Elantra MD (2010-15) :: Interior Lights Stopped Working After LED Install
Mar 30, 2012
I installed my dome light, map light, and rear license plate LEDs with no problem a couple of months ago. When my LEDs for the vanity lights came in today, I immediately went to install them. The first one on the driver's side was installed without a hitch, but after I installed the second one on the passenger side, none of the interior lights worked. The only difference in installation I can think of is that I disconnected the light on the passenger side as opposed to keeping it plugged in on the driver's side.
View 6 Replies
Advertisement
I just got my 2013 Elantra in Pearl White GLS Preferred Package about a month ago, and since then the interior lights fuse has blown twice. The first time I took it back to the dealer and they replaced a fuse. It then worked for about a week or so and they're out again. Also, the passenger fog lamp keeps just blowing bulbs.
View 8 Replies
One of my interior bulbs had blown and all of the others was still working ! I replacement the blown bulb and now none of the work!!
I've had a look thought the manual and cannot find a fuse for this, how to sort this.
View 1 Replies
I have an '06 Camry, which has lost all power functionality. The follow items just stopped working
1. Key fob -- keyless entry and alarm stopped working
2. high beam doesn't come on when headlight is on. However, when headlight is off, it comes on--go figure
3. Power door lock also does not work, even from driver side door. Have to lock all doors manually
4. Interior lights don't come on when door is open.
View 4 Replies
The last week or so i been having problems when I go to start my car. The car wont turn over unless the battery is boosted. Seems pretty straight forward I know, DEAD BATTERY..but I have tried 2 batteries, one I know for sure is good. And again same things. Recently my interior lights stopped working. I read that is could be the courtesy control module, could this also be causing the battery to be drained? It only happens over night, when I go to school and its parked for 7-8 hours its fine, but over night it dies.
View 1 Replies
I have a moonroof & there were no map light bulbs, so I tried putting them in place but the electric connection there wasn't so good (there is a plastic covered with wires) so the bulbs are in but it doesn't work. What worst is, that now all the interior lights (glove box & rear dome) don't work as well!! nor the power windows & moonroof don't work now (it worked before). I guess that I have touched something or a fuse broke... I don't know what to do...
View 2 Replies
I have a 1995 Dodge Caravan le which is in perfect condition throughout. But recently the interior lights stopped working when the doors are opened and when the keyless entry thing is activated. The overhead lights do work when manually pressed but the dashboard switch that is supposed to turn them on when in the far right position doesn't do anything. If I hold the drivers door open and push in the activation button on the door jam, I can hear the relay clicking but nothing happens. My mechanic said he thinks it might be a bad computer part and will replace it but didn't really want to. I can't find a fuse for the interior lights so don?
View 5 Replies
Our 2015 Prius 4 with 8,900 miles just suddenly stopped chirping and turning the lights off upon locking. The courtesy lights also no longer work (the lights worked last night as I approached the car but not tonight. The locking chirp/beep worked 3 hours ago but not now. Also headlights no longer go out after double clicking lock on either of the 2 fob.)
View 13 Replies
I got the aftermarket lights through Yefeng, with quad HIDS. So after a while, Cluster lights, Vanity mirror lights, tail lights, cabin roof lights all started to flicker or strobe faintly. Very noticeable either when lights are on or off, drive or park.
Car has less than 12k miles.
I've been driving it like that with no problems. Except one morning before I left to work, car wouldn't start. (Happened randomly) Battery is good, alternator is good. Could something be pulling power from the alternator? I have no clue.
View 10 Replies
Accent 2012. I replaced the trunk and map lights with LEDs and they worked okay. I did the dome light last and something caused the interior lights to not come on. The light switch is set to door for the dome and middle position for the map lights. I am pretty sure I have the LED dome light polarity correct because it did come on for a bit while I was seating it.
Now the map and dome lights don't come on. I checked the 'ROOM LP 1' fuse and it looked good but I replaced it with one of the spare 10A fuses anyway. Still not working. The trunk LED does still light.
I searched this site and found in the 2007-2012 santa fe forum under 'front dome light not working when doors open' which mentions a blown diode in the dome light housing causing a similar issue.
View 12 Replies
I replaced all the interior halogen lights, parking lights and license plate lights with cool white LEDs. They look good and all was fine until the last step while installing the license plate lights. I plugged one side then turn the light switch on to verify the polarity to see if bulb would come on which it did. Same process for the second license plate light but this time around after turning on the light switch to see if it was plugged in right, I noticed the brake lights didn't come on. So I flipped the switch around a few times and nothing. Now the DRLs do not come on either as well as the parking lights. The only lights that work now are the head lights and interior lights. What happened how do I fix???
