BMW :: 1990 - AT Cannot Leave 1st Gear Or All Forward Clutches
Dec 27, 2015
My car is 1990 BMW E34 M20B20 that uses 4HP22 transmission and here is the problem:
When I put it from P into R it makes a sound like a hitting and doesn't move but you can understand it is on load, because when I step on the gas, engine cannot outrun 2000 rpm (even at trying to rev).
When I shift into N, it starts to move forward and it's drivable but not an engaged drive, and while traveling or not, when I shift from N into D, it retrieves the engaged drive and goes normal.
I think it cannot leave 1st gear or all forward clutches. What the problem could be?
View 7 Replies
Advertisement
I have a 98 Mazda Protege-Automatic, it has the following problem:
- When i press the gas it takes about 2-3 seconds to feel it and start moving.
- at the beginning of a drive, it is very heavy to go and some time i have to reach 4000 rpm to get it move. after running for some time it is better.
- some time it sticks to a specific gear (usually 1st or 2nd) and does not shift forward??
Is it the clutch or the transmission or something else? how much it may cost to fix?
View 3 Replies
My car will not leave first gear until the car reaches 60 x 100 revs 9 has heated up. After leaving first gear it shifts smoothly so I doubt its the transmission fluid, plus it's over 14 thousand miles and I was told not to change the fluid for the transmission. I think it could be a bad solenoid because when I bought the car the dealership wouldn't let me take it home until they installed a new one or else "it wouldn't leave first gear" if so witch solenoid would that be so I could replace it.
View 7 Replies
I am trying to figure out why my car makes a certain sound and movement when I shift between first and second gear. I don't think I am making the car lug or stall out because the RPMs never fall too low, but there is a clear "ka-chunk-ka-chunk" noise with a corresponding forward-backward lurch. I am pretty sure the car is fine, and it's all my bad technique because my girlfriend does not get that "effect" as much as I do (really, not at all, and it's a bit emasculating that shes such a better driver than me!). This does not happen when shifting into first from a stop, but then again, I'm not the best at that either..
I drive a 2002 Honda Civic with 120k.
View 14 Replies
I have a '90 Bonneville SSE and after coming to a stop at a red light on the highway, when the light turned green the car wouldn't move forward. There were no odd noises, the car had been in cruise control and there had been no problems up to that point. The car shifted crisply, there was no obvious slippage or hesitation going into gear.
I can feel the car engage in both drive and reverse, but it won't move at all.
View 5 Replies
I put a clutch and throw out bearing in it about 4 months ago. All the sudden driving went to shift from 3rd to 4th and it wouldn't go. If you turn the car off you can shift it into gears. BUT if you try to turn the car on in gear it just jumps forward. I have had guesses all over the board about what it COULD be. It seems like a very exact problem to me. BUT with that said I have never worked on a car, just drove one.
View 5 Replies
I have a manual transmission and am having difficulties with my stick shifter. I had my car in neutral with my foot on the brake, and when I tried to shift into first gear I was unable to get it into gear. I wasn't able to get it in any other gear as well. Once the car was turned off though, I had no problems getting into gear. But when I turned the car on again, I wouldn't allow me to get anywhere but neutral. After about 10 minutes being off and not moving, the car shifted like normal again and I was able to drive it without a problem.
View 1 Replies
While driving our 1990 toyota corolla (3-speed automatic transmission) on the freeway recently, the car gave a slight jerk, at which point my husband looked at the gas gauge and noticed it was well below "E".. Oops. fortunately, there was an exit right there with a gas station. Filled up and we were off toward the next on-ramp. Got to about 35-40 mph, and all of a sudden the car literally just stopped moving forward after violently jerking back and forth several times. We then tried to put in neutral and push it to the side, but it wouldn't even do that. Everything was locked up, seized solid. Somehow we managed to get it to the side.
The flatbed tow truck took us home, and all we could do by that point was move a foot or two in reverse after it dropped us off... fast forward... After several days/weeks of it sitting around we can now actually drive it forward! reverse! but we haven't taken it out of the driveway to go more than 5 mph.. We had seen some fluid leaking prior to this incident, but could NOT figure out where it was coming from despite checking obvious fluids meticulously every couple of days. A friend said it might have been the diff fluid? We'd like to fix the car, but to repair a tranny on this old car (although it only has 67K miles!!!) is too expensive. My husband wants to make it a weekend project.
View 5 Replies
I just rolled over to 90,000 miles on my 2002 Accord. Its running beautifully, however every so often the car "rumbles" or "shudders" when I'm releasing the clutch after I shift into second gear, or sometimes it'll do it when I'm facing up a hill pulling into first gear letting out the clutch. Its almost as if the clutch rapidly grabs then slips a bunch of times, similar to if it was warped. It doesn't completely slip at all to my knowledge. The car was bought new by my family and has been driven pretty carefully since (although 2 people have learned to drive stick on it, and my dad isn't the most "gentle" driver in the universe). I know that Clutch rebuilding and replacing is a big expensive job and its something I wouldn't even consider doing myself. So, when is it time to really seriously consider dropping down the serious cash to get the clutch rebuilt? To be honest, the shuddering is really annoying (it doesn't happen all the time though) but its something I could live with for a bit.
