Ford Excursion :: Right Front Wheel Bearing Started To Squeal Around Left Turns
Mar 23, 2009
My Excursion has proved to be a reliable winter vehicle, as was the intention. A few weeks back, at 116,000 miles, the right front wheel bearing started to squeal around left turns. Not very loud, so I didn't think it was all that bad, just an indication it was going. I jacked up the front of the truck anyway for good measure, and found a tremendous amount of slop in the bearing. Yeah, the bearing had disintegrated. Time for a replacement.
I bought a new replacement hub off of eBay, and proceeded to start tearing into the thing. Should be an easy repair... Right.
The repair itself is actually straightforward, but I had a few little snags get in my way. The one I'm facing now is that the new hub did not come with replacement studs, and the old hub's studs will not come out. Yes, I tried using a torch (and failed). I got one removed, only to find it's a fine thread and possibly Metric. Either way, it's not something that they have at Lowes.
Where to get more of these, or what the size is so I can order some from McMaster?
View 14 Replies
Advertisement
I have been having towing with the X. I have been getting a growl lately sounds like the front left wheel bearing. Today I jacked it up and did the wiggle text. I have a very slight wiggle in both wheels. Is a slight wiggle normal? I know the bearing on the left is more than likely gone as the growl goes away when I jerk the steering wheel. But I haven't heard any noise from the right side yet.
View 14 Replies
What is causing the right front wheel bearing to keep going bad on my 06 f-150 2 wheel drive....
View 1 Replies
So on my girlfriends 2000 echo I get the classic bad wheel bearing noise/vibration on the front left (driver side) wheel. Worsens under load (right turn) and goes away when unloaded (left turn). I've replaced left side bearing, CV axle, brake rotors/pads and the noise still persists. My next thought is maybe the ball joint but humming/vibration tells me something out of rotational balance. Bearing in the transmission? I don't know. I'm stuck.
View 5 Replies
This past week I changed out the front wheel bearing hub assemblys on both sides. I'm curious if completely disassembled one of the units? If so what did you use to get the large nut with the 4 notches in it off?
View 2 Replies
I have a 2000 Passat and brought it to a local shop to have the left front wheel bearing changed. He took the car apart and said he couldnt do it because the anti lock brake wire ran threw the control arm and had no plug on it and was wired right to the dash board. Should i find a different place to take it to or is it a dealer required fix. Can i buy the bearing myself and change it?
View 1 Replies
Having issues with noise from either LT or RT front wheel bearings? My 2011 Elantra has some sort of noise coming from the LT frt wheel
View 10 Replies
I have a 2007 the front wheel bearing started humming real bad, changed it out. Can't seem to get the right front brake bled good. Did it three times. No air. Today locked up the left wheel upon putting on the brake, the right one ain't working. Is there any thing I can do other than bleed the left front again, check fluid?
View 2 Replies
Driving at hwy speeds and head a pop noise in front end. Stopped and couldn't find anything, heard it a couple of more times, still nothing found, now I have a grinding noise left front wheel. What the issue may be. 2001 Ford EX 4X4.
View 6 Replies
Before I take my 3 month old T2 in for service AGAIN this Saturday. The more informed I am when I walk up to the service counter, the better.
When I make a hard left turn (more than 90 degrees), I now hear a sound from the front left wheel area. It sounds sort of like the sound a plane makes when flying overhead. It's sort of like something is rubbing.
This started all of a sudden last Thursday. I thought it would go away. It doesn't sound normal and it doesn't happen when I turn right. It doesn't affect my steering. I don't recall hitting anything (note I sait recall).
Obviously, I got out of the truck and examined the entire area but I don't see anything unusual. I drove around in circles with my head out the window trying to figure this out.
View 6 Replies
I have a 2000 Excursion 2wd. The left front wheel or something up front is making a rubbing sound when I turn to the right. Checked the brakes, they looked fine. Pulled front rotor off and replaced the wheel bearing just incase. Still making that same noise? I can't see any sign of something rubbing either on the frame, brakes lines, or control bars?
View 3 Replies
2004 PSD 4x4 72k. I thought I would be proactive so I bought the front ball joints and have plans to install them but recently I starting hearing (and feeling) a clicking sound in the front LEFT when I make sharp turns to the left and hit small bumps now and again. I jacked up the front end and am able to get 1/4" of movement front to back (top to bottom so not steering) in the wheel.
I narrowed it down to the hub. I took it apart and it is most likely a sealed unit so no adjustment is possible....that I can see.I pulled out the locking hub and got as far as I can to know there is not an adjustment. Need to confirm that it indeed is a sealed bearing and if so what are the part number(s) I may need to repair it.
View 14 Replies
Well I'm am getting a low toned squeal out of the left front of my truck every time I pull away in the morning. I thought it was the caliper sticking as it wasn't releasing but I replaced the brakes and that and it still is happening. I guess I am going to looking at the hub and see if the hearing is bad. What do you all recommend for a hub replacement. (OEM, moog?) I looked it up on white bear is part # AC3Z-1104-B right?
View 2 Replies
Not my video, but I have the same exact sound coming from my passenger side wheel on my 03 V10 4X4, 130K. Passenger side only, no noise from the other side.
YouTube .....
