Camry :: 2010 XLE Loosing Power When Trying To Maintain Low Speed (25 - 35 Mph)
Sep 2, 2014
I've noticed when trying to maintain a low speed (25-35mph) the car doesn't really like that... Almost feel like the brake is being slightly pushed on and off, or the car is losing power. It's been most noticeable around curves when coasting but having to give it a bit of gas to maintain speed. Shifting overall doesn't seem bad, so it doesn't feel like a tranny issue. I've also sometimes noticed the opposite. Sometimes when coasting then pushing the brake to slightly slow up it almost feels like the throttle is very slightly being pushed. Not sure if I'm having powertrain issues or just not used to the way this car drives. It just get most annoying when trying to maintain 30mph in city and the car occasionally surges a bit.
(2010 camry xle, i4, 97,000 miles)
View 1 Replies
Advertisement
R32 has 29,000 miles. I live at 8000ft. Recently, my R, when traveling back from sea level, starts to have what seems like fueling issues at around 7000ft. These take place by the car being unable to maintain a steady speed and then losing power. Once power falls you can press on accelerator and then will pick up again and accelerate through the gears until you need to back of the accelerator, then the same problem will happen... Once home after lurching around like a kangaroo the car will be fine if switched off and then left for an hour before driving again.
View 7 Replies
Problem I'm having, when in overdrive my 04' F150 FX4 5.4 Triton surges while trying to maintain a steady speed during power delivery to the wheels, it causes a shuttering and bucking effect. If I push the button to turn the O/D off, the RPMs rise and problem goes away. During the problem no CEL illuminates and tach stays constant. Fluid condition & level are okay. (not burnt) I'm completely baffled since there is no code in the ECM to point me in the right direction. I do use the truck to occasionally tow my 5k lb boat & trailer. When I began towing I did not know to turn the O/D off and put some miles on towing in overdrive, I know now that was not good for the tranny.
View 7 Replies
I have a 1990 celica hatch automatic with 33x,xxx miles on it. the cars always had problems like it would suddenly turn off or the rev would go high but all of thats been fixed
recently the car started losing power and it cant really accelerate to a high speed and speed past 30 and the car will start to shake a lil as if it was gonna turn off and even if i floor it at high speed it doesn't really go anywhere and if i use overdrive the rpm shoots way higher then usual.
Do i need new engine or is it other problem? my friend said it could be distributor?
View 2 Replies
My cruise control will engage but not maintain set speed. It slowly loses KPH, 10 KPH every 30 seconds. What to look for?
View 6 Replies
I have '98 Transport Montana and I took it on a trip last weekend on the expressway. I would be doing 70 MPH and approach a hill and start depressing the accelerator to maintain my speed and I could feel a chugging. Also, I could hear the engine seem to make a change in its sound coincident with the chugging. The RPMs at this point were around 2K. It's a 3.4 and all of the normal stuff has been maintained properly (spark plugs, filters, etc.).
View 2 Replies
I recently picked up a 2001 Nissan sentra. This car sat since around 2010. I guess the previous owner had a lot of work done by the dealer a year or so ago and it looks it, brake pads etc. are brand new, a couple other things look new but he's not a car guy in the slightest and can't find the receipt nor will the dealer give him one due to computer system change and I actually tried with them myself, that's correct.
Anyway, the check engine light is on and bringing it home we had reports of black smoke out the exhaust. It also felt like it wanted to stall at times when stopped but it never did. Well, I ran it a while and at times it seemed like it wanted to clear up, at others it didn't but the light stayed on and what not. I scanned it and it claimed the O2 sensor 1 bank 2 was bad so I replaced it.
It didn't make any difference so I cleaned the Mass Air flow sensor. Again no good it's the same. Here's the funny thing though, it's great first thing in the morning usually. As the day goes on and as we drive it, it gets worse. What I can try/change next?
I'm almost leaning on electrical issue where it gets worse as the day goes on and dew dries off. I'm new to Nissan's, I like the car and really want to work this issue out. I did replace the fuel pump when I got the car, and have run sea foam through and actually on that tank of gas it ran pretty good but that's worked itself out now.
View 5 Replies
Recently bought an Audi A4 Quattro from a dealer with 112,876 miles on it.. The car runs absolutely beautiful, it up-shifts and downshifts without any noticeable issue, it changes gears without any issue, however... When I am trying to maintain a stable speed of around 35 - 40mph and my engine hangs around 1700RPM it'll bounce up and down slightly..
