Corolla / Matrix 2009-13 :: Change Color Of Light On Dashboard And Center Console From Orange To Light Blue
Jul 24, 2014
I am trying to change the color of the light on my dash board and center console from the standard orange to a light blue color. I've tried searching the internet looking for any advice but I haven't come across anything for a 2009 Toyota corolla. I understand that some cars need to have the light bulbs soldered and some can you can change out a colored film. Which of these options applies to my car? If it's the light bulb change then what size and how many. Also, how to take out the instrumental cluster.
View 6 Replies
Advertisement
2009-10 Toyota corolla hear a lot of noise in the center console below the radio? I know those radio bezels can be noisy along with the area underneath the radio.. The plastic there tends to creak when you go over rough tar roads or uneven bumpy roads. Especially when its hot outside..
Will this be resolved by insulating those area..? Also, when you go over a bumpy road the back of the headliner tends to make a creaking sound..
View 2 Replies
Anyways, I know nothing about cars, so we'll get that out of the way. For the past few months, my 2010 Corolla S has made a weird creaking sound when I drive on the highway - what this could be? It really only happens when I get above 60-65mph, sounds something behind the radio is falling apart.
It has about 50K miles, and I've had it since it was brand new. This has just recently started.
Maybe this is normal, not sure, but my previous car was a 2001 Camry, and it never made any noises like this.
I was planning on taking it to the shop, but I wanted to ask around first, since I replaced my brakes/rotors in January, and just put 4 new tires on the car - a little tired of throwing money at it!
Here's a YouTube clip I filmed the other day : [URL] .....
View 1 Replies
I need to change my rear brakes on my 2010 Matrix. According to my Haynes repair manual, I first need to loosen the hand brake cable which is found under the center console. My problem is, is that I can't figure out how to remove the center console!!! The instructions in the Haynes repair manual for removal of the center console are for 2008 and earlier Matrix models.
View 8 Replies
The radio trim/bezels around the center console and down to the shifter tend to be noisy when its hot outside and the car driven over rough roads. How to insulate these radio bezels with felt or some kind of insulation so the noise is dampened? I think any rough road tends to make them creak and the hooks tend to rub against the plastic..
View 5 Replies
Driving home yesterday and my dashboard battery light started flashing intermittently. This morning it came on and won't go off.
So far I have...
1. Tested alternator and battery with a multimeter and the results appear to be within normal ranges.
2. Pulled out the alternator and had it tested. It went through 7 test cycles on the bench and passed all of them.
3. Swapped out the battery with a new one.
4. Checked the charging system fuse.
5. Thoroughly cleaned the battery cables.
6. Cleaned the battery to chassis and engine to chassis ground cables.
The battery light stays on no matter what I do. What am I missing?
View 2 Replies
I just got an oil change, and my maintenance light is flashing when I start up. It has about 36 thousand miles on it. I don't know when the previous oil change was before the one I got two weeks ago.I have read about resetting the maintenance light, but this is my first car and I have only had it for about 8 months, so I don't want to ignore a potential issue here.
View 4 Replies
After taking my 2009 Corolla S to the dealer on 4/07 for an oil change, about 4 or 5 days later the check engine light, the traction control light, and the VSC light come on (VSC off blinks). The first day it came on, I took it to autozone to look the code up and they said it was P0353 (issue with ignition coil c I think). I immediately afterwards drove to the dealer to see what they would say. But after parking in their garage speaking with the greeters, they said the light wasnt on, and asked if I wanted to wait the 2 hours to see a tech. So I took it home.
The code came back about 3 days later, and this time there was a slight stall/jolt for about 4 or 5 seconds. This occured on startup and not during driving. After the 4 or 5 seconds of the mild jolting it felt like it was running smooth. I took it home and after leaving it off for about 20 minutes, the light went out again. A couple days later it came back and stayed on over night and was still present when I started it the next day. It went off again later that day.
My question is what could be causing this that might be a simple fix. Do toyota techs check anything with the spark plugs during normal Oil Changes? I know they checked my brakes but Im not a car guy and am not really sure all that they do. Could it be a loose spark plug? Code P0353 coming up sporadically after dealer Oil change. Is there any steps they normally do during the oil change that could be causing this, like leaving a spark plug loose after checking them or something? Would the coil / wiring harness fall under an engine warranty?
View 10 Replies
One of my light bulbs for the rear license plate light is out.
what kind of light bulb I need to get?
