Aurora :: 2001 - Swap 3.5L For 4.0L?
Jul 5, 2008
Can swap the 3.5l for a 4.0L? Are the trans different? I know this year offered both the 3.5L and the 4.0L.
View 5 Replies
Jul 5, 2008
Advertisement
Aurora :: 2001 3.5 V6 Won't Turn Over
I have a 2001 Oldsmobile Aurora 3.5 V6. Last Thursday, I started it cold, drove it about 500 feet, and it just stalled. I didn't lose power or anything, it just stalled; I did lose power steering though. Something that may work is that the battery light came on and started flashing when the car stalled, and continued to flash when i attempted to start it.
The car cranks, it just never turns over. I do not lose power like the battery is draining when I attempt to start it (The dummy panel shows the battery dropping to 11.7V, and returning to 11.9/12V when I stop trying to turn it over. I can do this for 15 seconds at a time (It automatically stops trying to turn after 15 seconds) for a long time, and the battery never drains, so it is as if it is charging as I am trying to turn it over. (Not sure if that is important to note or not).
I had it towed home, did nothing to it other than try and start it (which didn't work). Let it sit the weekend, and it started with no issues Monday. Drove it to work, almost made it, and the same thing happened. Same exact thing, battery light came on and started flashing, and the car stalled. Had it towed back again, and it hasn't started since.
I have checked all fuses and relays, nothing shows signs of failure there.
When I turn the key, I can hear the fuel pump getting power also.
Here is what has happened to the car in the past year (excuse me if too much detail is included):
Replaced the Alternator
Replaced the Starter
Replaced all break lines
Replaced all brake pads, rotors, calipers, bearing/hub
Replaced fuel line
I have not tested the fuel pressure, because I do not have a tool to do so.
Aurora :: 2001 / 3.5L - Coolant Seems Low But No Leakage
Just had to replace the steel line that runs from the motor to the firewall with a rubber heater hose due to the steel line rusting through and spraying coolant around. (i left a steel section above the head along the firewall due to heat concerns. I refilled the system through the reservoir but I hear coolant sloshing around in the heater core and the low coolant light is popping up.
The coolant is not low in the reservoir but I really do not feel like the lines were filled when I added coolant to it after the repair.
The temp sensor indicated the car was running normal temp range and the car ran fine when I gave it a 6 mile test drive following the repair. No leaks in the new hoses.
Aurora :: 2001 - Wobbles Only On Acceleration At About 40 MPH
our mechanic told us we had bad belts in our tires, and we should replace them. So we did. Over $500 later, the car still wobbles. It only happens on acceleration, and it starts somewhere around 40 mph, gets worse as I drive faster, and then around 55 mph it goes away. It does not happen on deceleration. We've seen posts on other pages where people have replaced CV joints, both front wheel bearings, both axles, tie rods, control arm bushings... but that doesn't solve the problem.
View 1 RepliesAurora :: 2001 - Door Controls Not Working
I cannot control the windows, locks, trunk or gas release from my 2001 Aurora. The fuses are under the back seat, which I took out. I checked the Drivers door module and the fuse is fine.
View 1 RepliesAurora :: 2001 - Power Locks And Doors Went Out Without Warning
Everything in my 2001 Aurora runs/work fine - 2 days ago however, without a warning, the power locks and doors went out. What this might be ? I checked fuses and relays but not circuit breakers. Is faulty wiring more the likely the culprit ? All other electrical systems are fine.
View 5 RepliesAurora :: 2001 - Rubbing Sound From Rear When Brakes Are Applied
I have recently had the rear brakes on 2001 Aurora replaced. When car is driven about 20 minutes, there is a rubbing sound from the rear when the brakes are applied. I have taken the car back to the shop and they said for some reason the new pads were worn and put new pads on thinking it was bad pads. The noise continues. Is there anything special that must be done on this car when the rear brakes are serviced? Are there special type of brake pads that must be used for rear disc brakes? I am just going to sell the car if I can't figure out how to fix this problem soon.
