I had a flow master 50 sieries on my v10 and it sounds like something rattling around when towing. Guess i will have to find something different later on.
View 13 RepliesWe just got back from our first big trip with the EX since we have owned it. We towed our (new to us) 25' TT up to northern Michigan (Elk Rapids area). This was my first time pulling a camper this far. We have been on smaller weekend trips with it.
My question is regarding the speed control. I tried using it but when it was going up a slight incline it would not kick back down. I would have to turn off the speed control in order for the RPM's to drop back. Do you guys use your speed control while towing? What about over-drive? Should I have it on or off?
By the way, we had a great time and so glad we have the EX!!! Kids had plenty of room. Got about 8 MPG! That's how we roll!
I have a 02 excursion 7.3 with 120000 miles. Went camping and towed my 28ft travel trailer weighs about 9000 lbs loaded . The trans got super hot dumped fluid in the past this time same thing but the front seal went had it replaced and the trans pump rebuilt on the way home it got super hot a few times what I need to do now. The trans guy said the trans had been rebuilt in the past don't know when cuz I bought the truck used 1.5 yr ago..... The truck has tow package coolers its set up for towing how the hell do I keep the temp down...
View 14 Replies2005 Excursion 6.0 104,000 miles
I have a scanguage2. Normal driving yesterday morning. Not towing. Temp got up to 200 deg.....then later to 240!! Never an issue with the tranny !!
Yesterday I checked:
-the fluid level and it's fine.
-There was some crud on the dipstick though.
-temps for EOT and EWT are fine.
-a distinctive hot rubber smell too when it got to that temp.
Today I checked:
- the coolant for traces of transmission fluid...there was none.
-looked under the truck for fluid that may have blown out the vent....none
-no leaks anywhere
The truck is parked and will be towed to the shop so i don't incurr any more damage. So what could the prob be??
I towed my friends car hauler yesterday for a short distance for him. I had no turn signals or 4 way flasher while towing. After dropping off the trailer still no signals or 4way flasher. I parked and checked fuses all were good and signals started to work. But still no 4ways. Any thoughts on what to look for. Never had this before. I have blown a fuse before and always been able to find and fix.
View 13 RepliesHow much do any of you increase your tire pressure while towing?
View 7 RepliesI have a new set of towing mirrors for my beast and also a set of the LED smoked signals. It appears that the old ones just "pop" off but I would like to know for sure.
View 3 Replies3 for 3 this year. When I'm towing, arrive at our campsite and back our trailer into the spot. I get white smoke pretty quickly and there is transmission fluid all over the ground.
4R100 transmission with 71k miles on it. I had the fluid changed this year HOWEVER it did do the same thing last year on a camping trip when I was towing.
I don't have any other issues other than this. I assume the fluid is getting ridiculously hot and then boiling over? The gauge doesn't change at all in the cab (but I assume it is either a GOOD/BAD sensor vs. an actual temp sensor).
I've tried using 2WD, 4HI and 4LO all with the same results. What needs to be done to prevent this? Larger transmission cooler? Is there anything that is 'plug and play'?
Ive got a 2004 excursion Eddie bauer and I've got the non-towing paddle mirrors with power adjustment, heated, and turn signals. I want to put the 2008 style towing mirrors on that have power adjustment, heated, turn signals, and have the marker lights but not power fold or power telescope.
How I can wire these new mirrors to my factory wires? I understand that the marker light may have to be separately wired in, but all of the other functions I want to wire in to my existing wires.
I have an 01 EX that handles excellent (no wandering)! I tow my 06 Jeep LJ Rubicon (4500 lbs) that is on 35" tires with a Ready Brute tow bar. I use a 10" drop hitch (reversed) to get the tow bar level and my tire pressure is 65# front and 60# rear. It handles nice on level, uphill and mild downgrades. When I am doing steeper downgrades (I-70 in Colorado) it tends to want to push my rear end to the point that I am really fighting the back and forth feeling. If I slow down to about 50mph it steadies out.
I'm thinking that part of the problem might be the slop in the hitch. What I mean is that with just the hitch installed I can rock it back an forth in the receiver about 1/2 to 1". When I start downhill instead of a steady transfer of weight I get a "bump" as the weight shifts which contributes to the handling problems. Is there anything I can do (other than wood shims) to get rid of the slop in the hitch? What my problem might be?
