Ford Aerostar :: 1994 - Low Pitch Groaning Noise At Start Up - Oil Starvation On Restart?
Feb 25, 2016
Starting a hot engine in my 94 3.0L RWD occasionally produces a low- pitch 'wah-wah-wah' groaning noise that goes away after 3-4 seconds. It sounds like it's coming from the engine itself and what I'm hearing is an engine running without sufficient oil. It has never happened on cold starts, but about 30-40% of the time when restarting, like at a gas station after fill up, etc. I live in sunny San Diego so I put 10W40 in at the last oil change. It's also currently overfilled by about a quart--I intend to remedy, but have not gotten around to it yet. Could it be the viscosity or quantity of oil? It's a real sphincter puckerer of a sound and I want to get it resolved.
View 2 Replies
Advertisement
I just bought a 94 Anniversary Edition that came with an aftermarket remote start. I upgraded the module so I could get better range and would like to connect the rear window defrost to it. I have the trunk release feature on the module and since it isn't in use figured I could use that function for the defrost. The module has a negative output. What wire in the defrost switch would I connect to and would I need a relay to convert the negative pulse to positive? The winters here get extremely cold.
View 3 Replies
Srange noises of my 1994 AWD. When driving, if I take off fast, it makes a lot of pop noise, but if I take off slowly, then It's Ok. Or when I make a quick acceleration after slowing down then it make noise, but if I take it fairly slow then it's OK. The frequency is getting worse. My front axles are in good condition (30K miles on a rebuilt pair). I have unplugged the AWD controller box, it didn't do any difference. All gear shipped OK. So what is that noise in that condition? My 94 AWD is about 110k miles, good shocks.
View 14 Replies
What would cause the front wheel on drivers side to lock up if it isn't the brakes. have been hearing a loud popping noise for a while on drivers side especially when turning left. Today got really loud just driving and then a real loud grinding noise. Then a loud pop and front wheel locked up and skidded across highway til i came to a stop. What it could be or how can i at least get wheel to turn to get it on trailer...
View 6 Replies
Dealer says groaning noise at start up, when I let my foot off brake at a stand still is normal,worse if i turn steering wheel with brake on.
View 8 Replies
I jump started my wife's mini Cooper using my aerostar van 3.0l cargo. Her battery was so dead we had no luck after running my van for 8-10 min. There were a couple of attempts. My van suddenly died when she wasn't cranking the mini. It won't restart.
About one week prior I had a no start situation. I thought I had solved the problem. The first thing I did was listen for fuel pump engagement. I didn't hear it. I pulled the fuel pump relay and cleaned the connections. I put it back and the van started. I drove all week and then I get the call to jump start the mini.
So back to today. Fuel pump is engaging. I checked for spark at #4 cylinder with fuel relay disconnected so as not to flood the engine. I have spark. Battery is strong. I put a new fuel pump relay in place even though it appeared to be working properly. I had my wife crank the engine and the pink/blue wire at the fuel pump relay which goes to the pump lit up my voltage tester. Power appears to be present when cranking and not just initial engagement.
I'm thinking the original no start had nothing to do with the wire connections which I cleaned and it was just coincidence that it started and ran again for a week. The connections are now clean with a new relay attached and not starting. I'm thinking if I have spark and a fuel pump engaging then injectors may not be firing???
View 3 Replies
I replaced the timing belt an waterpump at 262,000 miles and ever since the engine makes a loud low pitch noise that varies in pitch depending on the engine speed. I replaced the alternator and it didn't work. I don't know if the power steering pump, a/c compressor or something else is making this awful sound.
View 1 Replies
When starting the car and ONLY when it's a cold start, like sitting overnight, it makes this weird "groaning" or "whining" noise. I took a video of it because if I drive it to the dealer, then start the car there, it's not going to do it as it only happens after a long period of being off. Listen really closely after the car starts and right before the radio comes on, you will hear a faint groaning noise. It's louder in person, but this is the best I could do.
[URL] ......
