Durango :: 2000 / 5.7L Runs Fine But Doesn't Want To Start Again - Cranks But Does Not Fire Up
Jan 20, 2012
I have a problem with my Durango whenever i drive my car it is fine and normal. When i get to where I am at and i try to start my car again it will just turn over like it wants to start but doesnt. I just recently started driving the car for about 4 days ago and it drove fine. Until yesterday i got to my shop and tried to start it.. it will just crank. I scanned it and it turned out i had a bad crankshaft sensor. I gone ahead and replace that and the car starts up fine. I drove it around town and then this morning drove it to work and when i tried to leave for lunch it did the same thing. It cranks but does not fire up. I scanned it.. and no codes. My dad was saying something like sometimes it has sparks going to the crank and sometimes it doesn't.
View 2 Replies
Advertisement
My 2001 Accent GS (1.6L DOHC) wouldn't restart after a short 2 mile trip to a local store. The engine cranks fine but doesn't fire.
It has had a CEL issue for awhile and after it wouldn't start I checked the codes and got:
303
335
722
I replaced the Crank Position Sensor and Fuel Filter but it still just turns over.
I hear the fuel pump run when I turn the key on and I broke the fuel line and it is Pressurized, so I doubt it is a fuel issue.
The 722 code indicates the output speed sensor has an issue. Need to know definitively if that sensor is completely shot could this prevent the ECU from firing the engine?
I have had this car since it was brand new and I'd like to keep it going a little longer.
View 5 Replies
I have a 2003 Ford Ranger 4X4 4L AUTO. About once every 6 months it will not start. It cranks just fine but doesn't fire. After about 45 min. it start and runs great for an other 6 Months. I have replace the plugs, wires, distributor cap but it hasn't solved the problem. It has had this problem when it is cold and warmed up.
View 4 Replies
About a month ago my 2002 accent started intermittently turning on. The car cranks nice and strong when it doesn't start-(until the battery loses too much power from repeated cranking). When it does start, it happens instantaneous, no issues no hard start.
I have talked to multiple people with varying amounts of automotive experience, who have given many things to try.
Things I've replaced or tested, hoping they were an issue:
-Starter and relay
-Fuel pump and filter, as well as relay for pump.
-Battery, post connectors and wires to starter
-Alternator and belt
-Multimeter tested fuel injectors and ran fuel system cleaner for last 3 fill ups
-Replaced spark plugs and wires
-Ran fuel line antifreeze every 2 tanks or so
Things I've been told might contribute to the intermittent starting, but haven't looked into
-Inconsistent fuel pressure
-water in the fuel tank
-Bad ignition switch
-MAF sensor
I live in area, currently in the icy grip of winter. I thought the cold would be a huge contributing factor, but alas, when the car has fired up the temperature has ranged from 1 to -32 degrees and has no issues starting in the deep cold.
View 9 Replies
I have a 2003 Silverado 1500 V6 vin code x with 260000 miles, for about a week now in the morning when its damp out or when it has rained the truck won't start, it cranks fine but will not fire. once it sits for a few hours and everything drys up it fires right up with the first turn of the key.
View 3 Replies
My girlfriend has a 2003 f150 4.6lt pick up its a great truck most of the time. Problem is when the temp gets in the neg double digits it becomes very hard to start it cranks fine but doesnt want to fire. When it does fire it might stall a few times before it stays running. The last cold snap we had I replaced the battery and in the summer the starter got changed. I have heard that this model of truck are known for hard cold starts. I am just wondering if this is true and any other thing besides block heater. It is strange that my 89 gm pickup will start no matter what temp and I'm having problems with the newer truck.
View 1 Replies
I have a 2001 mustang convertible in good cond. A 6cly that I have had very little trouble with over the past year. I put in a new battery then, just after I bought it from a dealer. The dealer had gone over it with fluids etc. and I had a friend look it over when I bought it. He said it was very clean and a good buy. So, last week I started having trouble starting it in the morning. It would crank but would not fire. I turned the key off, and then tried again, Same result, cranks but doesn't start. I turned it off again and being worried about draining the battery, I turned everything off, radio, heat and fan, lights. Then I tried to start it again and, it started. I'm thinking I need new plugs, but I ignored the problem and went to work.
A couple days later I was leaving the grocery store, turned the key and same thing again, cranks but doesn't fire. I knew what to do. Turned off everything and tried it again, it started. Ok, so now some repair, possible plugs, is on my priority list. I need to get this fixed before the bad winter weather comes. Yesterday, after a long day at work, I was ready to go home and I it happened again. This time it's terminal. No matter what I did I couldn't get it to fire. This morning it's sitting in the office parking lot and I need to deal with this today.
Could be plugs, could be the fuel pump. Before I call the dealer and pay 4x what I should for this, what do you think it could be? 3.8 6cly. The car is sitting on a slight incline, in the parking lot. Gravity pulls fuel from the engine to the gas tank, if a fuel pump is going bad this could be why I can't get it to start. I'm going to roll it to a level area and hit it with starting fluid to determine if the pump is bad. I'll also pull a couple plugs.
View 18 Replies
I have a 03 xc90 t6 came out of work the other day and it wouldn't start replaced spark plugs, both cam sensors, crank sensor. After doing all that it sounds like it wants to fire now but doesnt.
View 1 Replies
My dad has a 99 F250 with a no start issue. Everything was starting and running fine one day. The next he gets a no start. Cranks fast and fine but wont fire up and start. He has a scangaugeII hooked up to it and his oil pressures and volts look fine. His tach moves when he is trying to start it. He checked the icp sensor and it had oil through it so he replaced it with a Ford part. Unplugged it and the scangauge pressure goes up but no start. He also replaced the ipr with a new Ford one just in case. He checked and is getting low pressure and high pressure oil.