As the title says I have noticed a strange sound on start up in the last couple weeks that sounds like rocks in a can. Noticed only at start up and then stops but I have noticed it slightly infrequently when driving. Truck runs great, no noticeable problems. I have looked under the hood and suspension to see if something maybe hung up and didn't see anything. Thought this might be the problem since I was following a plumbing truck that had plastic buckets flying out the back and I hit one!
View 7 RepliesI have a 2000 Excursion with a 7.3 diesel. I have 245k on the clock. Engine and transmission are original. I have an overheating issue when I am towing and pull a long grade. It's not as bad as it was before but it still happens and I am tired of turning off the AC and putting the heaters on full blast to support cooling when it is 90 plus outside. A list of things that I have done so far.
Newer water pump and thermostat.
New tensioner.
Installed a new trans pan with about 7-8 larger capacity.
Used some magic juju juice to clean out colling system.
Installed a coolant filter. I am on my 5th filter. The first one didn't last 500 miles before getting stopped up.
Switch to Delo ELC.
I recently had the upper hose off and when I looked inside, I didn't see any scale or build up. I also read about some of the trucks of that vintage didn't get a trans cooler. When I looked, I saw a cooler but it doesn't look like it is plumbed through the radiator.
I want to install a large trans cooler. I don't want to replace the radiator just for the sake of replacing it. Also, look at the pic of the water pump with the thermostat sitting in it. Is the thermostat supposed to be resting all the way down? I keep wondering about that.
So this may be a really dumb question, but here goes. I have a new to me 2001 v10 gas 4x4 ex. It has obviously been lifted in the past. The springs seem totally shot as the back end is quite a bit lower than the front and drops dramatically while towing. I am adding a helwig and have a wd hitch but have not set it up yet. So my question is can i do the spring swap? It would seem that i would need to address whatever changes are made from the stock ride but im not sure. I like the current lift and would be fine keeping it and adding the lift from the new springs.
View 14 RepliesWhen driving my car it will rattle and its been getting worse over time... it sounds like a thin metal such as tin. I've already been under my car a couple times and can't find anything.
View 24 RepliesI've been hearing buzzing and rattling sounds somewhere around the top of the dash in the mornings when the car was cool, by the afternoon many times the sound would go away a little while when the car warmed up in the sun.
Sometimes it would buzz when it was cold or hot. It sounded like it was coming from the HSI display area, but I couldn't quite nail down where it was because its a little to far to reach while driving. Also I didn't want to scratch the clear plastic cover with my fingernail.
I'm having a problem with my Prius. It pings under acceleration and it sounds like something metallic is rattling. It only happens when I use 87 and 89 oct. I use 91 premium to reduce the ping however, gas prices are rising and I want to go back to 87. There are no warning lights or anything and the ping has been happening for quite some time now.
View 3 RepliesJust purchased 2007 Prius Touring model w/ Package 6. Wonderful car.
I hear a buzzing/rattling noise when stopping at low speeds or starting at low speeds. It seems to be coming from the drivers side. Doesn't happen every stop/start.
Waiting on a flatbed ... Everything was normal and then my abs light comes on then crunching sounds from my left front. Would a hub or wheel bearing cause this?
View 14 RepliesI currently own a 2006 prius which has done about 100k km. I've been hearing knocking and rattling sounds coming from the left tire whenever I go over a rough patch of road or even a speed bump, between slow to moderate speeds. It's currently bearable, but it gets irritating at times and it seems to be getting louder. What is the cause of these noise and how I can rectify it? I wish to get rid of it.
View 5 RepliesI have a 2011 Sonata SE 2.4 In the last week Ive noticed a noise what sounds like my valves are rattling or maybe even a bad lifter. This only happens when I bring the RPM's up to 2500-3000. Not at idol or normal driving when RPM's are around 2000 or lower. Its getting progressively louder every couple of days. I've ruled out bad gas (I used another station in another city on last fill up ). My oil is changed every 3000-4000 miles with the recommended oil as well.
View 47 RepliesTried to start my 2002 7.3 Ex today and it tries to start but than sounds like something is grinding, on a 2nd or 3rd try it starts. The sound is similar to if you try to start an already running vehicle.
View 3 Replies