2000 7.3 180,000 miles. It sounded like I was in passing gear from the turbo but not as loud or strong. The tach never moved like it would if it was in passing gear. We kicked it in and out of overdrive, pushed the O/D, no change. Then while driving it would just go quite/back to normal. Oh forgot, this was while pulling a cargo trailer with a total weight of about 4,500 lbs...
View 5 RepliesI got new tires a few months ago and when the shop was putting them on they said the driver's side ball joints had a little wiggle in them. I've noticed it has gotten worse and I am going to change them prob next week. I am just going got do both sides while I have it torn apart. I have found some great info on how to do that. I also have noticed some ratcheting sounds from the drivers side hub when I start the truck and accelerate, and then it feels like there's a pop and the sounds goes away. Also if I flip on the 4x4 switch while there is the ratcheting sound it goes away. Is that just from a vacuum leak in the system? I don't know a whole lot about that, or what hoses are vacuum hoses etc.
I haven't really looked in the manual that much yet. My big question is this, I was driving down the freeway going about 70 when all of a sudden there was a gear grinding type sound, kinda like when you try to start a car that has already been started and the starter teeth make that grinding sound. Could it be that the axle has started to get some play from the ball joints getting worse and then it just reached the right RPM to cause a crazy vibration? Or could the 4x4 have a possible malfunction to where it tried to engage but the truck was going too fast? It hasn't happened again, but I have not gone 70 again either.
I have a 2012 Ford 4x4 crew cab 150 xlt. 15,000 miles. When pulling my dump trailer I was stopping to turn and the transmission disengaged. Once I turned the corner coasting the transmission kicked back in again. During this happening pushing the gas did nothing but rev up engine. My dealer said if this happened that a warning light would of came on or a wrench would appear on dash but it didn't. He said then it didn't happen. This happened 3 times in 10 miles of driving. I had it in tow mode.
View 4 Repliesi have a 1997 f150 2wd and it has a 4.6 litre v8, it runs good but it seems to have no power when pulling a trailer anymore, it has 321,465 miles on it, original motor and transmission, it uses about a half a quart of oil every 2500 to 2800 miles between oil changes, the trailer i pull is just a small car trailer i have always pulled it with the truck, what could be causing it to lose power?
View 1 RepliesI took it to the dealer and they blamed the trailer. I told them that I have pulled two different trailers and it did it with both. Then he said that the trailer was not heavy enough to weigh down the springs. So now I not suppose to tow an empty trailer? Also my father in law has pulled the trailer with his Z71 with no shake and the other belongs to a neighbor with a 98 F150 with no shake. The vibration only starts above 45mph. Any clue as to what could be causing this?
View 14 RepliesI have a 07 with the 5.4 engine and it has started to jerk or miss sometimes when I'm pulling my trailer. I'm thinking about changing the plugs, but the dealership is telling me they will break off in the head.
View 11 RepliesMy truck makes a horrific screeching sound when it's loaded or pulling a small trailer (2000lbs) up hill. I discovered last night while I had it in drive, if I hold the brake and give it a little gas (like if you were trying to do a burnout) it will make the screeching noise as well. It won't break the rear wheels loose either, which makes me think it's down on power or the transmission is slipping.
My first thought is the transmission, but some searches on this forum describe U-joints or the carrier bearing as possibilities. The previous owner told me he replaced a U-joint just before I bought it, so I'm not ruling that out at all....
My truck specs: 1995 351 E40D 4x4 (manual transfer case & hubs), extended cab eddie bauer. 158k.
My 05 f-350 6.0 is giving me some problems. I have 311,000 on my truck. It had had its share of problems, at 80,000 it blew its first head gasket. Ford fixed that one!! At 199,000 it blew its second one. I had head studs installed this time. At 299,000 I had to replace two injectors, a new turbo, a egr delete kit, a new oil cooler, power steering gear box, and while I was burning 1000.00 dollar bills I put a new edge cts on it. IOne the way out day one it was 95 temp out side, the truck ran great coolant temp and oil temp stayed around 202 to 204.
Day two 70 degrees my o temp hit 235 while the coolant temp went to 210. Backed off the throttle to 60 mph. Coolant temp dropped to 202, but the oil temp stayed around 217 to 220. I can not make the oil temp go above 198 with out the trailer. The other thing that scares me the most is my coolant level dropped about a half gallon!!! It is not blowing any white smoke, there is no coolant smell or leaks that I can see, and the holding tank has no evidence of being over pressurized. The edge system does not give me any codes except for the two for my egr delete.
