Ford Excursion :: Remove Plastic Cover In Front Of Radiator?


Sep 20, 2012

I took the plastic cover in front of the radiator off to clean the radiator and condenser. It directs air through the condenser before it gets to the radiator and I was wondering if it would cool the engine without it (if you don't need real cold ac air) . Without it the air can go over the top of the condenser and it is still blocked by the flap that stops airflow above the radiator. Also, I am wondering if the fact that the condenser has nothing in it affects the radiator cooling, and is it bad for the AC system to be empty. (My AC doesn't work)

View 7 Replies

Advertisement

Prius (2004-09) :: How To Remove Plastic Rim Cover

I got a piece of cable tie stuck in there.

View 6 Replies

Ford Excursion :: How To Remove The Cup-holder Cover

I need to send my cup-holder cover and trash hook to Clay so he can color match my F650 dash and I can't figure out how to get the damn side clips on the cup-holder to let go!

I got the top clips and the bottom clip to let go but the side clips will not slip through the slots... I've been near the point of breaking them trying to slide them through...

View 1 Replies

Ford Excursion :: How To Remove Overhead Console And Cover For Rear Seat DVD

I need to pull my front overhead console to make some changes, gonna try to mount my sirius cradle up there to get it out of the way. Can't figure out how it is fastened up there. Also, I need to pull the cover off the rear seat DVD player as I want to solder in some RCA's onto the aux in. Can't figure this one out either, and I'm afraid to break the cover.

View 4 Replies

Touareg :: How To Remove The Front Plastic Plate

how can i take off the front plastic plate on the front of my touareg

View 4 Replies

Touareg :: How To Remove Cover Below Front Seat

Exactly how do you remove the cover (facia) below the front of the front seat so the battery can be removed. To my knowledge no one has spelled this out on this board.

View 7 Replies

Ford Excursion :: Circle Plastic O-Ring Behind U Joint Is Lose On Both Sides Of Front Axle

I noticed on my 03 excursion on both sides of the front axle there is a circle plastic o ring behind the u joint that is lose? Nothing is leaking and no signs of leak marks ever. Kind of looks lik a spacer ring of some sort because its at least 1/8th inch thick plastic. Also some time ago I posted about a whistling noise but never got a answer but its only there when im in 4wd there is a whistling noise from my right side and my locking hub when I turn it the hub seems lose and has a crunchy feeling to it. I just bought it a few weeks ago and now I am running into a whistling noise and noticed theres a piece of plastic that looks like a spacer....

View 14 Replies

Ford Excursion :: Front Carrier Leaking At The Bottom Of Ring And Pinion Cover

My front carrier is leaking at the bottom of the Ring and Pinion Cover. I am going to pull the cover and replace the gasket. I am also a believer in Amsoil full synthetics, should I use the Severe Gear 75W-90, Severe Gear 75W-110 or the Severe Gear 75W-140. How many ounces does it take. I presume to fill until the bottom of the fill hole? What are the torque specifications for the bolts?

View 14 Replies

Ford Excursion :: Left Front Spring Shackle Interfering With Differential Cover?

I recently installed front and rear Mag-Hytek diff covers and the front had a small leak. I thought I had gouged the housing during removal of the factory cover, so I set aside time to remove the Mag-Hytek and repair the housing. I just removed the new cover and upon inspection, there is no gouge. There is a slight scratch, but not in the area of the leak.

Upon further inspection it appears as though the o-ring wasn't properly sealing. There is a slight rust coloring where the o-ring was seated against the housing, running from where the left lower spring shackle touches the diff housing, to the bottom of the housing. The rest of the o-ring route looks clear (no rusty coloring where the o-ring was seated).

Is it possible that the spring shackle is too close to the diff, causing the new cover to not be able to seal properly? (The truck had a lift on it when I bought it. When I installed the Bilsteins, I noted that the old shocks were installed very "amateurish", so I suppose it's possible the springs were as well.)

View 7 Replies

Ford Ranger / B-Series :: 1994 2.3L - Coolant Leak Coming From Under Black Plastic Cover

I noticed green coolant leaking from bottom of black, what I think is called, timing belt cover. There is 188, 000 miles, and when I changed the timing belt, I did not change the water pump, although I did change out the thermostat. I have done a lot of work on this truck in the past. I checked the oil and no signs of water or coolant mixed in. The water pump is not weeping from the top well. I rely on this truck and the way I look at it is I may just keep driving it until it goes kaput (its real beat up). Should I go to an auto parts store and see if I can buy some sealant. I would guess it is either the water pump or maybe the timing cover gasket? I have inspected all hoses, and I see nothing. The leak must be coming from somewhere under that black, plastic cover. I am capable and willing to do just about anything other than perhaps a full engine pull, although I have the wherewithal to do that too if absolutely necessary.

