Ford - Escort :: 1992 Engine Dies Where Just Driving (or At A Stoplight)
Oct 14, 2014
1992 Escort GT 1.8 liter ... It's been a problem for a while, where I'll just be driving (or at a stoplight) and the engine dies. It doesn't sputter or give any signs (that I know of) before it goes. Usually if I let it sit for a while, generally under an hour, it'll start right up again and run for a few days and then happen again. The engine light will sometimes come on, but only after I get it started up again, and it never stays on for long. The other day, it died on my way to work and didn't start up again for a few days, but the engine light was on, and gave a code 23. I think this means I should get the throttle sensor fixed.
View 1 Replies
Advertisement
I have just inherited my recently deceased father's 1992 Ranger with the 2.3 liter engine. He was a Ford Mechanic but got to ill to worry about fixing the Ranger. So, let me begin, the engine dies randomly, (at idle or in gear driving doesn't matter what gear or speed), turning key to off and then to on will allow vehicle to restart every time. No "Check Engine" light has ever lit, I do have an "Antilock" light that comes and goes. The engine codes I keep getting are: 10, 218 and 222.
Code 10 is a computer check code,
Code 218 is "Loss of Ignition Diagnostic Monitor (IDM) signal/left side, and
Code 222 is "Distributorless Ignition System - Loss of right side ignition diagnostic monitor (IDM) signal.
These codes were from my Innova reader. I have read where other similar problems were fixed with a new Crankshaft Position Sensor, replaced mine, no change. Another symptom I just noticed is my temp gauge stays near the cool end when it should be higher.
View 14 Replies
Car basics: 1992 Chevrolet S104 cylinder2.5 L
Have in the last 4 months replaced :
(1)fuel filter
(2)fuel pump and spark plugs
(3)EGR Valve
(4) Vacuum lines (possible vacuum leak)
Problem: Car will turn off while driving, sometimes after a service engine light comes on. Usually at 40-65 mph, car will shut off with electricity still working. When I attempt to start the car afterward it will turn over, but will not catch. Have had to be towed twice, other times, we waiting we it out, came back later and it started up just fine.
Attempts to solve: Various points I've brought it into a AAA shop, and they were unable to figure it out without the check engine light on (pre-1996). I finally did get the codes read, and they were for the EGR Valve, and the MAP sensor. EGR replaced, test on MAP sensor showed no problems afterwards. codes were cleared.
Yesterday: Last night the car turned off randomly on me again, and had to get towed home, today it took a few tries, but then the car started up just fine. Took it to the shop, they reattached a loose wire from the spark plugs, and are asking me to replace the (1)wiring, (2) coils, and (3) rotor head but without the check engine light on this morning, they are not 100% sure where the problem exists. The car sometimes runs fine, but since I am going to be working pretty far from home, I need reliable transportation. Everything else is in great shape on my little pickup, but this has been racking my head for a bit.
View 3 Replies
I have a 1992 Ford Escort. It's a junker (literally - it has a recovered title, the car having been totaled at some time in the past), but it gets me around. Or, it did.
The battery went dead a while back, and I'd been using the wife's car. She had to be out of town, so I got a new battery. Car started right up, but I couldn't get the transmission out of Park. I think there are switches to make sure that the brake is on, etc., that have to be made before the car can be put into gear. Is there anything I can do? Where are these switches? Obviously, I can't drive the car to a shop, and I'd prefer not to have it towed unless there's no alternative.
View 2 Replies
I am repairing a 1992 Celica GT w/2.2 litre I4. Just replaced the TPS. Now, it will only idle. Any caressing of the accelerator, and the engine dies. Will idle smooth as glass for abt 5-10 minutes, then begin idling rough, and then die. Will not allow me to restart immediately after it dies. Must wait 10-15 minutes before restarting. When the vehicle is placed in gear, it will continue to run, but the moment the accel. is pressed, the engine dies.
I think part of it may be vacuum-related.
View 4 Replies
95 Ford Escort shuts down like you turn off the key. This just started happening with no warning. Idles fine had to replace the plugs,wires and the dist.pack.
