Ford F-150 (2004-2008) :: 2005 STX Misfiring After Spark Plug Change
Apr 15, 2013
I just changed the plugs in my 05 stx 4x4 4.6L. Truck was running fine, never a problem but it has 105k so I figured id change them. #4 was the only one that gave me a little problem (besides being so tight). The coil and spring pulled off the boot, and I had to get a pair of pliers and get the boot off the plug.
I simply slid the spring back through the boot and replaced it once I had changed the plug. Other than that they all came out easily. I replaced with motorcraft plugs, and #5 did have what looked like some oil down on the threads when I pulled it out, but not sure if that's a big deal or not
Any way, I am torn between ordering new boots and changing them out, or just biting the bullet and getting 8 new coils with new boots attached. Truck runs fine, but does the usual buck/jerk under a load in overdrive now (never once did it before)...
View 3 Replies
Advertisement
I have a 2006 Fx4 with 60,000 miles. I wanted to change the spark plugs myself yet I can't seem to find were they are in the engine, I know how to take them out but I don't know how to get to them.
View 1 Replies
I own a v10 and am getting ready to assist a buddy out with his 05 5.4l. He wants me to change the spark plugs out. I have changed the spark plugs on my 04 v10. I think this is the year for went to the 2 piece spark plugs. Also what torq setting should I torq them to? Should I also use anti seize with them or no? Does the gap need to be set on the plugs? I dont have a book to go buy.
View 12 Replies
I had first two spark plugs break off in my 2005 F150 before stopping. I ran five tanks of injector cleaner through using different brands of cleaner. The next six plugs removed without any issues.
Since then, I replaced 2 plugs after 25000 miles. Used one tank of injector cleaner and had no problem.
I would suggest that anyone planning on changing plugs run some injector cleaner through before the change. The cleaner seems to remove the carbon build-up around the plugs.
View 8 Replies
I am getting a cylinder 5 misfire and this has been a "on again off again" situation since last August. I took it around to a few places and the general solution was to get new spark plugs. After doing a bit more research I was advised to change the coil cover. I did that and it fixed the problem. Then about 4 months later the light came on again. I happened to change the air filter and the light went off. I though great, problem solved! not so much, when i went to the mountains the other day the light came back on. I did my research again and I have decided to get the plugs changed. Its a 2005 f150 with 94,500 miles on it.
I am told its time to change them regardless. I started calling around and getting quotes and have been told by multiple shops that ford made the plugs in my truck in a bad way. They have been telling me to change them and breaking them is a 50/50 shot. THEN, when they quote me they charge a rate to replace them plus the plugs themself. If they happen to break one then the customer pays for the new one. Do the plugs would really break that easy and should I plan on replacing some of them?
View 14 Replies
I have a F150 which has developed a miss or hesitation when driving. I took it into my mechanic and he told me this:
This year truck is famous for needing a tune up but the problem is that ford redesigned the spark plugs for these years of trucks. The problem is hat carbon builds up and when u go to remove them the plugs break and sometimes you have to take the heads off to get them out, he said that this would cost around I 2500 is one breaks!
So my question then becomes is this the norm for my V8 2005 Ford F150?
My truck has 85,556 miles on it.
View 6 Replies
my wife drives a 2008 toyota camry 4cyl. she has about 86000 miles so i figured i would do a little tune up. change plugs, filters, injector clean, etc. while changing the plugs i seem to have broken 3 of the 4 pressure tabs on the plugs that plug into the coil. for the time being i have the pressure tap electrical taped very tightly onto the plug. What I should do? or is that common to for those to break off. I didn't even really use a lot of pressure either.
View 2 Replies
I have a Ford Taurus 2004 and would like to change its Spark Plug. I am looking for instructions for doing so as 3 of the spark plugs at the back of the engine are under the manifold air-intake. I am looking for step by step instructions of how to reach to the spark plugs to the back.
View 9 Replies
2004 5.4L ... Codes indicate a firing issue on #4 cylinder, figure it's the coil pack. They bought truck used a few years ago and plugs have not been changed since they have owned it. I was going to change plugs while I was under the hood. While checking threads on this engine I picked up on plugs being a major job unless you know the tricks. So what tricks do y'all have up your sleeve to keep from breaking plugs?
View 14 Replies
Experienced lower mileage after changing the plugs at about 120k miles?
In the 10 months (23.6k miles) since I had the dealer change the plugs, I have averaged 43.3 mpg overall.
View 11 Replies
I have a 2007 Prius with ~180000, which runs great. The mechanic shop I used for oil change suggest me to change spark plug because they are dirty. After the change, I found I cannot step on the gas pedal too hard for acceleration. The car will hesitate, choking or die if I try to accelerate too fast. But if I step on the gas pedal gently, and let it reach the desired speed in a slower way, it has no issue. I went back to the shop and they replaced with another set of 4 plugs, and no improvement. I checked air intake tube and it looks no leak, but really old. Other than that, the car runs great.
