Ford Excursion :: Clunking Noise From The Left Front Going Over Bumps
Apr 15, 2014
I need to replace the rubber axle bumper guards. I have a clunking noise from the left front going over bumps. Troubleshooting I found the left front axle bumper guard is missing, right side is missing chunks and dry rotted. I had a question about how they attach. The one that is missing looks like a rusted bolt snapped off. Is it safe to assume a bolt goes right thru the center of the bumper guard into the frame? Couldn't tell on the right side it is in bad shape. Right front bolt may have sheared off on the bottom and just held in on the top by what is left.
View 5 Replies
Advertisement
So about a month ago my 2013 Sonata GLS started to make some clunking noise going over the littlest bumps over the road from the front end on both right and left side.
I brought it to one mechanic and they said the rack and pinion needs replacing which is an expensive fix. I couldn't believe that was the problem as I had no leaks and it was on their solid. I ended up taking it to my uncles mechanic and he stated its the stabilizer links on the front right and front left wheels. My way to work has a lot of bad pot holes... so I'm hoping that the stabilizers are actually the problem.
Anyways, tomorrow I will be bringing it to the mechanic to have them both changed. I know a lot have been complaining about this issue and instead of replacing the rack and pinion, I thought I'd try and see if it actually is the stabilizer links and provide a fix for some of the sonata owners on here.
View 28 Replies
I bought a 2000 F250 V10 Super Cab. Oddly after a few weeks it has grown on me. There has been a clunking noise out of the right front over bumps. I traced it to a bad axle bearing. The u joint moves up and down about a 1/2 inch. Besides pulling the hub/bearing assembly out and removing the axle are there any surprises getting the old bearing out?
View 1 Replies
I have a 2004 2WD supercab. And am hearing a 'clunking' sound when I turn almost full-lock. Below is a summary of what I have experienced so far:
- My truck used to be lowered 2" (below stock) at the front since new. Last month I lifted it (front and rear) and it now sits 2" above stock on new rancho shocks.
- I installed a camber kit and had the front aligned (toe and camber) after the above suspension work.
- The truck drove beautifully for two weeks until one day a 'clunking' sound was heard from the front-left every time I turned left. The alignment also changed as I had to now hold the steering very slightly to the left to drive straight.
- The alignment shop re-did the toe tracking (the camber did not change) and the truck drove great for about a day. Now I can hear the same clunking sound when I turn right and the tracking is again screwed up meaning I need to hold the steering very slightly to the right to drive straight.
What parts are playing up and what may need replacing?
View 2 Replies
I've had a front end clunk best felt on the floorboards at very slow speeds on uneven ground. I've read for a month on this site on this issue and have replaced the ball joints and sway bar end links with Moog parts. New shocks also. Well I've improved but its still there. I cannot budge the trac bar bolts with breaker bar. The axle u bolts seemed loose so I tightened them but I'm not sure of the torque specs on them. What are the torque specs on the u bolts and where to go from here?
View 14 Replies
I plan on replacing as I have a clunk happening. Thought I'd try here first.
Is there a brand that's better? 1Aauto has OEM. Is there a brand that's better or makes a difference?
Or is a front sway bar end link a front sway bar end link?
View 7 Replies
I have a noise in the front end that is only happening during suspension travel. It is really bad on bumpy roads. I thought it was my sway-bar end links but they are a year old and tight. I have checked the shocks and they are tight. It sounds like a clunking noise. Could the front drive axles be making this noise while not locked in?
View 14 Replies
I have a 2000 ford excursion limited when i drive a loud clunking noise comes from the front end, so i pulled the front passenger tire off and realized what looks like the axle bearing behind the hub assembly is rattling around. What part is that. I am going to post a picture tomorrow in the day light.
View 2 Replies
Driving at hwy speeds and head a pop noise in front end. Stopped and couldn't find anything, heard it a couple of more times, still nothing found, now I have a grinding noise left front wheel. What the issue may be. 2001 Ford EX 4X4.
View 6 Replies
2004 PSD 4x4 72k. I thought I would be proactive so I bought the front ball joints and have plans to install them but recently I starting hearing (and feeling) a clicking sound in the front LEFT when I make sharp turns to the left and hit small bumps now and again. I jacked up the front end and am able to get 1/4" of movement front to back (top to bottom so not steering) in the wheel.
I narrowed it down to the hub. I took it apart and it is most likely a sealed unit so no adjustment is possible....that I can see.I pulled out the locking hub and got as far as I can to know there is not an adjustment. Need to confirm that it indeed is a sealed bearing and if so what are the part number(s) I may need to repair it.
