Ford F-150 - 1997-2003 :: 1999 - Service Engine Soon Light On Sometimes At High Rpm Or Rough Erratic Idle
Feb 18, 2011
My trucks symptoms include a illuminated service engine soon light, sometimes a high rpm idle, and sometimes a rough erratic idle. When a scan was done it indicated the oxygen sensor was defective. The issue is: which specific one (there are multiple oxygen sensors) or how could I check or determine the faulty one for sure. I am trying to economize and replace only the bad one myself if possible. I own a good multimeter, can it determine the bad one? 1999 F-150 4.2 Litre V6 oxygen sensor dillemna....
View 7 Replies
Advertisement
2000 Ford ZX2 2.0 ....I've got approx. 79,350 miles on this car. I'm the original owner. The "Service Engine Soon" light came on. I took the the car to an Advanced Auto Parts store, they hooked up their handheld computer to the car and told me "it might be an oxygen sensor or poor fuel octane", he suggested adding an octane booster and see if the light stays off. I did that,but two days later it came back on, the idle seems a little ruff when stopped at a light.
View 5 Replies
I started out with my 2000 F150 with a 5.4 V8 running rough at idle. It would idle way down slow and then rev up a little over and over. On a couple of occasions it would even die when in drive or reverse. I did finally get a Check Engine light so i put it on my diagnostic program to see what was up. Here is what I got:
P1151 Lack of HO2S21 Indicates Lean
P0171 System Too Lean Bank 1
p0174 System Too Lean Bank 2
After doing some reading up I checked all my vacuum hoses and cleaned my mass air flow sensor. I then got the same codes again after a few minutes of running. So I went to the next thing that was recommended, the upstream bank 2 O2 sensor. After changing it the truck ran fine for a couple of days, no issues. Then all of the sudden it idled a little funny again and I got a Check Engine Light again. This time:
P0171 Bank 1 Lean
P0174 Bank 2 Lean
P0300 Random/Multiple Misfire
I reset the light to see if I would get the same again later. Before the light came on again I filled my truck up with gas and it seemed to be running pretty good again. Then a day or so later it set the light again. This time:
P0171 Bank 1 Lean
P0174 Bank 2 Lean
P0136 O2 Circuit Malfunction Bank 1 Sensor 2
P0156 O2 Circuit Malfunction Bank 2 Sensor 2
P1131 Lack of Switches HO2S11 Lean
P1151 Lack of Switches HO2S21 Lean
I went ahead and drove for a few days as it had gotten really cold here and I didn't feel like messing around in my shop since it isn't heated. A couple days ago I needed gas so i filled up again. Suddenly the problem was gone again. Truck ran fine idled fine no missing or odd idling at all. That lasted a day or two before it started acting a little weird again. At that point i was down about 1/8 of a tank from full. I have read that there can be issues with the fuel pump.. I am kind of wondering if that may be it now. But I haven't had to deal with this sort of issue before so I am unsure what to check next. The truck always runs fine off idle, it only seems to have the issue when it is idling. I had reset the codes the last time and i have the light on again now. I haven't checked it yet but I am sure it is going be some combination of what i have had in the past.
I have read that the IAC valve can be an issue as well. I had a problem with mine sticking a couple years ago and when it would do it you could just tap it with a wrench and it would idle up. But it never died like it does now and it would also idle a lot slower than it does. Back then I cleaned the valve and had no more issues with it. The truck has always had times when it would act weird at idle usually after slowing down after being at highway speed. The current issue happens at all temps cold or hot.
View 10 Replies
I have a 2002 Vue with an annoying "service engine soon" light problem. When I first took the car in to have it scanned, codes 171, 172 came up, which were "Fuel too lean Bank 1/Bank 2". It also has a problem with a high idle condition where the idle will creep up to 2000 rpm when parked, and a vacuum leak. My mechanic fixed the vacuum leak and replaced the gaskets on the intake manifold plenum, reset the light, gave it back to me and within twenty miles the light came on again. It only has 20,000 miles on it....
View 2 Replies
I just purchased my first foreign car ever. it is a 2002 Elantra it idles very rough changed plugs using NGK and wires new fuel filter and ran 2 full tanks of high grade fuel with STP fuel injector cleaner. but had no effect on idle also have no check or service engine light. What to check next?
View 3 Replies
I installed a new alternator now the check engine light is on....