View 8 Replies
My beautiful 1990 Volvo 240 will not shift into 4th gear! It is an automatic. The OD light will go on and off and I can hear it click when I turn it on. I just noticed that when getting on the highway it seemed as if the RPM was a little too high so I started paying more attention to which gear it was in and noticed today that it stays in 3rd gear.
I have already replaced the fuse #11. With the OD seemingly working fine, should I mess with the relay?
View 3 Replies
90 Ranger with 5 speed manual, Every thing works as it should untill you put it into 5th, lift the clutch pedel and you fine, the tac responds and I asume your now in gear, but press on the gas pedel to give it a load. whhhhhiiiinnnkkk and the gear selector kicks back to netrual.Also I did remove an inspection panel from bottom center of the tranz and could see no sighns or damage, rounded or broken teeth.It's been sugested that it's just time to re do the clutch, if so why do all the other gear selections work without any problems?
2.9 v6 w/95k and I don't know the history.
View 5 Replies
I have a 90 celica gts. when it drove, it would violently shudder taking off in first gear. the front motor mount was shot so i was hoping that was the problem. well right after i fixed it, the starter went so i had to compression start it, and the shuddering was still there, and i was about to shift to second when it revved up popped outta gear and didn't go anywhere. it wouldn't go into any gear.
I can go through all the gears without the clutch in. the guy i got the car from said the clutch was new. now i'm not sure if hes just lying or if the guy who put it in didn't know what he was doing. could this be a bad throughout bearing? or the trans? if its the trans i'm scrapping it, also the shiftier is REALLY loose. and before the clutch went it would make weird whirring noises in 1st.
View 5 Replies
I can not resolve a rough idle in gear when engine is warm problem. I've replaced plugs, wires, mounts, isc, o2 sensor, ecu, have no codes.
View 17 Replies
I have a 2002 SC 430 with 68,000 miles on it. Having problems with the transmission? Today, I could not go forward in any gear...could go in reverse. I turned off the ignition and re-started the engine, then the car worked fine.
Tonight I went out and the car was fine. However, later had the same problem.
View 14 Replies
I have a 90 Cutlass Cruiser SL and it is shifting real hard going down to first. Other gears are fine. Checked motor mounts, ok. Also stutters at higher speeds in OD but when I kick it down to drive it quits. She has a lot of miles but I can't afford a new car.
View 15 Replies
got a sweet deal on it but only 1 problem with the car. when i shift into 2nd gear there is a grinding noise, however it doesnt grind if i drive super slow... it doesnt really matter if i upshift or downshift into 2nd it will make the noise either way... also the grinding noise is only there WHILE shifting the lever into 2nd gear so its only there for a second, once the lever is shifted into 2nd gear there is no grinding noise at all...not sure if this is related but the clutch pedal also feels very lose just when its about to hits the floor...
View 4 Replies
I have a problem with my 1998 Chevrolet Blazer. It won't go in reverse, but will go into gear going forward. I don't know whats wrong or what the cause is.
View 2 Replies
I just purchased an Automatic 2009 Camry LE with 64k 2weeks ago, and noticed that twice it felt like it was losing power on an incline so I bought the fuel system cleaner to see if that worked (seaform). Tonight I go to park it on a street with a slight incline. As I shift to reverse to line the car up, it rolled forward. It shocked me bc there was a parked car right in front of me. I tried putting it in Drive/Park etc then back in Reverse it still rolled forward. I put my foot on the brake and gas at the same time to try to reverse but not wanting to give it too much gas bc I was scared it might fly forwards into the car in front of me (still rolled forward). Finally I was so close to the car in front of me I gave it a try and it still rolled and bumped the truck in front of me but with enough gas it went into reverse.
View 6 Replies
My son called me today to pick him up. His 98 S10 would shift into gear but wouldn't go forward or into reverse. New clutch 6 months ago, hoping something simple like low gear oil or worse?
View 1 Replies
I have had my manual 2014 four months now and still can't get used to the fact, that to engage reverse you have to move the stickshift FORWARD into the same spot as first gear. I have had a half dozen near wrecks because of this.
View 5 Replies
We have a 2001 Santa Fe. Very recently it began hesitating when put in gear going forward or reverse. Once the gas pedal is pressed, there's a delay of up to 2 seconds as RPM climbs, then the vehicle jerks into gear. It seems to run fine otherwise. Mileage is approx 128 k. Maintained very well by the same mechanic until very recently. Internet searches have gotten answers of use fuel additive, install some computer patch, fix an oxygen sensor, change tranny fluid and flush tranny, rebuild tranny.
View 2 Replies
