Looking for diagrams for where the fuel filter is, the coils are in the engine compartment, and a steering wheel diagram because mine wobbles. I did attempt to look for one in a hayes when I was at Pep Boys a bit ago and didn't see one. 1998 F150 4.6L v8 w/auto trans 4wd 3dr...
View 6 Replies98 F150 4.6L 4WD...
Attempted to replace fuel filter tonight. The connector on the fuel tank side of the filter came off just like it is supposed to. The engine side, however, will not come lose at all. I can wiggle to back and forth, but I can't seem to get the tool to compress the springs.
The engine side connector seems to be smaller than the tank side. I've done this once before on a '98 Ranger, but didn't notice a difference in connectors.
I have a 99 5.4L V8 Triton engine. The power steering is not working. Need a full power steering diagram including components and hoses/lines? I have attached a picture of a broken line which I think might be for the power steering but I'm not sure. What this (?) line is in the attached picture or have a diagram?
View 3 RepliesLooking for the wiring diagram for the circuits on the steering wheel? For some reason, when I hit my cruise control on button, the horn honks...
View 6 RepliesWell I was trying out my four wheel drive today and it worked fine until I went to turn off switch, it would not cut off it is a 98 F150 switch is located on dash. It is stuck in four wheel high!
View 3 RepliesI have a 1998 Ford F150 with 4.2.. Started off a intermittent problem of not starting acct no fuel. Now will not start at all. Checked all fuses and relays.. Am not getting voltage at fuel pump. Changed ECM thinking that was the problem.. Have checked all multi wire connectors for corrosion and tightness. Am at a lost what to try next.
Also, not sure if its related or not. The turn signals and hazard flashers do not work. When I turn on the hazard flashers, nothing happens. If I leave the flashers switch on, the turn signal work. Checked all fuses and relays and they appear good.
Ok I have recently bought a 1998 Ford F-150 V6 4.2L 2WD and when the guy sold it to me the check engine light was on and he told me that randomly when you turn the key to the on position you will not hear the fuel pump buzzing sound and he knew it wouldn't start, he said you would have to turn the key from the on and off position many times until you hear this sound and then the truck will start and run fine.
First off I got the codes read and there were three of them P0171, P0174, and P1537 some things to note are that the drivers air bag looks like it had deployed, the cover is loose and when I pulled it back the air bag looks duct taped up inside there that would cause the air bag light to continuously flash while driving. I noticed the battery leads were corroded so I replaced the battery and put new battery clamps on both wires, after that the problem did not happen for a week and I though it was over but it happened again.
Next is that the truck has the PATS system and it did not come with a remote which I have also read that the PATS system can cause the fuel pump not to turn on but not sure if this would cause it to not start randomly because sometimes it starts right up. When I started to look at the simple things to fix I noticed it did not have an air filter in the housing. so I thought the MAF sensor could be dirty so I cleaned it with the special cleaner, I put sea foam into the intake via a vacuum hose and also have put a fuel system cleaner in a full tank and have driven most of the gas out. After putting in an air filter, cleaning the MAF sensor, and sea foaming the intake, it seems to run a bit better but I am still having the random fuel pump issue.
I have checked the fuses and the and the fuel pump and ECM relays both are fine. Today I put new exhaust on it because it had some bad exhaust leaks and the truck did not start again, so the guy trying to put my exhaust on, hit the fuel tank with a hammer and it didn't work then hit it again and it finally worked. Im not sure if the hitting it did it or if it just randomly turned on like always from turning the key on and off. The new exhaust has made a huge difference in driving it feels and sounds much better.
Also to note is that when I am stopped at stop lights it will idle at about 1500 and then it drops down to 500 and back up and back down again and it does this at most stop lights, and it is not an abrupt drop it just slowly idles down and back up again. Again once the truck is started it runs perfectly fine with no issues, and there are no specific times when it has the problem it seems to be randomly. I know that many people will tell me to change the fuel pump out and I am already prepared for this but if there is any easy things I haven't thought of yet...
I noticed after the crash the steering wheel is moved forward and gear shift is up against dash. asked around and one person said they made collapsable steering wheels to impact. i have never heard of such a thing.
View 5 RepliesI want to replace my steering wheel. Will this puller work for that job?
View 5 RepliesI have a 97 F150 that I just got a few weeks ago. I was driving home Wed. night when the 4x4 low range light would come on and off intermittently I had it in 2h the whole time. I went online and couldn't really find anything on it. So I get up to go to work on Thursday and the truck wouldn't even turn over. The battery was dead. I have put in a new one but now after turning the truck off I hear a clicking sound coming from the steering wheel. What this may be?
