Driving to work yesterday my engine shuttered and then shut off. The Display said low oil pressure and then powered down, all in about 15 seconds. Dealer called me today told me the engine is blown and is in the hands of Ford now. The only thing he told me was sit back and wait, I can not tell you how long it's going to be. but I am going to be screwed as far as work goes.
View 14 RepliesBad day for the 2011 yesterday. Pulling my TT home from a great weekend tailgate. Stopped at rest area for a bio break. While accelerating on the on-ramp back to highway speeds, I hear/feel a pop under the hood. Immediately pulled over, and did a quick visual inspection, didn't see anything obvious, nor was anything dripping. Proceeded back onto highway.
Torque Pro indicated a P0471 & P1247, however no CEL lit on the dash. Noticed turbo boost was zero/near zero, and power output was way down. All 4 EGT sensors indicating 1000-1200 degree temps the entire time. Was able to make it home at reduced speeds. Noticed an odor burning engine oil too.
Was afraid truck wouldn't restart, so took it directly to the dealer after dropping trailer at home. Seems as though this should be covered under the 100K engine warranty, and I am at 95K now, so the timing was good if it was going to happen.
I just got a used F350 with 28k miles I cleaned the battery posts and checked all fluids, changed the fuel filters just in case they were due ( they looked pretty clean), air filter is a WIX had a bunch of bugs in it but still pretty clean... oil monitor says oil OK and filter looks too clean to be that old. It looks like a coolant leak at the turbo was fixed about 1000 miles ago or so and dealer said coolant would have been changed out at that time.
Am I missing anything I should do or check?
So, I recently had my 4th oil change done at the dealer, just under 36k miles. Same dealer that has done /all/ service on my 2011. They used the same parts and materials as always, but this time there is a very noticeable "typewriter" sort of noise at idle. Much louder than the normal chatter, and not consistent - tick.... tick-tick... tick.... tick... tick tick tick... etc. The diesel tech shrugged it off: "Ford says it's nothing to worry about." As it has never happened before, and it sounded a /lot/ like lifter noise resulting from a low-oil condition, I asked him to put in another quart. He did, and the noise went away. Mostly.
Now I've only driven about 75 miles since the oil change, but the last time I drove it, I had the windows down and noticed what sounded like lifter noise again. Not the same pattern at idle. This time, it was under light acceleration and the frequency increased with engine speed. It's going back to the dealer in the morning. Not only for this, they're also on their third attempt in the past 2 weeks at fixing a squeak in the dash. But while it's in, I want this noise to go away.
In spite of all the posts about how this sort of noise it typical with new oil, and goes away in 10-2000 miles, I'm concerned. Nothing has changed other than the fresh oil and filter. In the last 3 oil changes, this condition never existed. Am I being reasonable?
2011 Super Duty, SB, 6.7, Lariat, SuperCab, FX4 Undercover hard bed cover, Ford bed mat, and mud flaps.Traded a 2003 Expedition with 100k miles on it. It was time for a new tow vehicle, I tow a 30 foot travel trailer.(7000 to 8000lbs) The dealer offered me a deal at invoice plus all of Ford's incentives, so I couldn't refuse.
I have about 1300 miles on it and it runs fine. I have been noticing a wet spot under the right front of the truck, checking today it looks like anti freeze leaking from above the air condition pump. It makes about a 3 inch diameter wet spot, the fluid recovery bottles are still at the correct cold coolant level. I couldn't get my hand in that space to find where it is leaking from.
Ive had my 2011 for 20 months. I have 7,300 miles. I know the manual states changing around 22k but do you think time is a factor as well? I wont hit 22k for two years. Truck will be 3.5 yrs old. Should I just change them at 10k and see how they look? Don't want to waste the money either if its unnecessary. I use it 50/50 towing/unloaded.
View 8 RepliesI have a 2011 in the shop for a fuel leak. Truck has 208,000 miles on it. Leaking fuel into the valley. I took the upper and lower intake off and cleaned all the fuel up so I could see and with the key on there is fuel coming out from the bottom of the CP4 area where it mounts to the front cover. Looks like there is an o-ring between the front cover and the CP4 but wouldn't that o-ring be for sealing oil and not fuel? I'm confused as to how this works. Truck runs great with no check engine light. It's not a fast leak but a drip drip drip from the bottom of the engine once it fills up the valley enough to run off the back of the engine.
View 14 RepliesI had an issue with my 2011 6.7 this weekend and I'm clueless after doing the google search for info. My truck started overheating after driving it about 10 miles in tow with a light load (20 foot boat). So my first panic reaction is to stop and check the fluids which all check out as good on the levels if I am checking them correctly.
So it cools off and we go for another spin and now that I am paying more attention I notice abnormally high RPMs before it shifts into all gears and that the heat seems to be a by product of this. there is no abnormal vibrations of any type but it sounds like someone learning to drive a standard for the first time.
I does it almost every time. So I tried the manual shift option and it had no problem and no overheat. If it reaches the 6th gear without the overheat alert posting it runs fine but getting there seems to be an issue.
In the back of my mind I do remember hearing this high RPM before but I have a short drive to work and back so I didn't think much about it as I have definitely keyed in on it now. I have only had the truck a year and I do not know when the service was done last on the Transmission.
I have a 2011 Ford F250 6.7 Powerstroke. It has 107,000 miles on it.
The other day I was driving it down the highway and it got a Reduced Engine Power message on the dash. It lost power and I got off the highway to the service road. Then it died on me.
