Ford A/C :: Temp Gauge Running Higher / Showing Above Normal Temps
Jun 7, 2011
My temp gauge (which very seldom deviated form its position) is showing above normal temps. Yeah its over 90 here but this is unusual for my car to run hotter. I put in a new thermostat about 3 years ago. I've also been adding water/anti-freeze because there was a small leak (that I finally found in the hose) that I corrected. Could it be that my mixture isn't a 50/50 mix or is it my thermostat again? They say they don't last long anymore???
View 1 Replies
Advertisement
I was sitting in my car on lunch break. I noticed the temp gauge was higher than normal. Then I noticed a little steam coming out from under the hood. When I checked, there was antifreeze leaking out from where the tube connects to the overflow tank. It didn't look like there was a hole in the tube, it was squirting out right where the tube connects to the tank. I turned it off, and had to go back to work. I'm not mechanically inclined. When I got off work, I put a bottle or Bars stop leak in and filled it back up with antifreeze. Started it up, didn't seem to be leaking. Drove it home. Any time I am idling or cruising, the temp gauge will go up to the 3/4 mark , when accelerating it will drop to between 1/4 and 1/2, which is where it normally was.
View 2 Replies
Took a trip today that was 3 hours there and 3 hours back. Truck ran normal on the way there (eot about 202 and ect about 196-198), but on the way back truck ran a little hotter than normal (ect as high as 214 eot stayed within 2-3* plus or minus ect). Fan did kick on every time I hit ect of 212 and would drop it down to 196-198 and oil temp would drop at the same rate.
Truck is stock 190k miles with a bulletproof egr cooler and coolant filter. Oil cooler probably has about 20k on it. (4th one on this truck- since I like changing them out as much as the rest of us). I checked coolant level when I got home and I might've added a pint to get to bottom of sticker. I'm not sure it wasn't a pint low when I did last flush and cooler replacement.
No puking and I can't find any leaks. I pulled egr valve and no moisture in manifold just a worm out o ring that'll I'll replace. I can't find any leaks. Where to check that I haven't? I don't feel like I'm losing coolant because I wasn't really low. My fan never failed to kick on when I hit 212 or stopped at a red light. No moisture in manifold so I'm not thinking losing coolant due to head gasket. Maybe radiator looks ok but tomorrow I will blow out any bugs to make sure.
View 5 Replies
I have a 2004 Grand Prix and it is displaying the symptoms of overheating but the temp gauge is not going above normal operating temp. I replaced the thermostat twice, and after driving for about 10-20 mins coolant comes out of the overflow. I'm at a loss, I'm thinking temp sensor(?) But I don't want to keep throwing unnecessary money into it. The fans work fine, the heater blows as it should.
View 8 Replies
'05 Ex overhead console temp is showing -40 deg... Had the board out looking for loose diodes, didn't see any. Have any of you ran into this before?
View 14 Replies
02 6.8 4x4 excursion. When I start the truck cold, the trans temp gauge immediately moves to "running" temp. Not really sure how this happens, I'd figure that if the xducer was trash it would ride all the way high or all the way low. What's happening here? I'd sure like a functional gauge...
View 6 Replies
I have a 77 F100 2wd 302/c4. I recently replaced the rear plate to my gauge cluster after it crumbled to pieces. I swapped all the gauges to the new plate minus the fuel gauge since it decided it couldn't live if livin was without the old plate. I have a gauge cluster out of my 75 and decided to swap in my fuel gauge from that one. I put the cluster in the truck and fire it up for 10 mins or so and everything is working great except the temp gauge isn't moving. I figure it romeo and Juliet with the fuel gauge so I just swap all gauges from the 75 into the 77 cluster except the speedo. Same result.
So I figure its the sending unit now and maybe both gauges were fine to begin with. I put in a new sending unit and now the gauges works but the needle sits on the P in the word TEMP on the gauge which makes me uncomfortable. That's about 1/4 inch or so from being past the end of the gauge. I don't believe the truck is running that hot. The gauge was more or less straight vertical before the swap sitting right at the end of the E on TEMP. Did I get a bad sending unit? Is it a bad ground on the gauge? Was I supposed to take off the teflon tape that came on the threads of the sending unit? I'm gonna try removing that first and see if it lowers the needle.
