My windows wont work and my interior door handles ALL need replacing. How exactly can I do this? I had to replace one a while back when the windows worked but I am stumped as to how I am going to attempt this. The only way I can exit my truck is to get someone to open it from outside or climb out the rear window (I'm a thick female and this is annoying/embarrassing).
View 2 RepliesChild safety switches on both doors are NOT activated, and both doors open OK when exterior handle is pulled. Jiggling the child safety switches does not resolve the problem. Removed interior handles thinking that perhaps some plastic tab had broken off, but both appear ok. Pulling on the linkage bar that connects handle to latching mechanism inside the door does not open the door. Indeed, the linkage bar won't move despite tugging.
View 1 RepliesTroubleshooting a problem with friend's 2000 F250. His power windows aren't working and are causing problems with his door locks and interior lights. When he tries to use his drivers side power window, his power door locks quit working. If he puts the switch to raise, the interior lights flash. From what I've read, it sounds like the GEM to me, we've inspected the wiring and it all looks good. I pulled it out today and it looks good inside, no sign of water leaks on it. If it is the gem, how much do they cost and do they require programming?
View 5 RepliesI have a moonroof & there were no map light bulbs, so I tried putting them in place but the electric connection there wasn't so good (there is a plastic covered with wires) so the bulbs are in but it doesn't work. What worst is, that now all the interior lights (glove box & rear dome) don't work as well!! nor the power windows & moonroof don't work now (it worked before). I guess that I have touched something or a fuse broke... I don't know what to do...
View 2 RepliesI have a 1997 explorer 5.0 AWD. The problem is that when it is about 44 degrees and below, the windshield wipers, power windows, and interior lights don't and won't work. We will run the heater until it warms up the interior, then everything seems to work fine. I usually leave the wipers on so I know when it is warmed up enough. I have checked all of the fuses and all are fine. the only thing that I can think of is there is a crack in the back of the fuseblock that breaks contact when the metal is cold.
View 2 RepliesThe interior door handles that is. Not the actual chrome but the black plastic that is made to be held when closing the door. Damn I hate it. Gives the car such a cheap feeling.
View 6 RepliesMy power windows and door lock controls on all doors have stopped working. No blown fuses and the local parts who says that locks and windows don't run on the same relay? I don't have a garage and cant really secure my vehicle?
View 3 RepliesEver since I painted my car my outer door handles have not worked properly. Once you open the door using the inner door handle then the outer one works fine...lock the doors and the outer handle becomes almost useless. I say almost useless because if you kind of pull it just right it seems to catch and work. How to remedy it? Really tired of using this auto window roll down to reach in and open the door.
View 4 RepliesI have a 2013 Santa FE 2.0T Limited with the Smart Key setup. Since new, when I would approach the vehicle and the key was within a yard of the door handle, the small lights in the door handle would come on so we could see the handle. A couple of weeks ago the vehicle battery died (again) and now those lights will only come on once the button is pushed.
The dealer had the vehicle for 90 minutes and could not find any thing wrong other than the Welcome Light was turned off in the center info console from the dead battery episode. I checked it again last night and the proximity lights still do not work. How tp get the proximity lights working again?
I have a 2008 Phaeton v8. The keyless entry feature on the exterior door handles has stopped working. The car neither locks or unlocks using the keyless entry feature. I tried using accessing the car with different key Fobs to no avail.
View 2 RepliesI have a 2000 EX 7.3L ... The power windows aren't working and neither is the interior lights. I am hoping it is a couple of fuses. Problem is that I can't find a fuse diagram and I don't have any knowledge about changing the fuses. Do I need to change them both under the hood and under the dash? Which fuses I need to look at changing?
View 5 RepliesFor about 3 months, my wife's 2003 explorer has had a bad door sensor (I'm guessing). The car claims a door is ajar and the alarm would go off randomly if it's locked. Yesterday the battery died because apparently the alarm had been going off for so long while she was at work. After having a stranger jump it, she has had major problems:
-She claimed the headlights didn't work in any setting except in the on position with high beams on, but now they seem to work.