View 1 Replies
Iv got this escort from my sister, i assume it has been hardly maintained considering the... state. I bought it because she was tired of dealing with the problem... driving, it will turn off. She said it got to the point where she just stopped driving it, although it only happened twice. It began when first time it shuttered then died. Took air filter off and it only ran it like that to get it home. Now it doesn't run but for a few seconds even without air filter, so Its the best choice to leave in.
Anyway, I've replaced:
-PCV Valve
-Fuel Filter
-Some dry-rotted hoses
-I didn't replace it, but i cleaned throttle body and MAF sensor in the intake.
I've tested alternator and batter, both are good. I tried fuel treatment. Being honest this is the extent of my.. automotive understanding. But Im fairly certain it is a fuel system problem.
View 1 Replies
car revs real high sometimes, other times just won't idle for long with out dying. getting harder to restart after it dies.have changed fuel sensors, oxygen sensors, throttle sensor,mass /map sensor. Whats going on with my car!
View 4 Replies
Girlfriend has a '92 automatic. Transmission's been acting up for several months, periodically not wanting to shift into higher gears. Now, it will not shift at all after the first one, about 20 mph. Engine whines, but has power up to about 50 mph. Odometer states 64,xxx miles but don't know if accurate.
Need info on possible causes, other than total rebuild. Been reading about speed sensors, shift solenoids, control modules, as well as replacing fluid/filter and adding a treatment.
View 7 Replies
I have a 92' Escort GT and the clutch started to act up, it's not burnt cause it is fairly new. The clutch pedal feels slightly looser when pushing it to the floor, the feeling like a cable snapped or something?
I'm pretty sure the clutch is a hydraulic one, not 100% .. Is there a hydraulic reservoir that somewhere that might be low?
View 4 Replies
Recently, today in my 87 Ranger suddenly the engine dies and all electronics in the cab fail.
I noticed under the hood that the fusible link connected to the battery and an orange and black wire was smoking. Tracing this line i found that it leads to the ignition switch, as well as some other places.
There is another fusible link and the junction between the yellow ignition wire and the orange and black wire from the battery. This fusible link also was failed.
I'm planning on replacing the fusible links tomorrow but in case that does not fix it, where to look next.
The problem only occurs when the key is in the ON position. I'm thinking maybe I could do some tests with a multimeter on the ignition switch but am not sure of the details of what I should test for.
Summary: Fusible Links C, and E burn out when the ignition is in the ON position.
View 6 Replies
I have a quick torque converter question. I have a '92 F-250, 351W, E4OD. When I come to a stop the engine dies. I know it is the torque converter clutch staying engaged. I do have a TCC code stored. I'm wondering if there is a way to disconnect the TCC so it never goes into lock-up, since it only seems to happen after I've reached higher speeds and it goes into lock-up. I thought maybe a wire from the PCM to disconnect? I have All-data access, but it doesn't have wiring diagrams for the trans. Which wire, color and pin number, and if this will work? I know it's not the proper repair, but I have $17 into this truck, it's pretty rotted, and I'm just looking to get by until spring. I don't drive much, but occasionally I need to get somewhere.
View 14 Replies
My right rear supercab door will not stop squeaking/chattering when driving or idle at a stoplight.. I know this is a common problem for these trucks but how do I fix or dr it up?
View 7 Replies
I've got an issue with my 92 2.3 ranger.... sitting at idle for 30 or so seconds it starts to chug and sometimes dies.... I can hit the throttle and its fine for another 30 or so seconds.... while cruising on the freeway after about 30 minutes it starts to cut out badly... let out of throttle for a few seconds and it clears up and drives fine...
Here's the part that has me confused... pulled codes yesterday using a innova scan tool...
koeo were 4, 10, and 538...
koer were 111, 10, 157, 158, 181, 327, 328, and 334....
How does it give me a 111 pass code and then still come up with all the other codes? I am thinking my ecu may be screwed.....
View 4 Replies
While driving my car on the highway the engine died on me. I made several attempts to start the car again with no success. The mechanic has yet to find what the problem is. He has checked the timing belt, fuel pump, and everything else.
