My Excursion keeps blowing fuse #45, a/k/a "Ignition switch Run/ Start feed"
Going to have to go in shop. Seems to be a short in the steering column.
Then the dash lights go dim, headlights die, engine sputters and dies. I am guessing alternator most likely.
These two things might be related? Maybe there's not a short in the steering column, I dunno.
I keep blowing the fuse to the headlights. When low beam is on, the right blinker flashes the low lights. When high beam is on, the blinker works. when I turn on the low lights, my cluster light indicators show the right blinker dim and the high beam indicator light is also dim.
View 1 RepliesAs the title states I have a 2001 f250 with the 5.4 4x4 and lately the auto headlight / overdrive fuse keeps blowing. Both seem to function just fine but a couple of days later the fuse will be blown. I am not functioning the OD button when it blows so I'm guessing its something with the headlights. What else does that fuse protect?
View 2 RepliesEvery time I step on the brakes, there is a bright spark in fuse #13. My brake lights, turn signals and hazards don't work. At this point my truck isn't drivable.
According to the owner's manual in my truck, says circuit #13 is for "stop lamps, CHMSL/hazard, trailer tow stop lamp, and speed control."
I'm assuming that the hazard part covers the turn signals as well, but I know the cruise control works even when the fuse is blown. I used it last night on the way home (this was before I realized I didn't have brake lights).
So I know I have a short somewhere. The only mods I've done to the lights are the aftermarket headlights, but if the fuse only gets blown when I step on the brakes, I don't see what that would have to do with it. Also, these lights have been installed and working for about a month before this started. The only thing that I did around the same time was install the gauges. I ran the power to them from #5, the customer access circuit.
Are there any other "common" areas for this to happen? I already removed the rear brake lights and it didn't work. I am quickly running out of 20A mini fuses.
Fuse #27 keeps blowing as soon as I shift into reverse.
Prior to shifting, everything works as it should - I've unplugged the rear sensors, back up lights, trailer plug, and each time, fuse #27 keeps blowing.....
Where I should look? Also - looking for a 2003 excursion wiring diagram that shows what all fuse#27 controls?
I have a 2000 Excursion V10, I keep blowing the #19 10A miniature fuse while I am going down the road. All gauges and speedometer all of sudden die but the vehicle keeps running until I turn it off. When I try to restart she won't fire until I put a new fuse in.
View 14 RepliesOk I keep blowing fuse #3 in the interior compartment. Let me preface this by saying I have my always-on power for my rear view mirror which is the display for my back up camera, pulled from a wire that is fed by this fuse. The camera is on reverse power only and it pulled from the reverse lights in the rear of the truck, but the always-on power is pulled from this location for the display. Doesn't matter if I have always-on power to camera if the display fuse it has blown and I am guessing the mirror power is the source of my problem.
The fuse controls the OBD and the cigarette lighter and it seems to blow every time I plug anything into that power port that is more serious than say a phone charge. When this fuse goes then my mirror display is down, and back up camera is mainly used for hitching up a trailer solo. My camera is pointed straight down at my hitch ball and it makes hitching up by myself very easy.
I have a volt meter but not sure where I need to test, and well what a bad number is when I do test it? The mirror instructions say to pull always on power under the dash and the right wires are attached, and the fuse rating matches, so don't think it's a too much being pulled issue. Maybe a bad connection or maybe a relay issue? I had this fuse blow several times before I had the power mirror but it's certainly gotten worse.
Fuse 29 was blown when I got my truck, automatic headlights and overdrive lock didn't work. I replaced the fuse, the lights came on and overdrive locked out but when I shifted into park the doors locked and the fuse blew. How the door locks are related and why they would lock when shifting to park?
View 2 RepliesSo i bought an excursion 3 or 4 days ago and yesterday I went to install a double din dvd receiver. As I was installing something shorted out and I blew the radio fuse. No big deal or so I thought. Got the radio in and replaced the fuse but then the X wouldn't start. Went through everything and found a 5 amp fuse and a 15 amp fuse blown as well. Turns out the 15 amp fuse is for starter motor or something. Well I replaced the fuses and they kept blowing. Unhooked the radio completely and still keep blowing and the X is still obviously not starting. Pulled every relay I could in hopes something would reset and nothing. Any clue what it could be at this point?
View 14 RepliesMy 2000 ford excursion gauges fuse keeps popping. It started earlier this year and I couldn't pin point when it would pop. Now I'm sure after 30.00 worth of fuses that it happens when I change the gear shifter from park or rev to drive.
View 5 RepliesI posted earlier about the tranny in my 01 Ex v10 having a transmission problem. The show looked at it and found the O2 sensor had shorted out and in some way sending the truck in to limp home causing the tranny fuse to blow????