So the other day 2/3/2014 my dad and I went out during the snow storm for the people that needed assistance. That day I pulled a 95' RWD dually with a 4 car open trailer and pushed 4 people from one location. Then after I went to assist the tractor trailer driver. My truck is a 2002 F250 super duty 5.4L with 4:10 gears. I got him unstuck then pulled him a 1/2 mile up a hill.
Pulling a stuck semi out of the snow - YouTube .....
My husband and I bought a 09 f-250 with 58000 miles. It used to pull our travel trailer with no power issues. Now the rpms go up & the power goes down. It never gets hot nor any lights come on. It's been in the shop twice. The first time nothing was found. The second time we were told it was dirty fuel filters. The truck only has 70k miles...
View 2 RepliesA friend has a 2003 6.0,around 200000kms well maintained just had new injectors,filters etc. This truck is his bread and butter so anything that needs to be addressed gets it, pretty much touble free until now. Just out of the blue last week at driving @60kms/hr pulling an empty trailer it died no surge or sputter. Full fuel,oil etc,they tried to get it running and it would not fire up. His local auto shop pretty much gave up on it and it now sits at our Ford dealership. Thoughts are leaning to fuel delivery to electrical can we ball park some things that he can put forward to the dealer to get him in and out sooner.
View 10 Replies2002 7.3 4R100 ... The truck started flashing the O/D light pulling a 9K lb trailer on the highway.
The transmission codes read were P0705 (Range Selector) and P0873 (bad 3-4 shift - RPMs did not drop).
On the highway, the TCC seemed to lock up fine in 4th (OD button was set to leave O/D ON). When the truck would downshift (not often) then it would sometimes would rev high when it downshifted. It was like 3rd was slipping or it was downshifting into 2nd instead of 3rd. I think it was doing a 4-2 downshift but not 100% sure.
What confuses me is that if it is doing a 4-2 downshift then it would have to change state of both valve body solenoids. Is it possible that it was doing a 4-3 shift but solenoid was sort of sticking? Trans fluid looks fine.
I have read other posts where people had same problem (titled 3rd gear slipping), but they never seemed to resolve the problem in the thread. How likely is it that the solenoid is the problem? It seems to drive fine in 3rd when the O/D OFF button is pressed and O/D is not allowed.
2003 Ex limited 2wd, 6.0L ... Reoccurring wet floor in the rear right side of their truck? I am trying to figure out if it is a lift gate/door seal that has a leak or if its the rear A/C evaporator compartment.
View 14 RepliesI am wanting to put subs in the cargo area behind the 3rd row seats. Running power under the car back there? I'd like to come up between the 2nd and 3rd row seats since the amp will be right behind the 3rd row.
View 14 RepliesHaving problem with the left cargo door not opening!? You can pull the handle the cable moves but the door wont open, thinking maybe it a latch mechanism.
View 7 RepliesI need to locate the specs or blueprints of the rear cargo door hinges. Junkyards thus far, are not willing to sell just the hinges.
View 8 RepliesHooked up the trailer today for the first time, i have running lights, right turn signal, and no left blinker. left bulb looks good. dual filament. #6 fuse inside truck looks good, can't figure out why no left blinker... trailer worked fine on my previous truck. Not sure what to tackle next..
View 10 RepliesInconsistent connection through 7 wire plug and no taillights on four wire plug.
View 3 RepliesLast week we were camping, the site we were on had a downhill slope to it. Since I had to reverse and align my trailer with the hookups I remember hearing something on here about putting it in 4WD before trying to reverse up hill. As I did this and slowly reversed I started getting smoke, nice and white with a little bit of a burnt smell to it but not bad. There was also some slightly mucous liquid on the ground that had almost no smell and a slight red tint to it. I freaked out thinking my transmission was shot but after reparking (doing a loop and staying in drive) there were no more leaks/drops and issues. I've driven another 500 miles since then and notice no difference shifting. How to avoid it
View 14 RepliesI am putting a winch on my trailer and I got an optima marine battery to run the winch. I would like to wire it into my trailer wiring so that it will charge off the truck while its running, but so that it won't draw off the truck's wiring while I'm winching... I'm worried about the size of the wire and the fuse on the factory hitch wiring. I'm probably not going to be doing any extended winching, just pulling things up on the trailer. I may just unhook it from the wiring whenever I'm winching?
View 7 RepliesSo on our trip up here I experienced a strange problem. Normally when I apply my brakes my trailer brakes kick in via the controller. This time when I apply the brakes I'm only getting my truck brakes. I can still use the brake controller manually to slow down but it's worrying. What is going on.
View 7 Replies