Well, at a little over 10k I have my first issue. My monitor displayed a Tire Pressure Monitor Fault. All tires are OK. Light won't go out. Guess it just earned a trip to the dealer.
View 14 RepliesI have a question for 11-15 Superduty, regarding the factory option remote door unlock and remote start. How far away does your system operate from?
Mine is good for only 50 ft or so MAX most of the time it won't work until about 15 ft from the truck. Been trying to get the dealer to look into it, but got told today that in the owners manual it is only good to 30 ft. Plus I randomly get a tire pressure sensor fault. The sensors are fine, but since the TPMS and door unlock/ remote start share the same antenna I think the 2 are related.
Since my 2011 would work from 100 yards most of the time I call B.S. on the 30ft. I feel that the new truck should work at least as good as my old one. Besides that 30ft is a complete waste, and virtually useless, in my opinion.
I've looked at this 10 ways to Sunday, but the play on words have me questioning if it is the same thing. My truck says Tire Pressure Monitor Fault. I have a 2011 F350, if that makes a difference. I checked all my tires, they are about 80psi each, front and back. What could be the problem? Is it something to take to a Ford Dealer or something I can fix myself?
View 7 RepliesSo I scored a real deal on a set of Michelin on same size 17" OEM wheels that were taken off a brand new 2017 F-250 at about 100 miles. I installed them on my F-350 and had no faults show up. The tires had been marked as to which corner they had come off of so I put them on the same corners of my truck.
After driving about 50 miles I got a "Tire Pressure Monitor Fault" code. I pulled out my owner's manual and followed the relearning procedure exactly but I get the two beeps and the fail retry message from the left front. I have tried three times and get the same result.
Looking for info if the 2017 F-250 sensors are compatible with the 2011 F-350? Have I overlooked something? I habitually manually check my tires anyway, is there a way to disable the TPMS? Is it time for the dreaded trip to the dealer?
I have a 2010 F350 that has been throwing the "tire pressure monitor fault” on the dashes info center. Here is where it started. I purchased new wheels, tires and sensors a few weeks ago. I put them on and they were fine on the way home because I assume that the stock ones where still being read (they were in the bed of the truck). Put the old ones in the garage and then while driving to work the next morning I got the message. I tried to reset or “learn” the new sensors that night with no luck. There are two ways to get my truck into learn mode. One uses the hazard flashers then releasing some of the tire pressure until the truck horn beeps. The other method is a series of break pumps and turning the ignition from on to off then using the TPMS tool that apparently comes with the truck.
The truck went into learn mode every time with either method but it would never recognize the new sensors. After attempting everything on the sensors I checked to see if for some reason the trucks actual monitor was in a “fault” mode. Last night I tried relearning the old stock sensors with great luck. They all were recognized… for about 10 minutes. After getting them to work I left the shop I work at and on the way home the "tire pressure monitor fault” came back again. So just in case something had been in sleep mode when I did it I pulled over and reset them once more. Again with great luck… until this morning on the way to work again it went back to fault mode even with the stock wheels still in the bed.
I would get "Tire Pressure Sensor Fault" on my display all the time. The problem occurred mostly on long trips, however, it would occur from time to time on shorter trips. I complained to the dealer about this every time I went in for an oil change. They could never find a problem and wanted me to bring it in when the fault was occurring. Of course these thing never happen when you're by a dealer. To my dealers credit they said they would fix the problem out of warranty if we can find it.
Well I found the problem. As strange as it sounds if I use the cigarette lighter with a power USB adapter to charge my phone or iPad I get the fault. If I use the 12V accessory port on the dash no fault.
Last weekend we drove to Nisswa MN & back (about 1,200 miles). To test the theory I only used the 12V accessory port and no fault occurred. Normally the fault would occur w/in 50 miles then just continue on being annoying the whole rest of the trip. I wish I would have found this out 57,000 miles ago. I use the adapter because the USB port on the dash will only charge my iPhone if the phone is off.
OK so 2006 f550 6.0
If I want to monitor fuel pressure with a gauge in cab while running all the time... (not just testing) can I purchase one of the secondary fuel filter caps that have a port in the top and connect the sensor to this to run or is there a better way? (Or is that not going to work)
Cap I am talking about is something like this
[URL]
(I know this is a combo kit but they do sell the fuel only) But since it has a threaded port in the top I could connect the fuel pressure sensor to that and go from there correct? Would that give accurate readings?
I had new nitto snows put on my truck and low tire pressure light is on.....Checked tire pressure 65 front and 80 back.....Started truck and screen said tms pressure low.....Hit ok and drove around on and off for 2 days now and cant get the light to go out......Is there some way to get the light out or do I have to go to my dealer to have it reset???
View 14 RepliesBrought my truck (2012 F350) for recall service for one of the faulty exhaust temperature sensors. It took them one week to replace the sensor (!), then when I came to pick it up I got: "Trailer Brake Module Fault" message on the display.