Before I spring for the Timkin, does this sound like a bad bearing? No play in the wheel, but it's a clicking sound.
View 7 Replies
At 46,400 miles of gentle driving, my left wheel bearing failed on my 2010 Prius, which was not covered by warranty because it is not 'drive train'. I was told there was nothing I did or could have done to cause this. I have had 4 Toyotas, two with over 200,000 miles, and never had this serious a repair (that wasn't my fault!). Am I being unreasonable to think this is unusual? I'm wondering if this car is going to continue to be a problem.
View 19 Replies
Last year around christmas i replaced the drivers side front wheel bearing no issues with that side. pass side wheel bearing started to growl changed it out test drove went smooth took the car for a 100 mile drive about 50 miles in and a little in town driving noticed a hum drove back at 55 mph humming the whole way i would turn to the right any amount and its would quiet up like nothing wrong straighten out or turn the wheels left it would hum figured i didn't press the bearing straight jacked it up to tear down shook the pass tire no excessive play went and shook drivers side noticed the 3 bolts that hold the strut to the mounting plate sheared off any thought i know i gotta get that bolted up before i diagnose any further think a free floating strut would sound like a wheel bearing?
View 3 Replies
I have a 03 explorer with approx 160k, I am experiencing a thumping noise while driving. It gets worse on right turns and gets better on left turns. initially i thought LF wheel bearing so i ordered a hub assy and replaced LF. noise is still there. I guess, thumping noise caused by wheel bearings, i know its usually a grinding kind of whirring noise.
The noise doesn't seem to change with accel/decel so I don't think it is driveline related (diff, drive shaft etc.) should i bite the bullet and replace the rf as well??? I should also mention that there is also a shake in the steering wheel that seems to coincide with the thumping (i.e., my hand shakes along with the thumping, and the shake gets worse when the noise does)...
View 8 Replies
1999 explorer Eddie bauer. Front wheel bearing nut size? 33mm?
Looking for a torque spec procedure. Need to replace an abs sensor. Sensor alone was 120 bucks so just bought the whole hub assembly with sensor. Might just put the whole thing on.
Is there a good thread for a complete socket size portfolio on the explorers. Thinking sizes over and above normal socket sizes found in your typical socket set?
View 2 Replies
My wife's Explorer 4x4 has a noise in the front at around 100km/h. It is not detectable below 90km/h. Its not noticeable from a standstill until around 100, then you hear it a little. I find I can make it more noticeable if I vary my speed from 110 to 105 up and down, then its easier to hear. Once you get below 90 km/h you cant hear it at all.
I have a broken leg right now, and I normally do ALL my own work so I'm a little-limited mobility wise at the moment.
I'm suspecting a wheel bearing. I put the Explorer in the garage and my son jack up both wheels on the drivers side. I started the engine and SLOWLY accelerated up through the gears to 100. I know the hazards with this as I've done it with other vehicles, but this was the first 4x4. Then we jacked up the passenger side (after lowering the drivers side) and did the same thing. I could slightly hear/feel the rumble when the passenger side was jacked up.
I did drive the vehicle on my outdoor ramp/pit so I could use my crutches and get underneath to have a look. I grabbed the cv axles and they feel solid. The propeller shaft was replaced last year, and the cv axles look brand new. (bought the vehicle off a friend two years ago.).
So, are my suspicions correct, is it the pass. side wheel bearing? The Explorer has 294000kms. Never did test it on corners as I didn't want to swerve back and forth on the highway with the amount of traffic.
View 4 Replies
I'm working on a 02 explorer. The front end is howling so I replaced the left side and no change. The howl goes away when braking. Is it the right side then or something else? I replaced both front brakes pads so it's not that.
View 2 Replies
Repeat Front Hub Failures -- 2WD Try this situation -- Purchased 2006 F-150 XL with 57,000 miles. Truck built on 05/24/2006.
Sept 2011 68,621 miles -- Left front hub failure -- Wheel bearing grinding -- Done by Bell Ford in Phoenix.
2013 -- Left front hub failure -- wheel bearing grinding -- done by independent shop.
Sept 2014 -- Left front hub failure -- wheel bearing grinding -- done by independent shop.
Sept 2016 -- Upper & lower control arms, struts, strut mounts, springs replaced -- Quality part used -- Complete front end alignment -- Brake job front and rear.
Nov 2016 -- New performance exhaust system due to exhaust leaks.
Dec 2016 -- Failed automatic transmission -- Remanufactured FORD transmission installed w/ 36 mo warranty. Sanderson Ford gets an A+
March 16, 2017 151,000 miles -- Left front hub failure -- wheel bearing grinding! Verified by jacking up truck and spinning left front wheel -- GRIND! This is coming from down in the hub. This is a 2 wheel drive truck. Yes, you counted correctly, this will be the 4th replacement on the Left side!
NO Towing! NO Overloading! Wheels are 2006 XLT style Aluminum rims with P235/70R17 Michelin XLT M/S (Defender LTX) tires all around.
It only hauls maybe 200 to 300 pounds of electronic equipment at the max, once in a while. This is driving me crazy! I always use FORD PARTS for the HUB ASSEMBLIES. Really loosing faith, the front right hub is OEM original - NEVER CHANGED!
View 7 Replies
