Instrument cluster (speedometer, Tachometer, Break & ABS light) is not working while driving.
My video for my 2009 camry 2.4 LE is here: [URL] .....
Toyota service center asked $6000 to replace wire harness and PROBABLY electronic control unit.
I found some posts, but the answers are not that clear to fix it. [URL] ....
Have a '13 F150 Platinum. Recently three things "broke" at the same time and I suspect a fuse but cannot locate the right one. At first I thought it was just the GD Opener, but when trying to reprogram it, I realized the red lights were not lighting up and the Drivers side Vanity Mirror light was not working.
About the same time, I noticed that the Instrument Cluster Memory function quit working and weirdly, every time the truck is switched off and then back on, it always comes back to the trailer tow screen for my Snowmobile trailer.
I thought i had it solved when I found that the trailer back-up lamp relay power fuse ( #43 in fusebox under hood) was blown. I replaced with a good 15 amp fuse and the problems are still there. I have searched high and low and cannot find a fuse for the Car2u GD Opener or the Driver Vanity Mirror Light (neither Vanity light for that matter. I tested all under hood fuses, but the kick panel fuses are impossible to check one-by-one.
The speedometer, tachometer, fuel gauge, battery meter, temp gauge and idiot lights went out. The car works fine. Dash is just dead. I did a quick look at the fuses in the glove box but it doesn't have the little card to tell fuse locations. So, I can't narrow it down but I don't see any blown fuses.
View 4 RepliesI have an issue where the instrument cluster (tach, spedo, fuel, temp, door open indicator, etc) and AC stop working. It only happens under the following conditions and can be reproduced easily. All fuses have been check and are OK.
1.No Gauges
2.Remove and replace Multi-Fuse 20 (which is new and good)
3.Gauges and AC start working again
4.Drive car or start etc. and everything works fine
5.Power off car for exactly 1 min. or more with doors closed
6.Start car and no gauges or AC again
7.If wait less than 1 min. (tested 30 sec. to 59 sec. ) to restart the car and all gauges and AC continue to work fine
Where to start diagnosing.
The instrument cluster settings has not been working and they would not set when i would try to do this.It would go back to the same setting as before.They checked it on the computer and everything would register like it was ok but the computer could not detect the fault.Come to find out it needs a new instrument cluster and that was the fix for it after they took three more Tregs apart to make sure it would either work or not work at all.They all worked except for mine.It is being replaced and shipped overnight.
View 3 RepliesThis is for my gf's 2010 sonata. The instrument cluster stopped working but then after a couple days it started again. Once again it stopped working. This time I checked the fuse and it was fine, there was power going to it. I was able to get it to start working again by disconnecting the battery. I hate electrical shorts. I have done some research but haven't come up with anything other than re-seat the cluster or replace it. I plan on doing that the next time it stops working. I'm thinking it might have something to do with the ignition, but i really don't know.
Engine codes are P0011/P0014/P0462
The P0011/P0014 are, i think, the oil control valve. I ordered that.
The P0462 code has to do with low voltage to the fuel level sensor, but the gas gauge has worked fine, well other than when none of the gauges work. Still I don't think it relates to cluster problem.
This happened around 3pm yesterday on Limited 2.0T.
I had Hyundai Navigation going to see what the 3D view looked like (8" display on map fullscreen), along with my iPod Classic playing music. On the instrument cluster, I started cycling quickly through the tabs on the center LCD starting from the MPG/speed page to the navigation page (via the menu button on the steering wheel). I overshot it and cycled through again.
I was doing this very quickly when the whole instrument cluster restarted as if the engine was off and turned back on. The LCD and numbers on speedo and tach completely went out, the needles on speedo and tach went to zero and returned (while cluster was still off), and the cluster did a system check, with all icons displaying for a second then turning off and the System Check screen displaying on center LCD.
In addition, I previously had AUTO HOLD on and when the instrument cluster restarted, AUTO HOLD was displayed in red and could not be turned off or activated (car would not auto hold) and the traction control icon (I believe) stayed on. The main 8" display was unaffected when all this happened.
I was able to turn the car off and back on later and everything seemed fine after. It freaked me out quite a bit, especially when all this happened while I was driving.
The instrument cluster in my 2000 Silverado 1500 recently stopped working. All the gauges are flush to the left, except for the oil and battery which stay about in the middle. I ordered a different cluster online and went to install it today, finding that it still doesnt work. Except in this one everything aside from battery and oil are flush to the right. What to try next or am I going to need to take it in?
View 1 Replies2006 Sonata 3.3 (NF series). A few days ago the instrument cluster and LCD odometer stopped working.
The dash cluster lights up, warning lights flash on at start up just no indication of speed, fuel level, tach, or temp.
Fuse is good & has power to it. I re-seated all the connectors under the dash. No luck.
