Getting some rain here in az causing me to use my windshield wipers....which is rare. I can once and for all say I'm sick of the wipers working only with the steering wheel in the "up" position. Is it a big deal to tear into the column and replace that stinking multi-switch/harness? 378000 miles ....
View 1 RepliesI noticed after the crash the steering wheel is moved forward and gear shift is up against dash. asked around and one person said they made collapsable steering wheels to impact. i have never heard of such a thing.
View 5 RepliesI want to replace my steering wheel. Will this puller work for that job?
View 5 RepliesI have a 97 F150 that I just got a few weeks ago. I was driving home Wed. night when the 4x4 low range light would come on and off intermittently I had it in 2h the whole time. I went online and couldn't really find anything on it. So I get up to go to work on Thursday and the truck wouldn't even turn over. The battery was dead. I have put in a new one but now after turning the truck off I hear a clicking sound coming from the steering wheel. What this may be?
View 3 RepliesI have a 2000 Ford F150 XLT 4X2 that has a "clunking/squeaking" noise in the steering wheel, intermittent happens driving straight down the road, hitting bumps, breaking. It is very annoying! changed out lower ball joints tightened wheel bearings, greased idler/pitman arm thinking that was the problem and it became worse. Had someone look at it and stated that the steering shaft was welded?!?! Why would the steering shaft be welded what am I looking at in replacing it (cost for parts and labor time) and are there any other additional parts that will have to be replaced as well?
View 1 Repliesmy turn signals only work with the steering wheel tilted all the way up. It works for me, but my wife drives the truck mostly because we live a mile from her work. The dealer said it was a "peanut connector." And can someone walk me through the steps to fixing it?
View 8 RepliesLooking for diagrams for where the fuel filter is, the coils are in the engine compartment, and a steering wheel diagram because mine wobbles. I did attempt to look for one in a hayes when I was at Pep Boys a bit ago and didn't see one. 1998 F150 4.6L v8 w/auto trans 4wd 3dr...
View 6 RepliesI recently bought a 1998 f-250, regular cab, long bed, 4x4, 5.4l triton, automatic. The truck was involved in a wreck by the previous owner and I am trying to repair the damage. He hit some ice, slid off the road, and collided with a log cabin.
The visible damage was done to the driver side front. The bumper, grill/surround, header panel, headlight, turn signal, fender, and hood all need to be replaced. When you drive the truck there is a shimmy coming from the front that can be felt in the steering wheel. When going straight and releasing the steering wheel it pulls to the passenger side. The driver side front rim might be bent? Which might prove interesting if I have to replace it (7x150mm).
This is my first Ford truck. I was willing to take the gamble on fixing it up. I hope that it works out and I am able to do so. What years/models can I source these parts from?
I have a 2001 ford f150 lariat 5.4 L Trition it shuts off while driving the steering wheel locks up when the truck shuts off I tried everything and it doesn't seem to help the problem. I changed the Iacv idle air control valve,I had a bad o2 sensor changed that, changed the crank sensor, cleaned the throttle body and changed the Tps sensor, got a new battery, changed the vacuum lines.i really don't know what else to do this truck is becoming a nightmare and is dangerous to drive I never know when it's going to shut off and when it does shut off sometimes it starts right up and other times it doesn't.
View 2 RepliesWorking on my bosses 97 Econoline conversion van. The steering wheel was flopping in the breeze, gear indicator was off and some of the time it would be in reverse when you thought it was in park. Checked the torx on the shift cable plate and they are tight. Replaced the 2 bushings on the shift column. They tightened up the steering wheel flopping around. I checked the shift cable and it appears to be in good shape.
It would start sometimes if you worked the shifter in park or moved it to neutral. Now it will not turn over. Shift lock actuator does not appear to be working. Does not lock it park. No continuity between any of the three pins with the actuator pushed in or out. If you turn the key you can take it out of park without pushing on the brake. Really do not know the series of events that have to occur to make it turn over. How to trouble shoot the problem?
I've got 2003f150 4x4 and had a fender bender front end out of line so had it lined up but steering wheel 180 degrees out..well watched a video about just adjusting drag link..so i crawled under ready to adjust but cant find an adjustment collar. Mine the only one without it?