View 21 Replies
03 focus SE Wagon, Automatic Tran, has a bit of a problem. Whenever it gets driven through a puddle (big, small, paddling pool, etc.) it will make this high pitch squealing noise, and then when it gets shut off after driving through said puddle, will have trouble starting. (It will turn over, catch, run for .2 seconds & then the engine will cut out, but all the electronics will work) THEN! if you can get it started, it needs to be reeved constantly or it will stall when it idles. Lastly, if the conditions are ridiculously horrible, & you need to go some place, you have to '2 foot drive' the little beauty to whereever you're going. Now, she's been in to see the Ford mechanics and has 'stumped' them.
View 4 Replies
My 94 is on the mend , since I got it a few months ago. The air conditioner blows cool , just not cold . It's still a R12 system, and I got the fittings/R134a/oil charge/and mineral spirits to do the change over, but hesitated when I found someone locally had a few cans of R12 for sale . My thought is to buy 1 can , and see if a shot would make the difference before going through the procedure to flush the 12 out and go with the 134a .
My biggest problem is lack of a gauge set , but a guy from CraigsList here says he walk me through the change over for 60 , and betting he'd have the hoses for a 12 system to hit that if that's how I decide to try first. I just wonder why , since I got it , the "cool" it does blow hasn't changed so I am betting it isn't leaking , but the jackleg I got it from was one that IMHO wouldn't know how to open the hood , or what to leave alone, I am just at that point of impasse, as to which way to go ...
View 6 Replies
It is a garage queen 1994 4.0 AWD with 42,000 miles in nearly perfect shape. Except for the dent in the rear on the passenger side.
I have posted a picture of the dash when going down the road. As you see the engine light is on. It comes on intermittently, pulled the codes, indicated MAF, 02 sensor, running lean/rich. Runs like a champ, no hesitation, still gets up and goes, gets the appropriate gas mileage. I replaced the 02 sensor with the original Ford Part. Didn't cause the engine light to stop going on after about 20 to 60 minutes driving, sometimes it doesn't come on at all.
Could this thermostat be running too cool and causing the engine to throw those codes? Would gladly take it to a mechanic, but seems like it might be a fishing trip with my dollars for them. Next I was going to replace the MAS myself, easily done with the original remanufactured part at a cost of 150.00, 70 for the core, but don't want to chase my tail with these engine lights on when it runs nearly perfect.
Have sprayed the MAF. Checked for air leaks anywhere. Done all the things I could do by just lifting the hood.
So the picture shows the Temp gauge barely touching the N flying down the road at 70 on a level surface, outside temp about 60. Reading the posts says they all run in the cool section of the temp gauge.
So the question is, do they run this cool? Heater works fine and the gauge goes up past the N resting before the O when going up hills on the way to Tahoe. Is this a thermostat problem on a 20 year vehicle with low mileage, or am I going to have to bite the bullet and let the mechanic go wandering through the vehicle?
View 14 Replies
Was driving issue free most of day, when leaving a red light I noticed my i had to give the van some extra gas to get up and go, then i could feel the brakes getting tighter and tighter to the point where I had to park the van. So currently my van is sitting in a parking lot 30 miles from home with locked up front brakes. Both driver and passenger front wheels were hot to the touch.
View 11 Replies
1994 - 3.0 .... Back behind the water pump there is a stream of coolant what could that be. Water pump has been replaced earlier last year I thought that fixed it,there has always been a mystery leak..
View 6 Replies
2 or 3 years ago my airbag light started blinking. 120,000 miles, only owner. The code changes daily. Then the car started reviving at highway speeds. Then cruise control wasn't reliable. Sometimes when I hit a bump, the cruise goes off. My mechanic said the reviving felt like it was going in and out of overdrive, so he rebuilt the transmission. No change. This past month, the car started to pull to the right. It felt like I was driving with the brake on, couldn't get up a small hill. Before I could get the car home, the brakes went to the floor and the car stalled. I had it towed to mechanic.
