2010 Corolla LE ... This started today, on the ride home from work. Mid 50 degrees, light rain, driving down straight road it started. Engine light also on. No mods in car. is this something the dealer has to se, or can I bring it to my own mechanic?
View 1 RepliesI just got an oil change, and my maintenance light is flashing when I start up. It has about 36 thousand miles on it. I don't know when the previous oil change was before the one I got two weeks ago.I have read about resetting the maintenance light, but this is my first car and I have only had it for about 8 months, so I don't want to ignore a potential issue here.
View 4 RepliesI have a 2010 Corolla. The car is flashing the infamous VSC Off, trac, engine light! The car is still has the powertrain warranty. I was wondering if I should take it to a Toyota dealership.
But I read just getting the diagnostic itself is around $100. I don't want to end up paying for that if the repairs end up being something that's not even covered under the warranty.
My daughter has a 2011 corolla and when she first cranks the car the maintenance required light flashes a couple of times and goes out. I think last time I changed her oil, it was steady on. What is causing it to flash?
View 6 RepliesDriving home yesterday and my dashboard battery light started flashing intermittently. This morning it came on and won't go off.
So far I have...
1. Tested alternator and battery with a multimeter and the results appear to be within normal ranges.
2. Pulled out the alternator and had it tested. It went through 7 test cycles on the bench and passed all of them.
3. Swapped out the battery with a new one.
4. Checked the charging system fuse.
5. Thoroughly cleaned the battery cables.
6. Cleaned the battery to chassis and engine to chassis ground cables.
The battery light stays on no matter what I do. What am I missing?
I have a 2011 Corolla LE, about 58k miles. The latest work I did was replace the brake pads, rotate the tires and changed the oil a little over 2 weeks ago. Everything was normal so far. Yesterday I drove for about an hour, again everything was fine, but after stopping at a gas station and starting I have several indicator lights come on.
- Slip indicator, flashing
- TRAC OFF, constant
- ABS, flashing
- Electric power steering warning light, flashes but turns off after about 30 seconds.
I tried my OBD scanner with no luck, but figures since there was no Check Engine light.
So driving home today cel came on and vsc started flashing.
The codes I got were pretty out there
P0420 - cat converter (this one I did expect)
B0cc0 ???
C3a32 ???
U0a8e ???
B3e1f ???
I'm wondering if this was poor communications between the unichip and ecu? As for the vsc flashing, people complained about this during rain. It is currently raining. But not certain this is the issue.
My Abs traction control vsc off (keeps flashing) and brake light went on in my 2010 corolla....
View 2 RepliesI replaced my tail lights tonight once finished I clean up my mess and decide to go grab dinner.
Started the car, VSC flashing along with ABS light on... Did I blow a fuse when I turned the car on from the new tails?
So I recently bought a used 2009 Corolla S. It came with the above mentioned JBL system. My issue is this. When I try and load a CD, I get a flashing wait message. I know the player itself is not hot, as mentioned in the owners manual as causing the issue. I tried it last night, got the wait error. Drove it with the A/C on for a couple hours, same issue. Tried first thing this morning, same issue.
My question is this. Is there any sort of way to reset the unit, possibly dis-connecting the battery for a period of time? Or am I best just to set a service appointment and let Toyota deal with it since it is Certified and under warranty?
So today I start my car, I get the check engine on (steady not flashing) and have stability control flashing with my traction control light on. I found out it could be the gas cap not on right so I removed it and screwed it on again, check engine light was still on though. However, after starting the car again after a drive it was gone .
I do turn off stability control sometimes if it's nice out?
So I just bought new wheels, and had them put on. Went from stock 16's to 17's now. After I had them put on there was no issue.
Now after I was driving for about 30 mins, I noticed that the Low Tire Pressure Indicator started flashing for 20-30 seconds, then stayed solid.
And now the indicator has been there ever since. I've tried reinitializing the TPMS but it stlll didn't go away.
What the problem is? still drive-able?
View 14 RepliesOne of my light bulbs for the rear license plate light is out.
what kind of light bulb I need to get?
So I was on my way home i was 2 miles away from my house and my abs light and e-brake light randomly go on. I got home and turned car off and back on and it was still there.
View 14 RepliesSo I bought and installed bc coilovers and my abs light and 2 other lights came on. I did accidently mess up one of the wires on the front left strut but it is not torn in half or anything just sliced into a little. I electrical taped it back together.
View 4 RepliesThis morning I started my car, which was parked on an incline, with the car in gear (manual tranny) without remembering that I had left the car in gear. So, when I started the car, it lurched forward when I took my foot off of the clutch pedal. No big deal. I started the car again, but now the check engine light and abs lights are on steady, and the VCS is blinking. The car drove normal all the way to work. When I got to work, I shut the car off and started it up again, but the 3 warning lights are still on.
Is there a re-set procedure for the lights that happens automatically, or do I have to have someone with a scan tool reset it?
Could there actually be something wrong with the car?
I noticed my tail light isnt working, so I decided to change the bulb. And bought a 7443LL Sylvania bulb from Oreilly. Fits perfectly but noob that hasnt opened a car before. Old bulb is greyish, I guess its blown out or something. I change both bulb because you buy them in pairs. Anyhow, I thought its the bulb is the problem but now its not. Since both break light and tail are of the same bulb but tail light isnt working. So I figured the bulb isn't the culprit. I called a friend and he says its the fuse. Found the fuse, bought and replace the fuse. I turn on the car, tail light is still not working. Check the new fuse, its blown, put another one, the same thing happen. It keeps blowing my tail light fuse everytime I start the car. Im quite sure I got the right 7443, its dual filament bulb (I can see 4 wires at the base and 2 string that would light up for tail and break.
Is there 2 fuse for the tail light, I only found one by the break pedal, its just below the turn signal/hazard relay.
I am trying to change the color of the light on my dash board and center console from the standard orange to a light blue color. I've tried searching the internet looking for any advice but I haven't come across anything for a 2009 Toyota corolla. I understand that some cars need to have the light bulbs soldered and some can you can change out a colored film. Which of these options applies to my car? If it's the light bulb change then what size and how many. Also, how to take out the instrumental cluster.
View 6 RepliesMy wife's 2009 Corolla S has 107,000 miles. Early on it developed a low idle and vibration while stopped at a light. It was idling about 600 rpm after it warmed up. It never stalled but occasionally vibrated. After doing some research I found some were having success cleaning the throttle body and throttle plate. I did that along with changing the spark plugs. At that time I disconnected the battery to reset the computer. She has put about 2,000 miles on it since then and it never idles below 800 rpm. The vibration hasn't been back either.
I believe it was the throttle body/ plate cleaning and disconnecting the battery that resets the computer that fixed it. The plugs still looked good at 105 K miles, but I had new ones so I put them in. I bought a can of Berryman b12 choke & carb cleaner and sprayed a little on the throttle body and plate and then sprayed some on a rag and wiped down the body and plate. It was quite dirty.
So I'm having a problem, which I'm pretty sure is the switch. The traction control light won't turn off no matter how many times I've pressed the button. The orange light is really annoying now and I need to get it fixed. What should I do?
View 1 Replies