Ford 7.3L Power Stroke (1999-2003) :: 2002 - Vibrates When Throttle - Rear Differential Rebuild
Aug 5, 2017
My truck (02 7.3L cc) started making a grilled ding type of vibration when I would let if the throttle. I felt the axle going into the rear differential was a bit loose, so I took the cover plate off. The pictures below show where the pinion I think is hitting, sort of like the bearing is allowing front to Rear differential scaring from movement. Rear movement.
How difficult is a rebuild, and is there anything I should be careful of?
View 14 Replies
Advertisement
...when changing the fluid and RTV'ing the rear differential cover?
Usual suspects: Brake cleaner, Simple Green, soap and water, gasoline, etc.
I've never serviced one, but figure it is like this:
1. Drain
2. Remove cover
3. Spray, clean, rinse, whatever all the innards
4. Wipe and dry
5. Inspect. For what, I have no idea
6. Black RTV cover back on, replace drain plug, remove fill plug
7. Refill with 75w-140w Mobil 1 Synthetic (not sure what it is, but I looked it up here some time ago and bought enough)
8. Fill to within a finger tip's dip in the fill hole
I've had the RTV and oil for a while, but it's supposed to hit 59F here on Saturday with no rain!!! Time to crawl on the floor and get it done.
I didn't see any problems with my cover, so going to forgo the new aluminum finned cover this time
Guess the biggest question is what should I use to clean/flush the rear end?
This is 2002 Excursion WITH LSD rear differential. 4WD.
View 14 Replies
I'm trying to figure out what axle I have on a 2002 f350 single wheel 4x4 so I can order a replacement seal. So this morning I got to work and noticed that am oily guild was dripping from the front of my rear differential where the drive shaft hooks into it. I figure it the seal, so when I went to look up the repair kit they list several different axle options because of gearing, what axle I have as there wasn't a in owners manual with the truck. Who can I find out what axle I have so I can buy the repair kit for it...
View 5 Replies
The rear differential on my truck has been whining for the 2 years I've owned. The fluid has been changed but of course that didn't really solve anything. I'm trying to decide if I want to rebuild it. Was looking at buying the USA Standard brand rebuild kit, ring and pinion, and axle bearings and seals. How hard would/will this be to do myself?
View 4 Replies
Comming back from hunting today my truck suddenly lost power and stepping on the accelearator had no effect at all. We were on the highway thru the mountains but on a fairly level stretch for a few miles. Managed to pull the truck and toy hauler over and the engine was running fine but stepping on the accelerator had no effect. The check engine light came on every time I stepped on the throttle and went out when I released it. It started fine but no throttle response. Switched around a bunch of relays and checked the fuses and still nothing.
Not liking my parking spot i tried to see if it would move down the road at an idle but it would not. Then I thought to try it in 4 wheel low and as the shoulders were soft it wouldn't move forward so tried reverse and went back a foot, forward again and moved a foot and a half. did this several times and all of a sudden the throttle responded, took it out of 4 wheel and it ran fine all the way home. What would have caused this? I was ready to call a tow truck which would have been several hundred dollar bills for where we were and with the trailer
View 14 Replies
My 2002 f250 starts but has no throttle, I did replace the throttle body, still no luck, i did find a wire on the shiffter that had a bad spot , fixxed it still no throttle, code reader says it passes with no codes, I disconnected both batteries and waited 15 to 20 min, reconnected them, started the truck and let it idle for 20 min so what do i need to do now. I just cant figure it out....
View 7 Replies
Transmission rebuild? I seen a few threads where people talk of it but no follow up. I've heard it takes special tools but then so does a lot of things we shadetree on our own....
View 14 Replies
2002 7.3 rebuild and installed in the truck but won't start ... Everything is new other than hpop and injectors they came out of a perfectly running engine.
The truck is making enough oil pressure to fire the injectors the first couple cylinders then it quits kinda like a cold start with bad glow plugs. Fuel pump was working perfectly when the engine was taken out of the truck and is still building pressure enough to get some black smoke from the exhaust after cranking for about 15 seconds ...
The hpop reservoir full every time I check it and after cranking for about 15 seconds the oil gauge in the dash for the lpop jumps up to its normal place.
Injectors got new o-rings when they were taken out of the running engine. I'm not sure what else could be keeping the truck from starting.
View 14 Replies
I have a 1989 ford f150 xlt lariat it has a 5.0 and a 5 speed and is 4 wheel drive. Any way I am looking into rebuilding the rear end of the truck the pinion shaft has a lot of play in it up and down and both outer axle bearings seem to have lots of play in them. I believe it is a 8.8 inch in the rear. Just wondering if there hard to rebuild or what it all entails I have never taken one apart before and want to know what I am getting into. I have access to a press and a pinion and carrier bearing puller. the axle bearings i have done tons of them but never had to pull out the carrier. wondering how to set turning torque and backlash etc... and torque specs for everything.
View 8 Replies
I have this 99f250 and it has a 273f, the transmission side of the case has threads stripped so I am about to remove and retap them. While its out should I consider rebuilding this thing? 197k miles, operates decently although the rear bearing on output side is my first thought to replace from mileage only.