View 9 Replies

Ford 6.0L Power Stroke Diesel :: Radiator Starting To Seep A Little Between The Core And Plastic Sides

Looks like now the radiator in starting to seep a little between the core and the plastic sides. Couple questions. Whats the best replacement that wont cost a ton. Would this have anything to do with the intermittent not starting when warm.

View 6 Replies

Golf/GTI VI :: Oil Dripping On Plastic Cover When Looking From Engine Bay

This morning after pulling out of the garage, i notice a small wet spot on the floor, went to see what it was and it was oil, its was a wierd shade of red/orange and very clear, def not engine oil. Then looked under a car and saw it where it came from, front driver side, there is a some kind of plastic cover, it was collecting there then dripping out. I can see the oil dripping on the plastic cover when looking from the engine bay? What can it be?

View 4 Replies

Camry :: 2011 - Plastic Engine Cover Removal

How do I remove the plastic engine cover from a 2011 Camry ?

View 2 Replies

Prius (Gen 3) :: Unrecognisable Loose Wheel Well Plastic Cover

I have a 2012 Prius. I occasionally will clean the wheel wells, as I live on a dirt road. I have found that there's a plastic cover inside the left rear wheel well, at about 2 o'clock as you face the wheel. It seems to be loose.

View 3 Replies

Camry :: Some Black Carbon Came Off While Removing Top Plastic Cover

I recently removed the top plastic cover on my '05 Camry LE V6 to pull a plug and inspect/decide if I was going to change them out. While I felt I was being careful handling the plastic cover, I grabbed it by the access hole for the oil filler cap. Walking back into the garage, some black carbon came off, and looking at the bits on the ground, and what was left on the inside of the cover, I'm not sure if there is supposed to be a gasket there.

Maybe it was just an accumulation of spilled oil over the years that has trapped and "cooked", or something put in place to capture spilled oil. I scraped the rest of the carbon off using a razor blade and cleaned it up before installing the cover.

View 13 Replies

Golf/GTI VI :: Plastic Creaking / Noise On Sunroof Cover?

Having problems with sunroof cover making noise when going over bumps? It just sounds like the plastic is making all the noise.

View 8 Replies

Camry :: 2007 V6 - Plastic Engine Cover Removal?

I have a 2007 Camry XLE V6 that needs new spark plugs and the first thing to remove is the plastic engine cover. I do not see any screws or bolts attaching it down and I would like to know the proper way to remove it without damaging it or the plugs holding it down. How to do this?

View 3 Replies

Prius (Gen 3) :: One Side Of Bottom Black Plastic Cover Was Drooping

I just joined up after purchasing a CPO 2010 Prius IV. Love the car but after taking a closer look I noticed that one side of the bottom black plastic cover was drooping on one side. Upon closer inspection I noticed that there was a screw and plastic Grommet combination that was not locked into place. After unscrewing the screw, I tried to put the grommet back in place but noticed that it couldn't fit because (I believe) the white bumper portion where the grommet goes broke off. I compared it to the other side of the car and yes it does seem like part of the plastic top portion that is connected to the bumper broke off.

I inspected the bottom some more and it seems like there are a good number of screws missing and a large plastic piece that is the front tire well is also very loose.

View 2 Replies

Prius (2010-12) :: Clips Holding Plastic Cover Broken?

I opened the hood today to install the Carbon Fiber logo and noticed that the plastic cover sitting on top of the radiator was loose. That's when I noticed that the 2 clips holding the plastic cover were broken.

View 3 Replies

Phaeton :: How To Remove Plastic That Covers The Engine

How to remove the plastic engine cover that covers the engine? I'm know some of them are just held in place with friction plugs and only require a good tug, but I've thought that about other things in the past which have resulted in expensive noises.

View 8 Replies

Lexus GS 2013+ :: Plastic Cover Over Navigation Display Dirty On Inside

I just took delivery of a 2013 Lexus GS 350 all-wheel-drive. I have the luxury package which includes the large display screen in the center of the dash. Unfortunately the plastic cover over the navigation screen is dirty on the inside. How to remove the plastic cover on the center display?

View 11 Replies





Copyrights 2005-15 www.bigresource.org, All rights reserved