View 7 Replies
2001 F150, 5.4L gas, 4wd, stock, 217k miles, auto trans. Bought it used about 4 years back.
Currently away from home base. Left Saturday for a 600+ mile trip. All fluid levels are good. Truck has been reliable. No major issues other than an alarm malfunction a while back which got sorted.
About 90 miles into the trip down the highway, the service engine light comes on. Hmm. At the next fuel stop I tanked up. Started and it was a bit rough the first few seconds and then settled. Seemed to have an engine noise I had not heard before.
Pulled over in the station and popped the hood. Oil good. Coolant fine. Power steering fine. Listening to it I could definitely hear an unusual sort of "ghost" like sound. Hard to describe. Sort of like a low "woooooo." It was low, but definitely there and not normal. Could be unrelated to the engine light. Pulling out of the station the sound varied and got louder with slight acceleration. Possibly beginning of an accessory bearing meltdown?
No acceleration or dying issues. Got back on the highway and kept on trucking for 600+ miles. No running issues. No shifting issues. Ghost noise not noticed at highway speeds.
The power steering pump is probably in need of replacement at this point with this mileage. It does drip slightly, but not a lot. It may be the original pump for all I know. Same with the water pump.
The alternator was replaced last year with a Bosch unit. I have never replaced the O2 sensors. Stock exhaust. Spark plugs were replaced a while back with Motorcraft platinums.
It is now Sunday night and I went out to listen for the sound, and it is not there anymore, but the service engine light is still on. First things to check with a truck that has 217k miles on it?
Was tempted to bring it to the dealer here, but it seems to be running ok in spite of the light coming on. So I may leave it until I get back home and check it more myself then. Can't do much here since I don't have my tools/service manuals etc with me.
View 6 Replies
I have an 01 f150 4.6 4x4 automatic with 90,000 miles. I have an erratic idle but it only happens when I am on the freeway well actually when I get off the freeway and stop. the idle will fluctuate between 750and then drop to 400 then back and forth til I get moving again. I replaced the IACV because it was doing the weird humming and vibrating the intake tube. The humming is gone but still idles funny as stated above.
View 4 Replies
The Service Engine Soon light has come on on my 2000 F-150 with a 4.6L when I was driving home in the rain. It has about 120,000 miles on it now. What are some of the main reasons why this comes on? Oxygen Sensors?
View 14 Replies
I have a 1999 F-150 w/ 4.2 V6. and auto trans, truck has 219,000 miles on chassis but only 25,000 on engine and 10,000 on trans. I've been getting obd codes p0705 and p0715. I replaced the position sensor on outside of trans. but I continue to get the codes off and on again. I noticed that the O/D "OFF" light on the shift selector blinks simultaneously when the "service engine soon" light comes on. I've noticed that there is no low gear unless I have it in D from a dead stop, and not even when downshifting manually.
View 1 Replies
The Service Engine Soon light is on in my 2001 F-150. I checked the code and got PO156 generic O2; circuit (bank 2, sensor 2). What are the most common things I should look at? The truck appears to be running fine, no driveability issues.
View 5 Replies
My Service Engine Soon light came on early last week and I got the code P0442- Evaporative Emission: System leak detected (small leak).
What are the most probable things I should look at?
View 10 Replies
I have a 2002 f150 4.2 code p0340, ran rough, replaced cam sensor. drove after replacing and it runs fine now, code and service engine light comes on after restarting. from what i have read could this be a wiring problem?
View 4 Replies
2001 F150 5.4L Triton Motor. Everything seemed o.k. then got the Engine Service Light. Checked with reader and above codes only appeared. Read numerous articles/videos and pulled the PCV hose/boot assembly and replaced the whole thing with oem part. Visually checked for disconnected tubing = none found. After this and with the new hose assembly in place I performed a reset. With the scanner still connected restarted engine and read values: ST FTRM1&2 = -.08~+2.3, both oxygen sensor voltages are varying and the LT FTRM1&2 hang around +26 and +28.
From what I understand the ST seems o.k. but the long term is WAY OUT OF WHACK. Started it up again and took carb cleaner spray and covered all the connections I could see = no change in engine rpm. No cracks in the air cleaner body. Big plug to the MAF was inserted and plugging the hole. I am thinking of making a smoke "machine" and trying that or removing the hoses from the throttle body and plugging the holes in the throttle body and see if that clears them up. IF it does then connect one by one and keep checking the values. Lot more work but I am at a loss.