View 14 Replies
Had a grinding noise in my front end, left side. Found the hub was bad so got it replaced. Now I still have a grinding noise that comes and goes. If I hit a bump, it starts the grinding noise but nothing constant. Had the front end checked and nothing was obvious. Was trying different things and when I put it in 4WD, with the switch on the dash, the noise goes away. What to try next?
View 2 Replies
I have a 2001 Escape XLT, when driving thru a parking lot or otherwise at slow speed and hitting bumps, I can hear a clunking sound from the right front tire. Its especially bad if I drive over cobblestone or on a dirt road. Could this be the CV joint? Ball Joint? How can I tell what it is?
View 4 Replies
I've got a 2000 Accord. I recently started hearing and feeling a hard knocking/clunking noise at the front-center of the car during the correct after a left turn. My trustworthy mechanic told me the subframe is rusted out on the right side and that it isn't safe to drive until the subframe is replaced (he also said he's seen several of these this last year). He suggested that the cause is that the hose leading away or down from the air conditioner is too short, and leaks directly onto the subframe. There is no recall on this problem currently. I've done some Internet research and there is some buzz about this, but not as much as I was hoping for.
View 17 Replies
'01 Taurus with an occasional rattle/clunking sound coming from the front end when going over bumps. Took it to the local shopping center auto. service dept. (probably 1st mistake I know) They say the only thing they could find was the RH CV boot was bad and was probably the source of the noise. Doesn't sound right to me since the boot is rubber and what I hear is more of a metal sound..what I was thinking possibly a suspension link or tie rod end. I know what a bad cv JOINT sounds like and it's nothing like this. Now if the CV boot is bad I don't mind to replace it, but I don't want to spend the money if it is not going to solve the problem. I've never heard of a boot making noise before.
View 2 Replies
I went to check out a '03 7.3 SD the other day. It didn't seem to have a lot of surge when I accelerated to freeway speeds. Kind of lazy feeling. Didn't smoke out the back though. It did have a front end clunking sound going over the parking lot speed bumps. I opened the oil fill cap while it was idling and it blew a plume of vapor/oil about 9' high like a steam engine puffing. Held my hand over it and got a oil wet palm after just a few seconds. I'm hesitant to drop any $$ on it.
View 6 Replies
Aside from the clutch and gear changing noise, recently I've been noticing something that sounds almost like a rattle when going over bumps, say a series of filled potholes on a highway where they just slightly bump to move your wheel around, it's not that deep thumping you would expect to hear but it sounds like something is loose in terms of the suspension.
Happens on the front and seems like its coming from both sides. To me it sort of sounds like they forgot to tighten something up when they removed the shipping "blocks"/spacers, but I am not exactly sure what to check. I really do not want to visit the dealership at only 600 miles on the clock ...
View 5 Replies
I cannot figure out where the noise is coming from. I cannot duplicate the noise just by shaking the truck even with two guys on each side. It's not a squeak, but more of a clunk or a pop. I can feel it in the floor with my left foot if I press it against the fire wall where it meets the floorboard.
View 14 Replies
I have a clunking noise from the right front suspension when going over bumps. I've replaced the Strut bushings that were collapsed, the control arm bushings that had play and the noise is still there. There is no play in the links. There is a slight noise in the sway bar bushings when struck with a rubber mallet. I hate to keep replacing parts chasing down this noise.
View 9 Replies
Clunk in the front end when going over speed bumps? That is the only time I ever get it, never on bumpy roads or anything like that just at speed bumps. It seems to be louder on the drivers side but I am pretty sure its on both sides. I never noticed it until a couple speed bumps were installed along my normal route, but that could be because maybe I never drove over them previously?
View 3 Replies
I can't find the obd port on my new 2007 SF. Also there is a clunking coming from the front suspension when i go over bumps, what is the most common cause of this?
View 13 Replies
I am losing my mind over this. I bought a 2013 c63 in May and the last few months it has been making this clunking noise. I have taken it to the dealership 3 times so far and each time the noise goes away for about a week only to return worse than it was. It used to only make noises when I turned right on incline changes at low speeds. Now it makes the noise going over any bump at any speed.
The first time I took it in they replaced the front left strut. The second time they replaced the front right strut. The third time they replaced the lower control arm.
I am posting 2 videos of the noise. This video is between the first and second visits and the noise can be heard around the 24 second mark.
[URL] ....
This second video was taken today, 2 weeks after my third visit. You can hear the noise continuously throughout the video on any slight bump.
[URL] ....
View 11 Replies