The revs will hop between 1700RPM up to around 1750RPM and then back down, and then up again.. It's hardly noticeable and the only time it causes any issue/delay is when it hops above 2000RPM and then back down... Is the torque converter the issue or what else could be the cause? Timing belt has been done, spark plugs have been checked, oil has been changed.
View 11 Replies
Middle of May, I went to Boston. On the way there, I started to notice a slight whirring noise that was only present when I gently feathered the gas to maintain highway speed. If I were to apply any more throttle, the noise would go away, and if I were to pull my foot away and allow engine braking, it would also disappear.
So I did my best to finish the trip to and from Boston adjusting my driving to avoid the noise. Once I came home, I researched and thought the noise might have been my wheel bearings (I had just replaced lower control arms, lower ball joints, inner and outer tie rods prior to leaving for Boston). I also had a shop install my upper strut mount bearings and bushings simultaneously with the wheel bearings.
Since then, the problem still continues. It has grown louder, but still occurs under the same situations. I've focused more on it and here are the conditions under which it occurs:
1. Car must be warmed up. Starting it up cold and allowing SAI to run then driving, car is fine, no sounds. Usually takes 20-25 mins of driving to get it to start making noise.
2. Car still only makes the noise when the gas is being feathered (ie barely pressing it enough to give it any sort of throttle. It does also make the noise between shifts when reengaging the gear and applying gas, as the throttle pedal passes the point of throttle off to throttle on.
3. I'm hearing more noise now during engine braking than I had been previously. Could be related?
View 6 Replies
What may have wrong with my trans on my truck... this is what its doing, I am able to put in drive and drive it for so long then its like the truck is in neutral and doesn't gain or maintain speed. but i can turn the truck off and put it in park and restart the truck and it will go again?? that is how i got it home....
the fluid is burnt now but wasn't that bad until the trans started doing this. I have pulled off the pan and inspected the filter and it does have metal debris in it, pulling the valve body off tonight before work (work 3rd shift) to inspect that, i think it has something to do with the solenoids or valve body because it actually moves but then quits until i restart the truck. Also does the transfer case use fluid from the transmission? or are the fluids separated between the 2.
Truck has 4.0L SOHC with a 5R55E in it 4WD...
View 7 Replies
I have a 2007 Camry SE V6 with approx 170K miles. A few months ago I took my car into the dealership and they performed a service on my car that is a bit confusing. According to the invoice it is labeled: ENGINE INDUCTION SERVICE COMPLETED FUEL INDUCTION SERVICE. The description for the part is TOP ENG/INDUCT SV.Since this service I have noticed a weird vibration in the car when trying to maintain speeds of 65 to 70 mph. Also, if I were to floor it, the car accelerates rough -it shakes and jerks.
View 2 Replies
Can you glide (meaning no engine engaging) on straight road without a hill without loosing any speed over 40mph? I only can when my speed is dropping. I can drive all electric around town without EV mode, no problem.
Stock Yokohama's, front and rear @ 40psi. will bump them to 44psi. Also oil is higher the high mark, which I am planing to drain.
View 1 Replies
Our 2006 Prius (175,000 miles) has recently suffered intermittent periods of diminished ICE power. For instance, for about 1 hour recently driving a hilly section of I-81 through eastern TN, the car was struggling to maintain 68 mph and the HV battery stayed mostly drained at 1-3 bars. Gas mileage was falling, but no misfire. After stopping at a rest area, it was fine. No OBD codes and ICE seems OK otherwise. Experienced a similar reduction in ICE power a few days later. Dealer has no clue. Similar experience I've had with another car was when it's catalytic converter became plugged, but that was not intermittent.
View 19 Replies
I have a 2006 F250 with a 6 liter diesel I got about a hundred sixty thousand miles on it I've had it bullet-proofed haven't had too many problems with it I thought the fuel pump went out yesterday so I replaced it drove fine for a few hours then it started losing power and like it wasn't getting fuel and died I got it home took a test light and check for power at the fuel pump I don't have any positive or negative power ran a hot wire and a ground straight from the battery and hooked it up to the pump and it worked but when I plug the factory wiring back into it and turn the key on I don't have any power I checked the fuses they're fine...
