xlt 4.6l v8. I have noticing surging and dropping in my RPMs lately. No CEL. I have kept a journal when I notice when it happens. I only have issues when I am driving around 40-50 mph and if I go over bumps/pot holes/rough spots in roads or when I'm braking over bumps/pot holes/rough spots, my truck surges/RPMs drop CEL flashes on and off only during these instances. Makes me think something could be loose or something causing this. It has stalled at times when having to brake fast (yellow light, etc.). Where to look first? 1997 F150 4x4 4.6 V8...
View 1 Replies
I have a 1997 forkd F150 with a 4.6L Romeo engine. I have recently rebuilt the engine and now since it is put back together I am having a issues that i cannot pin point. When the truck is running and in gear my RPM drop to around 500 or below and my oil pressure drops and comes back up when the rpm's come back up this an intermittent problem and I have replaced the IAC valve and every once in a while i get a P0401 code for the exhaust recirculation. I think I am loosing some kind of vacuum. It was not doing this when I tore into the truck. It seems to be running okay not hesitation.
View 2 Replies
Hot or cold car always starts,Idles perfect , then RPM drops, Idles rough and stalls. Econometer moves to Red area.car will easily restart and drives well,it also idles well. Once engine is shut down, even for a short while, It does the same thing again. Car is used for short trips. Ambient Temperature 80 degrees. Once running car is perfect at all speeds and idles smoothly. Hero 1987 MB 560 sel ....
View 19 Replies
My '03 7.3 is "surging" on idle. When warmed up, and idling, the RPMs will drop by 300 or 400 for a few seconds and then will correct and shoot back up. It cycles like this (every 5 seconds-ish) continually . I just put in a new IDM and checked the UVCH - is there a separate idle control mechanism that I need to have a look at? (2003, 7.3, 214K, stock).
View 14 Replies
I have a pretty bad flex pipe leak on my 20th. Would this leak cause a very rough idle almost stalling when I come to a complete stop. The Idle fluctuates from almost stalling to 1000rpms.
View 1 Replies
My families 2001 Nissan sentra often stalls at stoplights, has low power sometimes in the low rpm's and sometimes (though not always) chugs/jolts a bit at low rpms and has trouble "overcoming" that window and getting more power. If I give it more gas the engine seems to get "normal" at around 2500 or 3000 rpm's and then is fine.
We took it in and the mechanic said it was a bad O2 sensor or MAF sensor... can't remember which. We tried replacing the MAF sensor but it still has the problem. We have heard that we may need the computer re-set somehow or made to recognize and sync up with the new part. As we call around this is very expensive just to make a part that is already installed work. Is this necessary? What's the next, cheapest, step.
View 3 Replies
I have a 2008 Ford Focus - 4 Door Sedan SE 60300 miles.
I've gone to 3 mechanics now and no one can seem to figure out whats wrong with my car. Here's whats happening:
About 1 1/2 years ago I took my car to get an oil change at Jiffy Lube (Yeah never again). When I left, my car was idling funny... Silly me didn't take it right back and have them tell me what was wrong.. so I let it go, well about a month later it started idling even weirder. Basically it feels like my car is shaking when it gets under 1000 RPM and I notice my RPM dial start falling and bouncing back, acting like its going to stall, but never does. I notice a loss of power when this is happening (on speed up and just accelerating in general). All of this is random, I can't seem to put a pattern to it as to when it happens. One day I'll start it up and everything is perfect... Then I'll shut it off and restart it later, and it starts vibrating and puttering again... No signals as to if its hot/cold or wet/dry, no environmental variables seem to cause it to happen anymore than others. And there is no check engine light on, everything "looks" normal.
What I've had done to it so far is:
Air filter changed / reseated
3 oil changes (keep getting told it will work)
Throttle cleaned
Computer reset for idle sensor data rebuilding
Now I'm told that I need new engine mounts, and that could be the reason for the vibration. I'm thinking that the vibration caused the mounts to wear out, more so than the mounts being the cause. Mainly because I don't see how bad mounts could cause loss in power/bad idling.
What could be wrong?!? Really bugging me and don't want to keep throwing money at it for phantom solutions. Seems like mechanics I go to can't figure it out unless there is a check engine light on with some diagnosis code to tell them exactly whats wrong.
View 8 Replies