View 10 Replies
Recently I was driving down the road in my 99 B5 1.8T AUTO and my power windows stopped working from all the interior switches. First thing I did was get out of the car and use the key to roll them down, which worked fine. Here is what I have tried/looked into so far:
- All fuses are fine except #14 which i replaced
- Swapped the master control switch in the drivers door
- Checked the wire harness under driver carpet and the ground wire for frays or breaks
- Checked the CCM connectors and board for anything burnt or damaged
I will also add that the locks work from the door switches and the power mirrors don't work as well.
View 2 Replies
Over the past few days I've been working on the car, a Canadian 2014 Elantra L 6-speed, in an attempt to install the keyless entry system into it.
- I found a wiring diagram online and for the most part its been working, gotten the tail lights/siren and just about every feature working excluding the doors themselves locking and unlocking.
From what I can tell, in order to get the mechanism to operate correctly a relay is needed and needs to be hooked up into, correct me if I'm wrong as the car isn't with me currently, Plug A and B (59 Pin and 24 Pin). However no matter the amount of configurations I have tried, it just will not work.
*Do not care for the trunk opening operation.
**The system I currently have is a Spy la-3 Pke keyless system.
View 1 Replies
I just recently put a jl8"w7 in my truck and this thing make my car rattle like crazy not just the trunk lid. The worse part is the rear deck below the back glass, any quick fix before I start tearing things apart?
View 4 Replies
How to install load resistors in the front turn signals to fix fast blinking after led changing? I have two 6 ohms 50 watts resistors but I don't know how to install in the front turn signals.
View 7 Replies
1 weird problem.... when I open either door, only 2 light on top of the mirror light up, but the rear one right beside the handle is not lighting up.
I play with the button at the side, it's only ON/OFF. no door option like the front....how can I make all of them light up when door open?
View 21 Replies
I just installed an aftermarket stereo in my 2001 Alero. I did not use a wiring harness, but I just cut the old harness out. (probably a bad idea!) I did NOT disconnect the battery when I installed it.
1. I did not know where to put the radio ignition wire for the stereo (the ACC wire) (it was orange in my case). It looks like this car does not have one? I ended up just plugging the radio's ignition wire into the constant hot so the radio is always on.
2. After hooking everything up, the car does not start, it turns over for about 2 seconds, then it quits. Also, the instrument panel lights are not coming on. Everything else seems to work OK, interior lights, etc. I checked the fuses IPC/HVAC BATT and IPC/BFC ACC and they are not blown. My guess is that I did not wire the ACC part correctly...
What did I do wrong? I hope it isn't some complicated anti-theft mechanism.
View 2 Replies
2002 Elantra GLS automatic Every once in a while when I use my turn signal, the signal will either not come on at all or flash very slowly. Also, all the interior lights (gauge cluster, windows, radio etc) that are on when I turn on the headlights will flicker when I move the turn signal selector sometimes. This comes and goes and the only way I can sometimes replicate it is when the headlight is on, I'll kinda jiggle the turn signal selector up and down and the interior lights will flicker and go out then come back on. Turning the steering wheel will sometimes cause the turn signals to flash slower or stop altogether, but again this comes and goes.
I'm guessing its something inside the steering column....maybe a loose or dirty contact? Or maybe a flasher? I know my old Camaro has a flasher that looked like a relay. Once the turn signal just came on and didn't flash and that's what I had to replace.
View 2 Replies
I decided to put white LED lights in my map light(the front 2 light) and after I put on the bulb I turn the light on and all my interior light including my dome light went off. My car clicker the trunk, alarm, door lock, and unlock doesn't work either so how do I fix. I don't know if I blew a fuse and I can't check as I don't have my car manual.
View 11 Replies
I pulled the TFL pin from the back of the harness plug that goes to the headlight switch (Euro one at that) but not only did it kill the all the dash, console, switch light, but the DRLs stayed. Pin was the 3rd one from the left on the top row if you look at the harness plug as it sits in the car. Thicker gauge red wire.
This is a 2003 Wolfsburg Jetta.
View 5 Replies
Okay so I was trying to change my rear reading lights, but the lights started to flicker on and off, I thought the connecter was loose.
Stupidly I took metal pliers and bent the connectors a little closer to each other. And now the interior lights don't work =.=
Could the metal pliers on the metal connectors have blown a fuse or something?
View 7 Replies