I am having him check the fuel heater fuse #22 to make sure it is not blown. He had the block heater plugged in all night along with a battery charger to make sure they are topped off as well. We have gone through a couple of the checklists on this site for a no start condition but nothing has solved it yet. I think he is sitting at about 200k on the motor. No major issues or problems until now. He is currently also pulling the ICM to check it out as well. No codes are being thrown.
View 14 Replies
Will not start. Engine turns over fine. Have electric to lights, radio, everything but the fuel pump, coil and fuel gauge. Ignition switch and fuel pump check out okay. Checked fuses, okay. Vehicle has an add on after market remote start/security system, has been working fine for years.
View 1 Replies
The car cranks absolutely 100%, in no way is this the battery, it just will not start. Then I noticed the fuel pump wasn't shutting off, I only had a quarter tank in the car, I figured as hot as it was today I was getting some vapor lock with the fuel. Went and got some gas, still wouldn't start, then the dash started yelling at me telling me I have no oil pressure, shut off the car.........car you are not running calm down. So then there's that along with the car not starting. I took the fuel hose off to make sure I was getting fuel, I was, so I took the key back out, but the car would not give up, the fuel pump kept going and the dash was blinking violently. When I put the hose back on and got compression it finally stopped, that can't be how the cars work can it? The fuel pump doesn't shut off if there's no compression? Checked all fuses and the fuel pump relay, every was fine, the fuel pump even still ran with the relay out. What could be going on, I can't seem to find one damn thing even related to the fuel pump not shutting off.
View 24 Replies
Went to the store came home no problems. Went out to go to work next morning truck won't start. Cranks just fine just doesn't try to run. Was not getting voltage at ficm replaced board in ficm have correct voltage now but still won't start
View 2 Replies
1998 Dodge Durango, runs fine when cold, but when it warms up, the transmission will lock up going down the road(scary to say the least).
View 4 Replies
2000 ford f150 4.6 auto. Will spin over but won't start. checked coil for fire, no fire. Check fuel rail for fuel, no fuel. No theft light flashing and no check engine light on. Has new battery and plenty of fuel in tank. Started fine yesterday but not today.
View 5 Replies
I have a 1995 ranger with a 4.0 it cranks just fine wont fire has alot of fuel spark it will crank and crack then it stop and acts like it is going to fire up and stops cranking... This thing has 253k on it...
View 4 Replies
I recently caught up on some maintenance with my truck, changed the turbo pedestal seals, replaced both batteries, brakes, e-brake cable etc and installed new 10k hid headlights. its a single cab 250 with a 7.3 and zf6 4x4 with 133k. a couple days ago I turned on the headlights and the truck died, restarted no problem and would die the next 5 times I tried to turn them on, then it worked fine. yesterday I got in my truck to leave for work and got no wait to start light, no glow plug chatter, no fuel pump running. turns over just fine but no fire.
I got a ride to work and tried it when I got home, fired right up. I pulled the pCM, checked it out, no weird smells and my TS chip wasn't corroded or anything like that, worked fine. drove to 711 to get a 6 pack and it did the headlight thing again. I removed the HIDs because this all started after I installed them and reinstalled my silvanias and it didn't die when I turned them on. this morning went to leave for work, same no start condition. I disconnected both batteries for 30 seconds to reset anything and same problem. I was about ready to light it on fire this morning.
View 1 Replies
Friends truck, 06 with 135k. Problem he's having is, truck cranks over fine but doesn't fire, if he kick starts it, it fires right up. Haven't had the chance to put my AE on it, figured I throw it out there.
View 7 Replies
96 sebring 2.5l v6 non-convertibleRan terribly for 12 blocks when I bought it, then died and wouldn't start.Bought it because friend said that mechanic had told him it just needed the head gasket changedReplaced the head gasket then it would crank but not start
checked, getting spark and compression on all 6 cylindersreplaced:-ecm-crank position sensor-combination distributor/camshaft position sensor/coil-flushed fuel system and replaced gas. checked everywhere for possibly misconnected wires and possible misconnected vacuum tubes, they are all triple checked ok. Checked the timing about a dozen times. Checked for misaligned timing sprockets, all ok, no sheared keyways, valves open and close at appropriate times / correct order and crankshaft timing mark matches cyl 1 position.
Fuel pressure is great.Turns over but doesn't fire at all.
View 1 Replies
Sometimes my Bravada won't start. It cranks good (new battery) and I can hear the fuel pump , but it doesn't fire up. I just got it back from the repair shop.?
View 4 Replies
My hyundai accent 2004 standard doesn't start. The engine crank, but there's no fire. I change the camshaft and crankshaft sensor. Also change my timing belt, my alternator, my starter, my control box and my computer. But if I pull the car with my pickup, it runs. While the engine is running, the computer doesn't give me any diagnostic code. I also check my fuse, relay,... Even jump start the starter to check if it was the switch.
View 4 Replies
My daughter's 1998 Saturn S-series will not start. It will turn over fine but will not fire until I shoot some starter fluid down the intake. Then it fires up and runs fine. It consistently will not crank unless I shoot the starter fluid to it. I can hear the fuel pump prime up when I turn the switch on. The Saturn dealer says it may be the ECM but I have my doubts. The ECM will cost my $800 from Saturn.
View 14 Replies
