Celica :: 90 Fuel Pump - Can Hear Buzz But No Pressure
Aug 11, 2015
I've followed steps 2-6 from this image
I don't feel any pressure in the hose from the fuel filter. I can hear a buzz (guessing its from the fuel pump) but no pressure.
I've checked both fuses, the efi main relay, and swapped out the circuit opening relay with a known good one and all checked out good. Only thing left is the fuel pump or the writing and electrical connectors.
Car has pretty much took a dump one morning and has almost no power. I can't find anything else wrong with this car besides this. Is the fuel pump the problem even though I can hear the pump?
View 5 Replies
Advertisement
Geo won't start. It has a new battery and air filter. Just replaced the fuel pump and fuel filter. I don't hear the fuel pump "whirring" when I put the key in the ignition (to on position). All the dashboard lights come on when the car is in on position.
I suspect the relay or the fuse, but having trouble finding the correct one of each. What does the relay look like? i.e. part number? What is the spec for the fuse? 20amp 30 amp? This has been a great car.
View 5 Replies
I'm working on one of our fleet vehicles here, a 1995 Explorer. about 2 months back, it stalled out. Got it back to the shop and turned the key on .... I couldn't hear the fuel pump. I replaced the fuel pump and the fuel pump relay. Vehicle started right up and seemed to run O.K. About 2 weeks ago, it stalled out again, same symptoms, acts like it runs out of gas and can't hear fuel pump.So, I have been playing with it and find that it starts up great in the cool mornings. In the afternoon when the temps are hotter, it won't start (can't hear fuel pump). The following morning when temps are cool, it will start right up and can hear the fuel pump. I almost wrote this one off as a defective fuel pump, but I'm not sure on this one.
View 7 Replies
Got done with replacing head gaskets and intake gaskets, Van started fine and I backed it out of the garage. Left it running and put down ramps and drove up on them so I could get under and connect the exhaust. Got that done and then got back in it and all it will do is crank and it will not start now. It also has a new cam shaft sensor( wire broke on old one). I can hear the fuel pump when I turn the key. It is like now there is no fire to start it. What could be wrong? What do I check? What causes it to fire? If something was connected wrong, would it have still started and then wont do anything but crank? Got dark on me and started raining so I say tomorrow is another day. I feel it is something simple.
View 4 Replies
when I turn key I should hear fuel pump, I don't. I can jump pump & it will run but it still won't start. I reset inertia switch, switched pumps (new one) still won't start. What next????
View 1 Replies
I need to check the fuel pressure to verify if my fuel pump is functioning. What is the procedure and PSI?
Assume that I open the valve on fuel rail with engine off, then connect pressure tester kit, put key in ignition to "on" position, then pump up to specified PSI???
View 3 Replies
2005 1.8t gti wont start. The other day I was driving on the highway when a thin plastic type wrapping got caught in my serpentine belt. The car immediately died and I hit the gas and nothing and with no power steering i pulled over to the side.
Timing belt was done with water pump and tensioners
Spark plugs and coils are brand new
What fuel line to disconnect to test if the fuel pump works? Like I said in the title I cant hear the fuel pump priming. The engine was running 100% before this 2 techs saw it and the vw dealer i workrd at looked it over.
View 7 Replies
It was acting rough and was a little loud. Like a low deep loud, the engine light came on. I tried to start it, it would crank but no start.
Code came up P0340 (Cam sensor) So i replaced it, reseted and scanned again, now it says P0343 To much input sensor 1 bank 1. When i turn the key over to "ON" I don't hear the fuel pump, is this normal?
I don't understand what to do I am so lost, I am ready to do the timing. Is there something cutting my fuel pump out or is it done? Do i do the timing, or replace the pump ...
View 7 Replies
Sometimes my Bravada won't start. It cranks good (new battery) and I can hear the fuel pump , but it doesn't fire up. I just got it back from the repair shop.?
View 4 Replies
I'd been suspecting that the fuel pump on the car was going bad recently, and yesterday when turning a corner the engine shut off and it won't start back up. At first it would turn over a couple times, but now there's nothing at all. I've checked the timing belt, which is good, and I'm almost positive that there's no fuel getting to the engine. The problem is that I can't figure out where the fuel pump / relay is located.
View 1 Replies
It acts like it is fuel poor, As if the fuel pump is not pumping. It spins fast on start. Then another try and it starts! No relationship to hot or cold. Fuel OK. Battery strong. I find no corrosion on fuel pump leads.
View 8 Replies
I have a 1992 toyota celica gt with the 2.2L motor. i need to know where is the fuel pressure regulator location? I keep looking and I can't find it.
View 14 Replies
I have a celica 1.8 st202 that doesn't start. The efi relay and fuse are ok. I tested these and even replaced the relay with another one.
-When I jumper the pins in the diagnose box B+ and FP the engine starts.
-When I remove it the engine won't start.
-When I remove the jumper the fuel pump doesn't get any power.
View 6 Replies
I have a 1989 celica gts. I can hear the motor but my sunroof wont move..it wont open so I dont know how to get in and see what the problem is. Do I start by taking out the headliner?
View 3 Replies
So, I just had the fuel pump replaced on my '15 6.7 a month ago and it just died again. (next day edit: it didn't actually die, it showed all the same symptoms)
Same symptoms: whining sound, low fuel pressure warning, reduced power warning.
This time I'm 50 miles from home so I pulled off the road before it shut off. Interesting, I was in a hilly area and my low fuel warning came on too. We are waiting for a tow. I was considering trying to push on but don't want to get stuck in a dangerous spot on the highway. We're in a church parking lot.