View 6 Replies
I have a 2003 Ford F-350 super duty 6.0. A few weeks ago it starting loosing power, it wouldn't even go up to 15 mph. It now won't even move. There is 0 power. When I press the gas the motor bogs down to a very low idle and wants to die. I also had recent trouble with it starting. It would wind up to a very very low idle and about a minute later it would crank up to full idle. I changed the fuel filters (on top of the engine and under the cab) and also changed the fuel pump under the cab. After that I still have no power when pressing the gas it will still act like it wants to die.
View 14 Replies
What I know the truck was running normal except if I stomped the gas pedal and let off it would not respond again until I shut off keys and restarted this was a month ago now the truck sounds like it has a lope tune.
When I hit the gas pedal it blows white smoke and if I press the gas while idling or driving it floods out I did the spray bottle test on manifolds the drivers side was plenty hot the passenger side is cold you literally can touch while it's running.
The truck sounds like it's only running on 4 cylinders it has gotten so bad I parked the truck. Also this truck always had poor mpg 8 to be exact city hwy and towing nothing changed the mpg at all it used to blow out wet soot that would fall down on the truck and anyone standing near it.
Mods unknown pcu program 4in straight pipe with 12in stack harpoon mod in tank
View 8 Replies
I have a 2010 Camry LE, 2.5L auto, with approx 35k miles. While driving between 65-75 mph (I don't drive above that, so I can't tell you if it keeps going), I get a slight vibration in the seat, floorboard, and steering wheel. If no one is in the passenger front seat you can look over and see the headrest and seat vibrating like a massage chair.
I had the wheels checked and three were bent (I bought it used, so I don't know how the wheels got bent). I had new aftermarket wheels installed, same 16 inch size as the OEM. That didn't fix it. I had the wheels/tires hunter road force balanced, found out the two in the back were out of spec. So I had brand new Michelin MXV4's installed all around and hunter road force balance. That didn't fix it (though it is a lot better -- clearly the bad tires and bad wheels were causing part of the problem).
I had the car aligned to perfection. That didn't fix it.
I had a rear brake that was rubbing so I replaced the discs and pads in the back, but that didn't fix it.
I've checked all the wheel bearings for any signs of being loose, but they don't shake at all when the car is jacked up.
I've checked the struts, both by bumping the car at the corners and a visual inspection, but see nothing wrong with them.
I've checked the CV shafts -- the boots are fine, there's no play in them, nothing.
I've taken the dogbone mount off and checked it -- no cracks.
I've taken apart the front brakes to check them. No problems there (they even have new discs).
I've checked the ball joints -- no play. I've checked the steering linkage -- no play.
There's no pulsation in the brake pedal.
If the car is vibrating at a lower speed, it's not noticeable. But once you hit about 65-70, it becomes obvious to the driver. I've had passengers in the car who didn't notice, but they aren't holding onto the steering wheel and pushing the gas pedal. Both give a massaging-like pulsation.
View 14 Replies
I am in the nasty position of having to remove my 6-spd manual transmission to investigate the nasty whine in it. The dealer says $2300 to fix it and the parts are $100, so I am going to do it myself. I have been unable to find a repair manual yet for the 2010 Camry and I was wondering for step by step for removal of the tranny. I don't need a lot of detail, but it is nice to know the order in broad strokes.
View 7 Replies
My Turbo Passat has slowly been loosing its A/C Power. Im thinking maybe a recharge will work. Is this complicated to do? I know they sell the cans to do it yourself just want to double check with the VW people to see if there is anything I need to look for while doing this.
View 2 Replies
Facing problem from last 6 months, brand new tiguan, car started put reverse gear then loosing power immediately, once you re-start the tiguan then everything will be alright!! Follow-ed it up with dealer but they can't simulate so no issue for them!!
View 1 Replies
I have a Golf 1.8 t 2003 and when the car reaches 4000 rpm on 3rd gear it starts sputtering and can't go above that rpm. it sputters a bit on 2nd gear but at about 5000 rpm but it keeps accelerating. I couldn't try the other gears because i don't have a suitable to reach those speeds (traffic laws speed limits). I have noticed a slight tear on the connection between the hose from the air filter and the T hose. could that be the problem.
View 9 Replies
