When i try to turn on my car it cranks but it doe not start. It starts when i pump the gas pedal multiple times but when i let go of the gas it just dies. i have used a scanner to find any codes but no codes come outs.
View 13 RepliesI got a caprice 94 l99 it was driving perfect. i was on my way home then it started to put put then the engine cut. gave it like 3 mins it started drove 1 block started to put then the engine cut. now doesnt start at all just cranks the gas gauge says it has 1/4 tank of gas.
View 5 RepliesThe car cranks but doesn't start. I checked the fuel pump fuse & its OK. I sprayed carb cleaner in the intake & it started for about 2 seconds. What some of the possible causes?
View 5 RepliesI've got a Mk4 Golf 2.0L with 136k on the clock. Hasn't really given me any problems in the past year of ownership till now. I recently picked her up from the shop for a rear axle beam replacement. When I picked her up she drove fine. I headed to class for the day and she sat in a parking lot for 6 hours or so. I hop in and try to fire her up and nothing. Had to have her towed back to my apartments. I've checked fuses, spark plugs were recently replaced but I am getting no spark. When I crank it I do hear the fuel pump and I can smell gas when I crank it. The rpms go up just a bit, 100-200 range. Going to check out the crankshaft sensor later on. maybe it could be the coil pack as well? I don't know a huge amount about these cars, only some info. And I sadly have no access to a scanner to check for codes.
View 2 RepliesMy 2002 Elantra GLS seems to have some sort of heat related problem.
I live in Arizona, where temperatures routinely reach well over 100. In the morning my car will start fine, after driving it for some time and parking somewhere, if I try and start the car within a couple hours of driving it, it will crank but not start. Lifting the hood to cool it seems to expedite this to get it started.
I had a mechanic friend of mine hook up his OBD computer at his shop, nothing out of the ordinary. He suspected either a crankshaft or camshaft position sensor. No check engine light, nothing out of the ordinary on his computer check. I removed spark plug wires for cylinders 1 and 4 and I have spark while cranking when it fails to start. My mechanic friend said the spark would rule out a faulty crankshaft position sensor. I have also tried spraying starting fluid into the intake manifold, and it has no effect. The battery has been replaced within the last two months, connectors are new as well.
I have a 2001 mustang convertible in good cond. A 6cly that I have had very little trouble with over the past year. I put in a new battery then, just after I bought it from a dealer. The dealer had gone over it with fluids etc. and I had a friend look it over when I bought it. He said it was very clean and a good buy. So, last week I started having trouble starting it in the morning. It would crank but would not fire. I turned the key off, and then tried again, Same result, cranks but doesn't start. I turned it off again and being worried about draining the battery, I turned everything off, radio, heat and fan, lights. Then I tried to start it again and, it started. I'm thinking I need new plugs, but I ignored the problem and went to work.
A couple days later I was leaving the grocery store, turned the key and same thing again, cranks but doesn't fire. I knew what to do. Turned off everything and tried it again, it started. Ok, so now some repair, possible plugs, is on my priority list. I need to get this fixed before the bad winter weather comes. Yesterday, after a long day at work, I was ready to go home and I it happened again. This time it's terminal. No matter what I did I couldn't get it to fire. This morning it's sitting in the office parking lot and I need to deal with this today.
Could be plugs, could be the fuel pump. Before I call the dealer and pay 4x what I should for this, what do you think it could be? 3.8 6cly. The car is sitting on a slight incline, in the parking lot. Gravity pulls fuel from the engine to the gas tank, if a fuel pump is going bad this could be why I can't get it to start. I'm going to roll it to a level area and hit it with starting fluid to determine if the pump is bad. I'll also pull a couple plugs.
I have a 2009 Corolla 1.8L. It turns over but won't start. I don't hear the fuel pump when I turn the key on or when I try to start it. There are 3 EFI fuses, and all of them are good. There doesn't seem to be an EFI relay (correct me if I'm wrong). I've replaced the fuel pump and it still won't start.
View 10 RepliesHave a 2002 malibu base 3.1 v6 that will not start. Battery charged, motor cranks, pump pumps 52psi at the rail, pink wire to injectors has 12v, fuses good, injectors click when jumped manually but not when starting. CPM is not grounding the six individual injectors to open nozzles. Bad CPM or is there another sensor I should look at?
View 14 RepliesI have a 03 xc90 t6 came out of work the other day and it wouldn't start replaced spark plugs, both cam sensors, crank sensor. After doing all that it sounds like it wants to fire now but doesnt.
View 1 RepliesI've got a 1998 Jeep Cherokee Sport 4x4, 4.0 L I6, automatic, 169k miles, that often cranks but doesn't start up. When I cut the power and try again, it starts up right away. I'm concerned this workaround will one day not work and I'll be left stranded, so I'd like to fix this if it's cheap and easy. The symptoms suggest either a lack of fuel or lack of spark due to an electrical problem, so I replaced the ASD (auto shutdown) and Fuel Pump relays, but they made no difference. The other two relays - Starter and Cooling Fan - seemed irrelevant. What this could be? Maybe the crank angle sensor? (I'm not even sure where that's located.)