View 6 Replies
Last week my service engine light came on. Friend checked it with his code reader. Got a P0402 code insufficient flow EGR valve. I have read several different threads on this subject on another Ford truck forum, slightly confusing me. Should I trust the code and just replace the EGR valve or do a number of other things that
1. Clean the throttle body first?
2. Test the EGR valve by blanking it off?
3. Test the DPFE valve?
4. Replace the DPFE valve instead of the ERG valve since the EGR valve rarely goes bad?
5. Only get OEM parts since after market parts do not last?
View 13 Replies
I have a 2000 f150 with 198,000 miles. The lite on the dash came on, "service engine soon" , I had the codes read and they said the coils are going bad.
View 2 Replies
I have a little more detail on when the truck starts and does not . I have gone out the past two days and put the key in the ignition and turn it to the on position and all the lights come on except Service Engine Soon light and truck will not start. I bought a ceramic electric heater and placed it on the floor directing the heat under the dash. after ten to fifteen minutes I go out and put the key in the ignition turn the key to the on position and the service engine soon light is on and the truck starts right up. I let it warm up for about a half hour and then shut it off. I then try to start it right back up and the service engine soon light comes on momentarily then goes off and the truck does not start?
View 5 Replies
I have a 2000 F-150 5.4 L. I was driving from home and seconds after the engine went into a rough idle that wouldn't let me accelerate. I scanned it and gave me multiple transmission trouble codes, about 15. I checked the wiring, the transmission fluid and it all looked good. So, what could be the problem?
View 3 Replies
Bought the truck knowing it needed a little work because it sounded like a diesel when running. So I had the timing chain, tensioners, water pump, etc. replaced and that fixed that problem. Then, a couple days later, a spark plug blew out of the engine. So, I go to do a full tune-up to find out that 3 of the 8 cylinders already had heli-coils in them.
I pulled those three and bored out and re-tapped the cylinders using the Cal-Van inserts. This has worked beautifully so far. I also replaced all of the other plugs as well with double platinum plugs. I also replaced all COPs. This got the truck running again and it drives great. No loss of power whatsoever. It just runs like a dog at idle. As soon as I give it throttle it smooths out completely.
It seems like the problem gets worse as the engine starts to get up to normal operating temp. Basically, if I am idling, in gear or in park, the truck shakes pretty bad. It kind of feels like it's starved for fuel or barely missing. I do not have any codes though and if it is a miss, it is completely gone under throttle.
Other things I have replaced within the past couple of weeks:
EGR
EGR vacuum solenoid
DPFE
Both PCV elbows
PCV valve
Air filter
Harmonic balancer
Other things I have done:
Cleaned IAC
Cleaned throttle body butterfly (including EGR ports)
Checked TPS voltage
I'm sure there are other things that I am forgetting.
The idle seems low to me but I'm not sure what is considered standard for the 5.4l. Mine idles around 600 in park once engine is warm and the needle doesn't move despite the roughness felt. Just going by the tach, you would think that the idle was smooth as silk.
Truck info:
2000 Ford F-150 XLT
5.4L V8 2V
150k miles
View 13 Replies
I am having a problem with my 1997 f150 4.2 v6. The engine is running rough at idle and while driving. It's running so rough that it vibrates the entire cab of the truck. I found water in the oil when I was trying to fix the problem. I have since had the heads redone and replaced all of the gaskets thinking this was the reason for the rough idling and rough driving. It wasn't; doing this fixed the water in the oil but still I have the rough running engine at idle and driving.
I have replaced the EGR valve, plugs and wires, pcv valve, replaced the coil pack, fuel filter and air filter (everything has been replaced with ford recommended parts because I have read that the engine I have doesn't like after market parts). While driving the engine vibrates and sound as if it's going in a cycle in a rhythmic sort of way (like a washing machine goes in a cycle), best way I can explain it. I have come to the end of what I think it is?
View 14 Replies
2001 5.4L 4x4...Engine bought from reputable junkyard with 140K has new manifold studs, motorcraft spark plugs, and 8 coils (bought on Amazon).
No check engine codes...checked for vacuum leaks...And has rough idle.
Is there a reason it might have rough idle aside from blown motor? The mechanic was going to take it to get computer reflashed but not trying to throw money down the drain...
View 6 Replies