-The instrument panel is totally out including all gauges and all lights
-the power windows don't work
-the radio won't turn on or show any display
-the interior lights won't turn on
All of the fuses are fine and my mechanic checked them as well. He did say that a few key fuses aren't getting any power to them on either side. But the battery is charging and drawing just fine. The car doesn't seem to have any other issues and all of the flashers work just fine.
What the problem could be? I have wondered if one of the relays is busted.
Just purchased my first Explorer. It's a 2003 Explorer XLS. Only problem with it is that both rear door Windows don't work. The dealership where I purchased the vehicle immediately threw a new drivers side door switch in it to no avail. Now they want to throw two new window regulators in it. Before they do that though I am going to do some checking to see if they are getting power. Both front Windows work just fine.
View 6 RepliesRecently I was driving down the road in my 99 B5 1.8T AUTO and my power windows stopped working from all the interior switches. First thing I did was get out of the car and use the key to roll them down, which worked fine. Here is what I have tried/looked into so far:
- All fuses are fine except #14 which i replaced
- Swapped the master control switch in the drivers door
- Checked the wire harness under driver carpet and the ground wire for frays or breaks
- Checked the CCM connectors and board for anything burnt or damaged
I will also add that the locks work from the door switches and the power mirrors don't work as well.
I have a friend who has a 2003 Explorer and all his windows stopped working.
I checked all the fuses under dash and hood and found that none of them were shorted, even swapped my window circuit breaker off of my Ex and still could not get them to work. I took a test light to all the power wires in the door and noticed that he wasn't getting positive power and that he had negative to the switches. I ran a jumper wire from the battery and could get the windows to work. I removed the door panel and traced the wire all the way through the rubber boot at the door jam but could not get any juice. The circuit relay has power to it but don't know where else to look!
What else should I look for? Is there another place that he might've lost contact or another fuse/switch somewhere that I didn't see. Looking for a wire diagram for the power windows that would also kinda trace faults.
White 1997 Explorer XLT 4 door 4x4 4.0 sohc 220,000 miles. The power windows and locks don't work. I've tried all of them in the whole car and nothing. Replaced all fuses at the inside panel and replaced all fuses and relays under the hood. Replaced master control switch on the drivers side and still nothing.
View 1 RepliesNone of the windows will function. Took off the door panel wiggled the wiring harness and the windows would function. Fortunately I got them all up.
Now with nicer weather it would be nice to have them working. I assume I have a broken wire leading to the master switch in the driver door. What would be the color code that is likely broken.
About 4 months ago I was at the gas station and when I tried opening my fuel door, the switch wasn't working. I went home, took the door trim off, and then removed the switch in order to clean it. Once I cleaned it, it worked but about every 3rd time that I clicked it. However, yesterday it finally gave out as I was at the gas station. So I came home and now I'm stuck because I don't want to break the fuel door.
I ran through the fuses in the fuse box but on the diagram none seem to be for the fuel door. The weird thing is that yesterday as the fuel door switch gave out, so did the interior door lock switch. Now I have to insert the key from the outside in order to enter the car. But the key cannot unlock the passenger door.
When I hit the interior door lock switch, I hear a click noise under the dash. I took a look under there and it seems to be a bunch of relays. It's very tough to tell which one is the one clicking.
One of the interior handles for the liftgate broke off. I removed it. From what I can tell, this handle is molded to the interior trim part.
I'd like to glue this piece back on, rather than having to purchase the complete lower trim piece.
What is the best type of glue for this plastic?
My brothers window won't work from any of the switches and the locks won't work they only work from the driver side no window action though from either side, checked the fuse and relay but nothing.... 1996 Ford Escape 4wd....
View 1 RepliesI am trying to keep driving my Astro until I pay off my wife's new car. Repairing the door shouldn't be a problem if I could get the door open to remove the inside door panel. How to get the door open? Can't use the inside or outside handle now.
View 5 Replies