I took my truck to a friends express lube to have some freon added to it. My truck has been blowing cool air, not cold. So i thought it might be low on freon considering its a 2000 f-150 w/ 145,000 miles. He took a pressure gauge to it and said it is over charged, the pressure was high.
View 13 RepliesAC works, but only drops temp by 15 degrees. Pressures 40/150 after adding some 134a.
Compressor runs continuously at idle. (I don't know if this is correct or not.)
Not sure what the issue is.
2001 F150 5.4 4wd - AC not working but when I turn the temperature dial to the blue side and turn on the fan, super hot air comes out of the vents or wherever I direct the fan to blow (Floor, defrost, etc) I know it shouldn't blow ice cold especially since my AC doesn't work but.....shouldn't I feel a temp change coming from the vents when I move temp dial from the red area to the blue? It's max heat wherever I have it set.
View 6 Replies1998 F150 XLT 4.6l automatic,,,
Drove the truck on a trip the other day, about 650 miles with a loaded 5x8 trailer in tow. A/C started acting weird. When the truck was on level ground, or going down hill, the A/C was fine. Cold air coming out the correct dash vents. As soon as I started up hill, or put the truck under strain of acceleration, the A/C would stop blowing out the dash vents and would start coming out the floor or defrost vents, or just not come out anywhere.
When I turned the A/C off and just used the vent setting, it would do the same thing with the fresh air. I guessing this has something to do with my vacuum lines, somewhere. What I should be looking for and where?
I have a 2002 f150 supercrew 5.4 liter. About mid winter my heat suddenly went from hot to lukewarm. A check of the fluids shows all is good. I use my truck solely for work so I didn't bother with it at the time. Summer is here and my AC blows kinda cold, at best. I can hear the blend door moving. The temp control does make a huge difference. It just doesn't get real cold or real hot. Not like it should.
View 14 RepliesWas driving my truck I have a 97 f150 4x4 4.6L, btw. The heater started blowing cold air and I looked at the temp gauge but it was showing lower than it normally does and then, after a couple of miles or so I looked at the temp gauge again. By this time I was in my driveway. And it was overheating it might have been that way before I looked at the temp gauge again. But any way I opened the hood didn't see any leaks, all my hoses were hot except the top heater hose. Also checked the oil it was full and coolant was too, what this could be? Sounds like a t-stat to me? But could be worse. Also forgot to mention that the oil had no signs of water in there nor the expansion tank cap !
View 3 RepliesNew owner for the passat 2003 gls passat 1.8T. I turned on the AC and its not blowing cool air. Looking for DIY to fix my AC problem.
View 3 RepliesI took the dive into a new heater core, as the heater was not getting hot. These are the things I did while on my adventure.
1. Before reinstalling the hoses, I blew thru them to make sure of no clogs...water flew out the other hose..no problem..no clog.
2. inspected mix door not cracked or broken...no problem
3.actuator opens and closes ok, I assume, I can hear the motor run and the door thump closed...no problem
4. water and anti freeze level good....no problem
Start vehicle,let warm up, turn on heat.....No Heat...
5. check hoses at core, one is hot ,the other is not....Problem...
1997 f150 4x4 ...
I went to walmart and let the engine run for a while and shut it off. It would not start until it cools off. Now that its cool it starts fine. It just started doing it. Come to think of it i did get some gas in it.
View 2 RepliesMy A/C is blowing cold but only thru the defrost vents. First it was blowing normally from the dash but during acceleration or under load, the a/c would randomly blow from any vent, from the floor, dash, defrost. Now that stopped and it only blows from the defrost vents above the dash-board.
1997 F-150 XLT, 4.2 Liter, V6, manual transmission.
2004 Foed Freestar, the A/C has started blowing less than cool air in the past sveveral days. I'm assuming its low on refrg. but how does one check by visual inspection? If it is low will a simple re-charge kit w/guage and super dupper leak sealant do the trick? I saw a kit at Advance Autoparts for manufactured by Interdynamics. It had a guage w/trigger release for can content and three 12oz. cans of R134a. Will this kind of kit work?
View 6 RepliesAs the season has started to warm, I noticed when I have my air temp set to 60 and only using the vent and have not selected AC I have hot air coming out of my vents. After doing some research it appears that I may have a bad Air blend actuator, bad air door or something else. I took my truck to the dealer to get my fuel filter changed and asked if they could diagnose the hot air issue. Not being a mechanic I told the service mechanic the problem and he says the AC compressor always kicks in on fords even if the AC is not selected and maybe I have a leak and he seemed to think it more than likely was not the air blend actuator or blend door.
I told him I had no idea that the AC compressor always kicks in even with it not selected. I knew it kicked in for AC and for defrots but didn't think it did for anything else. He said since the 90's all fords did. Well I get a call that after diagnosing the system, they believe the freon is low. I just have my doubts and wonder now if I should've just tried to take the air door actuator off and test along with sticking something in the air blend door whole and verifying it was moving.
