I have a few problems with my explorer. I was just wondering if there's any way I can fix them on my own instead of paying a mechanic. I
1. back passenger window wont roll down .. .
2. Gas gauge fluctuates can't get an accurate reading on it .. .
3. service engine light comes on for a couple days, then goes off .. .
4. shifts hard if i go over 65mph and then slow back down .. .
my wife has an 06 with 77,xxx miles on it. as far as i know there has never been any tranny upkeep done on the vehicle. we have owned the care for approx 15 months. it doesnt act up all the time. it will shift real hard into reverse, feels like it is popping into it real bad. then at times it feels like it slips very little going into overdrive. and at times it will pop when shifted into drive. it is hard to predict, i thought maybe when it was warmed up and the fluid was warm it might not do this, but it does. i know nothing about this thing, the dealer wants me to bring it in so they can plug it in?
View 5 RepliesMy speedometer is jumpy, odometer quit working at same time. Shifts kinda hard going into 2nd and 3rd gear. I am at wits end. I have replaced both speed sensors, checked all fuses, and also tore dash apart checking the worm gear in the cluster. I don't want to take to the ford dealer. The truck got 172,000 on it but been very well maintained. I just don't think its the transmission. Its got to be something easy.
View 9 RepliesReplaced the 2002 ford explorer 4x4 traction control module because of a shudder in first gear. With the new module the shudder disappeared but now the truck shifts into 4wd by itself and stays there. I am now on my 2nd new module because I returned the first one thinking it was defective.
If I cycle the 4x4 high switch and the 4x4 auto switch, the truck switches back int 2wd but on for a moment then goes back into 4wd. I don't get a 4x4high indicator light but I can hear and feel it is in 4wd. Almost like it thinks the truck needs work with the traction. I have now disconnected the module completely and the trucks runs/shifts beautifully in 2wd. I know my transmission is good. BTW, I have no trouble codes.
Do I have a bad speed sensor somewhere? and How do I trouble shoot for it?
I've just bought a used 2002 Explorer Sport Trac (Automatic) 120k+ odo and what I've noticed whenever I shift from Park to Reverse or to Drive it takes about 3 seconds before I feel a slight jerk moving forward before I can step on the accelerator for the vehicle to move backwards or forwards but if I step on the accelerator right after shifting to any gear except Neutral it won't run immediately as if the clutch is disengaged and after about 3 seconds it will suddenly engage. Is this normal or is there something wrong with the transmission?
View 3 RepliesI have 99 f350 v10 4x4 and trans shifts great under light rpms but 2-3 shifts very hard. At wide open from about 35 mph it will shift down and take off like a bullet but wont shift until I lift my foot and then it bangs hard from 2-3. All other gears are smooth. I did some searching and have found some threads saying it could be an accumulator spring that is broken? Truck has 115,000 miles on it. love the truck but want to fix this before it does some damage.
View 1 RepliesOur intrepid 3.5L with 135000 miles has been acting up a bit. Its had a couple hard shifts over the last few days/week that almost seemed like an engine hesitation, and this morning when slowing down from highway speed into a small town, it abruptly shifted down to 2nd and stayed there like its in "limp mode" ??.
Pulled over and checked fluid. Level looked good and smelled ok but has a brown tinge to the pink fluid.
Started to go again and it still wouldn't shift. Pulled over and shut car off. Checked codes P700 and P138.
Started car up and it shifted fine for the next 28 miles. Shut car off and parked it.
My 2002 Impala 3.4l sometimes starts shifting hard through all gears. It's not all the time. I have heard of others with this same problem and a transaxle service is apparently not the fix.
View 3 RepliesI have a 02 explorer XLT with the 4.6L and the oil pressure gauge has never worked (the three years I have owned it) I did an oil change yestarday and replaced the sending unit thinking that was the problem but the gauge is still not working. What other problem it may have? 4x4 light flashing (instrument panel looks like a xmas tree)...
View 10 RepliesThis is weird. SOmetimes my gas gauge fluctuates from low to high. I don't know how to explain it but it just bothers me thinking there might be a problem I'm not aware of. This also shows LCD display saying 190km left then after I start driving for a while it'll show 210km. [IMG] [URL] ....
View 8 RepliesSomething strange started happening to my '04 Prius yesterday and it happened again today. We are experiencing unseasonably warm temperatures here in Western Oregon for October and when I left my house this morning at 6:30 am, it was about 55 degrees. I have a half hour drive to work on a mixture of expressway, freeway, expressway again and then the two-lane highway.
Anyway, yesterday (and today) when I'm almost to work, my temp. gauge drops down to 37 degrees. This causes that yellow light to start blinking indicating that the engine will not shut off because of cold temps. It will warm back up to 45 degrees a minute or two later. Why is this happening? It for sure is not 37 degrees outside. Is my temperature sensor going bad? Is this exhibiting the behavior of a sensor going bad?
My fuel gauge fluctuates once I turn the key to Acc, once I fire it up it goes back to empty and climb back to the correct position,
Also once this happens, my MFD starts to act crazy, sometimes it shows nothing, and times gets stuck on the door open screen and my steering wheel controls go dead, if I turn off the car and then on its gets stuck "Volkswagen information" screen.
I disconnected/reconnect the battery everything went fine for a couple of days and then happened again,
2002 ford sport trac.I have been having an ongoing issue that started with the engine cranking but would not turn over until an hour passed. After replacing multiple parts (cam shaft sensor, crankshaft sensor, ignition pack) I am now down to poor fuel economy as the last of the issues (roughly 12 in the city and 15 highway). I was told the issue may be the engine coolant temperature sensor going bad so I decided to replace it. I found this was very difficult due to it being a plug and locking pin design and in a very tight spot in the engine.