View 6 RepliesAurora :: 2001 - Power Door Locks Have Stopped Working
Power door locks on my 2001 Aurrora have stopped working. It seemed to progress. First the rear door locks didn't work, now the rear and passenger door locks won't open or close with key fob or power switch on doors. I can still operate the door latches manually with the door lock lever. Also the interior lights and power windows to these same doors don't work. I examined the fuses under the rear seat and found nothing blown. What controls all these devices? The driver door operates as normal.
View 14 RepliesElantra XD (2001-06) :: 2003 - Sputtering After O2 Sensor Swap
My 03 Elantra GLS was throwing an error code that my reader said was the upstream O2 sensor (before the CC in the manifold) and the #3 plug. I swapped it out at the same time that I changed out the spark plug and spark plug wires and the thermostat housing.
The thermostat housing installation all looks good. There are no leaks/drips anywhere near it and all seems good.
The problem is that, after clearing the codes and taking the car for a test run, all seems good until I get it to the point where it is about to shift into 3rd or I've reached about 20-40 MPH. At this point, the engine sounds like it is gasping for air and ready to cut off. If I pull over for a moment, I am able to get going again until I reach those same conditions. I've even had the gas pedal floored and the car won't move during these times and the CEL is now back on saying that the brand new O2 sensor is the problem again (the codes for the #3 plug are no longer showing).
I did remove the battery cable to reset the codes in case my reader wasn't fully clearing them and verified that the fuses related to the ECM/ECU were all good.
Ford Excursion :: 2001 - Gear Selector Swap
I have a 2001 Ford Excursion with the 5.4 and auto trans. I don't know for sure what specific tranny is in it but I do know what I want to do. I really like the pistol grip style shifters that a 2004 ish F-150 has and I wanted to make that conversion in my Excursion. Is it possible? Are the trannys the same to where I can switch out the gear selectors? And also how would I even do it?
View 7 RepliesFord Excursion :: 2001 - Front End Swap Easy?
What all is needed to swap to the newer style and how easy is it?
View 14 RepliesFord Ranger / B-Series :: 2001 - Engine Swap / Knocking Noise For A While
I have a 2001 ford ranger 2.5 and a standard 5 speed. Its been knocking for a while now and recently its made a much lower tone knock, I am thinking I may have thrown a bearing. Also I am wondering what other engines I can use, besides the 2.5.....
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: 2001 - Swap Of Rear Axle?
I picked up an '01 F-350 standard cab and bed plow truck for parts and am preparing to swap the rear axle into my E99 F-250 SB unless someone gives me good reason to just swap the carrier. I want the LS differential. I will also do hutch/harpoon on the tank so I figure that bed removal will make both jobs easier. Once I have both beds off I can give things a visual and see what lines and cables need to be changed out as well. I believe that there is a difference in the passenger's side caliper but I am not 100% on that and I don't know what I will need to change if anything. I am hoping that my drive shaft will remain.
Thus far I have gotten to rotted bed off of the donor truck. The bolts would not come out and I had misplaced my cutoff wheel so out came the torch. In the process of blowing the heads off of the bolts I also blew some holes in the bed but didn't care, it's scrap. Fortunately I did not blow any molten steel onto the fuel tank. I was able to lift the bed far enough to reach the light plugs in the rear and disconnect them without damaging them. The large one that is still attached to the frame goes to the trailer lights and could have stayed connected. The two smaller ones with ends up feed the tail lights and license plate lights, they have to be disconnected.
The bed is shot so I just hooked chains into the rear pockets and drug it off with the front end loader. I did have to get off a couple of times and unsnag it from the frame. Oops, and to cut off the fuel tank fill and vent hoses.
The bolts are extremely rusty and wouldn't budge so I cut them off.
The organ recipient has a spray on bed liner that I had to cut through to get to the bed bolts, the heads look like new and the bolts look like they will all come out for me.
And this is what the nuts and clips look like that mount the bed to the frame.
Yep, there is plenty of rust.
Also, I found two safety cables wrapped around the bed frame and main frame mid bed that will need to be disconnected before bed removal. These are on the E99 SB only, not on the '01 standard bed.