View 2 Replies
My 1985 Saab 900 turbo has been dying while being driven. Suddenly, and usually while the car is relatively hot and in traffic, the engine will die while driving. Usually it will die when at a light stopped but not always. This has never happened before the last week or so, but the car has always had trouble with cold starts and will die while idling when the ignition is first turned. This hasn't been diagnosed. At times a lot of smoke will come from the exhaust, and this has not had a trigger (too much oil, hard driving, etc) but the car did pass smog in California (the strictest state!). Just now, a light I've never seen (and I've had 2 80's Saabs) came on the dash which said EXH, which I read could be regarding the o2 sensor?
View 3 Replies
I bought my 2007 Santa Fe with 112,000 miles in April. It ran fine until about a month ago. When I turned the key to aux, the radio and lights came on but when I tried to start it I lost all power. Turning the key off and back on had no effect, it acted like the battery was dead. I opened the hood and noticed the pos cable was loose on the terminal. As soon as I touched it I heard a click, the security light started blinking and it started fine.
A week later as I was driving on the highway the electricity started blinking in and out and the car would shutter as it lost and regained power, then eventually died completely but the radio was still on. I got to the shoulder and tried to turn it back on but even though the radio and lights worked, nothing happened when I tried to start it. I lodged a matchstick between the pos terminal and the cable to make sure the connection was tight and it started. Driving home the power would occasionally stutter when I hit a bump but it never died completely.
I used a battery and alternator tester that plugs into the cigarette lighter and both registered as fine. I've driven it to work, about 2 miles, several times since and the power sometimes cuts out at bumpy parts of the road and it has died completely twice while sitting still at a light. The clock doesn't reset when it dies so, knowing nothing about electrical systems, I would guess that the electricity isn't being entirely lost. Every time it dies the radio and lights still come on but I have to get out and jiggle the pos cable to get it to restart. While driving the battery and seat belt lights flash randomly. A friend told me to try removing the pos cable while it's running and that if it died, it was probably the alternator. Tried it and the engine died immediately. Don't know what this means since the alternator tested fine.
View 6 Replies
I just had my 04 5.4l engine rebuilt. Ive driven it about 500 mi and it started running rough at a stoplight. I tapped the accelerator and it started running good again but service engine light came on. I pulled the codes and they were P0022, PO345, P0340,and P0430. It has done this several times now. Everything was replaced including the phasers, except for the camshaft sensors. Could they cause this problem?
View 3 Replies
My 1989 Honda Civic engine randomly dies usually while driving. When it dies I hear a relay click sound coming from the area of the glove box. The tachometer and speedometer go immidiately to 0. The dashboard indicator lights all go out. The turn signals windshield wipers and electric windows all quit working, but the emergency flashers, radio, and comfort system blower continue to work. I think the transmission goes immediately into neutral too because deceleration is much slower than it would be if the engine were running and I take my foot off the accelerator. So far I have always been able to restart the engine and continue driving, though it often takes many tries before it will successfully restart and keep running.
In an unsuccessful restart the engine will fire and start to rev up but die again as soon as I release the key from the Start position. Occasionally the engine will spontaneously restart while we are coasting to a stop. We took it on a long trip this summer and it would almost always work fine until we stopped for gas, food or restroom break. After the break it would die one to three times in the first 5 miles and then would work fine until the next break. My mechanic says the computer is not storing any failure codes and he is having a hard time troubleshooting it because the problem only randomly occurs. I'm wondering if the problem might be a flaky electrical connector somewhere.
View 5 Replies
Yesterday while driving to work the acceleration on my car just died; the engine was running and the car was in drive. I lost power steering and all the dash lights came on. I was driving down the road about 55mph and it just died, but the engine stayed on. What could cause this problem?
2011 Toyota Camry LE ...
View 7 Replies
At idle (like at a stop sign or sitting in the drive way) my '92 Toyota revs up and dies down (kind of a "brrrrvvvvvv-buh... brrrrvvvvvvvv-buh") We have been fixing it up and got ahold of another Toyota that has a decent motor but the body, frame, and everything else is shot. We are pulling a starter out of it and was wondering if the part that causes the gallop could be replaced too.
View 4 Replies
