Elantra MD (2010-15) :: Code P0880 - Trans Stuck In 4th Gear
May 31, 2016
I have a 2011 Elantra 1.8 automatic Gls with 133k miles. While driving approximately 70 miles per hour the car downshifted to fourth gear, and would not shift up or down. I drove the car home and found that this is called "lump mode". I checked the codes, and found P0880 tcm voltage input. I replaced the fluid temperature sensor and harness, and checked continuity through the harness. I found no problems in the harness from the tcm to the solenoid connector. I then purchased a matching tcm, but the problem persisted. If the battery cable is left off for several days the problem will disappear until the car warms up.
View 4 Replies
Advertisement
I have two codes P0760 and P0755, malfunction shift solenoid B and C, today I took it to Hyundai here in queens ny, I was told that It would cost e 2684.00 to fix my issue, I can't believe that if those two codes are the problem why would it cost 2684.00 ? Where are these solenoids located?
The car feels like your one of the flintstones, it's stuck in 3rd gear and cant get out, then it jerks when it tries to shift, tranny oil is fine not burnt like if the clutches are gone.
View 2 Replies
I have 2011 Elantra at ~20,000 mile, and strange things started happening since last year...and it kinda blew up today.
My dashboard has been flickering randomly for a while, as in everything goes dark and turns up again in the middle of driving.
And today it turned off and turned on (as it usually does), and the dashboard seemed broken; speedometer stuck at 0 mph, rpm meter stuck at 0, all warning lights turned on, gas meter going up and down and stuff.
Fortunately enough I was close to home so I drove it back home, and my gear shift was stuck at neutral (I could switch b/w N and D).
So I took out the shift lock release? thing and managed to put the gear to P and pull my key out. I stepped out of my car and I smelled something burning...not a very good sign. What should I do? Well I think I need to take it to dealership tomorrow but I'm not sure if it'll be safe to drive...
View 4 Replies
I don't know what is causing this but I bought a 2012 elantra last week (500 miles on it so far). Yesterday when I went to start my car the clicker wasn't opening or locking the doors so I had to use my key to open the door. When I got in my car would start but was "stuck" in park and I couldn't shift past park (yes I had my foot on the brake). After about 10 minutes it just randomly worked... Today I was driving to work stopped to get gas and as I was stopping I realized I couldn't shift passed neutral to put in park (I could go back and forth between drive and neutral). While this was going on my windows would not go up or down. Again after 10 minutes the problem seemed to fix itself. What could be causing this?
View 12 Replies
Just got my 2013 Elantra Limited last weekend. It appears the car is having some issues with the transmission shifter. I am not sure if its tranny related, but I highly suspect it is. Dealer gave me the usual bs not being able to duplicate the symptoms.
1. Intermittently, gear selector would get stuck in neutral, when I try to put the car into P, after a long or a short drive.
2. I would have to wiggle the shifter to get into P, or I would have to shift to D, and then I am able to shift back into P.
View 22 Replies
I drive a 2008 Elantra and had a mouse chew the wiring harness from the output speed sensor on the transmission to where the wires diverge from the Engine harness. It was still able to drive but the transmission stayed in third gear, the cruise set light stayed on and the check engine light came on.
I had noticed sluggish shifting before this happened and assumed the speed sensors needed replaced so I purchased the input and output sensors (42620-39200 & 42621-39200) and that is when I noticed the wires missing. I've checked the harness for other potential mouse foolery, took the old connector to the output sensor soldered wires to it and reconnected them to the engine harness. On a test drive after rewiring and replacing the sensors the car still stays in third and the set light is still on however the check engine light is not on anymore. At this point I'm clueless what to do next besides drive it to a dealer.
View 2 Replies
A friend of my brother swapped an auto trans OUT of his 98 passat (2.8 L) WITH a trans code EZZ and now its stuck in 3rd and in safe mode... What could be the cause??
View 2 Replies
I was driving and the red BRAKE came on flashing and it beeped. Then the message came on saying Emergency Brake Failure - See Manual. Then the Emergency Brake light came on. Next the Antislip light came on. After a few miles another light came on - ESL or something like that. Then the ABS started kicking in almost every time I stepped on the brake. Later the trans stuck in 3rd gear.
Wouldn't upshift or downshift - even in TIP mode. I took it to the dealer the next day and they couldn't find anything wrong, so they gave it back to me and said to call baco or bring it in if it does it again. Then a week later it did the same thing except getting stuck in 3rd. Took it back again. This time the Emergency brake light was still on. They have had it since yesterday and still can't find anything wrong.
I suggested looking for a bad ground connection somewhere. They say they have done that. Battery is original but starts just fine. Also suggested battery cables.
It's a '07 B6 Wagon - 3.6L TIP ....
View 5 Replies
I have a 09 f 150 4wd that i took in for a trans flush, the electrical bulkhead connector on the rear of the trans appeared to be leaking so i got the replacement part and asked the service shop to throw that in if possible. Two valve bodies were partially removed and the said part was still not accessible. i said No!!! put it back together and do the flush! s
So the flush was done (by a ford tech) and now the back up lights, rear parking aid, and rear view camera are all out of commission!
It has been in the shop for 2 days now and the flush was done a second time for whatever reason, now it wont come out of third gear. the shop owner called me to say i bought the wrong filter... I don't have the part number handy but i got it from oreilly. they say it is the filter for the 6r80 trans with the 21 bolt pan. does that sound right?
View 9 Replies
I have a 2004 Hyundai Santa Fe, has 99,000 miles 3.5L. After changing the alternator (alternator did die and drained my battery, the shop recharged the battery) now it seems be stuck in 3rd gear and does not wont to shift (it is a automatic). Fluids are good, transmission was flushed between 50-60,000 miles.
