Our 18 yr old grandson has a 1998 Dodge Ram pickup that dies when he turns. Was told that
1) either the wiring harness to the oil pressure sensor is rubbing OR
2) the oil pressure sensor needs to be replaced -
QUESTION: Where is this located? Is it hard / expensive to replace?
It sounds like oil pressure sending units are an issue for these trucks.. where is it located? 1998 dodge ram 5.2 L ...
View 4 RepliesMy 2005 Dodge Ram (53,000 miles) will sometimes die while I'm making a left turn, or when I'm moving slowly in a parking lot.I get the oil change regularly and asked my mechanic to checkinto it. He. thought it has something to do with using cheaper gas, so I started buying the more expensive gas but it is still doing it. This is scary when it happens because not only do I suddenly slow down, but the power steering goes out and I have to muscle it around the turn.
View 1 RepliesMy in-dash sensor is going off, beeping three times, flashing for three more, then off. Oil level is fine. I am unsure about how to check oil pressure, and am interested in determining if the sensor is bad. How do I go about doing this? (1.8T, 1999).....
View 4 Repliesi need to know what locations are these sensors at bank 1 sensor 1 and bank 2 sensor 1 what i`m asking is it at the front of the engine or the rear its a 2.7 liter engine.
View 1 RepliesWhere the oil pressure sensor is located on a 2013 F150 with the V8 is located?
View 3 RepliesI'm looking to use a 5V location for the Dash Boss fuel pressure sensor. I know most of the sensors (except the CMP & CKP sensors) use a 5V reference voltage. Which one to use? AIT & EBP are close to the sensor mounting location.
View 14 Replies'91 Toyota 2wd Pickup, 22R-E Engine. 1 yr. ago out of the blue it would start and idle, but if I give it any gas it would die. Shop had trouble figuring it out, then replaced Mass Airflow Sensor; problem re-occurred after once after this repair, but could not be reproduced at shop. 1 yr. later, driving along and engine quits without any warning. Very hard to start, but restarts once, drives about one more block, dies. Unable to restart; engine will crank and catch, but after about 1 second dies. Tried unplugging Mass Airflow Sensor; no change. Left sitting overnight, next morning it starts right up. Problem seems similar to a year ago, though this time it wouldn't start and idle, it would just start and immediately die. In every instance it was rainy/slushy and cold.
View 8 RepliesI have a 96 Dodge Ram 1500 4x4 5.2L pickup that wont start. I have replaced fuses, starter, ignition switch, tumbler. it still wont run. i can craw under it with 2 screwdriver and start it by touching hot wire and trigger wire. I have hooked it to a diagnostics machine and it said idle air was bad and I replaced that too...
View 2 RepliesI have a 79 toyota pick up, that will not run. the engine turns but does not start. It has spark, though not the best should start. The carb is old but there is gas in the engine when i try to start. compression in all the cylinders is fine. A friend thinks maybe the timing chain jumped a tooth. I cant find the bright link on it so im having trouble knowing if that is the problem. What it could be?
View 5 RepliesOk, this has happened to me and my wife while driving. During braking, once in a while the engine will shut off for a split second then turn right back on without me doing anything. We only have 1 other key on the key ring with the ignition key. Also the inside lights (dashboard/radio) flicker once in a while. The alternator is charging 14 volts, the battery checks out. When it shut off while my wife was driving she noticed the instrument panel lights came on for a second (like when you start the car {abs-check engine- temp- all the warning lights}) and the instruments bounced all the way up then down (also like when you first start the car)...
View 12 RepliesI've got a 1997 Dodge Ram 1500 pickup. It's got 145k miles. I've been using Costco gas in it for the last two years with no problems. One day, it randomly decided to start stalling out on me. It stalled out 3 times driving at low speed. I didn't have time to work on it, so I just put some good Exxon gas in there and hoped for the best until I could look into it further. Problem went away. I cleaned out the IAC for good measure. When I finished up that tank of gas a few days later, I went back to Costco. The truck begins stalling again. Is there a problem with the gas? Or is there something I should look at on my truck?
View 6 RepliesI own a 2007 Dodge Ram Pickup (3500). One day it started by itself while parked outside in the driveway. It drove into one of my other pickups and pushed it into my side by side. It finally pushed both aside and was headed toward the house but was stopped by a tree. I heard a loud crashing noise so I looked out the window and saw what was happening. I jumped into the pickup to try and turn it off but the key wasn't turned on. I put the clutch in and took it out of gear but it just reved up more. The horn was blaring and smoke boiling out. I turned it off by opening up the hood and unhooking the battery cable.
