I have 2001 EX with the 7.3 and my rear vent windows stuck open and I am stumped as to what might be the culprit. There isn't any power getting to the switches in the overhead console.
I replaced the relay 204 in the engine compartment, I believe that is the correct one.
Where the actual fuse is located for this and its number? Because both of them are stuck open not just one side.
My electric rear vent windows seem to have a problem opening when the temperature is cold outside. They work almost perfectly when the weather warms up, with the exception of an odd little glitch here and there. Generally summer is good, winter is a no-go. I understand this is a common problem ???
Even at the times when they don't open I can clearly hear an electronic click near the back pillars, with each push of the control switch up front, so I assume the current is making it at least that far and there is no problem with the wiring up to that point.
I have recently removed two used actuators (R+L) from a donor vehicle, and will likely be installing those into my van in the very near future. Although I believe they came from a close but different year windstar which did not have the exact same "rivets" through the window as mine does. External arms etc that can be seen do look identical as does the pivot ball.
#1. is replacement of the actuators a likely solution to the problem ?
#2. by chance, is it merely just an issue of dirty connections with my present actuators ?
#3. can / should I do anything such use dielectric grease on the connections of either my present ones or the donor ones upon replacement, to alleviate future recurrence ?
Is it possible?
View 1 Replies2008 Ford Explorer with 100,000 miles on it. My wife's car, and the last couple of times I've driven it I get a whiff of gasoline every now and then. I've looked at the engine and underneath the vehicle and have found no visible signs of a leak. Last night I walked by the car and smelled gasoline around the driver's rear quarter-panel. That is the opposite side of the fuel tank filler tube but it makes me think it could be fuel tank related. Where to start looking? Maybe a pin-hole in a line somewhere? Fuel filter? Fuel pump?
View 3 RepliesI recently purchased a 2001 XLT, 5.4L RWD. It has the rear windows with actuators installed. The upper console has the vent switches to open and close them. They don't work. I removed the upper console and the vent switches have no wires running to them and no visible wire harnesses that have been cut or removed.
With the headliner removed, I chased the wires from the actuators (white with brown/yellow with brown on the right and white with blue/yellow with blue on the left). These four wires meet up over the right rear door and run in a bundle to the upper console where they seem to end in the plug for the Rear A/C controller. There is no indication that these harnesses have been altered. They appear to be taped like they came from the factory.
My questions are, were the opening rear window vents standard on the XLT or only on the Limited? If only on the limited, would they have installed actuators regardless of what model and just dead-end the wires into open plugs? There may be the chance that the upper console was aftermarket because there is a price tag sticker on it...
I bought a used 2013 Santa Fe Sport 2.0T Limited in August from a Hyundai dealership near Vancouver, BC. The vehicle had fairly high mileage (95K) but had been well-cared for and I got it for a fair price.
After a few days I noticed there was a "crunching" noise coming from the rear driver's side quarter panel area when going over the u/g parking ramp into my condo. The rear seats also jiggle and rattle at moderate speeds. Didn't really notice either on my test drive before buying it, as I just went over smooth roads.
I searched this forum and found some good leads, such as the inner quarter panel being loose, rear trailing arm issues, or perhaps some faulty welds. I printed out this info. reported by other owners and brought it to the dealership.
As kind of expected, the technician each time has said he couldn't hear anything unusual. (selective hearing?) The suspension system is supposedly sound.
My friends and family members all hear this creak (under the right conditions when the rear wheels are at uneven heights)...it's not my imagination. I've taken out the styrofoam cargo support and nothing changed.
I had a loaner 2015 Santa Fe and there was no such noise.
The rear seat jiggle is also irritating. I've experimented with putting the seat backs at different angles and nothing really works.
The vehicle has about 500KM left on its 100,000KM warranty.
getting access to the back of the rear quarter panel for paintless dent repair? This is for a 2 door 2012 Golf 2.5L.
I've heard from a few people that there's likely some sort of access point for this car but I haven't gotten any specifics. I'd rather not have the PDR guy drill a hole in the wheel well for the needed access.