2011 F150 xlt . had a red triangle appear over the A/B trip mileage etc. yesterday.
Go to any other menu settings, and it disappears.
I have done a reset 3 or 4 times, and nothing changes. I checked the owners manual, but didn't find anything.
Did a search on here, but found nothing.
Ok .. Airbag warning light is on..... And won't go off i have taken battery off try reset that way nothing. Also steering wheel lights are off...
Only thing working on instruments on steering wheel is the left side is the radio and phone and volume and mode right side of steering wheel not working but nothing is illuminated!!!!???? On wheel
I have a 2013 F250 with 49.575 miles and Saturday the truck left me stranded. I was towing my small trailer and doing about 45 mph.....When just out of nowhere .....I got every possible warning come across my display and none of my instruments were working. That included speedo,tach,boost....even the radio and ac were effected in some way. So after a few miles I was able to pull over ....cut the truck off and it wouldn't start.... So I had Ford roadside service tow it to my home dealership.
View 13 RepliesI have a 2005 Camry with 150K miles on it. Last night while driving home from vacation, the instrument cluster and center facia (AC controls area) went out all of a sudden. When the front headlights are on the inst cluster and AC facia lights dont work, but when the front headlights are off the instrument cluster lights work. I checked the 10 A panel fuses and they are ok. The tail lights are also working.
View 3 RepliesI am really hoping that my instrument cluster in not working because my alternator went out at the same time. I really hope they are connected somehow. I really need a wiring diagram for this one. Just got the truck last week and have been taking care of the little things to get it fixed up and make it my own. my new rear step bumper came in today. I will be dropping off the the alternator for a rebuild tomorrow. So looking for a wiring diagram?
View 7 RepliesI'm having a little problem with my F350. I've had it for about a month now and the cluster had no problems or whatsoever. Then, I drove it today and I noticed that the instrument cluster is not working at all. The lights work, but the gauges wouldn't move. When I turn the key before starting it the chime is beeping faster than it usually did before and it wouldn't shut off unless I close the door. It also only indicates the airbag and battery light. I checked all the fuses and they were good especially #15 or #16 can't remember it right now.
I don't know if its related, but this past saturday I was messing with the overhead instrument cluster for the gas mileage and all that. I soldered some of the relays back on and that was it. I started the truck after I did all that, but everything was still working. It's been bugging me all day today.
I have a 2011 F150 supercrew 4x4 5.0, it has almost 8k miles. I have looked around online to see if this is a common issue but haven't found anything really. The airbag warning light in the instrument cluster will come on and stay on randomly. Some days it only lights up when I start the truck, other days it will turn on and stay on until I restart the truck. I think I have a glitch or a malfunction in a switch somewhere with the Airbag system. I will be calling the dealership about it after we finish the Easter Weekend.
View 5 RepliesSo, went to drive the truck (2004 F250 6.0, 145000 mi) yesterday and the right half of my instrument cluster was not working (tach, trans temp and water temp), CEL and check gauges lights on. My scan gauges gives me readouts of all 3, so I know the computer knows the right values. Pulled all three fuses related to the cluster, all looked good. All gauges, including those not working, did full sweeps with key on after putting fuses back, so I know they function. Also, the glow plug light stays on way longer than normal.
View 2 RepliesMy right side of my instrument cluster is not working. the Tachometer, Engine Temp and Trans Temp gauge are non responsive, and the CEL and Check gauge light is on. I have seen other posts with people that had the same problem but no solution to what fixed the problem. 2004 F250 Lariat.
View 4 RepliesHave probably 1500 miles on my '15 XSE. Got in the car today and noticed that there was a crack in the instrument cluster plastic shield. I just detailed the interior of my car 400 miles ago and it wasn't there and I've been the only person in my car.
View 5 RepliesTown and all shops nearby have a week wait to get the truck in there. This happened once or twice a year ago but I'd pull over, shut it off and when I restarted it everything was fine. I'll be driving and all of a sudden the information display on the cluster will show a wrench signaling something's wrong(see image), then the speedometer will go to 0 and all information in center display will show flat lines. This started up yesterday but is now doing it after about 10min of driving every time I being driving. What's worse is the truck will randomly start shifting or shift extremely hard even when driving at a consistent speed. This was taken while truck was going about 45, but shows 0...
View 5 RepliesMy 2014 Super Duty, the accessory delay relay is starting to acted up. When driving my instrument cluster and heater/AC will cut-out momentarily once in awhile. I guess Ford has known about this problem for years and hasn't done anything to fix this known problem in their Super Duties. My truck is almost out of warranty and I guess to fix the accessory delay relay is to replace the whole instrument cluster with a new one with the same defective part. Of course, the accessory delay relay will never acted up a the dealership because it's totally random. Plus, I don't trust the incompetent people who work at my local dealership to do a good job on tearing out my trucks interior and to get it back together like factory. I'm at a loss.
View 10 Replies