View 3 Replies
Just wondering if this is anything to be concerned about. I have a 2006 Saturn Vue. It has just over 80,000 miles on it. The temperature gauge has always registered just below the "second mark" once the car is warm. As of last week, the gauge is now registering slightly past the "second mark." So, higher. It is no where near the "red" zone, and nothing seems to be wrong, but it has me concerned. I took it in for service and they said "it is still well within the normal range, don't worry about it." But I think something made the gauge go higher, and I am concerned about a problem lurking. Am I being a Nervous Nellie? I love my Vue and want to take good care of it.
View 4 Replies
Was driving my truck I have a 97 f150 4x4 4.6L, btw. The heater started blowing cold air and I looked at the temp gauge but it was showing lower than it normally does and then, after a couple of miles or so I looked at the temp gauge again. By this time I was in my driveway. And it was overheating it might have been that way before I looked at the temp gauge again. But any way I opened the hood didn't see any leaks, all my hoses were hot except the top heater hose. Also checked the oil it was full and coolant was too, what this could be? Sounds like a t-stat to me? But could be worse. Also forgot to mention that the oil had no signs of water in there nor the expansion tank cap !
View 3 Replies
Recently installed a curt trailer light. I modified the V plug in harness to work with the C.
I noticed the fan was running louder then usual. I took the right rear panel off were the HV exhaust vent it and there is no ducting from the factory.
The battery duct just goes to the back of the seat and vents out in that right corner right behind the 12V.
It makes its way up and over the right rear tire tub then what ever comes out of the rear exhaust, just vents out with momentum from down below. No duct guiding it from what I can see?
I went back and zip tied a wire that was in the path to sides were other factory wiring runs.
This seemed to fix the issue after making everything neat?
Not sure what caused it but it seems to be from wiring that was in the way? When I run the HV fan with my SG and remove the shock tower assess cover on the passenger side. I can feel hot air coming out. This might be an easy way to get more exhaust venting for anyone that wishes to do that.
View 19 Replies
My friend has an 08 4.6. He has replaced the thermostat with 3 different ones all with different temps, still nothing. Temp gauge reads normal but after driving it for a bit he can take off the radiator cap while it's running and not get sprayed in the face with coolant, almost like there is no pressure in the system.
View 6 Replies
So yesterday my truck decided to start giving me fits right after it finally got extra cold and snowy here! I noticed early on this fall that my water pump was leaking, so I replaced it. I also found that my truck only blew hot air while in motion, and cold air while it was stopped or at idle. At this point I replaced the thermostat and housing. I originally had the stock setup with the combined thermostat and housing. The new one is and updated GM version with the separate thermostat and housing assembly. Everything seemed to be ok until yesterday morning.
This is where my problem is now. Yesterday on my way to work, the message center said my coolant was too hot. The temp gauge showed the truck at about 250 degrees. My speed was only about 45mph and it was 6 degrees outside. I ended up parking the truck and looking at it after work. I found it was still doing the exact same thing. When I investigated further, I found that the upper radiator hose was hot, while the lower one coming out of the thermostat housing was cold.
At this point I figured that I had a bad thermostat, and bought a replacement. I tested the old one on my stove top in a pan of water and found that it did actually open at about 175 degrees, so I'm not so sure it was bad now. With the new thermostat installed, the engine is no longer overheating and the temp stays around 235 while driving. However, I am back to the heater blowing cold air at idle and while stopped, and warm air while driving. In addition, the rear heater now only blows cold air, it never warms up.
View 2 Replies
Lately my engine/coolant temp gauge has been screwing with me. It is either been almost at 190* or dead 90-100*
It seems to go up when in the lower RPM range (idle-2000) and goes down when in the higher range (4000-redline I suppose).
I stayed at or above 4000rpm on my way home from work for 3-4 minutes and it was almost at 90*...went to 5000 for 2 minutes, same thing. I shifted to 6th and it rushes to 190*.
So is my sensor bad or what?
View 3 Replies
So my understanding is the water temp gauge at 200 degrees is pretty much spot on. The last three days I notice the temp gauge go to 200 then up to 240 which is like just one line away from the red zone. I turned on my heat full blast and was on the tollway and the temps went back to 200. The moment I got back into stop and go traffic the temp goes up again 220-240 range. Again, one line away from the red zone. No other alarms or dash messages come up. No smell of anti-freeze.