After 10 days, he couldn't duplicate problem, so I took the car back. A few days later, after 4 hours of errands in the hot Texas sun, it did it again for me. Pulled to the right, driving with the brake on feel, brakes to the floor. This time it smelled like something was burning, either brakes, belt or something, and the rear ABS light came on for the first time. Latest mechanic says it is probably a brake booster, but that doesn't explain the reviving does it? I've had it to 2 dealers, 3 mechanics, and no one has a clue what to check apparently. I am a senior, so I can't really start replacing everything. What should I tell them to check, and in what order? I love my Aerostar....
View 14 Replies
About two years ago I sold my 1994 Aero (transmission was going, and other stuff) and bought a 1997 that was in much better shape. But one flaw it has is that it was used somewhere with high corrosion, so a lot of stuff is stuck or rusty. I haven't changed the rear bulbs since I got it, but this week, 2 out of three bulbs went. Actually, I only noticed the 2nd one because the blinker went too, and started blinking fast. The 3rd Brake light on top might have been out a while already.
Anyway, to my frustration, I cannot open the 3rd Brake Light to change the bulbs. Even after I removed the 2 screws, the lens won't budge. I tried gentle prying, but I can hear the plastic starting to crack. I figure there are 2 possibilities.
a) It somehow got fused to the gasket over time. or
b) It was crazy-glued shut by some insane maniac (a long-shot?). In which case I can try Acetone.
For starters, once the screws are removed, does just the red lens come out, or does the black frame around it come out with it? I tried prying on both, but one of them is surely wrong. Worst case scenario is that I break it, and have to glue it back on or get another one from a junk yard. But that is not good... Meanwhile I am living ok with just 2 brake lights.
View 5 Replies
My 1994 Aerostar, with 100,000 miles on it, started lurching at highway speeds. Weeks before this, the airbag light began blinking. The transmission man said it felt like it was shifting into overdrive, then out, then into overdrive, then out, etc.,etc. About this time, the cruise control quit being reliable. Dealership said codes didn't show a problem, "I must be mistaken". Then they said it sounded like a fuel filter.
View 6 Replies
Looking for the fuse that controls the overdrive torque converter clutch/lock up/engagement. Had a look in the owner's manual, didn't find anything. Pulled a couple fuses that I thought might be the one, no go.
I had found this fuse b4 but now a couple years later can't remember which one it is and can't remember where I found the info on what # the fuse was.
View 14 Replies
Every morning for the last 3 days I've gone to go warm up my car and each time i turn on the car only from a cold start up i hear this loud high pitch noise from the motor. If i turn the car off and restart it. It goes away and the car is at perfect idle. what is this and do i have some serious problems?
Is this true? If it's only on a cold start up, and then it goes away during normal driving, you have no need to fear....that's the Secondary Air Injection Pump that turns on during cold starts, and the plastic hose just needs to be replaced.. If so where is it located so i can replace this hose.
View 5 Replies
I just replaced the water pump and put it all back together, now it won't run well enough to drive. Checked vacuum system, all sensor connections, hoses, gas cap, changed fuel filter, I can hear the fuel pump kick in, reset system with battery disconnected and have looked at everything I can think of so far.
Now - starts fine, idles about 10 seconds and then begins to idle rough and dies. If I use the throttle I can often keep the idle up, but then backfires or acts like no fuel and again dies. Used fuel cleaner and made sure there was plenty fuel in tank.
I am looking at replacing sensors at this point but which one first?? They get a bit expensive real quick.
View 5 Replies
i have a 96 toyota celica sx which makes a horrible noise when i start it, its almost like a high pitch rattling noise, usually goes away when it warms up but sometimes still making it accelerating, think the noise is coming from area which is in the photo, what it is?
View 7 Replies
When going short distances, half mile to two miles, and I turn off the car it will not REstart. Dash lights come on but engine does not make a sound. No clicking, no engine trying to turn over, nothing. After the car sits for awhile and cools off it starts up with no hesitation at all. If on the road for several minutes the car does not have this problem no matter how far or how many times I turn it off and on. The battery checks out ok. Someone said it could be a ground wire loose. What do you think. Is this something I could do myself?
View 5 Replies