So, last time this happened I was on flat road with about a half tank of fuel on a lunch break. I ran a mile after the warnings came on to feel out the issue and to see what would happen. I happened to be only about a mile away from my dealer so I drove that way. I got reduced power warning and then it cut power on me (limp mode). I made it to about 100 yards away before it cut off.
This time, I was in a hilly area at night on a windy two lane road with no shoulders in the woods. I was miles from civilization and was showing below a quarter tank of fuel. ~100 miles to EMPTY. I got the low fuel pressure warning first and then the reduced power mode before the whining noise started. I was climbing a hill on a curve at the time. I drove a quarter mile and then pulled off the road into a parking lot so I wouldn't be stuck on the shoulder. It didn't actually go into limp mode.
I let it sit a few minutes, talked it over with the wife and decided to call for a tow. After talking to the tow truck driver who said he would be an hour because he had to go find a bigger truck, I decided to see what I could do while I wait. I fired it back up and the fuel level dropped to below 1/8 and I was now showing 33 miles to EMPTY. I was parked on a hill with the back end up. I had backed the truck into a space to make it easier for the tow truck driver. I let it run a minute, checked for leaks and it seemed to run fine with no studdering or additional warning lights.
CEL was on but no new warnings. I put in my code reader and pulled the P0087. Just one code. I revved it a bit to see if there were any issues. It seemed fine so I decided to try my luck. I started driving towards home with the intention to stop at the first diesel station to fill up. Truck ran fine. After two minutes of driving gently, heart racing, my fuel level came back up and it now read 88 miles to EMPTY. I drove 11 miles to the nearest station and filled up. No issues. I shut it down. I fired it back up. Still no issues so with a full tank, I drove home the remaining 30 miles without issue.
Planning to take it in to the dealer Monday to get it checked. Could this be from an air pocked due to low fuel level and hilly terrain? Is my new pump dying already? Is there something else going on inside the tank or elsewhere?
View 14 Replies
I have a 03 explorer sport trac that has no fuel pressure the pump will not run. It is a bew pump just replaced it amd drove 4 miles cut it off filled up with gas now it wont run I replaced the pump again thinking I might have got a bad pump but it still wont run. I've checked the relay and inertia switch I have the 5 pin connector on the fuel pump module. 1 wire has good power to it but the pump won't run...
View 6 Replies
There is a noticeable whining sound coming from the back of my car. I searched and the closest thread I could find talks about whining at speed, but this is happening even at idle. From outside the car it is much louder. It goes away sometimes, but comes back pretty quickly. I restarted the car at a red light and the noise stopped, but by the next light it was back. Seems to be happening at speed, too, although that's harder to hear over the sound of the car.
Pulled codes, and the code P310b keeps coming back, even after cleared. The car has had a dead battery for probably the last 6 weeks, and was restarted two days ago, maybe 100-150 miles since restart, plenty of warm up and cool down cycles, but the code keeps coming back. I never noticed the sound before I let the car sit, and I didn't notice it yesterday while I was driving it around (although maybe I just had the music too loud???)
APR Stage 3, APR LPFP.
1- Does is sound like this could be the low pressure fuel pump?
2- Do I need to be concerned?
View 9 Replies
I have a gas leak at the connection of the High Pressure Fuel Pump and high pressure fuel pipe. Gas drips and sprays out from the nut area (see pic). The car take a several seconds to turn over to start.
What is the most likely cause? The car is out of warranty, so trying to repair myself without having to replace any expensive parts unnecessarily.
View 28 Replies
My 2011 has just over 27K miles on it. On Saturday the Check Engine light came on. The next time I started the car, it cranked over for about 5 seconds before starting, which is unusual. Then multiple times Sunday and this morning, it seemed to take even longer to crank before starting. This morning, it barely would stay running. And there was a lot of hesitation driving down the road.
I scanned it with my OBD II scanner and got P0087 (Fuel Rail/System Pressure Low). I dropped it off at the dealer this morning and jut got a call that they are replacing the High Pressure Fuel Pump. But they had to special order it overnight and probably won't have it replaced for another day after that.
Is the high pressure fuel pump the device sticking out the top of the valve cover on the back, driver side of the valve cover, with the multiple fuel lines going into/out of it?
View 71 Replies
My wife was driving our 08 B6 yesterday and suddenly had a loss of power. Check engine light was on. Took it to the dealer and we heard back today that the high pressure fuel pump had gone out. I had heard of the TDI's having this problem and I know BMW had to do a recall on the same issue. I didn't know that the 2.0 TSI had this problem.
I'm a little bit concerned 'cause we leased the car for 3 years and didn't have a single problem. I thought it was very solid so we decided to buy the car last month Now my confidence in the car is a little bit rattled.
The car is under warranty. I just hope that this is not the kind of thing that's going to go out every 20K miles! Out of warranty, this repair would have been costly.
View 6 Replies
I have an 03 Explorer that had a starting issue. Long story short, it had no fuel pressure. So after testing the relay, I switched out the pump with an Airtex unit . All seemed fine...for a while.
Became hard to start again, checked Schrader valve with the key on, and not running, no pressure. Strange though, it would run.
So got the fuel pressure gauge on it. Turn the key and pressure will go to about 5-10psi and then drop to zero. Turn key off and on again, up to 5-10psi, then drop to zero. Turn the key to start and pressure goes up to 10psi, then starts, then goes to 30 while running and you can drive it around. Shut off motor and pressure goes down to zero.how the sending unit is supposed to hold fuel pressure and not release it? Is there some kind of check valve in the sending unit assembly that can be cleaned or does it need a whole sending unit with another pump? I already spent the $100 for the pump, and it is working if you can drive it!
View 13 Replies