View 3 Replies
Bought truck for cheaper price with no 3rd gear. Went to a reputable yard and picked up a cheaper trans... It was carfaxed with 185K miles and in a rollover. (This is the last time I try to save a couple bucks by getting a cheaper transmission.)
I believe trans is stuck in 3rd gear...Takes off slow. RPMs do not drop..Doesn't shift...Feels like I'm in 3rd from takeoff. Here are the codes:
P2262: Turbo / Super Charger Boost Pressure Not Detected Mechanical
P2614: Camshaft position signal output circuit / open
P2262 again
P1000 On board diagnostics II Monitor / drive cycle test not complete
P0678 Cylinder 8 glow plug circuit
P0672 cylinder 2 glow plug circuit
P0603 Internal control module keep alive memory malfunction
P0720 output shaft speed sensor circuit
B1676 Battery pack voltage out of range
B1318 Battery voltage low
View 14 Replies
I have a 1999 F250 4-wheel drive with a 6-speed tranny. The tranny is several old but has only around 100k on a rebuild. Three times recently it has stuck in 6th gear (overdrive) and I had to get really rough with the stick to get to come out. Afterwards the stick felt "thick" for a while and eventually everything seems to go back to normal. Not for sure but it may have started after pulling a heavy load, around 16k, which is not unusual for the truck. Other than the times it stuck and shortly after, the tranny seems perfect.
View 5 Replies
Everything was working perfectly. I stopped at McDonalds to get a bite to eat. When I left McDonalds, the car would not shift out of first gear. I have checked the transmission fluid and it appears to be good. I shifted from Park to low, and low back to park several times making sure there was no problem there. I noticed it also kicks hard when going into reverse, and it kicks hard when going into drive. When it is driven it will not shift out of first gear.
View 8 Replies
2015 F250 with 6r140 Transmission. I have 13 K miles on my truck. While pulling my Travel trailer up a hill the transmission kicks down thru the gears, which is fine, but as I crest the hill and in 2nd gear, the engine begins to rev up and the speed increases, the transmission will not automatically go into 3rd gear. I have tried to let up on the gas pedal, but it remains stuck in 2nd gear. I have to shift to manual and then put it in 3rd gear. Then it shifts up as it should. I have tried with the transmission in "TOW' and not in "TOW". I have even tried it in "Cruise Control". Ford dealership ran tests but could find no problem. However it was road tested without the trailer.
View 5 Replies
After car warms and while driving trans moves to 3rd gear and stays ??
View 2 Replies
I have a Hyundai elantra 2002 that is stuck in second gear. I was driving it, I came to a stop sign so I put it in neutral and when I shifted into first i heard a pop. I started driving and when I shifted into second I noticed the shifter was really loose, when I tried shifting into third I couldn't.. it is like there is a brick wall. I can shift from 1st to 2nd but the shifter just moves up and down. Also if I let the clutch up it stalls the car. I was told that my car is stuck in second gear.
View 1 Replies
I recently started getting transmission problems with my 2001 elantra.. the car would slam into second gear and the check engine light would come on and it get stuck in 3rd gear.. The codes I am getting are P0720, P0715, P1529. I searched and i found that most people that had this problem replaced the input and the output speed sensor and the problem is fixed.. so i went and i got two new sensors and replaced them i am still have the same exact problem... the car drives good for the first 5mins and then it would slam hard into gear, check engine light comes on the it get stuck in third gear...
View 6 Replies
2001 Hyundai Elantra 183 miles.
codes- p0720 output speed sensor circuit malfunction, p0500 veh speed sensor a malfunction.
Recent fixes on my 2001 Hyundai Elantra.
A few months ago i had my speed sensor cleaned, and a power steering leak. No problem after that was fixed and cleaned the sensor. Soon after that my water pump went bad and i had that replaced along with 3 new belts. Just last week i had my front driver side replaced with a new wheel bearing and axle.
My Problem then and now.
My problem months ago, my car would be shifting into different gears as it pleased; while driving or sitting at a light i would feel it jump and it felt as if it was stuck into 2nd or 3rd gear as i was driving. My engine light would soon come on after this. To accelerate i feel as if i had to floor my pedal when the shifting or engine light came on. I looked up my codes and they are the same as they are now. I read about same problem and fixed it by just cleaning the speed sensor off. My friend and i did the same thing and it fixed those issues. My problem now is that i just had my axle and wheel bearing fixed (my car moves smoother and quiet) my engine light came on again, it had not been on since, i read the codes and they are my speed sensor same as before but my car has not been shifting as it was in the past. Would this be because the sensor needs to be cleaned again or replaced, or because of my new replacements on my wheel.
View 1 Replies
This lady at work has a 2011(?) Elantra sedan and she said she complained about her manual trans. not being smooth. She said the Hyundai mechanic adjusted something in the clutch and her transmission became smooth again. What part needs to be adjusted? She doesn't know and I would definitely like to know because I know it is not normal.
View 4 Replies
My friend has just brought a truck and has lost 3-4 gear in the auto trans. We have the PO782 code coming up. Is there something in particular we should look at first.
View 2 Replies
My auto transmission in my 2007 Elantra with 125,000 miles went into default mode, stuck in 3rd gear. No codes went off. I drove it home this way, but after sitting for 90 minutes, now it works fine. I've heard about the input and output sensors. What should I replace? I went to HMA service to get info on both sensors, but it wasn't detailed enough.
View 3 Replies