Had to get it pushed to a station then towed home. It wouldn't start. The starter cranks over for a few seconds but engine won't start. Checked all the fluid levels and batteries. My DEF fluid was only a half gallon low.
What I have noticed is that the DEF level indicator hasn't reminded me that it was low for over 4-5 months now. I had been putting in about 2-3 gallons every 3 months or so. But it hasn't reminded me lately and I just forgot. This is my first diesel.
My 2011 6.7L F250 Superduty died on interstate the other night. Picking up throttle pulling onto interstate when a message came on the dash "reducing engine power" and the truck died. It will crank but will not start. It will start on ether but dies when that runs out. Has the following codes... p1249 Wastegate control valve, p0087 fuel rail/system pressure too low, p1291 & p1292 injector high side short to ground or battery (bank 1 & 2), p2291 injector control pressure too low-engine cranking. The codes are telling me I don't have enough fuel pressure but scan tool says I have 4000 w/ key on and 6370 while cranking and I thought 5000 was the pressure needed.
View 9 RepliesI have a 2011 6.7 F-350 Diesel. I bought the truck new and I've never had any problems with it until now. I have a SCT Chip & Tuner. It needed an update so I returned the truck to stock and a code came up on my dashboard that said "reduced engine power" which obviously I thought was Normal because of the modifications done to my truck.
I updated my tuner and returned the truck to a performance tune but this dashboard code will not go away. My truck isn't reading any codes and there's no other indication lights on. The truck has Normal RPM readings but 0 throttle response. No power at all...
Ihave a 2008 E 350 6.0 , while driving i hit a small pothole no big deal the van stops running and coasts to the side of the road. get her towed. The dash lights show the PATS is engaged so it is no start no crank.
The 30 amp fuse PCM power relay is blown. when i replace it it blows as soon as i turn the key. im checking for wire chafing but so far have found none.
So I am not sure exactly what is going on with my truck. It is a 2004 F250 has a 6.0 L. Sometimes when I take off from a stop the truck has no power and blows some black smoke. Then the turbo kicks in and all is fine. It comes and goes when it pleases no matter the temperature. What started happening is when I drive it a steady pace on the highway sometimes the turbo gets quieter and louder and quieter and louder sometimes when it gets quieter I see a little bit of black coming out of the tailpipe. Sometimes it doesn't do it at all. Also sometimes when I let off the gas the truck sounds like it's trying to laugh at me like a wastegate is fluttering.
View 10 RepliesBlown fuse causing a lack of power to the OBD port?
I just got my Kiwi2 BT OBD2 adapter and was hoping to start diagnosing my truck, but the adapter won't power on while connected to the truck.
I pulled and visually inspected fuse #12, I also verified power to the cigarette lighter plug and the accessory 12v power outlet.
The adapter powered up with no problem when I connected to a co-worker's Tacoma.
Truck is a 2006 F-350 6.0, ARP studs, Ford Head Gaskets, Bullet Proof Diesel Oil Cooler Kit and EGR with an SCT tuner on tow mode.
Towing approx 15,000 pounds noticed truck started to lose power and misfire. Pulled over and noticed engine oil all over the driver side on engine, looks like it sprayed to top of engine as well. Oil on valve cover, FICM, exhaust manifold. I looked under the truck and saw that oil is all over bottom of the truck, differential covered in oil as well. Looks like blue smoke coming from tailpipe and smells of oil burning. Cannot tell where oil originated from.
I removed the EGR Valve, to see if there was moisture on the valve and when I looked into the intake manifold there is engine oil pooled in the bottom of the intake manifold and on the EGR Valve.
This is not dirty water from soot, it is oil. Truck is misfiring, with no codes being thrown. I noticed a small amount of white residue around the radiator cap however I had just filled up the reservoir, week prior. I unfortunately do not have gauges in the truck and rely on the factory gauges; coolant temps did not rise or move at all when this happened. I am not sure if I blew a head gasket, and really confused on how engine oil got into the intake manifold. I ran the engine with the air filter removed and can see blue smoke coming out of the CCV and oil in residue in front of the turbo inlet.
If you have a blown head gasket on a 6.0, after the gaskets were removed would you be able to tell where the gasket failed?
Since the gaskets are metal or multilayer metal in some cases would you be unable to tell where the gasket failed or would it always be visible?
Noticed oil on the underside of the engine last oil change, took to Ford dealer for repair under extended warranty. Got a call back today, stating the the oil leak is coming from a injector on the drivers side, and that the injector seals is not covered under warranty. I'm having an issue understanding that oil leaking out from around the injector is not covered under a power train warranty.
View 2 RepliesOk this may be the norm, but I'm hearing something like a motor running after i kill my engine? It sounds like a fuel pump or something!!! O ya I have a 2011 6.7. I've had the truck for several months but just now hearing this....
View 11 RepliesMy best friend has a 2011 Ford F-250 6.7 ltd power stroke diesel XL. He was driving to Denver in -4 degree weather when all of a sudden his windows iced up and the temperature gage would not sit at normal operating range. ( stayed all the way down on the cool side) the heater seemed to be blowing warm air not hot like it usually does. The thermostat was changed 2 months ago any thoughts on this one?
View 14 RepliesWell another problem with my 11. It was just at the dealer getting the fuel pressure sensor replaced and then it started throwing a different check engine light. Dealer says it needs a new EGR cooler. They said there is a TSB for this. I don't have the exact code it was throwing right now. I haven't heard much about EGR coolers being a problem.
View 4 Replies2011 Ford f350 6.7 diesel ... Is this a problem we need to have fixed?
View 2 Replies