Ford Wiring/Electrical :: 2001 F250 - Auto To ZF6 Swap Cruise Not Working
I have a 2001 F250 with 7.3. We swapped the auto for a zf6 manual. We left the auto's shift position sensor tied to the frame and left in neutral. I did install a pcm from a manual transmission pickup. Also have the clutch position switch hooked up. I have an Edge Evolution CTS2 reprogrammer, and on the display the gear indication always shows P. I suspect that is why my cruise doesn't work. For interests sake, I tried manually adjusting the shift position sensor through all gears, and the reverse lights come on when in reverse but the Edge's display always shows P. My question is with a manual transmission, how does the pcm know that it is in gear? The only sensor that I am aware of is the reverse sensor on the zf6.
View 4 RepliesFord Super Duty (1999-2016) :: 7.3 Engine Swap From 2001 Dual Alternator - Replace Computer Too?
I putting a bit newer engine in my truck. from what I know there have been few changes in the middle of 1999. Do I need to replace the computers too or are they the same. what about the wiring harness.
My truck : 1999 (11/1998 production date) 7.3, zf6 trans, 1 alternator, 315k
Donor truck : 2001 7.3, zf6, dual alternator, 110k
Aurora :: Blower Goes On And Off Randomly Whether On AC Or Heat
I have a 97 Aurora and I have had no other electrical or major issues with the car. However randomly the blower goes on and off. It does it on all the settings, and whether it is on AC or heat. It is really starting to bug me but its almost time to put it away for the winter and I would like to have it ready for "constant" cold AC this spring. I have tried tapping on the motor and it makes no difference. The temp flashes on the climate control all the time but it has always done this. What the random on/off issue could be? It is not throwing any body codes, just the usual o2 sensor in the engine.
View 4 RepliesAurora :: 95 - How To Check Fuel Pressure
How/Where do I check the Fuel Pressure on my 95 Aurora?
How much fuel pressure is needed to start and then for the engine to run normally?
Aurora :: 95 OBD1 - Engine Lights Comes On
95 Aurora, engine light comes on . I looked under the dashboard and can't seem to locate the plug for the reader. ALSO how do I read codes out of an OBD1??
View 1 RepliesAurora :: 96 Just Cranking And Wouldn't Fire
I drove my Aurora 300 miles one morning and when I arrived home it was running fine. I shut it off and went in the house and after 10 mins, went to leave again. It just cranked and cranked and wouldn't fire. I assumed it was the fuel pump and upon pricing one out, decided to wait and just plated another car. The Aurora sat all winter and now with the weather a little nicer, decided to try and fire it up last week. It cranked for a few seconds and there was a small explosion under the silver cover plate on the motor. It sounded like a backfire. It did it 2 more times and I stopped trying. It seemed to be coming from the intake and the foam on the under side of that silver plate is singed on the side by the power steering resovoir. Is there something there that could be pooched? Could it still be a fuel pump being that there is something exploding there? Could it be a fuel rail issue? I have read that there have been recalls. And where is this fuel pressure regulator?
View 1 RepliesAurora :: 95 - Belt Routing Diagram
I'm trying to get my hands on a belt routing diagram of a 95 aurora. I can't seem to figure it out. If you know of a link where I can get a visual ...
View 4 RepliesAurora :: Water Flooded The Interior Of Car And Submerged OBD I
My car was subject to flood waters, August 19th 2011. The waters flooded the interior of the car and submerged the OBD I. When the flood waters receeded, I was able to turn over the car and drive it. After removing the car from the flood waters, parked it in higher place and used shop-vac to suck out water.
Passenger seat functioned -ok
heater-ok
sun/moon roof - ok
battery - ok but was shorting out
htd seats - not ok
drivers seat - not ok: seat will not move for/aft and seat will not decl/recl.
water did get into the OBD, yet, devices that work off OBD seem to work fine.
Q: Would be be true that the OBD I is still salvagable, or should I get rid of it? 1995 Olds Aurora