View 19 Replies
About a month ago I changed the plugs on my EX to see if I might pick up a few tenths on my mpg. There was no real issue, but I wasn't sure when they were done last. I used Autolite platinum's(AP103). Since I changed them The truck has a hard miss during acceleration. It feels like it is missing on multiple cylinders. It is most noticeable below 2000 RPMS. During hard acceleration it almost clears out, but the the truck feels like a pig.
There is also a miss at idle, but it goes away if the truck is in park, or neutral. Thinking that it may be my choice of plugs I went back last week and replaced them again with motorcrafts. Still having the same issue. Have scanned the truck with both the Torque app, and an sct scanner and its not throwing any codes. I'm at a loss. In the last year I have replaced the fuel pump, and the filter so I'm ruling those out.
View 14 Replies
Had a spark plug sleeve come out, the part with the hex head to turn the whole thing. Wonder if JB Weld put on the inside of this sleeve and placed back over the plug will hold enough to turn the plug and get it out after some more pb blaster?
View 4 Replies
I just picked up a 05 F150 lariat 5.4 2wd with a 177k on it. What the chances of these plugs coming out with out breaking? Any tips tricks to getting them out? Should I put motorcraft plugs back in it ?
View 6 Replies
I am a newbie here, and also a new owner of a 2006 F150 XLT 4X4 with the 5.4 engine. It has 68K miles on it and looks to have been well cared for. I have a couple questions. First the truck is runnig great, no problems. I have read the threads regarding the spark plug issues and was looking for an opinion about changing them. Should I wait until I have problems, or due to the age of the truck, should I go ahead and attempt it soon? Also, I would like to find a used cap for the bed. I have the 6.5 bed, and wondered what range of years would work with my truck.
View 3 Replies
I have an 04 F150 5.4 w/67k. Just changed the OE plugs. While I had it in the garage also cleaned the K&N air filter. Truck runs great but I lost about 3 MPG. I was getting 16 all around and am now getting about 13 under the same conditions. I bought a Purolator air filter and switched it with the K&N but there had been no difference. I used Champion plugs as the replacements. Truck ran great before and runs great now.
View 14 Replies
In the "Old days" I could pull the one-and-only coil wire and trigger the starter motor to rotate the converter so the plug was at the bottom. How do ya do this with COP engines so the engine does not start?
View 4 Replies
I just completed a successful second spark plug change, using Motorcraft SP515 plugs just like last time. After reconnecting battery and starting engine, it ran poorly throughout a short road test. Felt like it was skipping. Checked under the hood and found that the #2 fuel injector was disconnected, so I reconnected the injector.
I took another short road trip and it still ran poorly as if skipping. So, this time I disconnected the battery for several minutes while removing the #2 plug thinking I may possibly have fouled the plug by the injector not being connected. I also checked all of the other injector and coil connections. Reconnected battery and took another short trip. It still runs poorly. No codes yet.
View 14 Replies
Had a miss in the #5 cylinder on a 2005 F-150 5.4 Triton. Had it hooked up to see which code was given and the tech said that #5 was the culprit. Taking no chances, I purchased a new plug and coil pack. I installed them and it ran great until I got up to around 70mph and then it started dong the same thing it was doing earlier. I took it back to the place that checked the codes and it came back as the #5 cylinder misfiring again. I am not sure how this is possible after replacing the plug and coil pack. Is there some way that the plug that fires just ahead of #5 is fouled out and causing the #5 cylinder to get too much fuel transferred to that cylinder? Or is there a possible short somewhere causing that cylinder to misfire and ruin the coil pack? I am stumped on this for the moment anyway.
View 8 Replies
I have a 2011 Escape Limited 3.0l V6 AWD. Did a spark plug change at 115k miles for the first time per dealership recommendation. Got new plugs from dealership.
Was pretty cut and dry to replace. Did not check gap on plugs as was told they are not adjustable per dealership. Put pea sized amount of dialectric grease in the COPs and then fitted the plugs into several times with a little spin to coat evenly. Installed plugs to 11 ft.lbs. and reassembled all components without issue. Installed them one at a time so as to not mix up the coils.
I did break the 90-degree nylon quick disconnect for the fuel line that connects to the fuel supply manifold and had to purchase a new hose assembly. Reinstalled without issue.
Went to start up and engine cranks (hiccup sound) but does not turn over. The sound is weak and not a throaty crank like an engine should give. Check engine light flashes on dash and issues a frequent tone also.
Wondering what the issue is? Are they the wrong plugs? Improperly gapped? Possible the fuel line did not pressurize and there is no fuel getting to the plugs for ignition? Kind of stumped as it was a pretty cut-and-dry replacement (if such a thing is possible).
View 4 Replies
I want to change spark plug, took connector of spark unit and took bolt M6 out, lifted spark unit but not enough clearance to remove the unit in order to use wrench for unscrewing spark plug. How it works?
View 14 Replies