View 8 Replies
I noticed my tail light isnt working, so I decided to change the bulb. And bought a 7443LL Sylvania bulb from Oreilly. Fits perfectly but noob that hasnt opened a car before. Old bulb is greyish, I guess its blown out or something. I change both bulb because you buy them in pairs. Anyhow, I thought its the bulb is the problem but now its not. Since both break light and tail are of the same bulb but tail light isnt working. So I figured the bulb isn't the culprit. I called a friend and he says its the fuse. Found the fuse, bought and replace the fuse. I turn on the car, tail light is still not working. Check the new fuse, its blown, put another one, the same thing happen. It keeps blowing my tail light fuse everytime I start the car. Im quite sure I got the right 7443, its dual filament bulb (I can see 4 wires at the base and 2 string that would light up for tail and break.
Is there 2 fuse for the tail light, I only found one by the break pedal, its just below the turn signal/hazard relay.
View 4 Replies
My GF recently purchased a used 2009 Corolla LE when a yuppie type with a bad texting habit, rear ended and totaled her last ride.
It is a great little car with excellent handling and performance. We also enjoy the 30mpg's and sub $40 fill ups.
I drove it recently and noticed a knobby tire sound coming from the rear of the car. I rotated the tires to see if the noise moved with the tires and it did not (this was to rule out a cupping tire). I suspected a wheel bearing / hub failing and took it to my mechanic buddy to confirm. He agreed with me as there are really no other moving parts back there other than the brake shoes. I had already taken it down the highway and gently applied the parking brake to rule that out. No change when the parking brake was applied at highway speeds.
Found the hub assy at Rock Auto and it took about 30 minutes to replace. It comes complete with an abs sensor. The hub housing was blue from excessive heat so it was about to seize or fail completely which would have been ugly.
the bearing rides is actually blue from excessive heat.....
View 14 Replies
What the problem is? still drive-able?
View 14 Replies
2010 Corolla LE ... This started today, on the ride home from work. Mid 50 degrees, light rain, driving down straight road it started. Engine light also on. No mods in car. is this something the dealer has to se, or can I bring it to my own mechanic?
View 1 Replies
At night, when I turn the key to "on". The stereo light (orange)'s illuminated but no light coming from the dashboard. Other lights on the dashboard -- e.g. engine check, oil, door indicators are fine. When I start the car, the stereo light's gone away and I still have no dashboard lights. I tried to change the channel, put in a CD, increase/decrease volumes but none of those activated the light. All other functionalities seem to be working fine.
I checked the fuse box under the dashboard console. All fuses look good to me. What might be going on or I just simply have bad dashboard light bulbs? What's about the stereo lights?
View 1 Replies
I own a 2010 Toyota Corolla. Approximately 1 month ago I noticed green colored drops on the dashboard and on the windshield (inside). The car is still in warranty. I took it to the dealer, but they could not find where this liquid is coming from.
View 10 Replies
I am a two Corolla owner. I have a 2004 with 205, 000 kms and a 2010 with 70,000 kms. By far, my favourite car to drive is the 2004. The build quality is by far better. I could list other issues or pt peeves of mine about the 2010.
My 2010 is giving me some issues.
For starters my seat and console squeak like crazy. About 10, 000 kms ago I had the dealer try to deal with it under a TBS.
The next issue I have is that when I turn my steering wheel I hear a low pinging noise!
Lastly, in my trunk that plastic pieces that hold the trunk latch cable to the trunk arm have broken.
As for those plastic pieces in the trunk, what the part numbers might be?
View 14 Replies
I have a 2013 Corolla with full synthetic (0W-20). The dealer states this type of oil is only changed every 10k miles. I'm used to changing my oil every 3500-5000 mi. I'm not too keen on their recommendations but $70 for an oil change outside of the Toyota Care package is a little steep.
View 14 Replies
So I was on my way home i was 2 miles away from my house and my abs light and e-brake light randomly go on. I got home and turned car off and back on and it was still there.
View 14 Replies
So I bought and installed bc coilovers and my abs light and 2 other lights came on. I did accidently mess up one of the wires on the front left strut but it is not torn in half or anything just sliced into a little. I electrical taped it back together.
View 4 Replies
This morning I started my car, which was parked on an incline, with the car in gear (manual tranny) without remembering that I had left the car in gear. So, when I started the car, it lurched forward when I took my foot off of the clutch pedal. No big deal. I started the car again, but now the check engine light and abs lights are on steady, and the VCS is blinking. The car drove normal all the way to work. When I got to work, I shut the car off and started it up again, but the 3 warning lights are still on.
Is there a re-set procedure for the lights that happens automatically, or do I have to have someone with a scan tool reset it?
Could there actually be something wrong with the car?
View 7 Replies
I am going to change the coolant in my 2009 corolla 1.8L. The service manual instructions tell me to open the "cylinder block drain cock plug" and I can't find it. The picture in the manual is not very clear, but it points to a spot on the engine just above the throttle body.
View 9 Replies