View 3 RepliesGetting some rain here in az causing me to use my windshield wipers....which is rare. I can once and for all say I'm sick of the wipers working only with the steering wheel in the "up" position. Is it a big deal to tear into the column and replace that stinking multi-switch/harness? 378000 miles ....
View 1 RepliesI have a 2000 Ford F150 XLT 4X2 that has a "clunking/squeaking" noise in the steering wheel, intermittent happens driving straight down the road, hitting bumps, breaking. It is very annoying! changed out lower ball joints tightened wheel bearings, greased idler/pitman arm thinking that was the problem and it became worse. Had someone look at it and stated that the steering shaft was welded?!?! Why would the steering shaft be welded what am I looking at in replacing it (cost for parts and labor time) and are there any other additional parts that will have to be replaced as well?
View 1 Repliesmy turn signals only work with the steering wheel tilted all the way up. It works for me, but my wife drives the truck mostly because we live a mile from her work. The dealer said it was a "peanut connector." And can someone walk me through the steps to fixing it?
View 8 RepliesI recently bought a 1998 f-250, regular cab, long bed, 4x4, 5.4l triton, automatic. The truck was involved in a wreck by the previous owner and I am trying to repair the damage. He hit some ice, slid off the road, and collided with a log cabin.
The visible damage was done to the driver side front. The bumper, grill/surround, header panel, headlight, turn signal, fender, and hood all need to be replaced. When you drive the truck there is a shimmy coming from the front that can be felt in the steering wheel. When going straight and releasing the steering wheel it pulls to the passenger side. The driver side front rim might be bent? Which might prove interesting if I have to replace it (7x150mm).
This is my first Ford truck. I was willing to take the gamble on fixing it up. I hope that it works out and I am able to do so. What years/models can I source these parts from?
I have a 2001 ford f150 lariat 5.4 L Trition it shuts off while driving the steering wheel locks up when the truck shuts off I tried everything and it doesn't seem to help the problem. I changed the Iacv idle air control valve,I had a bad o2 sensor changed that, changed the crank sensor, cleaned the throttle body and changed the Tps sensor, got a new battery, changed the vacuum lines.i really don't know what else to do this truck is becoming a nightmare and is dangerous to drive I never know when it's going to shut off and when it does shut off sometimes it starts right up and other times it doesn't.
View 2 RepliesWorking on my bosses 97 Econoline conversion van. The steering wheel was flopping in the breeze, gear indicator was off and some of the time it would be in reverse when you thought it was in park. Checked the torx on the shift cable plate and they are tight. Replaced the 2 bushings on the shift column. They tightened up the steering wheel flopping around. I checked the shift cable and it appears to be in good shape.
It would start sometimes if you worked the shifter in park or moved it to neutral. Now it will not turn over. Shift lock actuator does not appear to be working. Does not lock it park. No continuity between any of the three pins with the actuator pushed in or out. If you turn the key you can take it out of park without pushing on the brake. Really do not know the series of events that have to occur to make it turn over. How to trouble shoot the problem?
I've got 2003f150 4x4 and had a fender bender front end out of line so had it lined up but steering wheel 180 degrees out..well watched a video about just adjusting drag link..so i crawled under ready to adjust but cant find an adjustment collar. Mine the only one without it?
View 10 RepliesPurchased 2000 F150 (224000 miles) about a year go cheap for knock around truck. Only gets driven about twice week (20 miles most). Has been running great until recently. Got in the other day went about a mile and notice really strong vibration in steering wheel and dash. First thought about something to do with alignment etc. After a little experimentation realized it was the motor. When you get to around 40 mph and try to hold the speed constant it starts shaking (I believe the motor is missing). If you mash the gas and accelerate it stops. As soon as you try to hold constant speed again it starts again. I can run it up to say 45 and let off the gas and the shaking stops. Once it was driven like this for about 5 miles or so, when I come to stop sign it idles rough. If it is put in neutral runs smoother. Could the fuel filter be clogging up? I did try some additive to see if it would clean it out, no luck. Now the check engine soon lite came on. Fuel Filter, Plugs?
View 5 RepliesI took my truck to work and needed a pitman arm. So took it home put a new one on and the steering wheel was crooked which didn't bother me. but after in cranking the torsion bars I noticed how Badly I needed an alignment. So took it back in for an alignment and I cant turn the steering wheel back to center because the tie rods are maxed out. I tried to take the pitman arm back off center the wheel and everything but the key ways just line up the same way. Any chance the after market pitman arm is off or any clues?
View 11 RepliesLooking for a diagram for the ecm pinouts for a 2000 5.4 4x4 f150? Im mostly trying to find the TCC for the tranny.
View 1 RepliesI just bought an 01 F150 and previous owner didn't have the manual.
Need a copy of the fuse box diagram for this truck?
I've been surfing the net, and can't find what looks like the right one.