Ford - Explorer :: 1992 XLT Starts Chugging And CEL Comes On After Running Good For 15 Minutes
Feb 15, 2014
1992 Ford Explorer XLT 4wd 4.0L (California vehicle) runs good for about 15 minutes, then suddenly starts 'chugging,' loses power, and check engine light comes on. After sitting overnight, it will again run good for about 15 minutes, then repeats the problem.
This problem began AFTER smog check test failed (it ran smoothly all the time before) and after, as was recommended to me, I replaced the 02 sensor. (Failure of smog check, it turns out, was more likely because, unknown, a 10" piece of exhaust pipe was missing, so Catalytic Converter was not connected to the tailpipe).
I had a mechanic scope the Explorer but he could not determine a specific failure from the codes, although he suggested possibly it's the missing 'Octane Adjust Shorting Bar,' or maybe the 'crank position sensor' is bad, but he could not give a diagnosis.
View 6 Replies
Advertisement
1992 Volvo 240 ... I'm having car jerking problem after running for about 20 minutes at speed between 90 -110 kph. Car stabilizes again when the speed comes back to 90kph. There is no problem initially when running beyond 120kph when the engine first started up. The problem only starts after a short while.
View 1 Replies
1992 Honda Civic Starts fine but kills as soon as you release the key. Hold the key in the position with the starter motor running and it keeps running. In the old days we would replace the resistor on the firewall. Today?
View 3 Replies
Car: 1992 GMC Sonoma 2.8L Manual Miles: ONLY 197,000 miles
Symptom: When ever I put the switch to OFF or VENT or HEAT the console starts to smoke (if the truck is on, of course). I noticed that I can hear the A/C running even when I put switch to one of the off positions.
Fixes: I have not had a mechanic take a look at this yet. They usually complain about other things when I bring it in. Little things like "your brakes are almost gone" (big deal, I don't need breaks because it is a stick shift) or "your tires are showing their metal wire" (big deal, I've had a front tire blow out before at 70 mph... on this same truck come to think of it).
Current workarounds: I keep the A/C on all the time even if I don't need it. I tried pulling the fuse and that did work, I can put the switch anywhere without the fear of smoke but it turns off the blower motor as well. If the blower is off then I'll have a hard time getting heat in the winter (Florida winters are very cold, down to the low 40s sometimes)
Feeble attempt to diagnose: I think I've seen card board be used as insulation inside the console before, I think whatever insulation was in there started degrade. I'm thinking that I'd like to track down the wires for and put the A/C on a different switch so I can still turn off the A/C and keep the blower going for the cold cold winter. Are there simpler solutions?
View 4 Replies
The 1997 Saturn SC2 is new to me. It was delivered to my home after purchase and died. The car had been sitting for a while and was suggested by previous owner that it was the battery. After having charged the battery, she ran for about 5 mins and stopped. I was also informed that the fuel line sometimes would disconnect, but that is not the case now.
View 1 Replies
I have a 92 accord lx that has been giving my endless hours of trouble. at 2 thousand rpm the engine chugs like its missing, but it only does this at exactly two thousand rpm. It also revs up when i put my foot on the clutch to shift. when it does this it stays at about three thousand rpm for several seconds before dropping rapidly back down to normal idle. I have just rebuilt the engine from the block up, changed the clutch, cleaned the E.G.R. port, put a new fast idle thermo valve on, new ignition system, new E.C.U., and much more.
View 14 Replies
My extremely used Explorer was driven off the lot, and ran like a champ for 3 months. One morning, I started it up, and noticed a chugging sound. While backing it out of the driveway, the truck felt like it was going to rattle apart. This was a sudden change. When I hit about 40mph, and I'm in 3rd gear, the truck hesitates and chugs along. If I stomp on the accelerator, the truck will kick into 2nd gear, and stops chuging for a second, then the gear changes back to 3rd and the hesitation starts again. If I disconnect the battery for a few minutes, then connect, I can drive normally for about 10 minutes, then back to the surging/hesitation. I've heard this might be a problem with the oxygen sensors or the mass air flow sensor.
View 4 Replies
Brakes in my 06 explorer are squishy, the pads are all good, what else i should check?
