it's now 1,500 miles away on the side of the road.White smoke, knocking and lost power. Truck has 133,000 reman engine installed at 46,000. Is it common for hydro locking to bend a rod? He sent a video and it def sounds like a rod and degas is empty.
View 9 RepliesSo I am owning my first diesel so I am still getting use to it. Shortly after I bought it, I had to make my 900 mile drive to work and it ran great. After being here for a week or so I noticed heavy white smoke bit thought it had to do with the -5- -10. And haven't seen the white smoke since the weather warmed up. Since then I have noticed a "knocking" sound that to me sounded like a rod that I didn't notice before. After reading through these forums, it sounds like I probably have a cracked injector. I have had no engine light or anything. So my question is, can an injector fail or be cracked without an engine light and can a code reader detect which one it is with no light on?
View 6 RepliesI bought a 2004 power stroke with 100k miles, ran well for 15k miles then started having low power for first few minutes to no power, regular oil changes and fuel filters at 5k, checked FICM 48v KOEO , 48v cranking, new batteries just in case. Oil pressure when cranking at 50% of gauge , even crank cycle will jump when trying to fire, no loss of coolant, block heater working, it did start a few a few times and blew white smoke until warm then full power but the last 2 times I did get it to start it ran for less than 1 minute and died could not restart.
Fresh fuel additive in both fuel and oil for stickshion, have read hundreds of posts but not seeing similar problems no codes. With key cycle 120 amp draw on passengers battery for approx 25 seconds 48 amp on right battery glow plugs good due to the amp draw? So I think my FICM is good, good oil pressure cranking, the oil pump should be good, ICP good? Because of gauge coming up? Everything I read says black smoke for EGR soot issues. Not sure where to look.
I went out to the store today all was fine came back out and started driving got 2 miles down the road to a red light and the truck about stalled no power it doesn't smoke at idle but revved up it blows black and some white and the truck shakes. I am thinking its stiction or bad FICM????
View 13 RepliesI have a 2003 6.0 when it has having troubles trying to cut out when running low rpms but would throttle out of it then it lost all power cab filled with smoke and died now it does nothing won't even try to turn over everything under the hood is covered in soot I'm ready to pull the cab just wondering if I didn't loose any oil or coolant...
View 6 RepliesI have an 07 6.0 with 400,000 miles. Has been a great truck with no major problems. Before I started the work I had 3 bad injectors, running rough and the oil/ coolant temp just outside of 15 degrees. So I tour her down and replaced head gaskets, installed arp studs,all new injectors,all new glow plugs and new oil cooler. Ran great for a couple days. Then when driving to work lost power on and off for a few miles then completely gone could only go 10 miles an hour. I checked codes and there was the under boost code witch has been on there for a while and I forget the other code but it was for the ipr valve so I replaced the valve and right after still the same but that code went away and the p0470 popped up. So I cleaned out the ep sensor tube and replaced the valve. After several miles she now runs great but now I'm getting a little puff of white smoke when I take off and not every time and mainly when I take off some what quick. All codes are gone expect the under boost. I have an egr delete already.
View 7 RepliesI picked up a 2003 6.0 awhile back went ahead and did studs,gaskets, delete. Was driving it and seemed to lose power, started coughing and carrying on blowing bluish white smoke then shut off. Ended up hydrlocking #5, Oring on injector was tore when took out. Put all back together, ran horrible, did a balance test with AE, showed #3 injector, replaced, ran horrible, did AE dropped #1 injector. So in process of replacing the rest of the injectors. Just wondering why it is or was dropping them 1 at a time. Ficm was showing 47.6 to 48.6 volts, could that be it?????
View 14 RepliesI just looked back and it has been since July 7th that my girl has been sitting in my shop. Well this past weekend I finally got her back together and started. It took a while to build pressure but she finally came to life..
While I am thrilled that she is running again i have low power before the boost kicks in and is idling rough with a blueish- white smoke coming out of the exhaust. Once i kick her a little she will get up and go but I've never had the smoke before.
I'm thinking maybe a bad injector???
2007 6.0 6 speed, 187,000 miles. The other day started truck, had been running about 20 minutes before. Started fine, go to drive, chugging white smoke, smelled like unburnt diesel, baby truck home, seemed to run ok at low rpm, truck warmed up and ran fine. But I also noticed turbo boost was acting funny. Truck ran fine next few days. Then this morning, started cold fine, started to drive it and same chugging white smoke, it quit by the time j got to the end of my driveway, but drove to work, it quit smoking, ran pretty smooth, but will not build any boost. Truck is bone stock except for exhaust, it's straight piped. Ok. So this eve I borrowed my dads edge cts, here's all the engine codes:
P0069
P0269
P0299
P2262
P2269
The last one is water in fuel, since it started this crap I did notice it was right after it came on in the dash. I'm trying to figure out where to start....
On another note. VGT duty shows 85% at idle ?
Ficm voltage is constant 48 volts
Newer batteries
yesterday I went out started my truck and white smoke started coming out my exhaust so I turned it off waited a bit started it back up let it run for a bit smoke went away drove it about 60 miles. Later that night it did the same thing but I was 2 gallons short on coolant drove it another 60 miles ran fine. Next morning decided to take it to a shop put more coolant in it drove maybe 20 miles to shop got there turned it off everything was fine never over heated once. So this shop is now telling me my trucks hydro locked and I steamed the EGR valve. And there telling me it's gonna be $8000 to fix it .