View 10 RepliesPurchased 2000 F150 (224000 miles) about a year go cheap for knock around truck. Only gets driven about twice week (20 miles most). Has been running great until recently. Got in the other day went about a mile and notice really strong vibration in steering wheel and dash. First thought about something to do with alignment etc. After a little experimentation realized it was the motor. When you get to around 40 mph and try to hold the speed constant it starts shaking (I believe the motor is missing). If you mash the gas and accelerate it stops. As soon as you try to hold constant speed again it starts again. I can run it up to say 45 and let off the gas and the shaking stops. Once it was driven like this for about 5 miles or so, when I come to stop sign it idles rough. If it is put in neutral runs smoother. Could the fuel filter be clogging up? I did try some additive to see if it would clean it out, no luck. Now the check engine soon lite came on. Fuel Filter, Plugs?
View 5 RepliesI took my truck to work and needed a pitman arm. So took it home put a new one on and the steering wheel was crooked which didn't bother me. but after in cranking the torsion bars I noticed how Badly I needed an alignment. So took it back in for an alignment and I cant turn the steering wheel back to center because the tie rods are maxed out. I tried to take the pitman arm back off center the wheel and everything but the key ways just line up the same way. Any chance the after market pitman arm is off or any clues?
View 11 RepliesI tried the test mode (hold trip reset and turn ignition to run) this revealed that the needle for the speedometer does sweep from zero to max and back, could it still be the cluster? Is there something I am missing? FWIW the odometer lights up but does not work and all other gauges seem to be functioning correctly.
View 10 RepliesI have a 2008 Honda Odyssey. I purchased the van used back in February with 34,000 miles on it. About a week after I bought it, the van started having odd electrical problems. My radio controls on the wheel would stop working, my rear wiper would start running even though it is in the off position. My power sliding doors would catch and close at the half way point on both sides at the same time. It is little odd ball stuff, but I am worried that the "brain" is not working properly. I have taken it to the dealer multiple times and of course they can't find the problem. They say to bring it back if it keeps happening, which I do, but every time they say it is fine and send me on my merry little way.
View 2 RepliesI just bought a 99 f150. Its in great shape only 65000 on it but there is a hissing swooshing sound when turning the wheel... not really any brake sounds. The truck has been maintained and I dont see any leeks in the ps system hoses. I didn't know anything about the atf fluid in the truck... and I haven't added either ps or atf fluid to it. I'm wondering if that is maybe something the dealer i bought it from did. or maybe one of the shops the previous owner did. Would ps fluid cause these kinds of sounds? Do I need a flush of the system.. How to do that.
View 14 RepliesI have a 2003 V12 Phaeton with 50k miles. Wonderful car to drive but unending series of electrical and mechanical problems. On FM, the sound completely stopped. The receiver seems to be working since all radio stations are displayed on the screen. But there is no sound. AM and CD both work. The dealer took a look and told me that they couldn't pinpoint the problem and that I would have to replace the entire entertainment console.
Unrelated but also annoying, all within the last month: the horn stopped working (dealer can't figure out why), one of the windshield wipers stuck in the up position, drainage canals plugged resulting in backseat flooding after a heavy rain that shorted electrical connections in rear seat (the dealer said this was a widespread "design defect" in Phaetons and Audi A8's) and front passenger seat heater shorted burning a hole in the leather (and, almost, my wife's rear).
My truck has developed a wobble in the steering wheel. I don't mean when you are driving down the road, but the steering wheel wobbles around. It wobbles in any position that the Till shaft is set to. How to repair.
View 10 RepliesReplacing Steering Wheel position sensor. How hard of job is it?
View 6 RepliesI have a 2003 F150 manual 4WD with 4.6L engine and 165000 miles. When i am driving i feel a vibration in the steering wheel and on floor board that intensifies when i press the accelerator. I do hear an irregular humming that sounds like it is coming from the driver side front. I checked the wheel for any play but it was very tight. i check tie rod ends, ball joints no play. i recently changed both u-joints on the rear shaft and the bearing hub on the passenger side front. Also, the steering feels a little 'wobbly' when i make sharp turns. it almost feels like it is giving. What else should i check?
View 1 RepliesI have a 1997 explorer 5.0 AWD. The problem is that when it is about 44 degrees and below, the windshield wipers, power windows, and interior lights don't and won't work. We will run the heater until it warms up the interior, then everything seems to work fine. I usually leave the wipers on so I know when it is warmed up enough. I have checked all of the fuses and all are fine. the only thing that I can think of is there is a crack in the back of the fuseblock that breaks contact when the metal is cold.
View 2 Replies