View 3 Replies
I've got this 96 neon. I can drive it to work and almost exactly 10 miles into the trip everyday I notice a subtle chug. Then it gets worst and within a couple of miles it chugs progressively worse until it dies. I pull over to the side of the road for 5-10 minutes. Then I can start it back up and run down the road another 3-5 miles before it happens again. I've changed the computer, coil, cam positioning sensor, O2 sensor, gutted the cat, changed plugs and wires. I'm to the end of my rope with this car. The codes that its throwing are no dice.
View 7 Replies
2007 5.4 . Starts good , idles all day. As soon as you try to rev it, it stumbles rattles etc. Shut it off, wait a second, restart then Idles fine. I watched live Data and it carries on when the VVT solenoids become active (above 800 rpm).There duty cycle goes to 60-70 percent while revving. I think it Is just one side of the engine. Could be VVT solenoids sticking on? yes ? No?
View 3 Replies
I have a 1993 Toyota MR2 Turbo with about 150,000 miles on it. For the past several years on a cold start (it doesn't seem to matter what the outside temperature is, just that the car has sat for a long time, like overnight), if I try to drive away immediately the car will chug. It almost feels like the car is choking or is not firing. It happens mostly on acceleration above 2500 rpm and in 2nd and 3rd gears, getting worse as you go higher in the gears.
After a few minutes the problem goes away and the car will run fine. Also, if I start the car and let it idle for 5-6 minutes it seems like the car will run fine without the chugging.
View 2 Replies
1997 Chevy C2500 silverado... Ok, so when i go to turn my truck on she'll sit there and chug as it starts. usually a few seconds and then roars up just fine. However I've noticed a couple of distinct things. 1. when it does start i see a second or three of black exhaust come from the tail pipe. 2. if its been started recently. IE within 24 hrs it has problems. but if i leave it over a weekend then the first start has no problems. 3. Last weekend we replaced the Fuel filter and the first few starts there was significantly less problems starting but after 5 starts its back to doing it again.
I checked and the fuel pump does work, I've tried changing the fuel filter ( #2 above), and put sea foam into the gas tank hoping to clean out any gunk in the lines somewhere. It does turn on and when it does it runs great so i know its not having electrical problems as well as the alternator is charging like normal.
Im about to take it in for an oil change and see if that does anything, and I'm praying its not a clog in the Catylitic converter.
View 10 Replies
V-10 running rough at idle, chugging. a problem has developed with my 2004 E-350 V- 10 after having a new fuel filter installed and the induction service done . Picked it up from a local shop and it was running rough after bringing it in when running great! I figured maybe it fouled a plug or something so I drove it home but it didn't improve so I brought it back and had new plugs installed. It is still running rough and wanting to almost stall when accelerating from a stop and the shop cant figure it out , not showing any codes.
I'm thinking maybe they caused some type of vacuum leak that is so far undetected. The killer is it came to the shop running great !!
No other problems with the vehicle, I drive it every day and have owned since new. 278,000 on it now and it has been the best vehicle I have ever owned.
View 8 Replies
It is a 1991 C1500 2wd, ext cab, short bed 5.7L engine with about 300k miles on it that I have had for a year. Supposedly a different 350 engine and transmission was put in a couple years ago.
This problem has been going on for 2 weeks. I'll start the car up and it runs just fine, no problems. After driving for about 20 minutes, the engine will die while driving, and will not start back up until the next day. I have sat in the car for literally 4 hours patiently waiting for it to start. I'll turn the key and the engine will rotate, but will not start. When someone shows up to give me a jump after the battery gets low, it will not start. I'll go home and go to sleep, and sometime the next day I'll go to my truck, and it will start back up, and I'll drive back home, and I'll make it as long as it takes less than 20 minutes.
It is not just a "morning problem", but a "first time I have started the truck that day" kind of problem. Last week, it happened to me in the mornings. On Saturday, I didn't leave my house until 2pm and the problem happened. Today, I first drove it at 8pm, and the problem happened.