I have never seen this message, since I own the truck (I am original owner). The service adviser said it will take a minute to reprogram the module and took the truck back to the shop. Came back after a while, saying that it didn't work and I need to leave the truck, so another technician can work on it tomorrow. Tomorrow came and I got the call that they reprogrammed the module, but the message still shows up, so they need to work on it (another day!).
As of now they still don't know what is going on. Apparently they broke something while replacing the EGT sensor and how to fix it.
Why are my tire pressure sensors going off, I have 70#'s in the front and 62#s in the rear, which is more than enough air.
None of the tires have a leak in them, yet I keep getting the sensors to trigger, and why would it be so hard for the system to point out which tire is low??
I had the low tire pressure message and light come on back when i was visiting california, about 3 weeks ago..i checked the tire pressure, and a couple tires were maybe 5 psi low at the most.. i aired them back up to the right pressure (as stated on the door pillar sticker) and the damned light/message is still coming on.. how do I reset the TPMS? it says in the manual to just drive the truck 20mph+ for about 2 mins after getting the tire pressure correct, and the light/message should turn off. i have done that...
View 14 RepliesOne of the few disappointments I had with my 2011 F350 was it lacked a display of individual tire pressures like both Dodge & GM have. I figured the idiot light would have to do. Recently I found that an inner dual tire was flat. It made a subtle squeal when braking or turning sharply, and a quick inspection showed I picked up a nail.
I never got a tire pressure alarm. I read my manual and it describes the system, but the writeup only indicates setting up four tires. Am I missing something? Have you guys got a working tire pressure monitor on your duallies?
2013 F350 SRW . Pressure is correct . Anything special you need to do to make the light go away ?
View 14 RepliesI do 98% of my driving unloaded and almost never tow. (Kinda weird for an F350 huh) I know that the truck recommends going with 65psi front and 80psi rear but the rear tires seem to not be wearing evenly across the tread pattern. The edges still have the little rubber stubs sticking out of them even after almost 3000 miles. Should I be running a lower tires pressure in the rear when empty or should I just let tire rotations take care of the uneven wear. If I should air down, what pressure would be recommended? The front tires are wearing normally at 65psi and they have more weight on them then the rear.
View 14 RepliesWell, I didn't get 10 miles from the dealer before the air pressure monitor fault hit. I had asked them to check this in advance and my salesperson said that only some T-regs have it and that there is no way to know until it happens. Was the dealer right? Or could they have saved me this additional 1-day hassle of having the problem fixed?
View 8 RepliesWhen I bought a used camry 5 years ago and drove it on the highway, my front tire busted and damaged the fender cuz it had too much air!! I wonder if it shows high pressure on my 2010 gen III Prius v with ATP. I know that the tires are special on this v version but still I like to keep a slightly higher pressure in the front ones because the lane keep assist feature works better with higher tire pressure. Summer is coming up so that gets me worried what to do with tire pressures.
View 10 Replies2009 Ford Explorer, 6cyl, 4L, 33K miles. When its started up, the message "Tire Sensor Fault" appears along with the low tire icon flashing (steady light after ~30 seconds). I can then press the reset button on my dash to clear the message. However, the tire light icon stays lit. I've checked and re-checked the tire pressure in all the tires (spare included) and I'm right at the recommended 32-34 psi on all the tires. No signs of leaks at all. I'm assuming one (or more) of the tire pressure sensors have gone bad and there's no way for a garage (or myself) to identify which one or repair this. Should I assume a trip to the dreaded dealer for this problem ???
View 10 RepliesI have an 04 - V6 with about 55k miles. Tire Pressure Monitor System Fault is the message. The tire pressures are fine. Message appears after 15 minutes or so of driving. After another 5 minutes or so of driving, the fault message goes away - whey you click to vehicle status it says "OK". I took it to my local VW dealer, they said they fixed it, but on the way home from the dealer, it popped up again. They are perplexed. This is not the "Faulty wheel on board" message, it is totally different....
View 11 RepliesI have a 2007 F150 Screw lariat and have swapped the factory 20" wheels for a set of18" FX4 wheels. Question is how do i get the light on the dash to go off?? I swapped these tires and wheels 2 weeks ago and never got a light.. now tonight I get a light? I don't know if the 18" have pressure sensors in them or not..Wouldn't I have gotten a light right away?
View 1 RepliesWhen I should use the tire pressure reset bottom under the dash? Do I need to reset the system after I adjust the pressure every time?
View 2 RepliesIs there a way to completely disable the TPM system, I have turned it off in the MFI, but it displays a warning at the top of the screen, always. I put some Porsche 19"wheels on the Touareg without TPM. I took it to the dealer and they were unable to provide a solution.
View 16 Replies