View 4 RepliesI have a 2002 Dakota 5.9l r/t. Always started and ran fine. It sat most of the winter approx 2 months. Now will not start but cranks/turns. Has new battery, newer full tune up and tried starting fluid.
View 2 RepliesI have a problem with my Durango whenever i drive my car it is fine and normal. When i get to where I am at and i try to start my car again it will just turn over like it wants to start but doesnt. I just recently started driving the car for about 4 days ago and it drove fine. Until yesterday i got to my shop and tried to start it.. it will just crank. I scanned it and it turned out i had a bad crankshaft sensor. I gone ahead and replace that and the car starts up fine. I drove it around town and then this morning drove it to work and when i tried to leave for lunch it did the same thing. It cranks but does not fire up. I scanned it.. and no codes. My dad was saying something like sometimes it has sparks going to the crank and sometimes it doesn't.
View 2 RepliesThe car cranks absolutely 100%, in no way is this the battery, it just will not start. Then I noticed the fuel pump wasn't shutting off, I only had a quarter tank in the car, I figured as hot as it was today I was getting some vapor lock with the fuel. Went and got some gas, still wouldn't start, then the dash started yelling at me telling me I have no oil pressure, shut off the car.........car you are not running calm down. So then there's that along with the car not starting. I took the fuel hose off to make sure I was getting fuel, I was, so I took the key back out, but the car would not give up, the fuel pump kept going and the dash was blinking violently. When I put the hose back on and got compression it finally stopped, that can't be how the cars work can it? The fuel pump doesn't shut off if there's no compression? Checked all fuses and the fuel pump relay, every was fine, the fuel pump even still ran with the relay out. What could be going on, I can't seem to find one damn thing even related to the fuel pump not shutting off.
View 24 RepliesMy 01 Jetta 2.0 started having issues a few days ago. The engine would crank, but wouldn't start. Wait a few minutes and it would start right up. I go to start it the next day and it would crank, but not start at all. I pulled the P0322 code and replaced the crankshaft sensor along with a new fuel pump, and spark plugs just to be safe.
Next, I checked for fuel and spark, which I have both. The car still won't start and seems to lose a charge on the battery pretty quick. At this point, there are no codes showing up. Could the engine be flooded from trying to start it so much?
I have a 2003 Ford Ranger 4X4 4L AUTO. About once every 6 months it will not start. It cranks just fine but doesn't fire. After about 45 min. it start and runs great for an other 6 Months. I have replace the plugs, wires, distributor cap but it hasn't solved the problem. It has had this problem when it is cold and warmed up.
View 4 RepliesMy 2001 Accent GS (1.6L DOHC) wouldn't restart after a short 2 mile trip to a local store. The engine cranks fine but doesn't fire.
It has had a CEL issue for awhile and after it wouldn't start I checked the codes and got:
303
335
722
I replaced the Crank Position Sensor and Fuel Filter but it still just turns over.
I hear the fuel pump run when I turn the key on and I broke the fuel line and it is Pressurized, so I doubt it is a fuel issue.
The 722 code indicates the output speed sensor has an issue. Need to know definitively if that sensor is completely shot could this prevent the ECU from firing the engine?
I have had this car since it was brand new and I'd like to keep it going a little longer.
Went to the store came home no problems. Went out to go to work next morning truck won't start. Cranks just fine just doesn't try to run. Was not getting voltage at ficm replaced board in ficm have correct voltage now but still won't start
View 2 RepliesCan oil leak out of Intake Manifold? i have Oil around lower intake manifold gasket. is this serious issue?
View 11 RepliesI have a 2007 Dodge Charger. The heat blows out warm air. I have replaced the water pump and thermostat. When accelerating the vehicle, the heat turns to hot. Is this normal, perhaps a speical feature? I have 66,000 miles.
View 9 RepliesI have a 2007 Dodge Charger. Battery light came on, I had AAA come out to me to test everything because I didn't want to be stranded just in case the car died while I was out doing errands.
I forget the name, but he connects it to the battery. It tested the alternator, battery and the starter. Turns out, the alternator had an open diode. Battery was in good shape and the starter too.
I ordered a battery, and had to wait to get it installed because my mechanic was busy working on a whole bunch of other cars. So I had to use the whining alternator for a whole week before I could get the new one in.
But he got it installed. And put everything back together where it should be (I think). He told me to start the car. It started up beautifully! No troubles at all.
A couple days later, it started to struggle cranking to start. Taking into account the battery and starter are good and the alternator is like-new (refurbished). I do not understand why it's having issues.
There's no battery light on. Why would it, a couple days later, start having an issue? Could my mechanic have not fully connected wires to the alternator? When loosening the idle arm to loosen the belt, could the have messed with the timing?
My dodge charger 3.5L 2007 model have heater problem, The heat blows out cold air.
View 18 Replies