View 18 RepliesI have a 98 chevy truck and shortly after the mechanic put brakes on my truck, when I start it you cannot get it out of park. In fact sometimes when I can't get it out of park when I shut it off I have trouble removing the key from the ignition. I've found that when I want to start it I turn the key one notch put the truck in neutral and continue starting. At this point all works correct.
View 1 RepliesI drive a 2004 Volvo v70 (non turbo). It died on me about 3 times in 5 years on tight turns ((switchback). It hadn't happened for a couple of years but now it has stopped 3 times in the last couple of months. It is very dangerous as the steering stops working and I have to totally stop, put my car in park and restart.
View 2 RepliesI have a 95 Volvo 850 2.2 L (non-turbo.) I recently replaced the fuel pump, and filter. Now when I try to start the engine, it turns over and sputters before it dies. I let it sit for about 10 minutes and try again with the same results and the same with a longer wait time due to having to charge my battery. I have checked the fuel lines and they seem to be clear, up to the fuel rail. I also checked the plugs and although they need to be replaced, after sanding and re-gaping them, there is plenty of spark. The plug wires and distributor cap are fairly new, and the points look good. So the only problem I see as logical, is the fuel rail, pressure regulator, and injectors. I have bled the fuel rail at the shrader valve, and I am getting little to no fuel from it. I want to remove the injectors and rail, and check out the regulator along with the rest. But how do I tell if the regulator is good, and what is the best way to clean injectors so they will at least last till I can replace them with new?
View 2 RepliesI drive an 05 Chevy Classic (that's an '04 Malibu made in '05), and it's never given me problems (though I've only had it about 2 years). This morning, I can't get it going. The engine turns over when I turn the key (though some of the time it takes several moments), but then as soon as I let go of the key, the engine dies. I tried giving it gas, but this doesn't seem to make a difference. After a couple of tries I noticed that the dashboard lights weren't coming on. They usually all light up while the starter runs, and I can at least get them to light most of the time when the key is turned to "on". None of this works. The power windows will open and close when I have the key turned to on, so the electrical system works somewhat.
View 8 Repliesthe truck has a few problems however nothing that I cannot be fixed (I hope). It has low miles, and I think I know why.
(1) I found out today that if you turn hard to the right the motor shuts off. ...It restarts easy.. . It will not do the same on left turns ..
(2) the Elect windows still go up and down at anytime after you cut the motor off and pull the key...
(3)The AC cuts off and will not restart..(the PO has replaced the low pressure switch) however I found that power is going to the clutch. I taped the clutch and it pulled in....If I remeber right it was spoken somewhere the one could pull the clutch and remove a washer...Is this true, and is any special tools needed?
I own a 1998 Mitsubishi Mirage with about 190,000 miles on it. The engine light has started coming on and I get three codes:
P0170 Fuel Trim Bank 1P0136 Oxygen Sensor Bank 1 Sensor 2P0301 Cylinder 1 misfire
Read more: [URL] ....
'99 Intrigue (3.5L) with 65k miles. The car has sporadic starting problems where turning the key in the ignition turns the starter motor and results in one of the following scenarios:
1) The engine does not turn on.
2) The engine turns on, RPMs drop and the engine sputters and dies.
3) The engine turns on with no problems (like this morning).
It does not appear to matter whether the engine is hot or cold.
Reading forum posts of people that have seen similar problems, several different solutions would seem to be in order:
1) Replace fuel pressure regulator.
2) Replace crankshaft position sensor
3) Replace camshaft position sensor
4) Replace fuel filter
5) Replace spark plugs
6) Replace idle air control valve
7) Clean the throttle body
Since I rather not start throwing money at the car by replacing parts one by one until the problem is gone.
My friends car suddenly quit running while he was on a trip, he went through the carwash and as he pulled out the car died. He had it towed to a shop and they charged him $400 to run a few tests and replace the fuel pump relay thinking it would fix the problem, obviously didn't or i wouldn't be typing this. At this point the car cranks but won't start.
This is what the sheet from the shop says, "retest through PCM to locate problem. Ran diagnostics per flow chart. all power, grounds and G28 engine speed spensor output to ECM test good excepting pin T121/86, wire color Lilac/yellow. Signal between camshaft position sensor to ecm. No voltage signal recommend replace PCM and RETEST."
I've put a used ecm (ecu? i've read both terms used) in and the car cranks, starts, gets to idle and dies. If i give it gas after it starts it'll rev up once, then die. I'll call it progress, but i want this damn car out of my driveway.