View 1 Replies
I was hearing a clicking noise on my passenger front wheel when rotating by hand.
Paul suggested I remove the ESOF hub and see if it is the wheel hub or the ESOF hub. It's the ESOF hub.
So I'd like to rebuild it for sure, it also has a nicked o-ring, so that accounts for part of the vacuum leak
I'd like to service the driver's side, too, while I'm at it. It doesn't exhibit any issues, so just regular maintenance stuff there.
Parts lists?
As always, I'll take pics in return
View 14 Replies
My '01 f350 up and running the last 5 years. The truck has 130,000 miles on it and the transmission quit on me two weeks ago. My mechanic pulled the tranny and sent it to a very reputable rebuilder for a complete rebuild. My mechanic then reinstalled the tranny. I picked up the truck and when I paid the bill my mechanic told me that the rebuilder provided a new 4-plate torque convertor and that I would hear it rattle when I was at stop signs, stop lights etc. and that this was normal for these types of torque convertors. I have searched this forum and found all kinds of reasons for this rattle. None of which tell me this noise is normal or should be expected. I have no problem going back to my mechanic and discussing flex plate cracks, engine/tranny misalignment or any of the other causes...
View 2 Replies
I am about to purchase a 2001 F450 7.3L with a 6 speed ZF6 that has a slightly worn 2nd gear synchronizer. I will be rebuilding this transmission with a friend and was wonder if there is any documentation available to assist with the overhaul.
View 14 Replies
Now that I have been driving for a while I kept seeing this light come on/off and I did a video below - I don't generally flash my lights so don't think I am aggressive - but I wanted to make sure to capture the video and the light coming on.
I was thinking valve cover connection the 50 cent mod - and maybe it's all coincidental - but I did have to pressure wash the troph where the oil collects and maybe something else got knocked loose.
[URL] .....
View 13 Replies
I'm fresh out of the perverbial womb to this place and only about a toddler when it comes to my truck. However I do want to learn! I just recently invested in an 02 XLT F350 7.3L. I'm in love with the truck except the leaning forward aspect. I am debating on leveling it via lowering the rear. Any thoughts? Things I need consider that will happen if I do? How would you do it? Would you do this over raising the front? I've heard raising the front can mess with the suspension geometry and that's not a good thing to do!
View 10 Replies
I am on the fence with getting rid of my 7.3. Here's why. Whenever I crawl underneath the truck or look under the hood I see all these different oil/fluid leaks. She has less than 200k miles and I use her to tow my boat to go fishing.
Right now I am trying to weigh if the truck is worth keeping or selling and then getting a new/newer truck.
Here are some leaks. One is obviously oil and coming from what I guess is the front main seal. I really don't know. The other leaks going onto the U-joint look like oil leaking down the axle from the front differential.
I'm growing a business and not sure if I have time to play mechanic. However, everyone I talk to always exclaims, "You got a 7.3?! You luck SOB!" and I am kinda getting the feeling letting her go would be a mistake. FWIW, she is paid off.
Other than a slight wobble in the steering wheel at speed, she runs like a hoss.
View 1 Replies
My 7.3 has a leak on the front diff passenger side. It went into a shop for repair and they did both seal but the passenger side came out with a worse leak than it went in with. So just looked this morning and small pool of oil under the ujoint area on the concrete. Its booked in again to be fixed under warranty repair (place that fixed it, repair came with 2yr warranty) on Wednesday next week - was the earliest I could get.
Question - can i keep driving the truck? I'm making a wild assumption that I can unless I use 4 wheel drive. My intention was to just keep topping up the diff to ensure there is fluid in it. It's the work truck so wouldn't be good to be without....
View 10 Replies
I'm currently adding some hideaway strobes into my 02 POV and was wondering if any good place to enter wires from the rear of the vehicle? I'm not wanting to drill any holes and worst case I'll go through the firewall with my other runs and run down my door jam. All my connections are behind my rear seat.
View 6 Replies
I currently have the rear axle shafts off the truck. I took off, cleaned then put on the rear diff cover.
I live in an area that does nothing but form rust anywhere and everywhere in very little time.
I don't want rust forming in the rear diff gears - can I fill the rear diff up ? Or will it leak out of the rear shaft holes ? Can I fill it up halfway then ?
View 2 Replies
2002 F250 diesel ... I found these two plastic pieces yesterday on the floor near the 4X4 shifter. I noticed the other day when i step on the brake the rear view camera in the head unit comes on, so i am thinking they are either a part of the brake switch on the pedal assembly, or something to do with the shift tube.
View 2 Replies
I have a 1999 ford f250 lariat 4x4 with 236,000 miles. Recently I have noticed when I am applying the brakes it sounds relatively normal until about 30 mph then it sounds almost like I have a flat tire or I'm running over a rumble strip, It's almost like a popping sound but a deeper sound.. I'm not sure how to describe it. The truck also vibrates violently when I reach speeds above 65-70 mph. Until about a week ago I could go 100 mph with no vibration whatsoever.
View 6 Replies