I do see what looks like factory hole with rubber cover behind where the door closes (lower part) ..
Here's the location of the dent (dent itself is not visible at this resolution, but it's right at the point of the crease):
I am hearing a squeaking noise by my right rear quarter panel inside the cabin. How to safely remove the panel. I tried searching but the instructions were vague.
View 3 RepliesHow to remove the interior trim on the rear quarter panel?
View 1 Replies2001 excursion 4'4 V10 XLT.
One or more of my door switches is stuck in open position. Door ajar light on and interior lights on.
Interior lights stay on for about 15 min than go off.
I have sprayed all 4 doors and both rear hatch lock assemblies several times with WD40 and electrical cleaner with no improvement.
When I open drivers door there is no key chime with key in cylinder. Could the hood switch cause this issue? How do I determine which door/doors is/are the offending crimimals?
Just got took delivery on a 05 Phaeton. After reading thru most of the newbie FAQ section and getting all the setting done on the vehicle, I turned off the ignition and the center vent wouldn't come down.
Instrument Panel air vent cover (decor panel) stays open, does not close when it should...
I tried getting it open and close a couple of times via the climate control with no luck. I tried starting and stopping the engine, the locking and unlocking from the outside.
I have a santa fe 2002 2.7 gls 4X4 automatic. I put today for the 1st time supreme gaz and the level of the gas stuck in the 1st quarter even if i turn the engine off...
View 1 RepliesMy driver's side air vent is stuck in the open position. I can coax it down with a piece of wire, and it will then (sort of) engage with the motor and move up automatically when activated (again with a bit of coaxing), but then gets stuck again... Not sure if it's the motor or gears/teeth on the vent itself...? Looking for instructions for removing the motor? Apparently it's straight-forward...?
View 5 RepliesI just identified an annoying squeak as the right side of the tailgate, right at the hinge, rubbing on the section of the rear passenger side quarter panel (one with FX4 decal) where it curls around to the rear. Any way to easily adjust the tailgate slightly to the drivers side? When the tailgate is up, the gap is noticeably smaller on the passenger side, and when down, the edge of the tailgate rubs the edge of the quarter panel, paint to paint.
View 1 RepliesMy passenger side rear vent window is leaking and I was gonna redo the weather stripping but I can't figure how to release the latch from the motor. It looks like a ball and socket type connection with a little wire clip in it, but I tried pulling it out and it wouldn't come out very far, and tried pushing in in more but no luck. I don't want to break the darn thing for sure.
View 9 RepliesMy passenger side front and rear windows dont work. Both driver side windows work, just not the right side/passenger side.
Also when I press the master door lock/unlock switch on the driver seat, every door except the rear passenger door works. It stays unchanged so I guess it is not receiving a signal or something is not letting the signal reach the lock.
I need to get to the filter in the rear ac panel. What is the best way to go about removing the Panel? How much do I have to remove?
View 6 RepliesThe "door open" light is stuck on and the truck thinks one of them is open. I went around and slammed all the doors and it went off. Didn't think anything of it till we went on a road trip and now its stuck on. No door slamming is working. How to unstick the sensor wherever it is?
View 14 RepliesWhen I'm driving and I open just the rear windows - I get a buffeting, choppy, shaking noise - kinda like the whop, whop of a copter blade. The first time it happened I thought I had a flat tire. Is it the cover for the cargo area?
View 15 RepliesThe dashboard on my 01Ex are getting dimmer.......not a good combination but we both have alot of miles on us and stuff just wears out!
In what limited information I can find it looks like I have to pull the dashboard to get to these things. Seems extreme to pull a dash, but then again this is not my 67-Rambler.
I just bought a 2010 RX450h and it is in overall great condition. The leather is damage though on the Rear Driver side door panel, so I am trying to remove it and get it repaired. I have removed 3 screws :
-one behind the door open/close latch
-one under the wood/window switch
-one in the handle area to pull door and close
I am now trying to take the panel off and have the bottom part pulled off. But I can't seem to pry open the top part... Am I missing something or a screw? Is there some trick? I am scared to break it.