Any way they fixed it or so they said and I drove it for a few hours and it did fine. The next morning I drove it and it blew the fuse. (under hood box I belive #19) I took it back to the shop and they beat and banged on it....got it wet etc. and can not get it to do it again. I know whe have an electrical issue but what all runs off of the fuse that controlls the tranny?
Is there any online wiring diagrams of excursions or superduty drive trains? Where all to look for the problem?
A few weeks ago I took my 03 Caravan to a shop and they said my alternator was fine, but the Wal*Mart battery (which I assume is a piece of rubbish) reads a bit low. When the temperatures are about 25 Fahrenheit or below the engine will sputter a bit usually at stop lights and the headlights will dim then go back to normal brightness a few times.
Now that the temperatures are in the 40s-50s I am still having this problem, but not as pronounced and sometimes it happens rather randomly. There is now another problem to go along with it. If I have the steering wheel turned hard while backing up and am not pressing the accelerator I have almost had Edward (my name for the Caravan) stall on me instead of just sputtering. Sometimes I feel like the engine is surging a wee bit as I drive down the road if I have just let off the accelerator. In general the RPM seems a bit erratic at times.
The fuel economy is the same as ever, the belts are all new over the past year, spark plugs, and all that. Recently replaced the vacuum plugs where the cruise control would go as well.
I also tried jump starting - get same same result. Engine cranks, turns, and then sounds like it is just about to start up normally but it just dies completely. It seems to want to start but just can accelerate the engine high enough to keep it running. Almost like it's flooded on a carb motor.. 2000 V10..
View 7 RepliesLooking for a wiring diagram for a 96 model with 3.4 engine? The horn fuse keeps blowing and I don't know what else is on that circuit to check. The horn works when the fuse is replaced but the fuse blows at some time afterwards.
View 5 RepliesI have a 2002 GTI 1.8T with the AWP engine and tiptronic. There is a fuse in the picture below that blows as soon as the car is started. It is located next to the brake booster on the firewall. It does not blow when the ignition is turned on, just when the engine actually starts. I'm not throwing a check engine light, pulling a scanner code or noticing any of my electronics not working. I took a 20 AMP fuse out and replaced with another 20.....and have since blown 5 of them trying to diagnose the problem.
View 10 RepliesHave 2 problems that are giving me major problems.....especially with 100 degree heat in Dallas.
1. Ac stopped blowing cold last night out of blue. Still blows just not cold. Replaced bad fuse and drove for 5 minutes. Blew again. Checked out the control/ circuit board but looks ok. Really cant afford dealer.
2. Check engine light problem for months. Gas gauge wasn't working. Replaced fuel sending units and it fixed that but still light. Code says p441. Dealer said need solenoid valve. Replaced both the solenoid valve and the purge control valve. Still check engine light.
I don't know if sputter is the right word, but at low RPM (around 1500) I hear this sound.
View 14 Replies2001 Ex V-10 4x4. Ran like a top yesterday. Turns over fine but not even a sputter today. Plenty of fuel & battery. Has spark. Tried starting fluid, but nothing. No codes. Checked fuses and relays in dash & under hood. Fast forward an hour...
Went out and tried it again - fired up like nothing ever happened. Plowed snow for the better part of an hour, - ran like a champ again, smooth, no missing or stutters - parked it and shut it off. Tried to start it again within a minute or so and it would start, run rough & die. Tried a few more times with same results. Now it cranks fine but no start, no sputter. Gonna try a fuel filter tomorrow.
If it were the fuel pump, wouldn't it throw a code?
Why the 30amp PCM fuse located in the under dash panel would blow. Problem started while truck was running and a simple replace of the fuse would it it back alive again. Now fuse is blowing at ignition on. Truck is 1997 F250 LD.
View 7 RepliesI am having trouble with fuse 23 under the hood blowing while driving. I have read several threads on this issue but still no luck. I have removed all 4 02 sensors and ac relay and still about 1/4 mile down the road the fuse blows, and is giving the shift solenoid A shift solenoid B and the torque converter clutch solenoid electrical circuit. I have checked both plugs on the trans, I even dropped the pan and ohmed the solenoids out. I dont know what else to do?
View 14 RepliesDescription: It will crank over forever but not start. New timing belt water pump, etc, so it is not timing. tried different fuel pump relay. no luck. new fuse no luck. The radio fuse also shorts and blows when I change it. Headlight does not come on, but the cabin "ding ding ding" sound plays. Marker, turning, reverse, and brake lights work.
CHECK ENGINE LIGHT does not come on during key turn. I may know what caused it or it may not. Before all of this happened, my audio system fuse under the hood blow. It blew again after I installed a new fuse (immediately).
One day, the wires on a portable cigarette light pump snapped and the two wires had been touch. I noticed the truck stalled several times when letting off the gas and coming to a rolling stop. The fuel pump relay makes a click noise when I turn the key