Crown Victoria :: 2003 Hesitation Occasionally On Highway At Speeds Over 45 Mph At Freezing Temp


Jan 12, 2016

I have a 2003 Ford crown Victoria with 137,000km (85,000 miles) which is in good condition overall. It runs well in the city and highway with few problems. I have noticed 1 issue with this car that is consistent. When it is snowing and below freezing it will hesitate occasionally on the highway at speeds over 45 mph. It does not put out any codes. I have sprayed the ignition wires with no change. I have not changed any ignition parts. I did over 500 miles on the highway this weekend in moderate rain with no trouble at all at temperatures around freezing. Today was snowing and below freezing with same problem on highway with occasional hesitation. In the city today with traction problems and tires spinning the ABS and Brake light came on. They were out when I drove it home.

View 3 Replies

Advertisement

Ford Crown Victoria :: AC / Heater Blow Room Temp Only

I have a 2007 PI and recently lost heat and ac. All the controls do what they are supposed to do but both heat and ac blow room temp only. Fuses and relays are all good. Is this a blend door actuator problem? This is my guess and I'm basing the next question on a yes answer. Is it possible to access the actuator by making an eightXfour hole in the top of the dash above the radio. I would prefer not to have to pull the dash out of the way since everything else works good.

View 1 Replies

Crown Victoria :: 1999 Ford - Temp Gauge Hardly Moves (up) And Heater Blows Warm Air Only

Ford crown vic, 1999, 125k miles, no engine work has been done, did flush cooling system in spring of 2013 and put in a 50/50 mix of coolant and distilled water (from a jug). No problems for the summer of 2013, have been using heater with no problems until around Tuesday of this week.

Car runs fine, no leaks, coolant checks out good. BUT now.. My temperature gauge hardly moves (up) and the heater blows warm air only. If I am driving the gauge will not move, if the car sits running for awhile it will move up some and the heat will get warmer inside of the car. My guess maybe a stuck thermostat?

View 3 Replies

Crown Victoria :: 1999 Cranks But No Start

100,000 miles new fuel pump three months ago all filters changed, new spark plugs and coils. Parked car for the evening next morning would crank no start. It would start when the fuel pump primed, now the fuel pump does not prime, I get no check engine light in the on position and no check engine light when car is cranking.

View 1 Replies

Crown Victoria :: 1997 - Low Clicking Sound Once Keys Taken Out Of Ignition

I was driving home and i turned off my car as soon as i put it in park. Came back down two minutes later and it wont turn over or try to start. It makes a weird low clicking sound once the keys are taken out of the ignition.

View 1 Replies

Crown Victoria :: 98 LX - Engine Surging At Idle When Heating / Air Controls Are In Use

I have a 1998 Crown Vic Lx with 66,000 miles on it. We bought the car about 2 years ago and at that time it had only 32,000 original miles and looked like it had just rolled off the showroom floor. The car was well maintained and we have kept it that way. Over the last few months we have started to have a problem with the engine surging at idle when the Heating/air controls are in use. It's like the engine tries to die and then comes back up and it happens about every 5 seconds. It stops when the control is cut off. The fan speed control has no effect,just the main control.

View 2 Replies

Crown Victoria :: 1999 - Windshield Wiper Only Works On High

99 crown Vic windshield wipers only works on high. What could cause this?

View 4 Replies

Crown Victoria :: 1996 Interceptor Wheels Skip When Taking Off

I have a 96' Interceptor. Recently, it feels like the back tires are sticking/skipping when I take off. I haven't noticed it doing that when I have it in reverse though. Sometimes it's hardly noticeable and other times it's fairly violent. I think it gets worse the more stops I make but I've parked it for now so there is no way to test that theory.

View 2 Replies

Ford - Crown Victoria :: Blower Fan Does Not Turn Off - Came On High All Times

I have a 2003 Crown Victoria. Within the last year, I changed blower fan resistor (or Blower fan control module) and repaired the Electronic Climate Control Module (the thing inside the cabin that controls A/C, heat, defrost and fan speed). Today, while I was driving, the blower fan came on high and would not stop. The weather was mild, so I did not have the A/C or heat on at the time. I tried pressing various buttons to make it stop, but it was running at high and wouldn't stop. The only way to make it stop was to turn off the engine. When I turn the engine back on, the blower fan was on high again.

What could possibly be wrong with the car? I recently changed the blower fan resistor, so that is unlikely to be the culprit. Even if it is, why wouldn't it shut off? Other people with a bad blower fan resistor say that the speed control is stuck on high, but the fan can be turned on and off.

Could it be the electronic climate control module inside the cabin? After all, it is the unit that tells the blower fan to go on. Air could be directed to defrost, vent and floor without any problem.

What do you think is making the fan stay on at HIGH and does not turn off?

View 16 Replies

Ford Crown Victoria :: 2010 - Heater Stopped Blowing

It worked fine and then just stopped blowing on any speed. The #303 relay was swapped with another and made no difference. The #101 40 amp fuse checks good. The blower fuse under the dash checks good too. The actuator moves the flapper door as it should.I suppose it could be the switch, but that requires some dismantlement of the dash. When a blower relay goes bad, it will usually allow (in fact cause) the blower to go only on high If it doesn't blow at all, can that still be the cause?

View 19 Replies

Crown Victoria :: 2000 - Disable Ignition For Crank Test?

When I was a mechanic in the 1980's it was easy to disable a car's ignition to do starter crank or compression tests, just pull the distributor lead wire in the center of the dist. cap.