I was hoping someone that knows more than me can verify if the AC compressor kicks in even when it is not selected when I have the temp selector set to low 60 degrees. Does it make sense that I would have hot air blowing out of the vents with the temp set on low even when it is cool outside. All of my temp controls work moving from defrost, vent to heat as I can feel blowing out of the different zones.
We are having an issue with the front air not blowing cool all the time. Sometimes if we hit a bump or something its like something is jogged and it blows colder but the rear air always blows cold. Also the front air blows colder with the rear air on. I put gauges on it and I have the right amount of refrigerant in it. What I can do.
View 10 RepliesIn my 08 Expedition I notice the a/c compressor cycles on for 18-25 sec. then off for about the same. This is with an ambient temp of about 75f. A/C seems to be blowing cool air-never was really cold since new. The idle drops/surges a bit when the a/c kicks on also-which is what grabbed my attention. Is this a normal or is it short cycling?
View 1 Replies03 F350 7.3PSD... A/C blows cool on max only but does not blow real hard on high.
Blower motor is loud like it is blowing but just not coming out of vents. On reg A/C blows hot, actually blows hot on all other settings.
A/C compressor is on but blows hot through vents. I am thinking blend door and or something else. Thing is I am not sure what or where to look and how do I check?
I have a 1998 f150 4.6 that has a problem with the heating system. It's blowing out a little warm, but "far" from what it should be. ( on a scale from 1-10, I'd rate it about a 3) I am puzzled because I flushed the radiator, changed the thermostat, and there a no signs of heater core leaks inside,hose leaks on firewall, or radiator/water smell present. I don't know if this has anything to do with it, but I did notice the top radiator hose was hot, but not the bottom. I don't know what else to look for.
View 5 RepliesI have a 97 f150 4.2L 5 Speed that is only blowing hot air. A/C lines are cold when A/C is on, but coming out of vents hot. When I turn the temp selector, on cold the air is warm to hot, but when turned to hot, it gets a lot hotter. Not sure how Fords operate (left my Chevy behind and got a ford). Blend door, thermostat, vacuum line, or actuator? Where to begin? Radiator and cooling system full with no air in lines and no leaks. Hope it's nothing too big.
View 14 RepliesMy 02 F350 7.3 new to me trucks ac stopped blowing cold. Not air gap issue (shims have been removed prior to my ownership-I pulled hub and checked), the charge is good (according to the shop I went to for evac and refill), and the compressor's cycling quickly. I'm no HVAC guy by any stretch. I have a cheapie gauge from days long ago that I connected to my low side port (which I know isn't definitive) and it reads from 25 to about 40/45 depending on the cycle.
Additional info that may not be anything:
1) Where the line goes from accumulator to evaporator the foam seal is slightly messed up and I feel ice cold air coming out of the housing.
2) The line is warm before the orifice and cold after it.
3) The lines going to the accumulator are both hot (after taking it to shop, before were lukewarm).
4) The condenser doesn't seem to have excessive plugging and I have rinsed it with garden hose sprayer with no difference.
5) The air from the vents blows good, just warm.
6) I've replaced the actuator for the blend door already.
99 f-350 crew cab. The A/C is not blowing cold as it should. Have already replaced the compressor and clutch, orifice tube and accumulator, also cleaned evaporator coil and put a new blower motor on, also a new blend door actuator. Also put a valve in to block coolant from the heater core. System has had vacuum pulled and charged correctly by my mechanic, he says he doesn't know of anything else to do, that it was as good as its going to get. Ive been in 2 more trucks identical to mine and the A/C will freeze you out, as to where mine will not come close. Temp coming out of the vents barely gets down to 60 degrees
View 14 RepliesI have a 2002 F150 V6 Extended Cab Truck. Currently my A/C strength isn't as strong as it used to be. On all settings from low to hi, the strength adjusts from low to high like normal. Heater works on floor and defrost just fine.
I'm trying to figure pin point how to make the air flow stronger. Recently my coworker replaced my freon and recharged my system with a new orfice because the air wasn't as cold as it used to be. Now the air gets down to about 58 degrees (he said it could get colder if we replaced the accumulator which I'd like to do in the future).
Right now though I'm trying to figure out how to get the strength of the air flow to be stronger. My evaporator core has never been cleaned. I've never had my condenser cleaned either.
I opened my glove box and unhooked it from the hinges to look behind it, and I found a plastic store bag in the back. I removed it and I think it improved the air flow to normal strength it used to be. Hopefully it's not a placebo effect.
Why the 30amp PCM fuse located in the under dash panel would blow. Problem started while truck was running and a simple replace of the fuse would it it back alive again. Now fuse is blowing at ignition on. Truck is 1997 F250 LD.
View 7 Replies