I tried to purchase a replacement and the parts store kept trying to insist on selling me a part with threading. I finally found someone that figured out the issue and found the part for the 2001 sport trac had the same plug style with clip that did fit but was shaped a little different on the sensor end which I assume was due to being aftermarket. I noticed that there were two plugs side by side and the one easiest to access was on the left and I was told the one on the right was the sensor that gave the temperature reading to the gauge.
After installing the engine coolant temperature sensor I found the temperature gauge on the dash now will not respond and is sitting below the cold end of the gauge completely off. Is it possible this is because the part was for a 2001? Is the sensor on the left (passenger side) the engine coolant sensor?I would hate to put the old sensor back in just to test if that's the issue due how difficult it was to put that locking pin back on. What to check that could resolve the gauge issue before pulling this sensor back out?
My oil pressure gauge jumps all over the place when I get over 3000 rpms. At lower rpms it is in the normal range and the engine sounds ok. How can I tell if this is the oil pump or the sending unit or the gauge? This is a 1980 CJ5 with a 151ci 4 cylinder.
View 2 RepliesI have a 2001 Honda CR-V SE, and I'm having a little trouble with it ... About a week ago I noticed that as I was driving around the city, my temp gauge was going up and down. I had the heat on, and when I was pressing the gas, the gauge would go down. When I coasted, the gauge would go back up to the middle. The gauge never went higher than the halfway point. I thought it was possible that my fluids were low, so I checked the coolant reservoir. It was empty, so I added some. The radiator itself was full to the lip (like the manual says it should be, if I interpreted it correctly). The first day or two, didn't notice anything, but then the gauge seemed to start falling again.
Anyhow, I decided to drive back to the big city to get it fixed, a 3 hr drive, last night. The car seemed to be operating fine. I did not have the heat on, but there was air flowing through the vents. The gauge started to creep downward, so I thought "Hey, let me hit that button that closes the vents" I did that, and the gauge creeped back up! Problem solved right? Negative! It was raining, so when that button was on too long, my windows got foggy. So that's how I spent the next two hours, button on, button off, then I finally just opened the windows to allow the air to circulate. In the meantime, I stopped for gas, allowed the car to idle for a while (no air/heat blowing at all) and the guage didn't move. It stayed in the middle.
Closer to the end of my trip the gauge started to creep upward, over the midpoint (The first time it's done that since this whole thing has started). Once off the highway, I turned the heat on that first notch, and the gauge went back down to normal.
At any rate, so it's Wednesday. I'm planning on getting the car to a shop on Friday, but in the meantime, I just wanted to get some info out there from the community. I'm pretty nervous about whats going to happen. I just had my car at an oil change place 5 days ago, and the guy didn't put the oil cap back on the engine, so I literally was driving for 3 days with oil spewing onto my hood (Checked the levels by the way and they were fine). The only way I would've known is that I opened the hood to check the coolant levels. I noticed the gauge issue last Wed, took it in for the oil change Friday (In which they said all my fluids were fine), checked the coolant Monday, and drove it 3hrs last night.
Are there any specific keywords I should mention to the mechanic for him/her to check?
My factory gauge on the dash reads Zero. I have put on a mechanical external gauge and it reads normal.
View 2 RepliesSo I noticed a few days ago when driving the turbo around that the temperature gauge fluctuates... ALOT. it will warm up to full operating temp, then when driving will go way down, almost to the cold line again and SLOWLY rise up, and when I mean slowly, I mean it takes about an hour or so to get there.
Well today, I changed the oil, there were about 2 qts in there but the car was about 2k overdue. MY BAD! So upon driving around seattle/bellevue/redmond today, noticed the gauge doing the same thing, and I am stumped, IDK why it would be doing this, the car doesn't overheat or anything.
Also, the girlfriend said that when she was driving the car, in the warmer weather, even while moving the temp gauge read almost hot, and the car was telling her to shut it off etc... I seriously am at a lose here.
The other night we noticed the TAIL light was out, but the brake light still worked. Last night we were out with some friends, they said that the TAIL AND BRAKE lights were not working, but ONLY on the drivers side, the passenger side worked as it should, we also noticed that when we hit the brakes, the front drivers corner light comes on and stays on until we take our foot off the brake.
He has a 2002 Explorer 4.6. The truck is having a hard time going into reverse intermittently, hard shift in normal driving and thinks it has slipped in first gear going up his driveway that is steep. He is worried that he put slightly over sized tires and this may hurt his tranny. The overdrive has blinked twice with in the year. Possible problems that could create this he is thinking solenoid pack, servos, torque converter. The truck has 110k and never done fluids, Would lucas slip fix or hurt we have heard that these tranny's are finicy.
View 1 RepliesI've noticed that my 2013 STX F150 4x4 5.0L shifts quite hard from 1st to 2nd. This clears up when I pull the battery cable for 30 minutes but comes back in about 2 weeks.
Is this a pretty normal thing?
I just rebuilt my E4OD transmission in my 1996 F250 7.3L it has all new clutch packs torque converter and a shift kit. When I first put itback together it would not shift out of second cleaned mlps and shifts threw all the gears now. I took it out on the road to test it and this thing ran great shifted smooth and quick could not askfor any better but when Trans temp gets around 140-150deg it shifts hard and od light flashes. I have ordered a scanner to read the codes but won’t be in till later this week. What I could check in the meantime.
View 13 RepliesHave an 01 f150 super crew 4x4 with 5.4 li shifts hard from 1st to 2nd - What could be the problem?
View 1 Replies