As well, the oil temp which was always at 200 has done the same thing. Running over 200 in the 220 plus range. Could this just be low anti-freeze? If so, would I not get a dash warning light?
View 6 Replies
For reasons I can't figure, the Temp gauge on the wife's Explorer is shooting from normal to high in just seconds. Then, it drops back to normal. When I looked at it this afternoon, I noted 2 things.
1) There was no sign of a coolant leak or overheating.
2) There wasn't ANY coolant in the tank!!!!!!!
The truck has evidently been running fine while this is going on.
View 5 Replies
Owning a Hyundai. I have a problem and it seems to be pretty common but haven't gotten anywhere with it yet. Last week my 2004 accent 1.6 manual transmission started running rough. It was idling higher than normal and while driving would not go past a certain rpm (about 2500 if I had to guess,no tach). On the way home from work it was running this way and then started badly misfiring and shut off, when attempted to restart it would not. I pulled the codes with a scanner and got p2400, p0562, and p0121. I charged the battery and replaced the throttle position sensor, still won't start. I can hear the fuel pump kicking on when I turn on the ignition. Also found the ecu 1 fuse blown, replaced it and continued to attempt to start with no luck, fuse was blown again. Like I said I haven't owned the car long and I don't know much about it. I am not sure where to go from here and I don't know how all these symptoms are tied together.
View 42 Replies
I have a 2007 6.0 that this has happened to twice now. It's fine around town but I never hear the can come on. Friday when on the interstate my my temp gauge started to rise past normal operating temperature before fan came on. Is this normal? After the fan came on it stayed at normal temp for the rest of trip....
View 5 Replies
Ok so here here goes I have a 1999 f250 super duty with 5.4 triton it seems to be over heating but the gage stays in the normal operating temperature range. I just changed the water pump. Could it be the thermostat and Would it hurt to remove the thermostat until I can get one...
View 8 Replies
Twice in the last year my 1999 Ranger (@138,000 miles) has started running very loudly: I checked dash and see oil pressure gauge says no oil pressure. First time this happened, I pulled over, had it towed. At garage they start it up: gauge normal, they check oil says its OK. I take it to the dealership, they replace sending unit, but can't explain why it was running loudly. Today same thing happens: I checked oil pressure gauge, it's OK. After an hour, starts running loudly, gauge in red. Park car for 15 - 20 minutes, start it up: all is well: gauge OK, running quietly. This is amy 'spare' car, so it only gets driven 1 -2 times per month, short distances.
View 4 Replies
Fluctuating temperature gauge? In the past few weeks I have noticed that my temp gauge goes over the normal temp line but the car never actually overheats. This doesn't happen all the time and only every once in a while. Today however, the gauge went very high and I immediately put the heat on high and it slowly dropped to normal again.
I had a water pump replaced several years ago and last year had the thermostat replaced as well. The only thing I have had done recently was an oil change at one of those convenience stations. During the check-point, I was asked if I wanted the filter changed that filters the air coming into the car. I said no, but now wondering if they actually disconnected something when checking for this. The reason I'm bringing this up is because sometimes I don't get hot air when the heat is on or cold air when the a/c is on.
After reading online more about this, I read that a faulty Temperature Sensor can give a false reading. Just added some water to the radiator but not much...so no leaks that I can see.
View 2 Replies
At idle temperature is above middle. Upper radiator hose, which is connected to the thermostat is hot. Lower radiator hose that feeds back to the engine is cold. Radiator fan will not stop running if the temp guage is at middle to needle above middle. When running the temperature reading is normal at 30 mi/hr (middle to just below middle). Temperature will also go down if at high rpm idle, about 2,500 RPM.
New thermostat replaced last week. Water pump replaced less than one year ago. Upper radiator and lower radiator hoses are pressurized when running and off.
I suspect the thermostat was installed incorrectly. Pressurized hoses mean excess air in the cooling circuit/system. If so, does it mean I have to bleed out the air? How do you bleed out the air on a cooling circuit of a car, I thought the reservoir tank already does that naturally? I think the normal range for the temp guage should be 1/3 of the whole range of the guage, right?
View 19 Replies