View 3 Repliesno change, changed stand pipe and dummy plug on driver side, no change and guess what? Now I am stuck on the side of the road waiting to give my last $100 to a tow truck! Engine is hydrolocked, fuel pressure is low, starts off at around 20 and works up to 54 with key on engine off, and that is as much as I know from the side of the road with out my AE. Blew white smoke also. Smelled of unburnt diesel. I think it's linked to my rough running issue. Maybe a bad injector? But every time I did the click test they all passed. Idk, I'm gonna remove the glow plugs and see which hole is loaded and with what. . .
View 14 RepliesI would like the hear what others have to say about the problems I'm having with my 2006 F-350 sd xlt 6.0 with 113,000 miles on it. It's being used as a tool truck mostly going from a shop on the property to close by buildings on the same property. In other words very short distances. Used occasionally to take a dump trailer to a close by dumping ground.
1. White smoke from exhaust. I've read this is most likely an ERG cooler that needs replacing. Any other possible causes? If I end up having to replace the cooler is there a stock cooler that is reliable or should I get the one by bullet proof?
2. Diesel is dripping from the muffler weep hole. Last full tank lasted only 60 miles. Could this be the oil cooler? Anything else? If so is the Ford replacement cooler OK or should I go with an upgraded cooler?
Ok, took the sub for a spin around the block yesterday. Turbo was singing a tune when I left. white smoke and minimal boost on the way back. It is spinning, just not boosting very well. Stuck? Electrical problem? any pointers, or easy stuff yo check, before pulling the pump?
View 10 Replies I have the green light to bulletproof it. I just tore out the engine so she is on a stand now.
The whole backstory to this truck is one day a while back he was driving, noticed white smoke and instantly parked the truck at his house and fell on some hard times and couldn't get it fixed. The truck sat for some years and now was putting some life back into her.
I drained the oil and noticed right away the chocolate milk that was coming out of it, so right there I'm heading towards head gaskets.
What I am looking for is a list of the practical things to do to the engine while it is out on a stand. I am not looking for an extra 1000hp, just looking to bulletproof it so he won't have to worry about any other failures. I'm also looking for other maintenance items to change as well, maybe injector cups?
I was passed the other day by a newer (square mirrors) nice-looking Super Duty that was slightly spewing white exhaust smoke. As a life long truck driver, I know a few diesel smells (and I kinda like some ). But, this was so pungent that it was irritating my eyes inside my own cab.
It was so irritating and nasty smelling, that I had to slow down (to let him gain some ground) and open my windows to clear out my truck. So that I may be better informed, what could've caused this?
I have a 2006 F350 6.0 litre diesel. The other day I started it up drove away and it was blowing huge plumes of white smoke out of the exhaust. Shut it off.....started it up again after a while then went on a long drive and it went away. What that was?
View 6 RepliesReplaced turbo stock with a wicked wheel. Truck smokes like crazy took turbo out rebuilt it and reinstalled in truck now truck pukes white smoke and has a of white smoke while idling. I don't get why. I've rebuilt injectors about two months ago. Truck is stock not bullet proofed at all. Truck has 170k head gaskets were done at 130k.
View 6 RepliesSo This all started when I noticed my 03 Ex 6.0 started to not upshift every once and awhile.It has 300,000 miles on it.As far as I know it has never had tranny filter changed.So I said it shall be done.I did both internal and external filters and the fluid was very dark but not burnt.The pan was very clean and no sludge or metal on magnet.Put in new fluid and ran the truck until warm and checked fluid level and all was good.Now this where things get weird.Went for a drive and truck would not up from first easily or I had to feather pedal to upshift. If I put my foot into it I got a lot of black smoke after about 5 seconds and some sort of shuttering in the engine on deceleration. Ran AE for codes and nothing came up. The engine has EGR Delete. Blue spring, new injectors, glow plugs......
View 3 Replies06' with 85,000 on it started smoking yesterday. When idling , and stopping at red light, and then sometimes it doesn't. Run it this afternoon for about 10 miles, let it warm up. Ran good and smooth didn't smoke when cranked then at the red light it started to put out a little white smoke. Drove back home, pulled egr valve and it did have a little wet on it, the coolant level has dropped some to. I scanned it and it didn't have any codes, no misfires or anything! Is it safe to say that the egr cooler has a small crack in it and its just starting to leak?
View 14 RepliesI have a 04 6.0l and all of a sudden it started dumping white/grey smoke at idle and when I drive it it goes to black then let off throttle and back to grey/white I had an up pipe leak at the y pipe I thought it might be an issue with that but I just got done fixing it and the problem still there so iam guessing it's either a sticky injector or the ficm but it starts up nice and does not knock around egr delete is don with all the goodies arp studs ect also the injectors have only 30k so it's hard to believe but iam just stumped haven't tested ficm yet and my tuner doesn't pick up any codes
View 14 Replies2006 blowing white smoke and sluggish until its driven for a few miles ..smells like fuel .. New head gaskets and the works started after 20 days over below freezing temps nights at 5 to -5 ....
View 14 Replies