Ford Excursion :: Use Speed Control While Towing?
Aug 6, 2012
We just got back from our first big trip with the EX since we have owned it. We towed our (new to us) 25' TT up to northern Michigan (Elk Rapids area). This was my first time pulling a camper this far. We have been on smaller weekend trips with it.
My question is regarding the speed control. I tried using it but when it was going up a slight incline it would not kick back down. I would have to turn off the speed control in order for the RPM's to drop back. Do you guys use your speed control while towing? What about over-drive? Should I have it on or off?
By the way, we had a great time and so glad we have the EX!!! Kids had plenty of room. Got about 8 MPG! That's how we roll!
View 14 Replies
Advertisement
My cruise light will activate but won't hold speed, it shuts off when I tap the brakes. I did the self test and it went through complete. All buttons worked. After the test it did not show any blinks which according to the chart shows speed control switch faulty, I replaced the switch and does the exact same thing. The recall was also done.
View 8 Replies
Just looking for comments on using the cruise control while towing? and what's the recommended weight for using the tow haul mode. The enclosed trailer I have is about 3300 lbs. taking it across the country empty. 2004 6 liter.
View 11 Replies
I have a 02 excursion 7.3 with 120000 miles. Went camping and towed my 28ft travel trailer weighs about 9000 lbs loaded . The trans got super hot dumped fluid in the past this time same thing but the front seal went had it replaced and the trans pump rebuilt on the way home it got super hot a few times what I need to do now. The trans guy said the trans had been rebuilt in the past don't know when cuz I bought the truck used 1.5 yr ago..... The truck has tow package coolers its set up for towing how the hell do I keep the temp down...
View 14 Replies
I had a flow master 50 sieries on my v10 and it sounds like something rattling around when towing. Guess i will have to find something different later on.
View 13 Replies
2005 Excursion 6.0 104,000 miles
I have a scanguage2. Normal driving yesterday morning. Not towing. Temp got up to 200 deg.....then later to 240!! Never an issue with the tranny !!
Yesterday I checked:
-the fluid level and it's fine.
-There was some crud on the dipstick though.
-temps for EOT and EWT are fine.
-a distinctive hot rubber smell too when it got to that temp.
Today I checked:
- the coolant for traces of transmission fluid...there was none.
-looked under the truck for fluid that may have blown out the vent....none
-no leaks anywhere
The truck is parked and will be towed to the shop so i don't incurr any more damage. So what could the prob be??
View 5 Replies
I towed my friends car hauler yesterday for a short distance for him. I had no turn signals or 4 way flasher while towing. After dropping off the trailer still no signals or 4way flasher. I parked and checked fuses all were good and signals started to work. But still no 4ways. Any thoughts on what to look for. Never had this before. I have blown a fuse before and always been able to find and fix.
View 13 Replies
How much do any of you increase your tire pressure while towing?
View 7 Replies
I have a new set of towing mirrors for my beast and also a set of the LED smoked signals. It appears that the old ones just "pop" off but I would like to know for sure.
View 3 Replies
3 for 3 this year. When I'm towing, arrive at our campsite and back our trailer into the spot. I get white smoke pretty quickly and there is transmission fluid all over the ground.
4R100 transmission with 71k miles on it. I had the fluid changed this year HOWEVER it did do the same thing last year on a camping trip when I was towing.
I don't have any other issues other than this. I assume the fluid is getting ridiculously hot and then boiling over? The gauge doesn't change at all in the cab (but I assume it is either a GOOD/BAD sensor vs. an actual temp sensor).
I've tried using 2WD, 4HI and 4LO all with the same results. What needs to be done to prevent this? Larger transmission cooler? Is there anything that is 'plug and play'?
View 14 Replies
Ive got a 2004 excursion Eddie bauer and I've got the non-towing paddle mirrors with power adjustment, heated, and turn signals. I want to put the 2008 style towing mirrors on that have power adjustment, heated, turn signals, and have the marker lights but not power fold or power telescope.
How I can wire these new mirrors to my factory wires? I understand that the marker light may have to be separately wired in, but all of the other functions I want to wire in to my existing wires.
View 7 Replies
I have an 01 EX that handles excellent (no wandering)! I tow my 06 Jeep LJ Rubicon (4500 lbs) that is on 35" tires with a Ready Brute tow bar. I use a 10" drop hitch (reversed) to get the tow bar level and my tire pressure is 65# front and 60# rear. It handles nice on level, uphill and mild downgrades. When I am doing steeper downgrades (I-70 in Colorado) it tends to want to push my rear end to the point that I am really fighting the back and forth feeling. If I slow down to about 50mph it steadies out.
I'm thinking that part of the problem might be the slop in the hitch. What I mean is that with just the hitch installed I can rock it back an forth in the receiver about 1/2 to 1". When I start downhill instead of a steady transfer of weight I get a "bump" as the weight shifts which contributes to the handling problems. Is there anything I can do (other than wood shims) to get rid of the slop in the hitch? What my problem might be?