I have a 2000 vintage 4.6 engine and was wondering the easy way to knock out the ignition to do crank tests, etc. This engine has all the modules resting independently on each spark plug, so no central distributor cap to get to. Is there an easy way, and does it work for Chrysler and GM cars too?

View 3 Replies

Crown Victoria :: 95 - Water Leaks Into The Back Seat Every Time In Rain

I have 95 Crown Victoria and every time it rains water leaks into the back seat so I checked the condencer drain and it was not clogged ...

View 2 Replies

Crown Victoria :: 1995 Ford - Unintended Acceleration And Slow Start

My husband and I bought a 1995 Ford Crown Victoria not too long ago. We have already had to replace the brake lines 2 times (well, first the front and then a few weeks later the back). It has had nothing but problems. One thing is the air conditioner, but that probably just needs charged.

Now on to the bigger problems. All of a sudden we started having unintended acceleration. It is strong enough that if you don't have the brake pressed hard it will move your car forward every 5 seconds. The engine revs up on its own. This happens every time we stop anywhere. Including when I was pulling into a parking spot last night. I went very slow and as I was turning pressing on the brake it revved up and I thought for sure the way it jerked, it was going to go over the curb into the road. This scares the crap out of me.

Also, we have a problem with the slow (very slow) start. I know they had a recall on the cruise control, but I have not heard of any recalls on this. However, I did read somewhere about accidents happening due to this and something about it had to do with the way Ford build the car.

View 1 Replies

Crown Victoria :: 2009 - Rear Doors Don't Open From Inside / Windows Won't Roll Down

I have just purchased a 2009 Ford Crown Vic Interceptor a few weeks ago. One of the few things I would like to fix is the rear doors. I want to have people in the back have the ability to roll down their own windows and open their own doors. I have plugged the wires, that were in the armrest back into the button but still doesn't work. I am assuming the fuse might also be missing from the fuse box but I have not looked yet and when looking through the owners manual I could figure out which fuse it would have been or its place.

The other issue with the doors is people getting out on their own rather than me feeling like their limo driver or something... Iss there a kit I can buy to get the doors in full working order? If I take it into a ford dealership will/can they fix it?

View 7 Replies

Elantra HD (2006-10) :: 2008 - Downshifting Occasionally At Highway Speeds

Have a 2008 Elantra GLS with 63K miles. A/T was serviced by dealer at 51K. Car now occasionally downshifts from 4th to 3rd when driving between 60 and 70 mph. Happens only when trans is hot (after 2-3 hours on hiway). When it occurs, it searches for the right gear, going back and forth from 3rd to 4th for several minutes before returning to normal. One thing odd is if I shut the car off for 5 minutes after it occurs, it runs fine afterwards. Do I need an ECU update or do I have a A/T problem?

View 11 Replies

Ford F-150 - 1997-2003 :: 1998 - Shudder / Hesitation At Certain Speeds

Just bought a 1998 5.4l F-150 Lariat. 136,000 miles.

Question about the overdrive button on trans handle. When I push the button, I don't see any light turn on (or off) and I don't feel any change in the gear ratio or increase/decrease in rpm's. I assume since the button in there marked "overdrive" that the vehicle in fact was equipped with it. Could it be a bad button, fuse, or ?

Also, it just started the shudder/hesitation at certain speeds that I see a lot on these threads. Seems like that is a coil issue as the description in many threads is exactly what I am experiencing to incl the rotten egg/fuel odor. However, it started the same day (not same time, later same day) I decided to push the overdrive button while checking out all the things on the truck.

View 1 Replies

Toyota - Camrysolara :: 2001 V6 Won't Start When Temp Gets Below Freezing

I have a 2001 Toyota Solara Convertible, V6, low mileage (92,000), and it will reliably NOT start when the temperature gets below freezing. I have tried a couple of tank fulls of injector cleaner on advice from a friend, but no success. Once the temp falls below freezing overnight, the engine cranks but never catches. Once the temp is above freezing for a few hours, it fires up fine.

View 9 Replies

Prius V :: 2014 - Windshield Washer Nozzle Freezing If Temp Is +20F Or Less

The windshield washers of 2014 Prius v (lowercase v for the Prius v) didn't work all winter if the temp was +20F or less. I'm using -30F or -40F washer fluid. I use the same fluid in my 1995 Previa, and its washers worked all winter. A friend has a 2014 Prius, which didn't have any washer problems.

I tried pouring warm water over the nozzles, but they're location makes it difficult to reach them. Is it the nozzles or is it the rubber hose that feeds them from the reservoir?

View 12 Replies

Lexus - Doors - Noises :: RX450h SUV Rattles Only When Temp Around Freezing

2010 Lexus Rx450h... Rattles in the morning, only when really cold. (Around freezing?). Somewhere in or near the passenger side door, or the air vent by that door. It gets quiet(er) after warmup. Car has been at the dealer for a week... They can't find it; they want to pack in additional insulation. That hardly sounds like a sound solution.

View 2 Replies

Chevrolet - Silverado :: Starter Solenoid Not Engaging Below Freezing Temp

1996 SILVERADO TRUCK. Starter solenoid doesn't engage when temperature is below freezing....

View 11 Replies

Santa FE SM (2001-06) :: Windshield Washer Not Working In Freezing Temp?

When the temperature drops below about 30 degrees f, the windshield washer won't spray. I am using washer fluid so I don't think that it is freeing or that there is any water in the lines. I read somewhere that this might be a defective motor, part number 98510-26100.

View 1 Replies





Copyrights 2005-15 www.bigresource.org, All rights reserved