Things I have changed so far (mostly from Autozone):
Starter - burnt it out when it first died 2 weeks ago, now I know not to crank when below 9 volts - lifetime warranty
Spark plugs - no more engine popping or driving with 2 feet - changed last week on Tuesday - AC Delco CR43TS gapped at .035
plug wires - changed all in November, since I noticed one of the old ones was tore - lifetime warranty
Distributor cap and rotor - changed last month when the engine started popping - autozone
Ignition control module- I changed today, I really thought that would fix the problem after speaking with the Autozone guy - lifetime warranty
Ignition Coil - changed last month because of popping
Fuel Filter - changed last Thursday, thinking it was a fuel problem
Here are some of the other symptoms I have been noticing over the last couple months:
Pretty bad gas mileage, I know it is a V8, but it is just as thirsty when I am not carrying anything as when I am pulling a car. A couple months ago, after driving for about 30 minutes or so, the engine would make a "Pfft" noise and would start popping and I would have to drive with 2 feet to keep the engine running.
View 14 Replies
I have a 92' Areostar XL 3.0 2WD. When I first start it and put it in drive it takes a few minutes before it kicks in. After a few minutes of driving it doesn't have a really bad problem (only a few times has it slipped in lower gears.) I was told it could be a clogged transmission filter, old transmission fluid that is glummed up, or pull belts need to be tightened. I have the van up on jacks now and was getting ready to change the filter and fluid but I decided to get some advise first before I screw things up or do any unnecessary work.
View 14 Replies
I've got a 92 star with a 4.0 liter engine and I think a 4ald auto trans. When I 1st start the motor it takes 3-4 minuted before it will go into gear. after that it's fine. I've tightened the 2 bolts under the dash tightening up the shifter and my fluid level is fine.
View 11 Replies
I have a 2003 Toyota Echo with 250,000 miles. It has been a great car as I commute 90 miles to work. I have had no major problems with the car. Unfortunatly it recently died on the way to work. It was running great and then all the sudden it sputtered and killed. When I first tried to start the car it would just turnover but after waiting 10 minutes it started back up (this was a cold morning). When it started it was running great again. I drove it another 15 minutes and it all the sudden died again. This happened 3 times.
I have hooked up to a scan tool and a camshaft position sensor code displayed. I replaced that but had no change. Another code came up as mass air flow sensor. I purchased a used one of those and still no change.
I have started the car up numerous times and always have the same results. It starts right up, idles good, speeds up good and runs good at full throttle. The problem becomes when it warms up the car kills. If I run it at idle to a slow acceleration it takes longer to kill than if I run the car at full throttle. Once it kills it will not start up until the car cools down, but once it cools down it will start right back up.
View 9 Replies
I have a 2004 Nissan Xterra that has been chugging for a few months now. The problem is intermittent and only happens about once or twice a week when driving, but when it starts to chug (feels like it is running out of gas, jerky, will not accelerate) it is unsafe to drive on the freeway. I have taken it to several places and no one can figure out the problem. It was pulling two codes the speed sensor on the transmission PO500 - and the knock sensor code was coming up along with that. I had the speed sensor replaced twice and checked the wiring. We replaced the fuel filter, checked the fuel pump with a fuel gage and fuel lines, replaced the distributor cap and rotor, put in a new MAF sensor and still nothing is working to remedy the chugging. My last stop is replacing the knock sensor for $600, the problem is that the Nissan Mechanics (I visited two dealerships in different cities) told me not to replace this as it would not cause chugging. Several other mechanics around town tell me that they are wrong and I do need to replace it.
View 13 Replies
The truck started acting up while driving. It would shut off (no miss or anything), but would start again. Now it is sitting in the driveway and wont run more than 3 seconds. The fuel pump has been changed and did not work. The fuel pump relay is new and did not work. I read that the fuel pump goes to another circuit after start up. Could it be running to start and then shutting off? Inertia switch is not tripped. Where to look next. 1992 Ranger 6 cylinder ....
View 10 Replies
Why is my 1992 ford explorer self accelerating between 15- and 25 mph?
View 1 Replies
Ok long story short I was given a conversion van that is built on a e150 van and has a 5.8 liter with an e40d tranny.. This van sat for at least 3 years till recently..
I have cleaned all electric connections on the tranny and the one on the rear differential . New filter and fluid but did not drain the converter after driving it for about an hour we finally got it to start shifting gears automatically the problem is it wants to shift only under heavy acceleration and then only to second at about 35 mph and drive at about 60 mph and over drive around 80 mph and all this only under heavy acceleration you let of the gas a little and it starts down shifting..
What I may look for next that may be pretty easy to try. My thoughts at this point are maybe the torque converter is going south but I am hoping for a more simple solution..
View 8 Replies