View 14 Replies
I have a 2000 Excursion with a 7.3 diesel. I have 245k on the clock. Engine and transmission are original. I have an overheating issue when I am towing and pull a long grade. It's not as bad as it was before but it still happens and I am tired of turning off the AC and putting the heaters on full blast to support cooling when it is 90 plus outside. A list of things that I have done so far.
Newer water pump and thermostat.
New tensioner.
Installed a new trans pan with about 7-8 larger capacity.
Used some magic juju juice to clean out colling system.
Installed a coolant filter. I am on my 5th filter. The first one didn't last 500 miles before getting stopped up.
Switch to Delo ELC.
I recently had the upper hose off and when I looked inside, I didn't see any scale or build up. I also read about some of the trucks of that vintage didn't get a trans cooler. When I looked, I saw a cooler but it doesn't look like it is plumbed through the radiator.
I want to install a large trans cooler. I don't want to replace the radiator just for the sake of replacing it. Also, look at the pic of the water pump with the thermostat sitting in it. Is the thermostat supposed to be resting all the way down? I keep wondering about that.
View 14 Replies
So this may be a really dumb question, but here goes. I have a new to me 2001 v10 gas 4x4 ex. It has obviously been lifted in the past. The springs seem totally shot as the back end is quite a bit lower than the front and drops dramatically while towing. I am adding a helwig and have a wd hitch but have not set it up yet. So my question is can i do the spring swap? It would seem that i would need to address whatever changes are made from the stock ride but im not sure. I like the current lift and would be fine keeping it and adding the lift from the new springs.
View 14 Replies
I recently bought a 2008 F250 with the 6.4 diesel indirectly from a dealership. The truck itself has 220,000ish kilometers, but the engine (as well as the turbos) are Ford reman that had about 12,000km when I bought it and I have only put about 6500km on it. It is already leaking oil but that is for another thread.
The reverse sensors, steering wheel controls and part of the stock 6cd radio have never worked. The towing system has errors as well. The fuel level sensor often has problems reading the new level after I put in fuel, but that is always fixed by disconnecting the batteries and forcing a hard reset.
I figured the steering wheel/cruise control problem was due to either a broken clock spring and/or the brake pressure switch. I replaced both those as well as the airbag because the horn relay failed closed when I put it back in the wheel. It did not fix the problem. The steering wheel buttons still intermittently illuminate, but the radio controls and cruise control buttons do not function regardless. The truck isn't giving any codes either.
The towing system will activate lights and brakes on a trailer as well as set the gain, but it will not detect that it is actually hooked to a trailer. I cleaned the pins, but I haven't looked any further into it. No codes for this as well.
The reverse sensors/system does not work. It will lock itself in "off". I am guessing this is because one or more of the sensors have failed, but I am skeptical that it would be just that given the trucks other problems.
The radio does work, but the auxiliary input/mode will not work. I ran the diagnostics on the radio and on 'Test 1' I got "SELF FAIL B1342 ECU" and "B2477 CONFIG". I tried to clear the codes, but I can't. I think this means the radio is kill.
View 6 Replies
2005 Excursion Diesel Ltd
1/ The Heater/AC control, one in awhile is not Turn-On when the engine is started, manually turn it ON did not make any different, but the next time/few times the engine is started it is OK.
What is the possible problem and how can I fixed ?
2/ The overhead console is dead, not sure which fuse it belongs to so I checked/tested all the suspected fuses=OK.
What is the possible problem ?, and can it be fixed ? or take the panel apart for further testing ?
View 5 Replies
Turn on car and radio does not come on nor CD. The fan speed control does not work. Basically the main turning knob appears to be in-opt? Everything else appears ok. Says CD not available? There are the following symbols: -- -- on the screen where the radio station would display.
Is there a radio re-set ?
Main control knob ?
View 1 Replies
My cruise control will engage but not maintain set speed. It slowly loses KPH, 10 KPH every 30 seconds. What to look for?
View 6 Replies
I turn my cruise on and then attempt to set it , nothing happens , doesn't set, no light , nothing. I hit coast and the light comes on but still doesn't hold. Should the light come on when cruise is turned on or set? I checked the master cylinder switch and it's not wet. I also did the self diagnostic test and got nothing but the initial first light blink.
View 4 Replies
2009 F-150 FX4 SuperCrew 4X4 5.4L
My ABS and stability control lights are on. I had the codes pulled today (listed in order):
1) C1298 (Right Rear Wheel Speed Sensor Input Signal Fault)
2) C1165 (Right Rear Wheel Speed Sensor Input Circuit Failure)
3) C1963 (Stability Control Inhibit Warning)
4) C1299 (Left Rear Wheel Speed Sensor Input Signal Fault)
5) C1175 (Left Rear Wheel Speed Sensor Input Circuit Failure)
I'll ignore the stability control code for now since I'm sure it is tied to the speed sensor errors. Anyways, I decided to inspect the rear wheels and I found this sucker just hanging beneath the right rear brake caliper:
Is this a speed sensor? Where does it plug into? Diagrams would be extremely useful! I am planning on ordering 2 new sensors for each rear wheel but I don't know where to begin.
View 3 Replies
Have this problem?
View 2 Replies
